Ford - F150 :: Hood Won't Open Unless Holding On To Release Handle While Pulling Up
Apr 30, 2015
I have a 2006 Ford F-150, and when I pull the hood release, the hood won't open unless I'm holding on to the hood release handle while pulling up on the hood. I've been trying to figure out how to adjust it but I can't find any information on it. The cable isn't broken, as I can see the cable move, it just doesn't seem to move enough to open the hood release. How I can fix/adjust it so it will work? Do I need to adjust it at the handle, or at the actual release under the hood?
View 12 Replies
Advertisement
When I pull the release handle there is no resistance. I suspect the release cable is broken. How to release the locked hood?
View 1 Replies
I've been driving a 2009 Hyundai Sonata for about 9 months now and it recently (2 weeks ish) started to not shut its hood. I haven't gotten it officially checked out yet as I'm low in funds and don't want to shell out money where I don't have to. I know it's dangerous to drive around with my car hood open (like an inch which is noticeable). I would shut it before I start driving and when I reach my destination it would be up again. Someone (a random guy who pulled up next to me at a red light and told me he could give me a quote for my hood... and the dent on the side of my passenger door) told me it may be due to a loose hood release handle on the driver side. There was no give when I tried the handle (is this called the latch?) and when this someone tried to loosen the rust on the hood lock itself (is this the latch idk these car terms), it still wouldn't close. It would click but pop right up. It keeps clicking when I close it but doesn't fully close because I could lift it up about an inch and it'd stay that way. He said it may be due to a cable issue with the release handle.
View 2 Replies
I have searched and tried everything that was suggested to open the hood on my 2000 and nothing works. When looking form the front you can see the hood release operate, but nothing happens. What part of the release do I need to operate to get the hood to open?
View 5 Replies
How to manage to open the hood when it wont "pop" from inside the cabin. There is not enough tension on the cable and seems as though either the cable has been stretched or either came off or broke its retainer under the hood... I noticed "TSB"s but to be honest I dont know what these really are or how they matter...
View 3 Replies
I picked up a new CSG GTI, 6speed with Xenon and Bluetooth on Thursday. Yesterday evening when I got home from work I opened the hood to make sure everything was cool I guess. Then this morning I was going to open it again, and the release inside the car is loose, like it's hardly attached to anything.
MKVI? I know it's probably a cable issue, but it sucks to have to drive back 50 miles to the dealer, 2 days after buying it, because the hood won't open.
Pic: ........
View 2 Replies
Went to pull on the hood latch lever and nothing happened. It almost appears that the cable/ball has either popped or broken off the latch. While pulling on the lever you can hear a sliding noise at the latch.
I removed the bottom panel under the bumper but no support there as the latch is covered and not accessed from that location. There is a slight gap from the front under the hood and above the logo but how to get around to this.
How to at least open the hood from the outside. Remember, the cable won't release.
View 34 Replies
My hood has ceased to pop open when I pull the latch from the interior release. I removed the panel to see if the cable came undone from the release lever but it is still intact. From what I can tell, the cable seems to be snapped in the middle. I brought the car to 2 different mechanics, both said they would have to do damage to get under the hood. But I've read online and it seems other people are able to do it.
View 5 Replies
I have a 1997 Ford Econoline conversion campervan that I don't use very often. I need to open the hood to jump start the battery. Last time I opened the hood I did not notice anything wrong with the hood or the hood release latch inside the cab. Now when I pulled the hood release latch inside the cab, nothing happens to the hood at all (the hood does not open at all).
Is there a way I can open the hood or do I need to tow it to my mechanic?
View 1 Replies
This is an Auto/4z4/4.6 V-8. It's Skidding or a Clutch is not holding at times when shifting up or down while on Cruise and slight hills.
someone suggested changing oil and filter about two years ago. I did that and it didn't change a thing. $145 that time.
I'd like to know if its the clutch in the torque converter, or the Transmission? If I have to change something out, should I get both?
View 3 Replies
I have a 2000 F150 5.4L with 157k miles on it. I think it has the 4r70w trans. The transmission has started holding 2nd gear too long before shifting into third. Throttle position doesn't matter, it does it even under light throttle. I do not have a check engine light. I have owned the truck since new and the trans fluid has been changed 3 or 4 times. The fluid looks pretty good now, not burnt or anything. The truck has been sitting in the garage a lot over the past 2 years, I drive it at least once a month and have put maybe 2000 miles on it this year. It shifts fine through the other gears, just 2-3 has an issue. Truck has the towing package.
View 6 Replies
So in order to get my hood to open, I have to pull the hood release lever in the cab, go pull up on the hood itself, then pull the release lever again, and pull on the hood to get it to finally pop. Is this a cable perhaps going bad? Or another issue I need to fix?
View 14 Replies
This happened a few days ago, that the driver's side door handle does not release the latch and let the driver door open. we can open the door fine from inside. the remote key un-locks/locks the door fine. What I've tried :
- Slamming the door hard a few times,
- Pulling both the inside and outside door handles at the same time
- Greasing the latch mechanism on the door end (what hooks onto the latch)
Today I removed the lock cylinder, but from what i can see with the cylinder removed the door handle looks ok (no broken or missing pieces). What would be the next thing to do?
2010 Tiguan SE
View 2 Replies
My battery went flat and to compound my misery, when I went to open the hood, the cable was snapped. How I can open the hood without using the release cable ? I'd rather not have to pay for it to be taken to the mechanic and then also pay to have the battery changed !
View 3 Replies
My car is getting close to the 55- thousand mile service, and correct me if i am wrong the service is not mentioned in the owners handbook unless i overlooked something. However for the first time since i have the car the service due message is counting down in the readout.
Recently the CEL came on again, giving me an opportunity to use VAG adapter to read out the error code from memory. So went to open the panel underneath the steering wheel which contains the OBD connector. And that's when i got stuck.
According to the owner hand book the compartment has a little latch to open it. The only latch i found is the one used for the hand brake release. So what am I overlooking ?
View 7 Replies
The problem occurs intermittently... about once every few months. The hand brake would be loose (no click) pulling the handle up to engage. If I pull the handle up and down many times, somehow it would return to normal.! I searched my Bentley manual but didn't see any page about the hand brake mechanism. Passat 2002, 1.8t...
View 1 Replies
I own a 2000 Jetta GLS TDI 5 speed with 501,000 kms on it. The problem I have is the passenger seat back release handle broke off so there is no way to fold down the seat.
View 4 Replies
The little device that hold doors open (so they don’t swing freely) aren’t very effective on my ’09 model. Actually, it's only a problem on the front doors. The rear doors hold position quite well. The front doors have always been a problem and I wonder if is this typical. Is there a fix (other than replacement)?
View 6 Replies
my park brake will work when pushed to the floor but when i pull the release lever it will not disengaged.
View 1 Replies
How to remove hood release and plastic trim from driver side covering wires going along driver door, left rear door and to the trunk? I am trying to install subwoofer and amplifier in the trunk need to fish wire through the car from battery to a trunk, and got staked with hood release (opener), i can't remove it and piece of plastic where you put your feet holding together. I don't want to brake anything.
View 2 Replies
My problem is that I get a pretty good pop from the main release inside the car. The hood doesn't come up too much, and the secondary release tab does not pop out from under the hood. I've managed to get the grille off. The tab will move back and forth a little, but then stops. Even yanking on it will not cause it to release the hood the rest of the way.
A couple of the fixes out there are spraying some lube in there (done) and popping the latch with a screwdriver (can't see how to do this on my car). There is even one for drilling a hole to get access, but I think this might be a B5 thing?
View 4 Replies
