Ford - Ranger :: 1998 Truck Spits And Sputters On Startup
Apr 17, 2011
Truck spits and sputters when it starts up..and now it does it more often New spark plugs, new fuel pump and filter New mass air flow. I changed fuel octain and that work for a few weeks and back it spits...... It seems that when I put something new in the truck it runs great for a few weeks and then it starts up again...... I can not find a fuel regulator that fits the one that is on the truck now......so I have not replaced it........
View 4 Replies
Advertisement
I've recently replaced the timing chains on my sons 04 F-150 5.4. Now I'm getting a code PO174. I've changed 2 coil packs, fuel filter, MAF sensor and cleaned all the connections. Fuel filter had what looked like brown fuel coming out of the in line of the filter. I'm stressed out now, the truck does not even have enough power to drive up the driveway. Backfires, spits and sputters, has rough idle.
View 4 Replies
I have a 1999 f150 5.4L that will drive normal and all of a sudden it will spit and sputter, the CEL comes on for a second or two, then it’s all over and its back to running normal. I changed the plugs, and fuel filter and it still does it periodically. Vacuum leak?
View 4 Replies
I have a 1999 f250 super duty with the 5.4 Triton motor with a 5 speed. I bought the truck a couple months ago, and it had a bad manifold leak (not surprised lol). but it ran fine just noisy. So i had a shop do new gaskets and bolts. Then my problems started.........
When you start up the truck she runs fine and some times drives fine. I will be driving along and its like some one hits a switch and i suddenly loose all power it spits and sputters and i have to down shift to make any kind of hill.
So I figures I had a misfire i got a light on for cylinder 5. So I decided to change all coils and plugs hoping that would clear things up...... well it didn't. It ran great for roughly 15 miles then it started to do the same thing again. I've changed air filter and fuel filter also.
When it starts sputtering i sometimes get a check engine light on and then it goes away. when the light is on the codes are:
P1151 A Heated Exhaust Oxygen (HO2S) sensor indicating lean at the end of a test is trying to correct for an over-rich condition. The test fails when the fuel control system no longer detects switching for a calibrated amount of time.
Read more at: [URL] ....
P1152 Lack of Upstream Heated Oxygen Sensor Switch Sensor Indicates Rich Bank 2
Read more: P1152 FORD Lack of Upstream Heated Oxygen Sensor Switch Sensor Indicates Rich Bank 2 | AutoCodes
Both codes come on together always. but it will go away when the sputtering clears up. I just checked fuel pressure its at 32psi at a idle.
View 1 Replies
Car spits and sputters when engine is cold. When engine is warm car runs fine. I believe that my cold start injector or my cold start injector time switch is bad. 7MGE Toyota Supra ....
View 10 Replies
My Honda has a strange problem that is vexing my mechanic. While I am driving, the engine spits and sputters and sometimes dies. I try to restart and it starts right up but runs rough. Sometimes it takes a while to start back up. If I wait a few minutes, it will start again and drive fine for a while. Then it will do it again. After it is warm or when it is cold at the start, it won't do it.My mechanic cannot get it to do it long enough to diagnose. The computer is not throwing any codes. I believe it is electrical because when it does this, the speedometer goes crazy bouncing up and down. Electrical problem also may explain why the computer is not throwing any codes. I need to narrow it down because my mechanic is reluctant to start trying things as I don't have a lot of money to throw at this.
View 4 Replies
I have a 99 ford ranger xlt 4.0 ohv basically it sputters so bad while driving it sounds like a dump truck but it all started when I changed my o2 sensors but in doing so I broke my heater control valve and when I was going down the road it started sputtering well it started sputtering so I checked the o2 sensors there good and I changed the heater control valve. But nothing so I changed my coil pack spark plugs and wires but still nothing. But on my reader it says cylinders 2,3, and 4 are misfiring and bank 1 and 2 are running lean plus it has a bad aroma of gas in the engine compartment but when it idles its somewhat smooth but when I'm driving it its horrible the sputtering is so bad it takes awhile to get up to speed plus I'm only getting 100 miles to a whole tank that's like 8 or 9 mpg I need to fix this soon. This is my only transportation...
