Ford - Escape :: 2012 - Blower Not Working At All
Feb 2, 2014
I have a 2012 ford escape with dual climate control with sync but not the touch system. Got in the car this morning and the blower isnt working at all. Thought it was a fuse, nope thats fine. Checked online and thought it was the blower resistor but he said the lower speeds would go if it was the resistor. He said that I need to reset the system and there is a procedure to do this involving pressing various dash controls.
View 7 Replies
Advertisement
Blower motor only seems to be working on the 3 & 4 position? Resistor bad? What is the location?
View 1 Replies
Have a 2012 Escape and the first level on my fan stopped working. All other speeds are good to go. Should I replace the blower resistor? If so, can you provide details on replacing?
View 8 Replies
2012 F350 Lariat 6.7
The blower motor has quit. All fuses relays etc appeared to be ok. So I tested the connector going into the motor, I saw 13.9 volts so assumed it was a bad motor.
After removing the motor I bench tested it by connecting 12volts to one side of the connector and negative to the other. It spun up.
I re-tested the motor supply connector in the vehicle, it has 13.9 volts on the yellow wire, and 4.44 on the other. I adjusted the fan speed on the climate control, although the fan images on the display increased, there was no change to the voltages on either line.
I used the 13.9v connection on the positive terminal and a ground on the negative, the motor spins.
Is there a method for accessing codes that will display what is causing this failure?
So why do I have 4.44 volts at what should be a ground? Is this a bad resistor or is the climate control euchred.
View 4 Replies
Turning the fan knob yields no results. The AC compressor does kick in as I can feel it when I turn it on when idling, so the knob appears to work. The blower does not move air.
I checked the fuse below the steering wheel and the fuse makes a complete circuit although the edge looks a bit darkened. Other fuses from working devices look the same and I took a spare 10A fuse from the designated area and inserted into the blower motor fuse location - still nothing.
I will also inspect the relays/fuses in the engine compartment to see if anything in there looks blown that's related to the blower motor. Hopefully it will be something simple, but probably not...
I will need to take it in to get it looked at and fixed, and this is probably not under warranty since vehicle has 56k miles... while I'm there I'll have a transmission fluid exchange done as well and I was planning on getting some body work done.
My bumper was torn off from the fact that it sits low enough that sometimes it would go over the parking stump. Well, it eventually got caught really bad and tore it off. Now the tab where the screw goes to secure the bumper has sheared off so it just hangs. Also, the tearing action from the parking stump caused the inner fender to come off and rub against my tire while driving, tearing it into shreds from the friction.
View 7 Replies
I have a 2005 Escape Hybrid. Last summer, the A/C went out, so when in the fall I finally got around to having the cooling system flushed. Did the trick, and A/C works fine. Now that winter's come along, I've noticed an issue with the heat. All fan speeds work correctly, and the dash controls for heat and cold work properly. But what's odd is that I get plenty of heat when the vehicle is at speed, above about 30 mph. As soon as I slow down below that, or hit a red light, there's no heat. The blower just blows cold air until I am back up at speed again.
View 9 Replies
Where the blower motor resistor is located on the '05 model.
View 11 Replies
I bought my youngest daughter a used 2009 Ford Escape (out of warranty) a week ago. Manual HVAC controls, 3.0 V6, AWD, 73K miles. The HVAC blower motor do not seem to move any air on speed 1 and 2. However speeds 3 and 4 appear to operate normally. Speed 4 noticeably puts out more volume of air then 3. Each 3 and 4 operator what seems to be normal speeds for their setting.
I would normally suspect resistor but my experience is usually that you have all or nothing not it's partially working like this is. I don't mind throwing a new resistor in there and trying it but I rather come up with a better way of troubleshooting it then throw parts at it.
View 5 Replies
The car is a '99 Volvo V70 XC AWD. The blower for the heater wasn't working this morning. When I left work it was blowing a little but not as high as it should on full.
View 7 Replies
The ac/heater works just fine. But the air only blows from front vents towards face; even if i press button to defrost or floor or frontnfloor.
View 1 Replies
I have a 06 Mercury Mariner and this past week fuse #26 keeps blowing turning the HVAC blower motor off. I replaced the blower motor since i had one already in the garage and same thing is happening. The AC will run for awhile and in about 10/15 mins the fuse will blow. Fuse #26 is the Climate control system mode switch, are these known to go bad? Is this the part I should replace or look for other problems IE compressor?
View 2 Replies
I have 2013 ford fiesta and the fan wasn't turning on!? It sounded like it wanted to and this is the first time I'm having problems with it. It was -23 out yesterday so that could b it but it's above 0 now and still not turning on?
View 6 Replies
My front ac blower fan is not working. I changed the resistor because seemed to be popular answer for fix but nothing I took blower off and straight wired it and it worked so that should rule out blower motor. Right? Swapped relay 103 and nothing...
View 8 Replies
Ok, I've read about the blower motor resistor, and everyone says you should have HIGH speed on the fan.
2002 Excursion with digital display.
I turn the truck on, then turn on the blower. A small puff of air comes out then shuts off completely. I can hear the direction doors opening when i change between foot and face A/C.
Is this the blower resistor that needs changing?
View 3 Replies
My blower on my 2010 Lariat truck isn't working and I can't seem to figure the issue. No heat or AC. It seems that some air is coming through, and the fan indicator shows it on high, but nothing.
View 8 Replies
I have a Full Size 93, 5.8L Van. The blower motor has stopped working. I have checked the fuzes, ok. I have checked the Power Distrubution Box, ok. I do have power to my Aux (rear) blower. I have hot wired my blower motor, it works. I have no power to the blower motor, thermal limiter, or to the fan control switch on the dash. (Like I said, the Aux on the dash works). What else is there?
View 14 Replies
I have a 2000 EX and my front A/C blower wet the bed yesterday. I have checked the fuses under the dash and under the hood. I removed the blower motor and supplied 12vdc directly to it. Works like a champ. I metered the harness connector with the ignition on and the fan speed switch at all speeds, I get a range of 8.1 to 8.9vdc. I metered the fuse terminals as well and get a steady 13.2vdc. Before I rip the dash apart, what is the most common to fail the Blower Resistor, Fan Speed Switch, or Blower Motor. Or, do I have a completely different issue?
View 5 Replies
I did not want to high jack the threat about the blower motor stuck on high, but on rare occasions my blower will quit all together if it is turned up too quickly. I can still hear the compressor clicking on and off, but no air moving. after waiting a few minutes it will work fine if you adjust the blower control slowly.
My truck is a 2012 lariat supercrew with navi and dual climate controls. oh and i believe i have about 300 miles left on warranty, but it is not doing it on a regular basis, i doubt the local ford dealership will repair it.
View 2 Replies
2003 Limited explorer 237k with auto climate controls. 95 degrees out and a/c on when fan speed began going up and down a few times and then completely off. Won't work on heating as well. Rear fan works fine so I changed the resistor but still nothing. The control lights up when changed as usual but no fan. What to change next?
View 7 Replies
I had to replace the vacuum control for the heater in the dash panel. The fan worked good on all 4 speed settings but only in the defrost position due to the damaged control valve. The control valve works all position for the heater positions now. There is power at both sides of the heater fuse under the dash but no blower function. Is there a fuseable link elsewhere in the system to check. Is the fan motor only accessible to test by accessing the heater/AC under the dash on the passenger side. 1973 Crew Cab....
View 1 Replies
My 99 f150 blower motor and blinkers slowly but surely went out on me. The hazards still work. I changed the flasher relay and the relay for the blower motor, and nothing. I've checked all the fuses, and checked for wire issues and nothing.
View 4 Replies
