Ford - Taurus :: 2001 - As Soon As Ignition Is Turned All Power Is Lost
Apr 30, 2011
2001 Ford Taurus 3.0 DOHC. Starting Problem. When the door is opened the interior lights come on, door dings, etc. As soon as the ignition is turned everything goes black all power is lost. Disconnect battery cable and reconnect, the open door again and the interior lights come on, door dings, insert key and turn, everything goes black, the car does not start. This cycle repeats over and over again every time the battery is disconnected and reconnected. I have replaced the battery, ignition switch. The starter was replaced last year. Why does power blackout, and car not start when the key is turned?
View 1 Replies
Advertisement
Having a problem with the fuel pump engaging. Warm or cold same problem. When I turn the ignition on I can hear the fuel pump engage and the car runs fine on start. Other times I turn the ignition on and don't hear the pump engage, thus no start. But repeatedly turning the ignition on an off I get the fuel pump to engage and I have start, will run until I shut it down. been doing this for a couple of weeks now. Is this an ignition thing or fuel pump? No wiring diagram. Replaced all relays, battery good. Never did anything with the fuel system.
View 3 Replies
I was driving my Taurus a few days ago when it lost all acceleration and power steering. The engine seemed to be running okay, and it restarted at the side of the road, but still no acceleration. I called AAA and had it towed to my mechanic. The following day they called and could find no problem.....
they had driven it several times, checked out likely causes but found nothing. This garage has been very reliable in the past. They said it could just be an electrical issue that may or may not happen again. The car seemed fine when I was driving it today, but I am worried about it happening again. What could have caused this/what I should do?
View 5 Replies
While pulling onto the highway and pulling pretty hard lost engine power all boost then engine truned off. Top of engine is covered in oil..... What happened?
View 11 Replies
I have a 97 Ranger, v6 4.0L, 2wd, 5spd. It has been my daily driver since 1999. I was driving to work today and when I pulled into the parking spot, I turned the truck off, and I thought it was odd that the locks didn't pop up when I shut the truck off.
I then realized that I had completely lost all electrical power. Tried to turn the truck on and nothing. No click. No dome light, no horn, no nothing.
My battery reads 12.5 volts and the connections are all clean on the battery. I checked all the fuses and they are all good. What else should I check? This may be the first time this truck has ever stranded me before.
View 6 Replies
here its is i have a 1986 ford f350 6.9 aftermarket turbo set up i was driving it then i went over rail road tracks lost all power to fuse box no headlights no interior lights no ignition power batteries are good so now when i turn key nothing lights up it just killed my whole truck....
View 7 Replies
01 Elantra, once warmed up to running temp starts to run like a pig & wont idle, has new plugs/leads.
Funny thing is there is no engine check light, in fact it doesn't even come on for the 6 seconds when the ignition is first turned on at all.
Secondly I have OBD2/ELM327 with scanpro but it doesn't connect to the ECU.
We put it into a shop & they claim they were able to connect to ecu but gave no codes which I find a bit strange.
View 16 Replies
I have a 2006 prius with about 75k miles on it. It was sitting for a few months (due to loss of job exp tags no insurance) finally got financial issues squared away and when I was ready to use my prius it would not start.
Jump start got it going and it drove great. Occasionally after having the car parked it would give me problems starting. sometimes screen would read "There is a problem with the transmission "p" lock mechanism. Park your car on a flat surface, and fully parking brake" after following steps and turning car on and off a few times it would allow me to drive.
Last night I got home and parked my car, turned it off and immediately noticed that as soon as I powered off the car i lost all power. I tried starting car right away and no power at all. door locks, all lights, brake lights, everything off. this morning i tried jump starting car and nothing so I went to toyota and had the 12v battery replaced.
Unfortunately still no power however power button illuminated green when pushed but nothing else, still no power nothing but the green light. I pushed the power button once more and light illuminated orange and when i applied the break i could hear clicking noises under the hood but still no power at all... nothing. I checked all fuses and everything checked out ok. I also checked the 120amp fuse and it seems to be just fine as well.
View 19 Replies
I have a 2004 Elantra GT, and for the past year it sometimes makes no attempt to start when the ignition key is turned. All the dashboard lights, radio, bells and whistles are fine, but once the key is turned to start nothing happens. There are no clicks or anything. Some dashboard lights stay on and I can hear the initial whirring under the hood from the electrical system.
I've replaced the battery, ignition wires, and plugs. This will happen very erratically. Then all of a sudden it will fire up like nothing was wrong. This is always over a several minute time span of trying and retrying to start. I took it to a mechanic but we can never replicate the problem while there.
View 8 Replies
I have a 2001 BMW 330i. The car has been a dream since the beggining but lately issues have risen to the surface. Today, when I turned off the ignition all the dashboard lights remained on. The keys in hand, lights off, nothing else on, but the dashboard was lit up light a christmas party. I recently recharged my battery, a problem, I think, caused by the cold temperatures. Other than that I have not noticed anything wrong ..
View 1 Replies
My car turned off and lost all power randomly on the highway. This is what happened on the cluster when I tried to start it up. Alternator maybe?
Pics .....
View 4 Replies
Got a late 2004 6.0 that runs excellent. When it is cold (as in not running for half a day, not ambient temp) it dies as if the ignition gets turned off. You can start it right back up no problem. It has been slowly getting worse. You maybe have to start it back up 5-10 times before you can get going in the morning. Also you can hear a random click with ignition just in on position as if there is a connection issue in the dash and cuts ign in and out that I think may be the problem.