View 11 Replies
I have a 2006 Town and Country with the 3.3L V6. The last four times I filled the gas tank the engine spits and sputters after running for 2 - 3 minutes. Sometimes it will even stall out. It will re-start after cranking for 4 - 5 seconds and then runs fine. It only does this right after I fill the tank and doesn't do it again until the next fill up. Thought that I might have water in the tank so I added a bottle of HEET to see if it would cure the problem, no effect at all..
View 4 Replies
I have a 98 Ranger SuperCab XLT 4WD 4.0 Auto. Occasionally, especially when it has been sitting for more than 3 days, it shakes for maybe 30 seconds on startup. It smooths out gradually after that, maybe 15 sec. to normal smoothness. It seems like it is firing on all cylinders and is more like something out of balance.
Never does it when sits less than 2 days. When it happens, the longer it sits the worse it shakes.
View 3 Replies
I have a 98 Explorer upon startup is horrendously shakes. What went to hell in the transmission?
View 6 Replies
1998 4.0 ... She only misses about 30 seconds during stone cold startup. I figure it's probably the plug thats hardest to reach ? Isn't that the way it always is? From the hood I can see only one spark plug, so I figure I'll do all the plugs. Is there any right or wrong approach to the plugs? I did the thermostat today, but this plug job looks like it's gonna be a bitch. Time for some skinned knuckles Next is the right side O2 sensor, that looks like fun too. But I gotta say, this little truck is sweet. Great visibility and easy to park in the city. I really like her. She's a keeper. She needs some new sway bar bushings too, but no surprise with 127 K on the clock.
View 5 Replies
i have a 02 ranger 4by4 with 4.0.every time i try to fuel the pu it spits gas back out the fill tube and i have to fill it very slow to get fuel in it.i just replaced the filler neck about 6 mos ago due to having a hole in the the hose by the local ford dealer,
View 6 Replies
I am having a problem with my O/D light flashing and my truck shifting hard. Just started out of the blue. After reading a few other topics, I am hoping it is the VSS. Now if only I could find the dang thing. Looking for a diagram, or detailed description on where it's at?
View 14 Replies
So Im working on a 1998 mazda b4000, frost plug blew out going down the highway changed the engine because it got cooked pretty bad. The wrecker engine I got for what ever reason will only run good if the driver side of coil pack is done 5,6,4 any other order truck wont run at all. Misses enough to shake the truck at around 80 km/hr otherwise its pretty good. Also the engine I got came factory with no egr.... no provisions nothing. exhaust manifold capped off, seemed kinda odd.
View 5 Replies
I have a 98 Ranger 4x4 XLT 4.0 5sp. It has 182K miles.
Once in a while it will blow the fuel pump fuse. It'll go 2 years sometimes. And sometimes the engine will stall just for a second making the truck "buck" as it accelerates.
Could it be the pump is about to fail? How long do they normally last? Btw, I change my fuel filter every 2 years, no issue there.
I've owned the truck since new and maintenance is always taken care of. Also, What's the best way to change the pump?
View 9 Replies
I have a 98 ford ranger with a 3.0 v6 it has 228,000miles standard tranny but I keep the truck running great. I did the plugs and wires about two weeks ago and it was running fine, actually great. This morning I got into the truck to start it this morning and it barely started. It fired up but barely stayed idling. I would get into the petal and it wouldn't raise rpms. I had to get to school so I headed out. I couldn't get any speed in gear the truck wouldn't gain speed. It would sputter and pop and then all of a sudden it would go ok but then start popping again. I took it to a buddy shop and his scanner showed p1131 and p1151 both codes. I don't know what to do?
