Ford - Escape :: 2001 - Engine Jumping When Idle In Cold Weather
Dec 7, 2011
I have a 2001 Ford Escape, and since the colder weather set in it is tacking below 1 and 'jumping' when idle. When accelerating and/or once the heat gauge has reach midway, the car is fine. I added a bottle of gas additive to the tank 3 weeks back, but the problem persists. The engine light is on but no code is registering.
View 2 Replies
Advertisement
I'm needing cold engine misfire. 2001 escape 3.0 engine 190300 miles on it. I changed the plugs, cleaned the fuel injectors, new air filter, new fuel filter, cleaned the pcv valve and new ideal control valve. When the engine is cold it starts right up but wont idle right and misfires sputters some to but run the rpm's up and it smooths out. drop to idle and it misses. Now when the engine gets to operating temp it seems to run fine. What am I overlooking to find the problem?
View 5 Replies
Have a 2001 F150 FX4x4 and since the weather changed and started having days below 40 the truck has started running rough for about the first 15-20 miles. When you first start it starts like normal for first 3-5 min and then it starts loping real bad like it has a cam in it!
View 5 Replies
I have a 05 escape hybrid with 75k on it. there is a slight problem every once in a while when it starts the idle jumps up and down and when it is put in reverse it has no power to move. you have to put the pedal to the floor....there are no codes and ford has had the car for a total of three weeks, nothing found and of course it did not act up for them..
View 9 Replies
I have a 2001 Escape, V6 engine and I guess it really does not like it when it's cold outside. Usually the car runs just perfect but when the winter arrives and temps drop into the 20s the truck does not want to run idle right when I first start it. I have tried by stating it without touching the gas pedal. And also by pushing it all the way down and then releasing it. I don't know which method is the right one, but it doesn't seem to make a difference. It takes some time and eventually after about 5 miles of driving it will act normal again. What could I do to fix that?
View 9 Replies
I have a 2001 Toyota Tacoma that has a knock or ticking in cold weather. The problem starts sometimes immediately after I start and other times it is only when I press on the gas in the cold mornings after a few min warm up. The noise goes away after 10 min. The question I am wondering is this:
1: could it be worn piston rings and the pistons are slapping the cylinder wall
2: is it an oil pump problem or a oil restriction issue
3: is it a valve guide issue
4: with the history of the 2.7 having exhaust manifold issues (poor manufacturing) could a cracked manifold be the issue
I change the oil myself, the oil filters have been OEM toyota, the noise has been going on since 60,000 miles, the truck is at 230,000 miles.
View 8 Replies
Does the 2002 7.3 have an automatic high idle in cold weather?When you start it after it runs for a few moments it goes into high idle until you hit the accelerator. I had a 96 powerstroke before this one,it didn't do this. Just wondering?
View 4 Replies
My car is a 2001 honda accord v6. It sat for 3 winter months. When I go to turn it on in the morning, the car will rev while idling. Jumping between 1000 and 3000 rpms. Why this might be happening?
View 3 Replies
I have a 2004 SF/2.4 I4. When the car warms up, the ignition coil sparks between the rubber boot and the coil itself, drawing the spark from the plug and resulting in a misfire. This is especially apparent when the A/C is running and the car is idle-ing, resulting in the A/C turning off and a rough jumping idle. Once the car is running this is not noticeable and the A/C turns on.
I have changed the spark plugs to new autolite plugs, and the situation disappeared for a day, but now it is back. I ordered OEM NGK Laser Iridium plugs, I hope they will fix the situation. Why would the A/C matter? Next on the list will be the ignition coil and wire change, but I hope to avoid that.
View 1 Replies
In the cold weather I found I had what sounded like ticking noise at idle on the R. It doesn't do it when first started and I didn't remember it in the warmer weather either. My research indicated it could be the DI injectors or the N80 valve. But what got me concerned was that I could hear the ticking inside the cabin, somewhere in the front passenger footwell area. And at times over normal radio volume. This was not the case in any of those other threads on the issue as they noted the sound only outside the car.
So I took the car into the dealer this morning to see what they would say. Had a good tech check out the car and try a few things. Turns out the tech found it was the fuel line underneath the car rattling. He said this was a common issue in the MK V cars and there is a service bulletin out on it, but he had never seen it on a MK VI car.
View 24 Replies
2000 Sierra 1500, 5.3L engine. When he starts it in the cold (below 40 degrees) at first hits 1000rpm, then immediately drops to 400-500rpm. The idle is rough and wants to die if he tries to drive it. However after 10-15 minutes and the eng warms up, its fine no problems at all. There is no codes, so the scanner we had didn't tell us anything. He had cleaned the TB and intake system with cleaner, no dice. He also disconnected the IAC while it was idling rough, that didn't change the way it ran at all. We would like to toubleshoot it more before we start throwing parts at it.
View 1 Replies
My idle seems to always be somewhat rough whenever I put the heat on in cold weather. While in drive I'll come to a red light, heat will be on and I'll stop. The. my idle will bounce down then back up. I shut heat off to test and it only does it while heats on.
View 5 Replies
I have a 1998 Chevrolet Prizm that will not fast idle when it is started in cold weather the first thing in morning. what could be the problem?
