Ford - Fusion :: 2007 - Rubbing And Wobble Sound That Increases In Frequency As Speed Increase
Dec 7, 2013
I have a 2007 Ford Fusion SE 2.3L 4 cylinder. It has approximately 94,000 miles on it. I purchased new Sumitomo tires with a 100,000 mile warranty in February of this year. They were balanced and aligned at the time of install. So far they have been very smooth and quiet with great grip. About 2 months ago I started hearing a noise that sounds like uneven tire wear, a sort of rhythmic rubbing or wobble sound that increases in frequency as the speed increases. It is most noticeable at speeds between 30 and 50mph. I rotate the tires every other other change (at least twice a year) and had the alignment done again in late October. I am hoping that there is nothing wrong with my virtually brand new tires. Is there anything else it could likely be?
View 2 Replies
Advertisement
I'm looking at a dirt cheap Explorer 4.0, has been sitting for 2 years. Runs nice, with a double "knock" noise but quieter than a rod knock. Idles smooth at 600 rpm, "knock" is consistent, but increases as engine increases speed. Has 2 year old oil, and 2 year old gas. Would a tune up support it, and revitalize it, or is the engine almost dead. Still drives, didn't push it to hard. Interior is 9/10, exterior is 10/10. I have him down to 600. 4x4 works, and feels good.
View 6 Replies
So I have a 2014 VW GTI 4DR 6speed with 25,000 miles on her now and I am getting this weird noise from what i believe is the front end right wheel?
The noise is similar to a rubbing / humming sound that occurs below 10MPH and then increases with repetition at say above 60MPH. I notice a little harder of a rubbing when wheel is turned at say when i pull out from a stop sign!
ALL that i have done was put on hubcentric spacers and that i pulled off to see if noise stopped but it didn't! Could the supplied bolts be to long? I had removed dust caps on rear for clean fitment and sanded any imperfections on all hubs.
The noise isn't loud at all but is definitely noticeable with radio off and windows up!
Could this be a wheel balance issue? Tie rod or arm? Bent RIM?
View 3 Replies
I have a 2007 Ford Fusion AWD and noticed a humming noise as I was driving last night. It started when I got near 50mph and seemed to stop or get so quiet as to be not noticeable when I got to 40 or put the breaks on. What this might be?
View 2 Replies
This is a 2002 Toyota Camry 4cyl with 249157 miles. I drove it 140 miles to work, noticed no issues, parked it, and got back in after 10 hours. On the way back I noticed a noise that got louder the faster I went. It is independent of the engine revolutions (I put the car in neutral and "coasted"). The noise is completely dependent on the speed of my forward movement.
So I put the car up and in gear and around 25/30 mph, the sound shows up and gets worse as the speed increases. It does not get worse in turns. And it is very consistent- not clunking or clicking, just a steady sounds almost like strong wind over an object. I replaced the wheel bearings in both front wheel assemblies about a year and a half ago.
View 3 Replies
00 F250 338k auto
No error codes or warning lights (Forscan verified)
No smoke out of the exhaust
No oil or coolant leaks
Have banging noise from the motor. When cold truck sounds normal, quiet. When it warms up, the banging becomes audible. You can hear it at idle. You can hear it under acceleration. Frequency increases with RPM
When at speed, and letting off the throttle, noise goes away.....comes back when back on the throttle. Any time during driving when I let off, engine quiets down to normal. To me it sounds like exhaust leak, bur not sure how to check for those?
View 14 Replies
I have a problem with my 2006 Sante Fe. When driving (at all speeds) my SF has developed a "cyclical", repetitive whining sound in the engine compartment that directly corresponds with the speed of the car. The "revolutions" of the sound are slow at slow speeds and very high pitched and fast at high speeds.
It happens at all speeds, with or without throttle being applied. I do NOT hear it when the car is in park or in neutral and I rev the engine so it has something to do with the rotations of the wheels/axles/drive shaft/gears or something that rotates in synch with how fast the car is going. I still hear it when coasting.
We recently put on new tires a few months back and I thought maybe it was just the sound of the new tread on the road but now I am almost positive this sound is coming from somewhere in the engine compartment. It is possible that it is coming from under the car but the problem is a can't confirm that because I only hear the sound when the car is moving. So far, it's just an annoying sound, it does not affect the performance of the car.
View 4 Replies
My GT is very quiet when running and I like that. However, the AC system seems noisy when it is on. When I turn on the fan and heater, I hear a distinct whining sound that increases in frequency as I increase speed. When I turn the fan off, the car is whisper quiet. Also, when I turn the AC on, I can hear what sounds like coolant circulating through the system. At first it sounded like it was coming from the glove compartment and I thought it might be associated with the glove-compartment cooling feature, but I don't believe it is. The noise is not unbearable but it is noticeable and distracting to me.
Is this a noisy climate-control system or is this something unique to my car.
View 11 Replies
My LS 460 has a pulsing wheel/front end noise that seems to increase as the speed increases from 5 mph to about 30mph and then fades out. I brought it in for service and they test drove it twice with 1 and then 2 service techs. They could hear the noise and said to me that they think it is cupping on the tires. The tires are in great condition inside to outside.Tires have only 14000 K. I switched the back to the front. The same dut-dut-dut-dut sound increases as the speed increases to about 30mph.
I believe that the noise is something more serious. I noticed that when the suspension compresses over a high point in the road at say 20mph the sound will stop during the time the car is comming of the high point in the road. Could this be a bearing/suspention- or something with the breaking motor because I also have been using the break hold feature for several months and not sure if that could cause harm. Also I do hear more grind or grumbling when turning the wheel to the left at low speed then when turning to the right.
