Ford - Ranger :: 1995 - Airbag Light Flashing / Code 41
Nov 23, 2011
The airbag light on my 1995 Ford Ranger is flashing a code 41 (four flashes, pause, then one flash...does this a few times when I start the engine, then goes to a solid light which stays on while I drive.) It has been doing this for several months, and to be perfectly honest, this has not been a concern for me but now that my state inspection is coming up in December, I need to do something about it. Just before I noticed it to begin with, I had a major repair done--the dreaded heater core replacement--which involved removal of the dashboard. I never associated the flashing with that repair and the possibility that the repair shop might have inadvertently neglected to reattach something when reassembling the dashboard and now so much time has passed, that I can't just go back to the repair shop.
View 4 Replies
Advertisement
My 2002 Ford Airbag light is flashing 46. I believe this is the Drivers side crash senor. I am repairing the left front fender and left front wheel suspension. I have replaced the two air bags and airbag control module. Where is the left front crash sensor?
View 13 Replies
I have a 1995 ford ranger 2.3 L dual coil packs new plugs, wires, coil packs, tps, idle air sensor, internal temp sensor, and a replaced mass air flow sensor from wrecker. That all said my one son missed a plug when i replaced it , it had no tip left on it , but since then i now have a misfire in cylinder 2 where the olther plug was found and replaced ...
Gap for plugs are .44
Used the wrecker maf to see if it would clear a p0113 which it did. I am stumped on why at approx. 30 minutes of driving that the cel will flash then set a p0302, no other codes no fuel smell. rechecked plugs all are clean haven't been able to check fuel pressure yet, and i out a can of seafoam in the tank to see if it clear out injectors.
Besides all, I will check injector to see if I hear anything but I'm stumped. Also we have to have an emission test so is it best to fail the test and will it show me what I'm missing.
View 14 Replies
So I swapped in a new cluster fx4 to stx to get my airbag light to work. It now works but flashes code 25. Is code 25 the passenger airbag deactivation switch?
View 2 Replies
Got an air bag code 41. Comes on and flashes the code a number of times, then goes off for the rest of the ride. It is a 96 Arerostar, XLT, 4LV6. From what I read it is a short someplace. Where are the crash sensors and how do you check them for "shorts"? I don't understand much about the whole system.
View 12 Replies
My son has a 99 Ranger where the airbag light is flashing code 32. I had the same code on my F350 and it was the clock spring. What it could be. It is 99 Ranger with 2.5l, auto trans, 2wd, no CC.
View 2 Replies
I noticed the passenger side on/off switch for the airbag doesn't illuminate anymore on my 98 Ranger. Whether I turn the key on the switch to on or off it doesn't illuminate either way. The airbag light on the dash flashes showing, counting a code 27 and then it stays on. I also noticed the seat belts on symbol doesn't illuminate and in the owner's manual it says it should illuminate and chime. I remember it use to illuminate but I don't remember a chime.
Someone with a 98 that has a seat belt reminder light that illuminates and chimes until you fasten the seat belt? I don't know if that and the airbag code is related. But I want to fix both? I guess the simplest one to tackle first would be the seat belt light/chime. I don't see a fuse for it. I guess I need to know first is it really suppose to chime.
View 12 Replies
I had been having battery issues with my 97 ford f150 4.6 liter for the longest time, thought i had a short under dash, i pulled entire dash out, disconnecting bat first of course, and inspected all wiring harness connections and fixing my issues and putting it all back together. now with new bat and all put back together i am now getting the airbag light flashing 5 times then 2 times (error code 52) i know it has some thing to do with power failure or backup battery, but now with the new battery in i cant seem to get it to reset. How to do this?
View 3 Replies
Ok I have a 2004 F150. The airbag was flashing 42, I have since replaced that sensor and now its flashing code 16. I have searched everywhere and cannot find the answer to my question. Any clue as to what this code is trying to tell me. Lost 1, this is lost 3, are you lost 2?
View 4 Replies
2006 F150, FX4, 5.4, super crew. Had the infamous airbag code 42 flashing at me the other day, replaced the sensor in the front of the radiator support, and am still getting the same code. The old senser had some corrosion inside the sensor itself, but the connections were clean on both the sensor and the pigtail. Is there something I may have missed?
View 3 Replies
What airbag code 29 on a 2001 ranger means? I have not seen that number on any code lists. I triple checked the code and it is 29.
View 9 Replies
Came on other day. No ses light or fault codes. What it means?
View 10 Replies
Yesterday I replaced the bulbs in my heater controls, today I have the Airbag light on, flashing 2/7. And when I turn off the passenger airbag, the "OFF" light does not come on. I've heard if the "OFF" light goes out, you replace the switch, would that possibly cause this code?
View 14 Replies
I am having an engine issue with my 1995 Ranger with a 2.3L. I have been having a P0340 code that kept appearing after several attempts at resetting the PCM. I gave up and took it to a Ford dealer for diagnostics and they called the CPS bad. They changed it, but the CEL light immediately came on with the code still kept coming up. The service rep. showed me the old sensor, it had a spot on the head of it where it looked like something was rubbing it. I'm assuming it's slightly rubbing on the gear it points to, which is the oil pump gear, correct? The truck runs fine, no performance issues whatsoever. Is it possible my oil pump shaft has developed play in it's shaft, causing this?
View 1 Replies
This is on my 1995 Crown Vic. It started after sitting for a day in the hot Al sun with all the windows up. At start-up the light is out. It blinks on and off a few times and then remains on until I turn the car off. My ODBII scanner will not tell me anything about that lamp.
View 8 Replies
The air bag lite is flashing 3-3 when you start up the truck. After several 33 codes it stays on constantly. I look up on internet and 33 is "passenger air bag open circuit". Pulled the glove box door and disconnected the wires and wiggled and reattached, still have code.
View 7 Replies
Dashboard light is flashing. Sometimes it flashes sometimes it doesn't:no real pattern. It just started with no accident or jarring.
1998 F150 5.5 V....
View 14 Replies
My airbag warning light is flashing 3 , and 4 which i assume is a 34. What this means? I have a 2006 Ford F150...
View 4 Replies
The OD OFF light starts flashing by itself and I can't get it to go out. Everytime it does this, the car is sluggish, won't pull very good at stop signs and kicks hard when down shifts. Thought it was weather related but it doesn't matter what the temp. is. Eventually it will go out by itself and everything is fine.
View 4 Replies
I pulled the wrong fuse, and now my air bag light is flashing a 5 2 pattern, and then stays on continuously.
it's a 96 OBD II - so I don't think I can do the "short the 2 pin gray connector" trick, or can I?
I pulled the right kick plate, and see the AIR BAG module, etc the fuel inheria switch mounted on the firewall, but no sign of that 2 prong plug....
so, how does one reset or clear this 52 code - I know that it was a result of me pulling that fuse, as the light was perfect before, and no issues.
I googled this topic, and still can't seemed to find this... will I need to take it to a dealer to have them flash the Air Bag Code?
View 14 Replies
I've been trying to trace down a issue with the airbag warning light flashing. The seatbelt light is flashing also. The airbag code is 53. If i search it i get the front crash sensor..I replaced it with a new sensor and pigtail. Other than that the search leads me to believe it could be anything.
I've checked and clean every connection that i could find. I haven't removed the center console yet to check the module. I did buy the truck last fall as a winter/work truck. The issue started a couple of months after i started driving it. Not sure if the module would just go bad.
View 13 Replies
