My transmission is manual, front wheel drive, 4 cylinder motor, plunger has come disconnected from shifting forks, car is stuck in 3rd or 4th gear. Would it be easier to change transmission or is replacing the plunger mechanism a viable option?
View 3 RepliesI just picked up another GTi and knew the transmission was iffy when I bought it. I had to deal with the serpentine belt tensioner which is now new and also a new waterpump since it was wobbling.
I've already drained and replaced whatever oil was in there with VW G60 Gear Oil which is what my Dealer here told me to put in and it shifts smoother now but still has the same issue. I also did the Shifter Cable adjustment to see if that was the problem but that only made it easier to shift but it still got stuck.
Basically what happens is when driving I shift into 3rd gear and when I go to shift out of 3rd it comes out of gear but it's like it hits a brick wall and will not go into the home position. I was hoping the adjustment and new oil would work but it hasn't done anything.
My 2009 Ford Escape shift lever is stuck, not allowing me to shift out of park without using the manual override. However, when I slam my foot to the brake (rather than simply stepping on the brake), the brake switch relay, etc. all engage and I am able to shift out of park. Is this a brake switch relay problem, or is it possible that it has to do with the age of my brakes, etc?
View 3 RepliesMy transmission has recently locked itself up in reverse. The shifter can easily shift through 1st-5th but if i attempt to drive forward it is still in reverse and works against each other. If shifter is left in neutral position it is still in reverse. If i push the clutch in the truck will move freely. I have taken the cover off of the tranny and all of the gears appear undamaged. It was dry however, and i replenished the trans fluid but it still is stuck in reverse. baffled.
View 2 Replies2007 V6 Mustang Manual Transmission. I recently got stuck in my drive way due to a poor plowing job by the plow guy. I had to turn the traction control off and aggressively shift transmission between reverse and 1st to rock the car and spin the tires. I eventually got unstuck but now the transmission doesn't feel right.
I thought it was the clutch but the issue seems to occur only shifting from 1st to 2nd. The higher gears all seem relatively fine. There is just a catch between 1st and 2nd now that sometimes causes me to not be able to shift into second gear without forcing the shifter down roughly.
Is it possible that I just threw something out of alignment inside the transmission itself? It doesn't make the car undriveable but i get ticked every time i drive it knowing that it was fine before the poor plowing job.
Should I even bother having it looked at? I know transmission repairs are expensive.
I have only driven my car a handful of times, but I noticed the past two times, that it sticks in 5th gear during the time that the oil temperature finally gets above the 1/4 mark until it finally settles.
It doesn't stick before reaching the quarter mark, and as far as I can tell, it doesn't stick in auto mode. This doesn't sound like something that should be normal, but what say you?
I have a 2006 Mustang (manual 5 speed) that recently has been having a problem getting into 1st gear
Symptoms:1. When the engine is cold, there is no issue getting the car into gear2. Once it warms up (after approx. 20 miles or 30 minutes driving), it is very difficult to get into 1st gear. I have to put it in 2nd then get it to slip into 1st.3. On hot days the problem starts sooner and is hard to get into the other gears4. when the car has warmed up on a cool day. I can get the car into the other gears (2nd, etc) when standing still, but first is almost impossible
Originally the problem showed up when my wife drove the car, but it is getting worse. Why the engine and/or outside temperature would affect how my I can get my car into gear?
My car is a 2003 Volkswagen Jetta GLI, I was on my way somewhere when slowing down i put my car in neutral and began braking. Going faster than i thought i shifted into first gear at about 40mph. At that moment i felt rattling in both the gear stick and the clutch pedal, i tried to shift again in case it was just a hiccup and my gear stick was stuck in neutral, i couldn't switch into any gears.Now when my car is off is the only time i can move the gear stick into the gear slots. And i also lost a lot of pressure in the clutch pedal but it does not stick to the floor it returns to normal position after a moment or so.
View 6 Replieslast night I was on my way to work and had the car in forth traveling about forty-five. A light ahead of me turned red and I held the clutch in until I had stopped. I shifted into what I thought was first. I discovered that regardless of the shifter position, the transmission left it in forth gear. Barely got it moving from a stop and brought it back home.
Looking under the car, I don't know exactly what the linkage mechanism looks like. I'm not sure how to tell if it has been disconnected or misaligned. I don't know if the problem is in the transmission itself either. The shifter moves to other positions freely, but in actuality it stays locked in forth gear.
I've owned a manual 2002 Ford Focus ZX5 for 5 years. I bought it with 77,000 miles and it now has 112,400. I've been pretty good at having the oil changes and tune-ups at the right mileage. This last time I took it to a new service place, they suggested I looked into changing the Manual Transmission Fluid. I have never had it done, and I'm not really sure about the previous owner. What's your take on this? I've done some research and opinions seem to differ quite a bit about at what mileage the transmission fluid should be changed.
