Ford - F250 :: 1991 - Gauge Sender For Forward Tank Stopped Working
Apr 21, 2013
I have a 1991 F-250 Supercab with the 7.3 L Diesel and twin fuel tanks.Recently the gauge sender for the forward tank stopped working. Ford tells me that the sending unit is obsolete. Perhaps they want me to buy a new truck. I recently found a NOS sender on E-bay but it is supposedly for the plastic fuel tank and mine is the steel tank. What steps would I need to take to make this sender work in my truck? Do I need to eliminate a ground wire, add aground wire, or make up insulators to prevent the sender shorting out on the steel tank?
View 2 Replies
Advertisement
The fuel gauge sender quit the other day so Im replacing the pump assembly. I believe in replacing fuel and ignition related parts with factory equipment. So I was going to get a Ford Motorcraft pump, but my wife checked for one through her work(local parts store). The counter guy found one that said original equipment, called them and was told "It is the same pump that gets installed on the assembly line". Well it came in today and its a Delphi. I was expecting a Ford pump. I associate Delphi with GM and I know GM pumps go out all the time. I know Ford pumps go out too, but I know several people with GMs that have replaced pumps multiple times within 100000 miles. Is Delphi worth taking a chance on?
View 6 Replies
I have a 2003 F250, 4x4, 5.4L and today my fuel gauge stopped working. I don't know if it had anything to do with a stall, I was on an exit ramp and the truck cut off, I quickly restarted and no issues after that. Other than the fuel gauge not working at this point.
I looked at the fuse panel diagram and there is no fuse for just the fuel gauge. The only thing I see is #35, instrument cluster. The rest of my instruments are working, so what else would cause the fuel gauge to stop working? It had a little over a half of a tank before the stall, after the stall it went down to less than half. I filled up shortly later and it's just stuck at less than half.
View 1 Replies
I am looking at buying a 91 f250 4x4 with a 5.0 and an e4od. When I start the truck I can feel It roll forward A little bit. I can put the trans In od or nuetral and It will drive and shift normally thru all 4 gears, no slipping and no noise no vibration, It shifts and acts perfectly normal. 1st and 2nd work fine as well. When I put it in reverse It rolls forward slightly then drops Into reverse, it will not actually back up, you can rev the engine to stall speed but no higher. Sometimes in park If you rev the engine It will actually over come the parking pawl and roll forward.
Also when In park I can rev the engine to stall speed only. It only starts in p or n, and the reverse lights come on in R so Im assuming the mlps is adjusted properly and the manual protion is adjusted properly. I pulled codes and had 3 in total, ect shorted, egr flow insufficient, and 1 code for torque convertor clutch solenoid I believe It was 632. Im assuming the reving up to stall speed Is related to the tc code. The fluid level Is fine but is a little dark In color, I tried doing a search with no luck ..
View 5 Replies
I recently replaced my gas tank in my Sundance, it was getting very rusty around the sending unit area and was starting to leak. Everything is back together and it is running well with no leaks. The new problem that it has, when the car is running, the gas gauge shows less than empty, even though it has a considerable amount of gas in it. When I shut the car off, the gas gauge slowly moves up to where it normally would be when it would be running. Did I somehow mess up the ground or did I cross something? This is my daily beater car and need a working gauge.
View 1 Replies
I have a 91 Ranger that the A/C was working great in but all of a sudden it stopped working even the fan. I turned it of and back on and it started again but then just stopped for good I can get the fan to work sometime, but no cold air. What it might be?
View 2 Replies
2005 F250 Superduty Crewcab 4x4 6.0L diesel/auto
Wife drove the truck before me and bunched the floor mat under the pedals. I didn't notice the mat issue when I drove the truck today. I accelerated fully after doing a left turn onto a busy highway. The motor spun up hard with the accelerator floored but because of the mats, the pedal stuck all the way down. I was approaching stopped traffic while under full acceleration and I shut the engine off and pulled over to the shoulder all while braking hard ( it was a hell of a ride!). I freed the pedal and restarted the engine.