View 4 Replies
I have a 2001 Ford Escape. When started cold, it revs up to abt 3000 rpm. Slowly drops back to about 1000 in abt 10 secs. When the engine is hot, it often wants to idle 2500+ rpms and I have to really step on the brakes to slow the vehicle. When I disconnect the IAC the engine dies. When it is revving high, I can disconnect and reconnect the IAC quickly, and the idle will drop back down for a few minutes, until I step on the accelerator, then start climbing again. It seems to be a lot worse when hot.
I replaced the IAC and TPS about 20k miles ago and thought it was fixed, but the problem has returned. At that time, I could tap on the IAC and it would "get well" for a while. Tapping on this one doesn't seem to change anything. No CEL, engine runs smooth, and I don't notice any air leaks (none that I've found, at least).
View 8 Replies
2001 Intrigue 3.3 L v6
Due to the cold weather, seems the battery could not start the car. I removed the battery to trickle charge it overnight in the house, and hooked it back up in the morning. It seemed to have sufficient charge to power the starter motor, but the engine would not turn over. I could hear a whirring sound whenever the key was turned, and the sound stopped whenever the key was turned off.
I am suspecting that the starter motor somehow is not engaging with the engine flywheel?
View 4 Replies
I have a Chrysler Neon 2001 and due to the recent cold weather in Montreal i had issues starting it. The battery seems to be functioning properly but when i try to start it, there wont be any sound what so ever, also i found a broken plastic pipe which im not sure what its there for ( I have uploaded a photo of it).
Link to picture : [URL] ....
View 6 Replies
I've got an 01 Ford Escape 4 cyl 5spd awd, it idled low when its warm, revs between shifts and if you put it in nuetral and let the clutch out when you're moving it revs to 3500rpms and just sits there until you stop or push the clutch back in. I've replaced the iacv and the pcv valve, elbow and hose, and the tps. What to look at next?
View 4 Replies
I got a 2001 Escape XLT (V6) a couple of months ago. Its in great condition, only 82k miles on it too. It had the notorious door handle issues which I have had fixed. It also had the wet weather stuttering problem, which I had fixed by having all 6 spark plugs replaced (Motorcraft OEM plugs), the back 3 coils replaced, upper intake gaskets replaced, Valve cover gasket replaced, PCV valve replaced (motorcraft).
It runs great when its warm, the problem I am having is when its cold outside and the engine is cold, it starts up fine but idles like crap and if its really cold outside, it starts and dies 3 or 4 times before it can even get to the crappy, stuttering idle. I have to intermittently feed it gas to keep the cold idle going long enough (3 or 4 minutes) before I can drive it. Once the engine is warm it drives like a champ. The only warm engine issue, is occasionally after driving it and putting it in park, the engine will rev up to 2000, 3000+ rpms, and just keep going up until I shut the engine off.
The codes read P0171 and P0174, which are lean on bank 1 and bank 2. It had also thrown a misfire on cyl 6 but once I cleared that it hasn't come back, just the lean codes are still present.
From what Ive been reading, this can be a number of issues, ranging from the IAC valve, EGR valve, MAF or the lower intake gaskets. I'm very much a rookie when it comes to car mechanics, but I think I can handle changing the IAC, EGR and MAF since they are all on top of the engine. However I don't know if I could handle the lower intake gaskets. Ironically, the gaskets are the cheapest part, but the most labor if I paid someone else to do it.
If I replace the EGR, do I also need to replace the EGR Modulator as well? Looking for brand names that are best bang for the buck when it comes to these other parts I have mentioned?
View 14 Replies
Truck is an extended cab, 8' box, 4x4
This truck has begun to not start in cold weather. No click of the solenoid, no starter movement. Dash lights all work, heater, wipers, etc. I put a space heater in the cab, on the drivers side floor board, warmed it up and then it would start.
View 1 Replies
I've read quite a bit in various threads about the large vacuum elbow collapsing, causing erratic idle speeds. My 2001 3.0 had that issue int he past. I shoved a 1/2" copper 45 degree elbow inside of the rubber elbow, and the problem was solved... until a few days ago.
We're now getting into the hot part of summer here. I've notice the same symptoms are beginning to return, once the engine compartment gets hot. My question is... is the large vacuum line a "hard line" all the rest of the way to the engine, or are there other places along it's length that can also collapse under vacuum?
View 3 Replies
I have a 2001 Toyota Sienna xle that started running rough when the weather turned cold. When started, the car idles very high and will not shift properly until it was been running for around 5 minutes. After that it will run well for about 10-15 minutes and then begin to run rough or poorly. The problem is very noticeable at low speeds and when stopped. It never actually kills, but it feels like it is going to. At high speeds it is less noticeable but occasionally you will feel it jerk or chug like the transmission is slipping or a belt or something.
I took it to a mechanic who checked the codes and found that the ignition coils were supposedly bad. I say supposedly because they replace three of the ignition coils and the problem still persists. I then took it back to the mechanic who then told me it was the oxygen sensor. The o2 sensor was replaced and the problem is still there with no noticeable improvement. I again to it back to the mechanic who tells me that they scratching their heads.
I have done some looking around on the internet and have found some discussions that seem to have some promising leeds and actually last weeks car talk show had a caller who described a similar problem. The guys told him it could be a oxygen sensor but they thought a better possibility would be EGR valve or a vacuum leak. Not sure if this sienna has an EGR, but I plan to suggest looking into it to the mechanic. Also, I found some discussions talking about the idle control valve and the engine control module.
View 2 Replies