I have a truck that is leaking power steering fluid. I have change out the line from the bottom of the power steering fluid container, but i cant get it tight enough to stop leaking. I tighten it, and it stops for a while then starts leaking again.
View 1 RepliesI was pulling out of a parking lot making a sharp turn when all the sudden I lost my power steering. I have a '94 Ford Ranger manual transmission. It didn't make any sounds. I was going to try to keep adding power steering fluid to it and try to get it home to my mechanic in my hometown - but it drips constant liquid when I drive it down the street (you can see drips) so I don't think that's possible. I've read a lot on here about gear boxes failing, but would this cause it to leak even if the truck wasn't running? (the puddle builds quickly when its just sitting there, engine off). I took it to a mechanic (I don't have tools), and they said they can't say anything for sure until they look around, it could be seals or a new gear box.
View 2 RepliesProud owner here of a '96 3.0L RWD Aerostar Utility Van with about 138k miles, and leaking power steering fluid. At this point I'm replacing fluid from zero every time I have to drive it which is about once a week. I've located the leak and it seems to be coming from the pump/reservoir around the pressure hose. The hose is loose as in i can move it around a bit, but from what I've read, this is normal and the hose is supposed to be like that. I figure that at this mileage, with so much air going through the pump, all the crazy squealing and whining it does even when full, at this point it probably makes sense to replace the whole pump while I'm in there, as opposed to just doing the reservoir. Anyway, I'm planning to do this in a couple of weeks, and have some questions...
1) The pump - I've read on this forum that the best way to go on brand of the pump is Motorcraft.
2) Hoses - I'd like to replace the hoses coming out of the pump while I have this thing all taken apart, but I'm not exactly sure what parts to get. I know one is the pressure and one is the return, but there are variations of each based on the research I've done. The parts on the Napa site have different descriptions like "with switch port", "without switch port" "56in hose" "26in hose", and so on. Which ones I need, specifically the ones connecting directly to the pump? I havent been able to find anything in my research online, in Haynes, or Chiltons manuals.
3) Washers - Whether or not I replace the hoses, should I replace the washers at the connection point? Chilton's seems to recommend replacing them. Will they come with the new pump?
My local auto parts shop has the pulley remover/installer for me to rent so I've already got that squared away. I'm pretty sure I've covered all of my bases otherwise.
My transmission on my 2002 7.3 4x4 is pouring fluid from somewhere above the rear of the pan. I thought it was the pan at first. I pulled it off and replaced the filter. After adding fluid while it was running for 4 or 5 minutes it started pouring again. It's not the pan. It's coming from above the pan somewhere. It won't leak unless it's running. Is there a place it can leak on top??
View 7 RepliesI need to replace the power steering hose because my power steering fluid is leaking. Is this the right part? [URL] .....
View 14 RepliesI noticed that the power steering fluid is leaking bad from a weird spot under the car, it looks like it is coming directly under the drivers seat but I can see any lines. It's an 02 Santa fe ....
View 8 RepliesI've got the feeling wire clothes hangers, duct tape, & screw clamps may be handy,;>). there appears to be a security cage around the fitting where the hose connects to the pump.
View 1 RepliesI have power steering fluid leaking out of the bottom of the Brake master cylinder out of a round hole. Every time I pushed brakes it leaks a good amount of power steering fluid out. Why it would do this and is there a screw missing out of the hole or what?
View 6 RepliesI have a '92 Celica GT which runs perfect except for the Overheating problem, the Power Steering problem isn't a big deal for me, Before I owned a '88 Chevy Beretta GT and after that a 94' Pontiac Grand AM SE. They were both pretty crappy.
But I need to figure out why it's overheating like this, Me and my stepdad did a raidator flush on it and it didn't work at all, The fan works fine, but I will be driving it and will have to pull over quite often to let it cool down and put water in it, I've stopped using coolant because I'm wasting too much money on it, and it does the same as the water, I know for a fact it isn't leaking, it acts like it's burning it up or something. I'm not even speeding in it or anything, what's causing the overheating.
I thought it was the radiator but I was told it wasn't, then I noticed the radiator cap was spurting out water and took it to the auto parts store to get it replaced and it didn't work, They told me somebody before I owned it switched the radiator from a 91 Camry? or something like that. That is the cap he replaced it with anyways because the cap for a '92 Celica didn't fit, it was too big. But the car ran perfect when I first got it around December, no problems at all, It just started overheating like this about a month ago.
I have a 94 Celica 2.2. I'm having issues with power steering fluid leaking from reservoir cap. I replaced the cap due to the old ones seal had dry rotted and dip stick was broke off, also replaced the 2 small short hoses and new clamps. The return hose is working right and the high pressure hose seems to be working right. None of the hoses are leaking but pressure is building up and pushing fluid out the reservoir cap. What else could be the problem to cause this??
View 14 RepliesBought a 98 last week and noticed an issue a couple of days ago. The car seems to be leaking power steering fluid from right in front of passenger front tire. Looks like it's coming down from somewhere behind the bumper, just not sure what line are over there. I had to replace one of the clamps on the line below the ps bottle and it seemed to be fine for 2 days.
The weird part is that it doesn't seem steady. I had the car parked in one spot for an hour the first time I noticed the problem and the wet spot was about a foot in diameter. But then I drove the car last night and left it parked in the driveway for hours and nothing. This morning when I was leaving there was a puddle about 4" in diameter.