Now, despite a bit less than 1/2 tank of fuel (I have the 38 gal tank), the dash readout was showing "Low Fuel", the gas gauge was below E and the engine was running like it was running out of fuel. I turned the engine off again and left it off for 1/2 hour before restarting it but the gauge and engine still behaved the same. As I drove to the nearest diesel station, the engine was not running "right". Of course the station I pulled into had 1 diesel pump and the pump was broken.
Because I thought I might actually be out of fuel, an understanding stranger took me to the store to buy some gas cans and then to another station to get 6 gallons of fuel. I got back to the truck and added the 6 gallons of fuel. When I turned the key on, the fuel gauge immediately came up to 1/2 tank. I then drove to that other station and added another 15 gallons of fuel to fill it. This confirmed that I had about 18 gallons of fuel in truck when the "Low fuel" warning occurred.
So, what the heck was going on with the fuel gauge? I am sure the "Low Fuel" warning is tied directly to the gauge but why was the gauge reading low? Is it possible that the "Key-off" while under full acceleration followed by hard braking had confused the ECU? I am just trying to figure out if I have a fuel sender problem or a confused computer that corrected itself. Until this incident, the fuel gauge has never been a problem but the wife messing up the mats has been an issue!
View 3 Replies
For the second time in 6 weeks My 2004 F250 Powerstroke has run out of fuel with the gauge showing a 1/4 tank. First time it was just under a 1/4 showing I had it towed to dealer and they told me it had sucked in the filters requiring replace and flush of system. The told me that this happening very often and I would be replacing all of the injectors at my cost. I told them that I didn't want this to happen again and to check out the fuel gauge and sending unit and replace if in doubt. Well they checked it out and found nothing wrong, told me it was accurate and should not be an issue again. Now 6 weeks later on the Friday night before a holiday, it did it again, this time with over a 1/4 tank showing. I really don't want to spend 6 grand replacing injectors and would really like to trust my truck again, getting to the point that I'm nervous at 1/2 tank.
View 9 Replies
My cooling fan just stoped working the other day (not sure why) i replaced the fuses and relays they are all good. Now when i unhook it from the radiator fan switch it turns on but plug it back in and well it shuts off, i put a new switch to see if it will work but it started running real rough and hard to start so i put the old one back on and nothing changed. I read the book and checked everything but still nothing and why my engine light came on and it started running rough.
its a 91 celica 1.6 (4AFE)
View 4 Replies
My 1991 240 always had 2 working back up lights. After one of two garage visits recently (with them not working on my lighting), one of the two stopped working.
The last visit (a different garage) I just made with this time the mechanics working on a tail light issue as well as other stuff now has me with the 2nd back up light not working. Since one mechanic lost me the use of one and another mechanic lost me the use of the other.
How I can troubleshoot this and get one or both "back" on my own?
View 2 Replies
I recently bought a 2005 Ford F250 Super Duty, diesel 6.0.
As I was driving to work this morning I noticed that the fuel gauge read almost full when it should have only had a half tank. A little while later I heard a beep and saw that the gauge was now on empty with a "Low Fuel" message displayed. Then I noticed the heater was suddenly blowing cold air.
I've only had the truck for a few weeks, but haven't had any other problems. I did replace the CD receiver and all of the instrument cluster lights a couple weeks ago, but everything seemed to be working fine after.
View 1 Replies
this thing stopped working on me today, can i fix it? or how can i get another one?
04 Ex
View 14 Replies
I have a 1991 740 Wagon with ~153,000 miles. I say approximately, because the speedometer, the odometer, and cruise control stopped working. My mechanic says it is the sensor loctated on the differential, I believe he said.
2 questions: My local Volvo junkyard has gone out of business; where is a good place online to get used parts? and second, .is sensor difficult to replace? I can fix things that are easy.
View 2 Replies
The radio in my 1991 Honda Civic has been dying a slow death over the past year. First it would stop working if the weather was too hot. Then it would only work sporadically, finally it almost never worked. Whenever the radio stopped working, there would be a loud electrical "pop" sound, so I thought it might have a short. Yesterday my husband fixed the upper rear brake light (cleaned contacts) so it would pass inspection. Now the radio works perfectly! Are the brake lights and radio on the same circuit?