View 13 Replies
Trying to do some trouble shooting on my own as I'm tired of spending $$ with my local "diesel" garage and getting ripped off. To start with, here's my symptoms:
1. Hard (very hard) to start in the morning. Gets harder every morning. Took me 10 minutes of cranking yesterday morning
2. Once it does start it's very loud, seems to run on just a couple of cylinders and lot's of white smoke
3. After about 10 minutes it's able to get down the road but then at about 2300 RPM and above it sputters, low power, and LOTS of white smoke again.
4. Lots of diesel smell, almost like it has a leak but no visible signs of leaking anywhere.
I've done a lot of research and seems to be leading me towards injector problem or in that general vicinity. However, my first step is to try to narrow it down a little more before I start throwing parts at it. So, first question is: what's my best option for downloading codes? I guess I need one that is CAN capable but seems like most of these or either a few thousand $$ or I have to go to something like a Scanguage or Bullydog. I've thought about putting a tuner on but I guess at that point I'm committing to keeping the truck for a few more years.
So, just initially looking for info on diagnostics equipment and/or test that will eliminate the issue(s). Second, need inputs on possible problems based on symptoms listed above that would be great too. Had EGR delete done a year or so ago.
View 4 Replies
I have recently purchased a 2012 facelift Tiguan diesel and it has a running fault. When starting the engine, 50% of the time it starts fine, 50% of the time it starts with a "misfire" and sputters for a short while (5-6 seconds) then stalls. If you Rev it a bit while it is sputtering then it clears the sputter and doesn't stall. It doesn't matter if it's hot or cold. Once it's running fine then the misfire never returns until you shut off the engine and then try to restart. The start stop also fails to cut in and I'm wondering if this could be linked. It had a new battery and alternator fitted a few months ago but a non start stop battery was fitted. This has now been changed for the correct battery but both problems still persist.
View 2 Replies
Drove the car, 20 min to shopping, and when I came out the car would sputter and die??!! it happened a few times.. it would crank for really a long time, engine would fire up but sputter & die. I was cussing & let the car sit at mall parking lot for a bit, thinking I'll have to cab home but it started up again after 10 min and drove fine. It happened on a parking lot, not on the highway.
View 24 Replies
I was getting a misfire in #4 cyl. Couldn't afford to change all my plugs, so I replaced the one that was missing. Two weeks went by, truck ran fine, then it started missing really hard (same cyl #4). Thought my COP was bad, so replaced that and the boot.
Drove my truck to work last night, seemed to run fine, but this morning, it started to sputter again around 45-55. Plug in my OBD2 and it wasn't throwing any codes, seemed to idle just fine.
When I got home I put it park and revved the engine a little bit. Got it around 2500 rpm and it sounded like I have a air leak in a way. What do at this point. It is a 2007 F150 5.4 triton with 104xxx on it.
View 9 Replies
I got my truck to throw some codes. As many of you know I have been having an issue where when I stomp my truck to the floor it sputters and hesitates. Some days its worse then others. It only happens under a load, and it generally doesn't last to long, however today it did it a whole bunch and lasted for a good bit any time I got on it hard. My engine light begin to flash, and there was a smell of exhaust. I went to Autozone quickly as possible. The guy read the code, and this time no lean codes, just a "P0430" which the code reader said was O2 Sensor Bank 2. It also had a pending code, which was "multiple cylinder misfire detected". So my question is can an O2 sensor cause this? Could my CAT on that side be bad?
If that is all it is, is a bad cat or O2 sensor then I will be very happy... Like I said I can sit in my driveway in park all day long, and rev outta my truck. It will never misfire or hesitate at all. Soon is I put it in gear and am going down the road and punch it sometimes it pop and sputter.
Another cool thing is some how their code reader was able to read my ABS light, and I found out that this whole time I have had a bad ABS Speed Sensor in the rear end. That is a plus as well.
View 14 Replies
