Ford - Explorer - Noises :: Airplane Propeller Noise That Comes And Goes With Acceleration
Feb 20, 2011
Over New Years I had to engage the full-time 4x4 button on my 2003 Explorer 4WD. Shortly thereafter I started noticing an airplane propeller noise that comes and goes with acceleration. It's pretty loud. It has not affected mileage or dashboard engine indicators. Tires still have 40% left, not them. Have I ruined an axle or something? There is a rear end whine that Ford says is endemic to this model and year, but I think they are not related.
View 1 Replies
Advertisement
My car, a 2009 Civic, has started sounding like an airplane when I brake, just in the last day or so. Sometimes the noise continues for a little bit after I'm off the brake and moving again, but mostly not. Obviously, I'm going to get it in to the shop, but my question is do I need to take off work and do it today / tomorrow (Tuesday / Wednesday), or will it probably be OK if I wait until Saturday morning?
View 12 Replies
Two different Subaru dealership repair shops told me that i have loose rear wheel bearings on my 2003 Outback. My car does sound like a VERY loud airplane all the time now, but the noise is the only symptom i have noticed. My shop has told me that they will fix it for a discounted price, but they are not pushing me to get it fixed, and have told me that it shouldn't cause any actual problems besides the loud noise being very annoying. All internet research to the contrary, though. I have to drive about 1000 miles round trip next month -- is it just going to be a noisy trip, or is something horrible going to happen if i don't get the bearings taken care of?
View 12 Replies
Recently, my Explorer will sound like a cessna first thing in the morning, and then at random times through out the day. Then, the other day, the temp spiked on my wife. She pulled over, and let it sit for a bit, started it back up, and haven't had a problem since with temp. We only hear the sound on acceleration, and I have noticed that my F250 does it sometimes also, but not to the same extent. Is this normal, or a sign that the fan clutch is bad?
View 8 Replies
I have a 2008 Prius, and I have a couple noises, one of which is related to the airplane noise. I've noticed recently mine starts to make that humming noise in the 50-60mph range (less so at higher or lower speeds). There is 44,000 miles on the car.
View 3 Replies
I have a 1999 f350, long bed, crew cab, 4wd, dually, v10, 107k miles
I'm certain my propellor shaft u-joints are shot, theres tons of play and I see rust everywhere.
I have been dealing with a vibration problem for a while now, See [URL] .....
I currently am using a pro comp shim kit and the vibration has greatly improved, however shimming different heights did not cure the problem. I'm currently shimmerd 7/8"
First question is when in drive, with hubs on AUTO can my propellor shaft spin fast enough at 70-75 mph to cause a vibration?
Second, can I drive without my front propellor shaft, with out causing harm? For a brief update to above mentioned post, I've had replaced the following:
Six new tires twice! Currently 235/85/16 general grabber load E
Rear pads and rotors
Mechanic opened pumpkin to examine rear pinion bearing (said was fine, no play)
All shock absorbers
Front calipers
Alignment
Continually adjusting carrier bearing height
View 8 Replies
My husband had my tires replaced this week. I drive a 2008 Ford Explorer.The car has been running fine - no problems what so ever. Now there is a sound when I turn or go quite slowly. We live on a street that is 25mph so we go slowly to start. I hear the sound while going straight at slower speeds, but also when turning - almost at full lock. It is difficult to describe the sound - not grinding and not screeching. Its almost as if I turned the wheel too far. The sound when running straight is lower maybe rubbing. The sound seems to be coming from the right side of the car. I can also feel the sound, but it isn't a strong vibration. My husband drove the car and said he felt nothing (of course - just like TV repair man syndrome). All 4 tires were replaced. Hubby checked the nuts - says they were alright.
View 5 Replies
2004 Ford Explorer Sports Trac.
Just recently when driving down any road, when I let go of the gas to slow down from any speed, there is a funny grinding noise coming from under the truck, the Speedo drops fast, but the RPM`s stays the same. Then at around 30-40 km/hr, it just stops. When I place it into 4x4, I don`t have the problem. Also, again just recently, when I put the truck into reverse, I get the same grinding noise from under the truck. I have to putt he truck into 4x4, and then I put it in reverse for it to work.