View 10 Replies
3 weeks ago my father (who died 2 weeks ago) gave me his 1991 Infiniti G20 which he has kept in great condition over the years with the last few being the exception. He's the original owner and I have paperwork from every repair and service it's had. Unfortunately the issue it has now started happening after he passed so I'm not going to get info about how it's been running the last couple years. Now to the good stuff.
When I got the car it was outside under a carport like always (lives near Seattle). I drove the car about 200 miles and then a couple days later I noticed the turn signal stopped working, but not only that there were several things not working. The turn signals (yet hazard lights work), the seat belt motor will not let it roll back across my chest, the blower won't work but the AC and heat still works, the rear defogger stopped, the ABS stopped, and the warning lights and sounds for doors open and seat belts were undone don't work.
Then while driving everything just "clicked" back on for about 5 minutes, then "clicked back off the rest of the drive. The next day I started the car, everything was fine but after waiting a couple minutes for the windows to get defogged everything shut off again. Driving around with foggy windows, no turn signals, and no seat belt across my chest is starting to scare me. Oh, and the problem can turn on and off without the engine on. If I just put the key into the "on" position it will sometime switch between working and not working.
I have unplugged and replugged the fuses and relays on the left side under the steering wheel, I've checked the voltage of the battery (2 years old with 7 year warranty and alternator was replaced 18 months ago) and it was about 12.4. I've tried reading the wiring diagram in the service manual without any luck figuring it out. When I took it to the Nissan dealership they did their scans and couldn't recreate the issue and charged me $100 just for doing the electrical tests.
I want this car to keep going since it has 174,000 miles and runs great (manual trans) so need to figure out whats going on. It doesn't seem like it's a loose wire because the car doesn't have to move for it to go back and forth between working and failing. It sometimes works more often if the car is kept in a garage but even then I'm not sure. At one point in the last year a couple mice got into the trunk but they have since left and I don't see anything in the manual that says they could have effected anything all the way back there.
View 16 Replies
Ok heres the story 1994 ford f250 7.5 4x4 dual tanks I used both front and rear tanks regualrly than one day front tank stoped working fuel pump doesnt turn on when key is in the on postion now you can hear the rear turn on when switched to rear tank took off pigtail connector to front tank no power at all to tank took off swith in dash no power there either good relay and fuse funny thing is with swith turned to front fuel guage reads correctly switch to rear reads correctly Im stumped because oveiously Im getting power to the switch but checked wires at switch and cant get any power or at front tank but power to rear.
View 6 Replies
My car is still at the dealer after having the recall done because they can't get the fuel gauge to start working after they performed the recall. But the gauge had nothing to do with the recall you might say. Correct. But prior to the recall being done the gauge was acting funny. Going from full to empty to 3/4 back to the current level.
I told the dealer about this and they looked into it as they were doing the recall. Now they said they replaced the fuel level sender unit, certain wiring connections but to no avail they still can't get it to work. So my question is, what is the type of Gremlin that could be causing this?
View 4 Replies
I have a 1969 chevy c10 pickup. One of its problems is the temperature gauge was not reading. I grounded the sender wire to the engine block to deterimine if the sender was bad, and ever since the gauge reads hot all the time, even with the ignition off. Could I have fried the gauge?
View 2 Replies
I have stock 02 F350 7.3 with 74,000 miles ... Today i looked down and noticed my RPM gauge sitting there at 0 ... It was working just fine yesterday. I figured before i go digging around looking for the issue id see what is causing it not to read ..
View 3 Replies
I have my 2004 f250 6.8L. Recently my truck has been having issue with the oil needle. When im stopped or coming to a stop my Check Gauge light comes on and my oil needle drops all the way down. As soon i step on gas it goes right back up. What could it be?
View 7 Replies
I have a 1990 volvo 240 dl and the gas gauge no longer works. Just wondering if there's anything I can do to fix it.
View 1 Replies
