I have a 2001 ford focus SE and l can't get the cruise control to work anymore, is the problem a fuse and if so where is it located or a problem with brake pedal?
View 6 RepliesOk replaced the front brakes, tie rod ends, and all ball joints today. Also flushed old brake fluid and replaced with new. Now my cruise control does not work. Light on the dash momentarily flashes when I try to set the speed. I have checked all the fuses and the connections and everything appears normal.
2001 Ford F150 5.4L 4x4 off road pkg stock height and tire size.
I am stymied by a weird Cruise Control problem on a 2001 F150 Lariat SuperCrew with 5.4L V8 engine that I just purchased. Long story short, the cruise control does not work. That is, when I push the "On" button at any time while the engine is running (even when traveling at highway speed), the dashboard CRUISE light does not come on.
I ran the cruise control "self check" procedure. The first time I ran it, we failed with 3 flashes. So I checked the cutout switch on the brake master cylinder, and it was indeed leaking brake fluid. So I purchased a new switch and cable (Motorcraft SW-6350 Speed Sensor Switch Repair Kit) and installed them.
With the new cutout switch, we seem to pass the self test. That is, after pressing all the buttons in order , I see all the quick flashes of the CRUISE light
(1. On (flash), 2. Resume (flash) 3. Coast (flash), 4. Set/ accel (flash)). Then the accelerator pedal is pulled away from my foot.
However, unfortunately, the cruise control still does not work. That is, when I push the "On' button at any time while the engine is running (even when traveling at highway speed), the dashboard CRUISE light does not come on. What to look at next? I note that horn works, in case that's useful info.
The car seems to start accelerating on it own. Say cruise control is set you notice acceleration for no reason. Now cruise control does not work and acceleration at times still happens. It's not like you are flooring it just keeps going faster slowly. Don't know if this could be related I did replace the fuel pump recently and the crankshaft position sensor. I was looking to see if there is a re learn procedure for the crank sensor. I have replaced them in the past and don't remember having to do a relearn.
View 10 RepliesRecently I was driving on the highway, about 70 miles into my trip, when all of a sudden my cruise control kicked out and the rpms went high and then I lost acceleration. I pulled over to the berm and tried to take off. Problem is I could not get the car past 30mph because the accelerator pedal could. not be pushed down more than an inch or two no matter how hard I pushed. What could be wrong???
View 1 RepliesI'm at my wit's end trying to install cruise control in my 2009 Corolla. I thought it was a relatively easy install, but then after putting the airbag in place, I find that the horn no longer works. I test out the cruise control, and the green "Cruise" lights up on the dashboard..but it doesn't actually work.
View 9 RepliesJust got my first X(and Ford) a couple days ago. Anyways, the cruise control doesn't work. I checked the CC switch on the master and it tested fine and I installed new switches on the steering wheel.
When I do the self diagnostic test with the steering wheel switches they all test fine, and on the last button(set) it lights up, but no other flashes. What does that mean? In 1 thread it stats that 0 flashes is the speed control servo.
I own a 2013 C-Max hybrid and I notice that during long drives if i engage the cruise control, I don't get as many EV miles as I do when I have my foot on the gas pedal and take it off when i have reached my desired speed. Does EV mode not work in cruise control? My feet start to ache a bit with constantly having to press and release the gas pedal just so that I can generate some EV miles.
View 3 RepliesI had a reputable repair shop briefly check out the cruise control on my Aerostar cargo van. They said it is not because of a vacuum leak. What is most likely the problem?
View 11 RepliesOn my in laws 2000 explorer the cruise control does not work. When driving and activating the cruise control (on, then set), the cruise-control dash light comes on for a fraction of a second and goes off again. Tried it at freeway speeds.
Any clue ? I heard there is a separate brake switch for the cruise control and one for the brake lights. The brake lights operate normal. Could it be the other switch ? If so where is this switch ? Under the dash or under the hood ?
I recently got an Escape and I am having a issue with the cruise control. That being, it doesn't work. The control module under the hood is all hooked up, the linkage the the throttle body and all. No broken cables.
The brake lights work as intended, and only when the brake is applied. On the inside, the dash-light cruise indicator works fine.
I ran the diagnostic by holding the off button and turning the key on. The cruise light flashes and I begin the sequence. I noticed I was pushing the brake out of habit while running the first few tests. They all returned 2 flashes upon completion of the diagnostic. All other buttons were registered.
Now the strange part, when I took my foot off the brake and did the same test, the final result is three flashes of the cruise light. I understand these flashes represent a fault, and I am having a hard time as I cannot find one.
What do these results mean? I'm thinking the brake being applied gives a fault surrounding the fact that cruise is disabled when the brake is applied.
New problem with my 99 f-250 superduty supercab 4x4. Cruise control does not work. Checked all fuses and all are good. No cruise light or speed cont light . Where do I start? What do I need to look for? Where do I look?
View 4 RepliesI am normally on the super duty side but I have a 2002 ranger 3.0 auto EX cab if that matters with this issue. My cruse control will only come on rarely but when i does it works fine. Most of the time when I hit the ON button the indicator only blinks like a "relay" of some sort is not latching up. Don't know if this is an all solid state system or if there are electro mechanical relays involved as well. When it does work and I hit the brakes it will drop out completely rather than just disconnect from the controller and need to hit the ON button again, usually with no results.
View 8 RepliesJust picked up a 99 F-350 V-10 today. Decently clean, works well. It'll be an occasional tow vehicle for hauling my car to car shows.
Anyhow, on the way home, I couldn't get the cruise control to work. I've read about the brake pressure switch problem before joining today. I can hit the on button and set it, and the cruise indicator lights up in the dash and will stay on, but will not hold the speed.
From what I've read, I can't seem to determine if the brake pressure switch will allow the light to come on or not. Should I be looking elsewhere for the problem?
Next fix - overhead console. That one seems simple.
I bought a 2002 Excursion 2wd V10 at an auction with 105,000 miles. I've been working through the little problems and I'm down to one last small item.
The cruise control will not work. I found a thread to diagnose the problem. My diagnosis is:
After doing the self test I received: 3 flashes - deactivator switch is open or circuit defective.
What does this represent and what shall I do to correct it?
Just bought a 2003 5.4 6 speed 4x4 F250 .. The cruise control does not work at all. The only fuse I can find in the owners manual is a 2 amp one .. it is in good shape .. Where do I look now to solve the problem??
View 8 RepliesI used to have LED brake lights in my taillights and decide to change them to old regular bulbs. After that Saturday 3am cruise control don't want to work. Then in the morning with all the lights off (headlights turns etc) the cruise works, as soon as I turn the lights on it stop working. I try to see the what's the cruise control fuse in the fuse card but I can't figure out which one is. 99 passat GLS manual trans.
View 1 RepliesWhen I bought my R32 at the end of last year the cruise control didn't work. The light doesn't come on.
View 8 RepliesI just purchased a low mileage R and trying to figure out if the car has been chipped. Not sure if when doing so you lose functionality of your cruise control but my cruise does not work and I am trying to determine how I go about checking the ECU on this ride.
View 5 RepliesI have a 2002 f350 my horn went off in the middle of the night got up and unplugged the horn what is my problem. also, the cruise control won't work when it all happened
View 3 RepliesAirbag light flashes on dash and then stays on. Cruise control and horn wont work. I cant find a blown fuse.
View 9 Replies