I don`t have the problem going into drive. Both problems don't happen all the time, it will go away for 2-3 days then ill have problems for a few days after. I Took the truck to the shop and they said its the tranny so I replaced with a brand new one thinking that is the problem, but After the Tranny was replaced its still making all the same noises. The grinding noise sounds like "ice in a grinder" or to that effect. I'm not sure whats wrong, and I'm getting frustrated at my truck.
View 3 Replies
My 2003 Ford Explorer, Eddie Bauer 4WD is making noises when the vehicle is at 2000RPMs. Below or above 2k RPM's no noise. Sounds like a very angry rattle snake. I seem to drive at speeds that require it to be at 2k RPM all the time. So needless to say as fall is approaching and I have the windows open, my hair is now falling out and not blowing in the fall air. I want to get it looked at, but don't know what to tell the mechanic to look for.
View 2 Replies
Every time I start my 1999 Ford Explorer It makes a loud beeping noise similar to seatbelt warning sound. Every 30 minutes or so it does it again as long as the vehicle stays running(even with all seatbelts fastened even if no one is sitting in the seat.
View 1 Replies
My 2004 Volvo S60 has 99,000 miles on it. Just today it started making a quiet noise like an electric golf cart when I accelerate. Also just today it developed a quiet grinding noise when I turn the wheels (but only if the car is moving). I just had a clutch replaced by on the a/c compressor and I have my car serviced according to schedule. What the problem(s) could be?
View 7 Replies
I have been experiencing pinging and crackling noises on acceleration from my vehicle it was purchased from the dealers May 2012. The problems started in October and I have been back and forth with the dealers for the same problems over and over and getting additional problems. Not to mention they keep saying that the problem is fixed and as I leave the compound I hear the noises.
I took it to have an independent scan from the dealer as it is now 5 months of run around with the issue not being resolved and I found out I have a bad ac compressor, steering rack and shock mount.
View 11 Replies
I have an '04 TRD Doublecab 4x4. I first started hearing a "clunk" upon acceleration, but only occasionally. It started getting worse and would happen pretty much every time I accelerate (although it never got louder, just more frequent). It usually only happens after a full stop (or near stop like in stop an go traffic), and I'd hear it pretty much right when I step on the gas. It seems like it has something to do with the A arms moving forward and back. When you accel, the rear wheels push the vehicle, essentially "sucking" the front wheels back slightly. When in 4wd, the noise is still there. It is quite obvious it's coming from the front right corner. I'm usually pretty handy with a wrench, so I decided to swap the upper A-arm bushings and upper ball joint (ball joint was leaking grease). Noise is still there. I ran out of time/motivation, so I took it to the Toyota dealer.
Here's what they did: -replaced front right coil-over, said it was "loose". That didn't work, so they put the old one back on. -tightened bumper etc..., didn't work. -then they removed the REAR drive-line and put it in 4x4 and drove it around. They say that "fixed" the problem since the noise went away. They were pretty adamant it was the drive line, but I didn't believe them since the noise is OBVIOUSLY coming from the front right. It just seems odd that it'd be the drive line. I took it home and tried what they said, I took the drive line off and drove it around in 4wd. They weren't lying, the noise went away. But since a good friend has an identical truck (but an '03) I switched our drive lines and the noise came back (HA! I was right!!). Driving in "front wheel drive" (no drive line) makes the front wheels "pull" the truck forward, vs in rear wheel drive, the rear wheels "push" the truck, and thus the front wheels will move backward slightly because of wheel/bearing friction.