I swapped all the relays to different spots to try them. I don't think it's wiring because it does it when cold then works when warm. Guy thinks plugging truck block heater so maybe it work better somewhat. New CMP, CKP, FICM, and it doesn't make a diff. So it's baffling to me. It's obviously electrical and works better when truck is warmed.
View 14 Replies
Ok, so I'm working on a 2004 Hyundai Santa Fe, 93,000 miles. The vehicle runs great! So great that you cant get it to stop running!! The problem is intermittent and generally happens after the vehicle has been running for at least 3 minutes. I turn the key off and she keeps on running (not dieseling, but running at 340-450 rpms!) I have already removed the aftermarket remote start that was installed on the vehicle thinking that was the problem, it was not. Then I went to the ignition switch and unplugged that, also to no avail! I plugged my scan tool in and can communicate with the computer and view pids while the key is on. When I turn the key off, I should loose communication. When everything acting normal and the car actually shuts off with the key, I loose communication with the computer upon turning the key off. When I turn the key off and the veh. keeps running, I do NOT loose communication with the pcm. The only way to shut the car off is to step on the gas pedal. Otherwise it'll run at 400 or so RPM for an hour or so!!
View 8 Replies
Truck ran good, but for the past month every once in awhile it would just stall quick, no rumbling, no smoke, like someone just turned off the ignition, if you turn the key it would immediately fire right back up. Well today it would not start back up. Pulled the IPR plug, no good. FICM replaced abt. a month ago. Checked with Scan Gauge, oil pressure abt. 925 while cranking dropped to abt. 780 after extended crank. And no codes. I do notice when turning key on I hear less clicking/noises going on. All dash lights come on and turn off as usual. Tach doesn't move.
View 14 Replies
1999 5.4L F250 ... When I turn my ignition all my lights come on and I have power to dash and etc, battery is strong, but when I turn the key I get nothing even when I do the shifter trick for the slip we get on most fords nothing took ignition lock cylinder out and blasted it with electronic connection cleaner, when key is turn i loose all power to everything and there is no "click" or i gage from anything under the hood or the starter rally confused!
View 13 Replies
My wife's 2001 Gran Prix has a problem with the ignition switch, or related to the ignition switch. Intermittently (more frequently in warm weather or when the car's warm) the ignition switch can't be turned back to the 'off' position all the way, meaning the key can't be removed from the switch. We've heard from several mechanics that there are a couple problems that can cause this, and in fact had the ignition switch replaced which did not solve the problem. I understand there is a connection to the transmission or gear shift lever that may also be part of this problem in some way. There can only be so many solenoids, switches, connections, etc, related to this, I'd like to fix the problem and avoid spending money unnecessarily.
View 2 Replies
I have a 2004 Hyundai Sante Fe 2.4L that keeps blowing the ECU fuse under the hood when the ignition is turned on. We have replace the fuel pump and the inertia switch. I have tested the relay, ignition failure sensor, both coils and O2 sensor wiring.
View 10 Replies
I noticed yesterday that my 2001 was stumbling when turning left. Later in the day, the CEL came on, and I retrieved a P0301 code. In both cases, I was driving around town, not cold but not fully warmed up, engine temp around 40-70 C.
I haven't done any further investigation, other than trying some different driving experiments. I've been able to recreate the problem several times starting out with a left turn when the car briefly runs on three cylinders. Going straight or turning right is fine.
Question: which cylinder is #1? My intent is to check the plugs and leads first, but since it's cold outside I'd like to focus my attention as much as possible on the problem area. I thought at first it might be fuel related because of the turning behavior, but on reflection, it feels more like an ignition issue.
View 6 Replies
2002 F350 7.3 PSD. 192k miles.
From my understanding, a CEL is supposed to illuminate each time you turn the ignition ON as part of normal startup procedure.
I figured the previous owner must have pulled out the bulb to hide the fact that the truck had a few "issues" before selling it, so today I pulled out the gauge cluster and it looked as if the CEL bulb was a tiny LED soldered directly into the gauge cluster itself. There were a few serviceable/removable bulbs for things like turn signal indicators, high-beam etc... but the CEL did not have a serviceable/removable bulb.
I've been driving this truck and working through it's "issues" and fixing things as I go, but it keeps throwing codes without the CEL illuminating. What's going on here?
I thought the check-engine-light was supposed to illuminate each time the ignition was turned on, and that it would come on each and every time the vehicle registered a fault code in the ECU/PCM.
View 14 Replies
I have 1997 chevrolet Silverado k1500. When I turned the key the other day, there was no electrical power. No gauges. No lights. I checked the battery and terminals and those are fine. When I turn the key slightly the (P) park illuminates but when i turn the key further it goes out. Then there is a buzzing sound from just to the right of the brake pedal. When I depress the brake pedal, the buzzing ceases but then a relay from under the hood in the relay center buzzes. Then when I turn the lights on, all buzzing ceases. But, the lights are not illuminated. I switched the buzzing relay with the a/c relay but that did nothing. I am wondering if there is a main relay that controls all the electrical power?
View 6 Replies
I put a new ignition cylinder the key won't come out at all. I was told that the key needs to come out in order for them to code the key. How do I get the key out of the ignition??
View 12 Replies
