Ford - Ranger :: 1994 - Coolant Leak Originate From The Driver Side
Apr 18, 2011
I seem to have a coolant leak somewhere - i changed the oil yesterday and while i was at it i topped off the coolant in the recovery tank to the cold line. Took the truck out for about a half hour then parked it over night. when i came out this morning i found a pretty sizable puddle on the ground, seeming to originate from the drivers side, and when i checked the radiator it was low but the coolant recovery tank was full past the cold line...i let idle today for about a half hour then let it cool down trying to catch it in the act but saw nothing. if i trace the source of the puddle it seems to be coming from the cap area or at least that side of the compartment. would this be the radiator cap itself? allowing coolant to boil over and out but not get sucked back in? Since I've had the truck i have noticed a small, very small, amount of coolant on the ground now and again but this is the first big puddle.
View 1 Replies
Advertisement
I noticed green coolant leaking from bottom of black, what I think is called, timing belt cover. There is 188, 000 miles, and when I changed the timing belt, I did not change the water pump, although I did change out the thermostat. I have done a lot of work on this truck in the past. I checked the oil and no signs of water or coolant mixed in. The water pump is not weeping from the top well. I rely on this truck and the way I look at it is I may just keep driving it until it goes kaput (its real beat up). Should I go to an auto parts store and see if I can buy some sealant. I would guess it is either the water pump or maybe the timing cover gasket? I have inspected all hoses, and I see nothing. The leak must be coming from somewhere under that black, plastic cover. I am capable and willing to do just about anything other than perhaps a full engine pull, although I have the wherewithal to do that too if absolutely necessary.
View 9 Replies
I looked at a 99 with a 5.0 and noticed a puddle on the driver side, a little below and inboard of the power steering pump but outboard of the water pump. The puddle was higher than the water pump weep hole and it was in a racetrack oval shape. I was unable to see where the leak originated and I couldn't tell exactly what part/housing the puddle was sitting on. Obviously, the leak had originated from above.
I don't think it was coming from the upper radiator hose as I remember the upper radiator hose being more on the passenger side and I don't recall any heater hoses in the area. The only things that came to mind as the potential leak source were the intake manifold and the sensors on it. Are the 5.0 intakes prone to coolant leaks? Other than hoses, what else would be leaking coolant on the driver side?
View 2 Replies
I have a '90 Bronco II w/ the 2.9L V6 with a head/gasket issue leak. Its burning oil/coolant in #3 cylinder drivers side. I would ask this in the B2 section, but the Ranger section seems to have alot more activity.
I'm wondering what my options are. I'd like to replace the head with a better aftermarket design if possible. I've seen World Products mentioned as a good replacement, but they are no longer making them anymore. Nearest I cant tell, that leaves King and Odessa aka Clearwater heads. On the 'bay Odessa doesn't have the greatest feedback. King looks like a good product, but kinda spendy also. Short of those two, re-man is the only other option.
The casting # on my head doesn't line up either, is the 86TM the better Euro head for the Merkur?
If I keep this engine, w/o doing a 4.0L conversion, I'm tempted to replace both cylinder heads because of the amount of work to tear it down to that point.
This motor has had some valve ticking also, but I've read it can be injectors instead. What should I do? This will only be used as an off highway light trail rig.
View 9 Replies
One last issue with my 2000 B3000 3.0L. The leak seems to be on the left (passenger) side of the water pump very near where the bottom radiator hose connects to it. I can't find any loose bolts. It does not leak while driving the truck or soon after. It has to sit for several hours or overnight before it shows up. There are usually 3 or 4 wet spots where it drips from the water pump to the frame to the driveway. It is small enough that I only have to fill up my coolant tank every 1 or 2 months. Could this just be a small gasket leak? It's been happening for about a year or so I think. I replaced the radiator about 2 years ago. I've been expecting it to get worse or bust loose and have been checking it very often. I've never seen one not leak while running like this-has me puzzled.
View 6 Replies
On Friday am I noticed a 6" sized puddle on the garage floor. Coolant leak on the drivers side coming off the frame. Dropped it off at the dealer on Sunday and today the tech tells me it was in fact a radiator leak and the new one will be here wed. They hope to have it buttoned late Wednesday. I am assuming all will be covered under warranty.
I have 23k miles logged and had just got home from a 1300 mile run pulling about 18k worth of hay and trailer. Truck performed flawlessly. Averaged 11mpg for the trip. I am hoping this is the first and last radiator replacement I have to go thru.
View 14 Replies
My truck just passed the 3 year/36k by 2 days! I got it on 8/4/10 but it only has 27,000 miles of course I just found a puddle of coolant under the right front drivers side. After a little reading, I guess this is common. Should I push for Ford to fix it or get an extended warranty and turn it in on that or... Aftermarket yet that isn't half plastic like this stock POS?
View 12 Replies
I'm trying to figure where the coolant leak is. Appears to originate on the driver's side front, right near the thermostat housing. Since the engine tilts back the entire drivers side is wet. The thermostat gasket appears to be OK, but it does have a lot of miles on it.
If it's not the thermostat then can coolant leak from the cross over tube. And is the cross over removable without taking off the intake. There appears to be a bolt coming up from underneath on the passenger side.
Also, does coolant flow through this plastic intake. If it does, then the leak could be some where else, if not, then it's probably the thermostat.
View 9 Replies
I recently purchased a 1997 Volvo 850 and a week ago it began leaking coolant. Currently I am having to refill the coolant every three days.
I have attached two pics. One is a pic of where the coolant pools and the other is a pic of where I am pretty sure the coolant is leaking.