View 7 Replies
2007 Camry LE 2.4
I just replaced the rear pads and rotors with no issues other than having to bang the cr@p out of the left rotor with a hammer to get it to come off. Now at pretty much all speeds I am hearing a rythmic humming-type sound that increases and decreases with vehicle speed. It's not a constant hum but more like one-hum-per-tire-revolution type of sound. It is coming from the left side as far as I can tell.
Thinking I had damaged the wheel bearing (and after searching the forums extensively) I replaced it with a brand new bearing from Advance Auto Parts. I re-checked the pads, rotors, all bolts, everything is lubricated properly, etc. Just took it out for a test drive and the noise is still there. Sometimes it gets louder when breaking but not always. I rotated tires and the sound did not follow the tire. The pads aren't stuck or rubbing excessively as far as I can tell.
This sort of thing has happened in the past on the left rear. It would sometimes happen when I swapped the summer tires for my winter tires on steelies, the left rear would make the humming sound, I'd take the wheel off and put it back on 180 degrees rotated and the sound would go away. I've done that a few times too and it has not worked.
View 3 Replies
I recently bought a 2009 es 350, it had 88K km on it (55k miles) and i seem to have a rhythmic road noise. it increases with speed until it becomes constant. So it's obviously the tires (getting old or need balancing) or a bearing..
Being new to these cars I'm not sure and the whole car is very quiet so any noise seems to be more noticeable.
My tires are the OEM energy's...which I've heard aren't too great. They have decent thread tho, however one sidewall looks as if it's wearing away. Could it be the tires? When do the bearings wear out on these cars - I seem to think that 90K is a bit too soon for bearings..
View 14 Replies
About 2 months ago i was driving and heard a clicking noise that would increase the faster i drove, i 1st thought it was something in the tire. after checking my right front tire and saw nothing was there for some reason i figured it was the brake.....so my personal mechanic the next day took off the wheel i told me i had to replace the braking kit because one of the pins was rubbing on the rotor, in the mean time he pulled it to try to realign it into place.....after he did that i realized the steering wheel shuddering when braking at highway speeds....figuring since i needed the braking kit that when replaced, this new problem would b solved.....braking kit replaced problem still there....
View 11 Replies
My Santa Fe is doing a pop sound, like a clunk, when I increase or decrease the speed. It is just one time noise every time the speed changes. Like when the "gravity center" changes from the car front to rear or vice-versa.
I notice already that doesn't happen when it's shifting, neither when I go over a speed bump.
It happens in all gears, but is more noticeable up to the 4th gear.
Also, usually I can hear this noise, a little bit lower, when I'm stopped and change the gear from P to R or vice-versa.
My Santa Fe is a 2011 model with 70K kilometres ....
View 18 Replies
i have 2009 Hyundai Santa fe 3.3 , My problem ( sometimes when i turn on my car, ESP Light appears off on my dashboard after 8-9 mile and Car speed can not increase more 40 km/h
View 5 Replies
I have an 08 ES 350 and when driving and coasting between 20 - 60 mph, there is a rubbing, grinding, low frequency sound that I feel coming through the gas pedal. What is causing it?
View 3 Replies
We have a 2006 CM later model Santa Fe 2.2 CDX+ 7 seater. Engine light came on last week and since then car does not shift into 4th gear. It revs very high upto 5000rpm with no increase in speed, it's limited to 30-35mph.
I had this problem back in 2010 where the Hyundai franchise identified a fault with the EGR which was replaced under warranty, and then a year later a problem with the fuel sensor which was also replaced.
I had the local garage check the EGR and give it a clean based on the steps provided by a member here - no change. So I took it to Hyundai but this time, they are reporting fault codes P0733 and P0744 which point to transmission problems. I just had a call from the garage who say they believe the gear synchromesh is jamming thus not allowing the change of gears. He said that the diagnostics report that the car is sending the gear change command correctly (pulse generator ok) so does not believe it is an electrical fault.
View 29 Replies
Had a long trip with the X this week and noticed a weird vibration up at speed. Anything before 65 mph and the truck was smooth, higher than that a medium vibration developed. Its frequency increased with speed. Never got the truck over 70, but the vibration was there enough to rattle change in the cup holder and the rear view mirror. What it might be? I was thinking a hub bearing... 2000 Limited 4x4 PSD ....
View 14 Replies
2007 honda crv fwd ... My car does an intermittent groan/rub thing when its been running for a bit and I am making turns. No rhyme or reason as to when it randomly happens. The repair was for my ac compressor...so its not that. It's also fed so its not the common rear dif issue Honda has.
View 16 Replies
My 2010 fusion radio sound quality isn't as good as when car was new. Also seems to vary on certain days. Has any one had problems with their Sony factory system & what was the fix?
View 1 Replies
2015 F-250 Super Duty, 6.2 L Gas with 6r140 Transmission. I have 13 K miles on my truck. While pulling my travel trailer up a hill the transmission kicks down thru the gears, which is fine, but as I crest the hill and in 2nd gear, the engine begins to rev up and the speed increases, the transmission will not automatically go into3rd gear. I have tried to let up on the gas pedal, but it remains stuck in 2nd gear. I have to shift to "Manual" and then put it in 3rd gear. Then it shifts up as it should. I have tried with the transmission in "TOW' and not in "TOW". I have even tried it in "Cruise Control".
View 3 Replies
I have an '07 Ford Fusion with 94,000 miles. The check engine light came on a couple of days ago, so I took it to a shop to have them pull the codes on it. The code that came up said the coolant was not reaching the proper temperature, and the mechanic told me the thermostat should probably be replaced.Two questions:
1. Should I go ahead and get it done, or wait and see if the check engine light comes back on? I usually only drive the vehicle about 10 miles a day, and it's all city driving.
2. What kind of cost should I be looking at? He said it would be a system flush, replacing the coolant and thermostat (which they would get from a dealer).
View 4 Replies
