Ford - Escort :: 1998 - Cannot Get Idle On The Car To Go Below 2500 RPMs
Feb 17, 2011
I have a 1998 Ford Escort which I drove about 450 miles in frigid weather over about 8 hours in mid January. After arriving at my neighborhood and getting off the expressway, I couldn't get the idle on the car (manual transmission) to go below 2500rpm's. Further, upon taking off, the car was trying to stall, and I was forced to feather the clutch through town driving and keep the throttle up so it wouldn't stall, even with the clutch in. The weather at the time was about -7 degrees (f). The next day the weather continued, and thee car would start, jump to the same idle for 10 seconds, then drop suddenly to 500rpm, then stall out. I wrote the car off, cleaned it out over the next week, and then I tried to run the radio while doing so last weekend. I got the car to start, and run normally. I think it may be a computer issue, but it may also be the temperatures. The car has 207,000 miles on it.
View 3 Replies
Advertisement
So my 98 f150 xlt 4.6 is having a issue where the truck is jumping from 1500 rpm to about 2500 - 2600 rpm. You know sitting there trying to get up to speed. then all the sudden i look down and its at 1500 rpm. but still not really going anywhere. So i give it a little more throttle or gas and it jumps from 1500 to about 2500. Its been like this for a month but i thought it was crap fuel. What is the cause or maybe a solution?
View 4 Replies
My F150 with 175,000 miles on gave me a the ol' P0305 code indicating misfiring in cylinder #5. I changed the plugs and wires using Motorcraft wires and Motorcraft AGS34FM plugs.
Now the truck idles fine, does not give a OBD code but runs rough at 2,000-2,500 rpm. Tried it out on the highway and it started "bucking" a bit. Not sure what to try next.
View 2 Replies
1998 Ford Escort SE ... On idle ( at a red light or in park while on) it shakes terribly. When I shift into N it will lessen for 3-10 seconds, but then it will cycle back to the vibrating. The spark plugs were replaced about 4 months ago and got a brand new transmission 5 years ago this coming summer. It came into the family in '00 and I got it when I turned 16. The vibration started about 2 years ago and at first I was told "little car has shaky engine". When it got worse I was told it was the motor mounts, which I replaced a year ago. When they were first put in the car ran smooth as ever.
My mother turned on the AC while I was taking her for a test ride that same day and it started back shaking. They said the motor mounts were perfectly in place, and that it was a broken fan blade. My husband and I just don't see a fan blade causing that much shaking. I can hear the car violently vibrating when I park and take pizza to someone's door. Also a more minor problem, ever since we put new brakes on, my brake light comes on too easy. The weight of the peddle will turn the light on, and I have to keep using my foot to pull it up after each time I touch it, and sometimes when I'm driving.
View 12 Replies
I got an old 1989 F-150, manual, in-line 6 engine, with an 8-foot bed. I use it for hauling landscaping equipment, as i am starting a business. i will likely start hauling trailers with it this summer, but I also just want the engine to give me more power.
What are some things I could do to up the HP, or a better truck in general. I'm not looking to make it into a 350Hp monster, just get a little more out of it. What can I replace or add that would do this?
First, the idle dies on me when i put it in neutral, or gets stuck at 2500rpms. is this a vacuum leak, or the idle-air control valve?
View 9 Replies
I bought a 2006 F-350 4WD Lariat SRW with a little over 200,000 miles on it. The truck seems to run perfectly, except when pulling a load (9,000-10,000 lbs) down the interstate/highway. Sometimes, when pulling above 65-70 mph for an extended period of time (45 minutes to an hour) the truck will all of a sudden idle down and won't get above 2300-2500 RPMs (even if you put it in neutral and floor it). It's not enough to shut it down, but it won't let the truck accelerate as fast as normal. Killing the truck and cranking it back makes it go back to running normal for a little while, but the periods of it acting up get shorter after each killing and restarting. I took it to the Ford place while it was acting up, and they thought it was a turbo problem. They cleaned the turbo and said everything looked fine, but the same problem arose after leaving the shop. They've been stumped at 3 different Ford shops, but one said there's a 95% chance a new turbo would fix the problem. What might be wrong?