I think it has something to do with when the front wheel is forced "backwards" but as far as I cal tell, all the suspension components are intact and show no signs of looseness. I can now occasionally hear the noise when under slight accel going over studder bumps like street reflectors or something (but only rarely, it's almost impossible to duplicate that on command. Makes me think a suspension piece is loose (shock/spring or loose bushing), but I NEVER hear the noise under braking, and rarely hear it on those studder bumps (and only for a split second). If it were a loose bushing, wouldn't I hear the clunk under accel AND decel (A arm moving back and forth)??? So I'm basically stumped (so was the dealer!). Ball joints appear fine, wheel bearing has no slop (that I can tell), and it has brand new upper urithane bushings and a new upper ball joint. I KNOW it's not the shock/spring, b/c I even swapped the left/right, and the noise is still there (and didn't move to the other side).
View 3 Replies
What would casue a clicking noise (like a sewing machine)under acceleration for the first several miles on a cold morning (50 degrees or below, we live in Louisiana)? Car is 2006 Chrysler 300C with 5.7L Hemi motor, 90,000 miles, all lifters replaced last summer - noise was apparent before new lifters. Dealership is stumped - they do not believe it is a problem with new lifters.
View 3 Replies
Why is my 1992 ford explorer self accelerating between 15- and 25 mph?
View 1 Replies
My truck has grinding noises when i am making turns from a stop or at slow speeds. Also my 4x4 dash light keeps flashing several times both when I am sitting still and when driving. Neither my 4x4 auto or 4x4 high work but the low will work. Trying to pinpoint where I should look to fix them. I did replace the 4x4 control mod as an attempt to fix this.
View 1 Replies
2001, 5-speed, 6 cylinder, 140K miles. Under acceleration, it feels and sounds like I'm driving over road warning strips. While coasting, it goes away. The CVJ's and wheel bearings appear to be OK. Could it be the final drive? It happens in all the gears.
View 3 Replies
My 96 Explorer has been sputtering on me. I took a right turn one day and now its sputters at acceleration. It has a new fuel pump, filter, injectors, coil pack, plugs, wires, idle sensor, EGR valve. Also, all vacuum lines are good and not cracked or broken. My mass air flow sensor is also clean and clear. I have done all my own repairs on my cars and trucks all my life and thought I was good at it (not so sure about that now).
View 1 Replies
I have an 02 5r55w 2wd that I'm on the fence about right now and not sure if I should try and fix myself or pay $990 for a used one with unknown miles and 90 day warranty..
I bought it with 160-164k with no 2nd gear, OD flashing. Took it apart, replaced some bands, planetary, servo piston(end broke off-think OD.
After that, everything ran fine. NOw at 195k it's doing the I believe 2-3 high flare, rpm's go up to I think about 4k before shifting, sometimes more.
It has no acceleration on the low end gears, sounds like a dang 18 wheeler in it's low gears taking off, then I believe when int band kicks in, it picks up some torq and speed and shifts fine after 2-3 (not always does it-mostly when having to dump on the gas a bit).
Had issues with it jumping forward while on the brake. I've been in an 03 explorer with a good trans and could tell right away mine is pretty weak...
I was looking at the servo bore sleeve piston fix for $200. Maybe that and a shift kit, would that fix the issues I'm having right now? I haven't had any OD flashing or any check engine light codes. Haven't hooked it up to check codes, not sure if it logs if it doesn't flash check engine first.
I'm starting a business and will be pulling a 4x8 and need to get this one replaced or figured out.
View 1 Replies
My 2000 explorer is trembling when I begin to accelerate. This does not happen when in idle. Why this is so.
View 5 Replies
Right before Xmas our 09 Forester was hit while parked on the street. The whole front end of our car got wrecked. Was still driveable but we needed a new radiator, AC compressor, fenders, bumper, hood, lights, etc...over 5K worth of work.
As soon as we picked it up we noticed that when you press on the gas the car makes a high pitched whistling noise, almost like the noise when you'd try to tune in an old transistor radio. It only happens when the car is driving and the gas is pressed, not when parked or in neutral.
I know we should have probably brought it right back to the shop that day but I really did not like the shop at all and they are not at all convenient to where I live. I've read it could be a loose cat converter. I checked the air intake housing and that is secure.
View 2 Replies