We have a 99 Honda Civic that just started leaking power steering fluid. My mother was out with it when it suddenly ran dry so she bought some power steering fluid from autozone unaware that Hondas aren't supposed to use generic power steering fluid. Now the reservoir is dry again, the fluid leaked out in a matter of hours, so what kind of damage could the non Honda fluid have caused? Also, what could be causing a leak that fast?
View 5 RepliesWe have a 2001 VW Golf w/100K+ miles and the power steering fluid's leaking. Mechanic says a new rack/pinion and steering gear is needed. The estimate is $1K which troubles us because of the market value of the car isn't great. So, in the meantime, I tried "Lucas Stop Leak" and it seems to work (when the fluid was completely empty, it was making that loud screeching noise). Seeing that this is a 2nd "back-up" car, my questions are these:
1) Is it a bad idea to use Lucas (topping it off w/VW-approved steering fluid)? We rather donate the car than than to pay for the repairs. Some internet searches indicate that a lot of people drive around with a bottle of Lucas in their trunk. That is, that they avoid the repairs by using Lucas
2) Is it dangerous to drive the car? I notice the alignment is off and that re-alignment is part of the repair job. Can I have the re-alignment done?
I just realized that my power steering fluid is leaking. It is reddish color and it is at the base of the windshield on the passenger side. my car has 40k miles. Is this normal and is this considered as power train and is it still under warranty. This really sucks to think that I bought the Camry for reliability.
View 14 RepliesI guess one of the hoses dried out and the fluid is leaking.
Called the dealer to buy a new one but guess what.. They don't sell that hose separate. Only the assembly with the metal line and the price for the whole thing is over $90 + tax .
Red arrow shows the hose that I need and the part number for what dealer sells is 44406
I cleaned everything today and put an extra clamp where the hose is connected to the PS reservoir. Will see if it's going to work for now.
My question is where can I get a piece of hose which will be compatible with PS fluid so I can replace this? Also what is the ID of that hose?
I have a 2010 Accord that started leaking power steering fluid at around 10,000 miles. In February 2011, I complained to the Honda service technician when I took the car in for an oil change about the leak. At that time, the service technician told me he did not see a leak and that I should simply continue adding power steering fluid as needed.
I took my car in for another oil change this month, now my car mileage is 46,000, and the technician informed me that the power steering fluid is linking and it is now necessary to replace the "rack" and "boots." The repair will cost about $1000. Though my car is no longer under warranty, the dealership agreed to pay for 50% of the repair. I have asked that the dealership pay for 100% of the repair, but I was told that they would not do that.
OK so my 2001 F250 was leaking power steering fluid from the lower portion of the gearbox (where the pitman arm attaches).
I found a thread on this forum where it showed how you could change the seals out WITHOUT taking the gearbox out.
So I got the pitman arm off with a heavy duty puller. Then I scraped out the 1st rubber seal hoping to reveal a snap ring behind it. Well, the seal is 99% scraped off, but there is not evidence of a snap ring. It does seem like there is some metallic ring holding another rubber seal in behind it. But again, I can't find the little open spots that you put your snap ring pliers in to get snap rings out.
How do I get this metallic thingy out???? I already broke a small drill bit trying to drill it out. It just doesn't seem like the best way to go about it.
2.7 Power Steering Fluid boiling/foaming leaking out a reservoir cap!
1) Recently had Timing Belt/Water Pump and spark plugs/wires replaced.
2) Issue started immediately after.
3) Removed most of old PS fluid, cleaned out reservoir w/brake cleaner. NOTE: nothing appeared to be clogging reservoir. Refilled with new PS fluid. Repeated these steps a second time. This appeared to immediately resolve the issues for several weeks.
4) Now the power steering is getting rough and noisy again. Also, the PS reservoir is leaking out of the cap worse than before. It looks like the fluid may be "boiling", but it is definitely foaming up pretty badly.
What my issue(s) may be?
My car is in the shop and has a leak at the Power Steering Pump. The rubber O-ring on the Power Steering Pump Solenoid Valve (p/n 4417030120) is leaking fluid. The Solenoid Valve is ok, just the Rubber O-ring is bad, but it looks like you have to buy a complete new Solenoid Valve to get the O-ring (a lotta bucks).
I did find a Lexus Power Steering Pump rebuild kit online at, but I can't see if it includes the solenoid valve o-ring or not. Have to replace their solenoid valve o-ring?
Last night at 2am and it was about 10 degrees out (I say the temp because it might matter?) I started my car, let it warm up to normal running standard and backed up. My car moved backwards but the wheel would not turn at all. I pull forward into my parking spot and noticed that the wheel is extremely hard to turn left or right... almost impossible.
I check under the hood and noticed that my car was leaking something onto the group but it was dark and I couldn't quite see what it was.
Checked this morning and I found that my power steering fluid was completely empty. I had a half bottle in my trunk and put it in my car, then turned my car on. All of a sudden I noticed that the fluid is leaking onto the ground. Not really leak, more like a slow/medium pour and the wheel still wouldn't not move.
I have 2002 F150 5.4L gas 4X4 Lariat FX4. Last winter when it got to -30C here in Manitoba one of the lines near the power steering cooler began to leak. I had just bought this truck and upon investigating found that the original line had been replaced and reattached with hose clamps. I had this "farmer fix" redone but then this winter when it hit -30C it blew apart. Obviously something happened to this line before I got it, so I am curious if there is an issue with these power steering cooler lines when it gets really cold. Should I just get factory lines installed and hope for the best?
View 3 Replies