View 8 Replies
Truck: Ranger
Year: 1990
Engine: 2.3 Lima
Trans: 5 Speed Manual
Miles: 83,445
Recently Replaced:Oil Pressure Switch
Oil Pan Gasket
Crank Position Sensor
Spark Plugs
Plug Wireset
Ignition Control Module
Driver Side Coilpack
After I got done with all of this crap on my Ranger, I noticed that it was driving great! But...today I was on my way to school and BAM! My engine idle started hitting (presumably because I do not have a tachometer) about 3000RPM and lowering down to about 2500RPM and from there, every time I am not in gear it decided to fluctuate between 2500RPM and 3000RPM. Crazy style too.
Now, I got to school, and getting closer to it at a stop light the truck basically died. It was almost at 100'ish RPM. I gave it gas, and BAM. I hear a continuous hissing noise from under my hood. Haven't diagnosed it fully yet because I just got home and its 12AM.
Now, every time I stop at a light or in traffic or whatever it may be, I have to give it gas every other second, like a small push on the pedal, to make sure the truck doesn't die. Also, every time I am out of gear and my RPM's are at an 'idle' state, I get continuous hissing from somewhere, I get no power loss or anything, just really weird idle RPM's and hissing when my foot is not on the gas basically. It is strange. I think It is some sort of Vacuum leak but I am not sure.
To get a better picture of the 'hissing' noise, it is the same hissing as you would hear when letting the air out of a tire. That is the best way I could describe it.
View 3 Replies
Had a first-time issue with my car today. Background, 2010 II bought in June, just short of 15K miles, never had any kind of mechanical issue.
While en route to work this morning, I was about halfway into my 15 minute drive to work, when I noticed my engine was idling very high, I would guess 2500 rpms. It started doing it while I was driving around 35 MPH, then continued doing it while I stopped at a traffic light, and continued when I continued driving to a speed around 50 MPH. The high idle while stopped was not transferred to the wheels, so it was not a safety issue as it would be in other cars.
When I got back up to 50, curious to try something, I hit the ECO mode button and the car returned to normal. I took ECO back off and the car was still fine. I had no further problems.
I would point out that this morning was about the coldest temp that the car has experienced. Outside temp ranged from 7 to 10 degrees.
View 14 Replies
!995 honda accord, 5 speed. Idle is fine until the engine warms up, then fluctuates between 1500 to 2500 rpms. The idle control valve was cleaned- no change. Valve was also replaced -also with no change. Put old valve back on. Computer was disconnected after cleaning and also after each valve change.Would the next step be to remove and clean the fast idle thermo sensor? Also how do you check the coolant lines coming in. Anything else I would need to check, clean or replace.
View 2 Replies
My 1998 Honda Civic DX's RPMs are fluctuating during idle. I start the car and it is normal for about two seconds. I am assuming around 800 rpms (I don't have a tachometer). Then it jumps drastically higher, then lower, then higher, etc. Earlier tonight I replaced the throttle body gasket, replaced the spark plug wires, and cleaned the fuel injector cleaners. I took off several things in the process. I think the problem originates from taking apart the throttle body - not the other replaced parts. I have a manual 2-door 1998 Honda Civic DX with a 1.6L engine (D16Y7 engine to be exact).
View 15 Replies
I have a 1996 Explorer XL 2 dr. It has the 4.0L OHV V6 and the 4R55E Transmission. I bought it used with 152,000 miles on the odometer. About a month after I bought it I noticed it sounded different. I looked down at the tach and the RPMs are up around 2500 with the overdrive engaged. I turned the overdrive off and nothing changed. I turned it back on and nothing changed.
That weekend I pulled the tranny pan and filter and replaced the filter and fluid. There was the normal amount of debris in the bottom of the pan but nothing major. Now when I drive it it tries to shift into overdrive but when it does the engine bogs down and the O/D off light starts flashing. I know how to do the overhaul but I wanted to get a few opinions before I start tearing into it. What could be wrong .
View 1 Replies
I have a 1998 Ford Escort ZX2, 2.0L DOHC. I recently had the check engine light come on with code that basically says my VCT solenoid is malfunctioning. It is not very easy to find information about this part, I see that it is expensive, and time consuming to replace. I don't really have the time or money, the car still runs with 120k.What kind of consequences would I run into if I decided not to replace the part. The only thing I can find is that I would not pass emissions.