The leak appears to be coming from the connection point at the top driver side of the radiator. I know there is a hose on the same side at the bottom of the radiator directly below the one in the picture. At first I thought that was the source of the leak but later found it was just run off from the leak above.
Does this a common and fixable leak? Or if it is likely an expensive fix? Any other troubleshooting I can do on my end or do I need to take it to a dealer to find out what is going on?
Radiator_Leak.jpg ( 765.54K )
Leak.jpg ( 1.3MB )
View 4 Replies
1994 - 3.0 .... Back behind the water pump there is a stream of coolant what could that be. Water pump has been replaced earlier last year I thought that fixed it,there has always been a mystery leak..
View 6 Replies
I had my 94 Ford Ranger recently repaired, new water pump and coolant. Seems to run okay, but after 10 minute drive, the coolant system loudly thumps and visibly pulses as if there is steam or huge bubbles in the hoses. They are timed irregularly, but about once every 2 seconds and they quickly go away after a minute after shutting off the engin. Water temp is showing normal on the idiot gauge.
View 2 Replies
I am working on my buddy's 1994 Ranger with a 2.3L I4 that has been going thru a large amount of engine coolant. The trucks has approximately 180,000 miles on it. When I had it parked on concrete I have not seen any signs of coolant on the concrete or any signs of coolant leaking. The next place I checked was inside the cab to see if there was any coolant from the heater core and there was not. The water pump has been replaced a couple of years back. I replaced the spark plugs today and did not see anything on the plugs that I would have thought were signs of coolant in the combustion chambers.
With that being said I have not worked on a vehicle with a leaking head gasket before. Would there be any visible signs on the sparks plugs? If so what would I be looking for? When standing in front of the vehicle with the engine running there is a slight smell of antifreeze being "vaporized". Are there any noted issues with this engine that would cause this? Are there any other things I should check? Could it be a leaking head gasket causing this? If so how can I check for that?
View 1 Replies
I have a 94 ranger and all of a sudden it started sputtering, i can hear a vacuum leak behind the intake manifold found what appears to be a pcv valve not hooked up is that the way it's supposed to be?
View 2 Replies
My poor old jeep is having some issues. Here's the stats: 94, 4.0 engine, 240k miles (jeeps am I right?). It started overheating on me so I start with replacing the thermostat. No dice. I noticed it was "weeping" coolant, so I replaced the water pump. No dice. It's still running hot and throughout the process of replacing things and test driving it is now struggling on accelerating/giving it gas to switch gears. It even out right died a couple times. (Air filter was gunky, replaced it.
View 7 Replies
My '96 ranger, 4.0, auto transmission has developed a coolant leak. It is at the rear of the engine, passenger side, at or just above the bell housing. I can't quite see where it is leaking from even using an inspection mirror from on top or underneath. The engine runs great. I just finished replacing the power steering pump, ac compressor, dryer and hoses. What is back there? Freeze plug? Do I fear the worst and that the head or block warped? I may drill a hole from the passenger compartment to try and get a better view.
View 4 Replies
I have 2000 V6 3.0 Ranger and it has sprung a small coolant leak from timing chain cover gasket. I think just few drips after driving a while since I don't see significant drop in coolant level (Took a month to notice level dropped in reservoir) and did not see an active leak while idling. No water in the oil.
The proper repair would be to replace the gasket, but for the age and condition of the truck, I don't think it is worth it. Searching for a cheaper solution, I found K-Seal and see lots of reviews with success. Will it damage the cooling system in anyway? I think it would be worth a try even if it doesn't fix the leak as long as it does not cause any harm.
View 2 Replies
Ok, about a month ago my drivers door power window just ceased to work. (Sadly in the lowered position) I pulled the panel off, and examined the switch housing. By removing the terminals from a window that worked, and putting them in the drivers terminal, I determined that the regulator/motor assembly was bad. Fast forward to today, after wrestling with some issues, the NEW regulator/motor are installed. But here's the kicker, NO CHANGE!!! Still wont work!!! The fuse/CB is good, all other windows work. The switch test good when voltmeter applied...so now I'm stumped.
Its a 1994 explorer...
View 13 Replies
I have an '04 Ranger Edge 3.0 with a severe coolant leak. It appears to be coming from the area where the head/water pump housing meet. I have been told I've lost the seal behind the pump on the timing cover. Is there any way to know for sure? Will I be able to tell, once the pump is out that it isn't coming from the head side? Are there any "special" instructions for re-sealing after replacing pump?
View 6 Replies
1990 Bronco II, 2.9l, auto, 4x4. Was running just fine. Sitting in Park just idling away. All of a sudden, just starts running real rough, ticking, etc.
Towed it home. This morning, started up OK but still running really rough.
While running, pulled spark plug wires one at a time from the drivers side. Had no effect but could tell the wires were sparking as I held them up to metal.
Turned truck off. Drivers side exhaust manifold COLD, passenger side HOT.
This sounds real bad to me. Am I missing something simple that could cause the drivers side of the engine to not work?
View 4 Replies
I have a 2003 Expedition with a coolant leak on the front R/H side of the truck. I do not see any coolent lines on that side of the truck and the leak seems to be running off of the A/C compressor. I notice a couple of drops about the size of a dime about once a week in my drive way since x-mass and have NOT had to add any coolant. I was getting ready to do a flush and fill but now have concerns that it may have a bad head or head gasket. The truck has 84000 miles on it and never has been overheated.
View 1 Replies
What would cause the front wheel on drivers side to lock up if it isn't the brakes. have been hearing a loud popping noise for a while on drivers side especially when turning left. Today got really loud just driving and then a real loud grinding noise. Then a loud pop and front wheel locked up and skidded across highway til i came to a stop. What it could be or how can i at least get wheel to turn to get it on trailer...
View 6 Replies