View 10 RepliesI have a 2000 VW beetle with a fairly new clutch (2 yrs old). My boyfriend is new to a manual transmission and I can't say I know much about how it works either. A few times when he was driving he will reverse out of a parking spot and then shift to first and the car will make a deep rumbling noise. We turn off the car and turn it back on and its fine. Is the car stuck between gears? Why does it make this noise?
View 4 RepliesWhy my vue manual tranny only goes in first third and fifth . Can't get it in second fourth or reverse . Bought it like that .
View 1 Replies1997 Saturn SL ... It's like 3rd gear is where 1st used to be and 4th is where 2 used to be. 5th and reverse work but are more towards the center. It's as if the stick shifted over to the left.
Is it possible for the shift stick and it's linkage to become displaced? The temp did drop today about 40 degrees and it snowed but the car stays in the garage and was only parked at my work for a couple hours after a 2 mile uneventful drive.
No warning lights that I can see but the check engine lite has never worked. The engine is a 96 rebuild but the transmission should be a 97 like the rest of the car.
Great mileage and otherwise drives fine.
My 1997 Saturn SL2 with 5 speed manual transmission won't shift into first or second gear. When I shift into the location where first would be the car is in third gear. It shifts into 4th, 5th and reverse just fine, though the shifter is in the wrong position for those gears. I can wiggle the shifter in neutral and get it to move into the position where 5th and reverse are normally found, but it is stiff and makes a clunking noise when I move the shifter over to the far right side.
I have removed the center console and the bushing appears to be intact. Both cables are in their proper positions inside the vehicle and at the engine. One of the cables (the top one in the engine) has some wear and tear on the boot, but does not appear to be binding. Other than the stiffness and the clunking noise, the shifter seems to be working fine too.
I am loosing gear oil through an odd place . There appears to have been a rubber boot or cover over this area that got cooked by a hot exhaust (whole other story there). This is left (passenger side) just above where the axle enters the gearbox. Not sure what this is and how I can resolve the issue. I have temporarily used silicone to stop the flow and have topped off the gear oil, but am still leaking a little. I have already done some damage to the bearings I fear, as the tranny really whines when I get up into 4th and 5th.
View 4 RepliesWhat RPMs do you see in 6th gear, say at 60mph or 80mph? Consumer Reports claims the RPM at 60mph is 3020!
So I went to vw.com to look at the gear ratios for a reality check. The site lists two final gear ratios for the manual. "Final I" is 3.94 and "Final II" is 3.09. When do you get one versus the other? With a final gear ration of 3.09, I get roughly 2400RPM at 60mph. But with a ratio of 3.94, I indeed get about 3000RPM at 60mph or 4100RPM at 80mph!!! That's absolutely insane.
I have had my truck in the local ford shop because the fluid was a little bit burnt smelling, I had a flush done to it and then afterwards I noticed first gear started hesistating and then would go to second, when it warm it doesn't have any issues, shifts normal, but when cold or starting off even with running in the morning before going to work its still does that, I would like to find out before it starts becoming a serious problem....
View 6 RepliesI have an extracted T18 transmission and it appears to be stuck in gear, preventing the Shift Control Housing (top part of trans.) from being removed. Would pulling the shifter remove that top plate? As it is I can get that plate lifted about an inch while I notice the in/output shafts turn, which leaves me to believe it's stuck in gear.
View 2 RepliesMy 88 celica's manual transmission grinds a little, at times, when going in 3rd gear. I have atf fluid in it now as specified in the manual. Should I replace it with gear oil?
I don't want to damage the transmission or clutch.
I have a 98 saab 900 se turbo.90000 miles on it. Just had a new clutch kit/throwout bearing and master cylinder clutch installed, as the clutch was going bad.
When I shift the car (while driving) from 2nd into 3rd/4th/5th gear,and accelerate I suddenly notice what sounds like a "grinding"/raspy noise that stays with the car while in those gears. It does not occur in 1st or 2nd , although it seems that in first gear the rpms go up real fast now (could the gears be slipping again?? this is a brand new clutch..).
The second I shift to 3rd gear and give it gas, the noise shows up instantly. Now when I let my foot off the gas, the noise goes away 100%. The second I give it gas again, it comes back. Also I don't believe the noise increases or decreases in relation to the speed of the vehicle. It seems to stay constant no matter what speed I'm at, as long as I'm actively giving it gas.
It occurs every time I drive..not sure what to do and what causes this..maybe I just need to check the transmission fluid?
2004 Jetta 1.8T w/5 speed manual transmission. Bought the car this way, mostly for a parts car, but everything else runs and drives good, so if it wasn't for this issue it would be a decent driver.
Won't/can't select first gear. Seems like there is no "spot" for first, or that the shift mechanism has no where to go., locked out. All the rest of the gear selections work perfectly. Tried the cable adjust ritual, but it was fine-as I suspected. The shift assembly works/moves perfectly from the tranny end and the shift lever end. Not a synchro, it won't go in stopped, moving, running or shut off.
So, what's the probable best guess or best way to come to a diagnosis? Shift tower parts broken somewhere, or something like a shifting fork bent broken? Seems like if it was internal there would be other gear selections that would be affected. Any links to some diagrams?