View 4 Replies
I recently replaced a bad head gasket on this car. After putting the reworked head back on the engine and putting everything back together, I can't get fuel to the engine. I cheated and took the intake manifold out and bolted it to the head and then set it back in the car plugging my injectors back into the manifold once in there. I checked all my electrical connections and they are all good. I am not getting power to the fuel pump, which was replaced a year ago when I first started tinkering with fixing the car. I get power to and from the inertia/fuel cut-off switch, but it doesn't appear to get to the fuel pump. I checked all the injectors to make sure they were seated properly which they were and all the fuses both under the dash and hood that I know about and then some. When I pull the 30amp fuse under the hood, and replace it, I do hear a sound that sounds like something is pressurizing or pumping for a second or to, but the sound is from under the hood and not from the pump/gas tank area.
View 2 Replies
So I bought this 2007 used with 86K on the engine. After 2 days cats code went off and i had both replaced with brand new ones. Now my truck is making a rattling as i step on the gas at about 2500 rpms. Its sounds like metal in a can swirling around amd as i let off gas the sound stops. It happens often, also the other day in was pulling off and heard a grind for about 2 seconds then stopped never beard it again, it sounds like its coming from the rear passenger side. It sounds like a bearing. This is the noise.
IMG_4285.MOV ...
View 2 Replies
I just recently purchased a 1998 ford escort. the gas gauge constantly at half. I haven't driven it yet because my insurance kicks in in a few days.
I asked my friend about it and he said that some cars always gauge the amount of gas no matter if its running or not. Is my escort one of those cars? or is it just broken?
View 1 Replies
98 Ford Escort SE
Been having acceleration issues with the Escort for a while now. The repairs I've made on the vehicle so far are; new fuel pump, coil pack and mass air flow sensor cleaning. Those are in order.
Now onto the issue. From a dead stop and sometimes while driving my vehicle will give acceleration issues though mostly from a dead stop. Checked the tranny fluid and it was a light brown with bubbles(?) so thought I'd do a fluid change but with the work required wanted some input before ripping into it.
View 19 Replies
98 Ford Escort SE... Was changing out fuel filter and noticed the bottom (filter sets upright) snap holder the broke. Would I be ok with just cutting off some of the metal line and adding flex/rubber and using clamps?
View 5 Replies
-My pickup was parked and hit in the rear axle in January. I had to have the whole axle replaced as well as the leaf spring to frame mounts.
-I finally received the pickup back and now when the trans is in Drive it will not up-shift until the rpms reach 2500 and it is a hard shift.
-Also the speedo does not work now.
-Check engine light also came on with code P0500- vehicle speed sensor.
-I replaced the VSS at the transfercase and the ABS sensor in the rear differential with no change.
View 8 Replies
I have a 2003 excursion... it is a v 10and just yesterday there was a whistling noise. I parked the vehicle and idle it slowly but no noise. I drove it again n the noise was there again. So the noise is there at 2000-2500 rpm. I'm wondering if its my exhaust manifold?? Also I'm starting to loose power. When running and in parked it shut off.
View 10 Replies
This problem showed up this summer, different times under load: on hot days, going uphill, AC on. Also, always happens when the temp gauge is just above halfway. Even after a stall, I am able to limp home, and it improves the longer the car runs after the problem starts. First I replaced the fuel filter which was pretty dirty, the problem didn't improve, so had the shop run codes -- low ignition voltage. They replaced the coil, and that seemed to work for a while. Now, in109 degree heat, it's starting to hesitate again, but the engine light hasn't come on this time. I had to replace the radiator about 4 months back, when it was cooler, and don't know if it's somehow temp related. Also, haven't replaced the timing belt since I bought it with 90K (its has 119K now).
View 3 Replies
Iv got this escort from my sister, i assume it has been hardly maintained considering the... state. I bought it because she was tired of dealing with the problem... driving, it will turn off. She said it got to the point where she just stopped driving it, although it only happened twice. It began when first time it shuttered then died. Took air filter off and it only ran it like that to get it home. Now it doesn't run but for a few seconds even without air filter, so Its the best choice to leave in.
Anyway, I've replaced:
-PCV Valve
-Fuel Filter
-Some dry-rotted hoses
-I didn't replace it, but i cleaned throttle body and MAF sensor in the intake.
I've tested alternator and batter, both are good. I tried fuel treatment. Being honest this is the extent of my.. automotive understanding. But Im fairly certain it is a fuel system problem.
View 1 Replies
