Ford - Engines - Focus :: 2011 - Transmission Malfunction - When Shifting Up Gears Throttle Remains High - Dropping Very Slowly
Jul 4, 2015
2011 Focus 2.0L L4 engine, manual transmission, 70K miles - when up-shifting gears, the throttle remains high, dropping v-e-r-y slowly instead of dropping rapidly when the throttle is released. It is the same when not moving, when the throttle is run up to steady RPM's, then the pedal is released, the RPM's drop slowly. This has started recently, at first I thought it was just 'operator error', and that our shifting skills were deteriorating with age (ours, not the car), but testing has proven the fault lies with the vehicle. I researched sticking throttle issues, and thought I had located the problem as a bad throttle body assembly. Changed it out with a new one, went thru the computer reset procedure,and the problem still exists. No error codes are showing, but the little yellow wrench light is lit on the dash (resets each startup. Vehicle drives fine otherwise, no loss of power, etc.
View 10 Replies
Advertisement
I have a 2009 ford focus The rpms are hight and the transmission is not shifting .
View 7 Replies
I've just bought a 2002 Passat, v6 5 speed manual with 119,000 km on it. When I shift through the first two gears the rpm are not dropping immediately... about a 1 second lag. I haven't had a clear answer about what it is I have called two dealerships and two independent mechanics except. They say that it could be a variety of things that might be wrong with the throttle body.
View 6 Replies
After a round of extensive maintenance this month, I thought my '02 was once again a road-ready betty. Just my luck! On the drive home from the shop Friday afternoon, I noticed a hard shift when upshifting from 2nd to 3rd. I've done some test driving over the last couple of days, and here's what I've noticed:
1) If I apply too much gas, I intermittently get a little bump—very subtle—when it kicks into first gear from a running stop. The car seems to engage fine at start.2) If I apply too much gas approaching 30MPH in 2nd gear, where I think it would normally shift into 3rd, the transmission upshifts late and hard. The more gas I apply, the harder the shift.3) Once, when gunning it at highway speeds, I got a little bump shifting into a cruising gear at around 70MPH.
I'm able to completely eliminate this problem if I am prudent with the accelerator. If I back off the gas before the tachometer hits 3000RPMs and wait a few seconds before accelerating again, the transmission shifts smoothly. I have not noticed any issues with coasting or downshifting.
I've had this car for a decade and 146K miles and it's driven like a dream every day until this symptom presented on Friday. I don't remember the last time the transmission fluid was changed, but I've never missed a scheduled service and I always use Honda dealer shops. I checked the fluid yesterday, and I think the colour (winey red) and odor (sweet) were both good. The car had been driven recently, and the level on the dipstick was higher than the second dot.
View 5 Replies
Am facing a dropping on voltage power. When my truck on the idle the voltage reading 12.2V , but when I turn the HIDs and the a/c plus the a/c fan, the voltage drop to almost 9.5V , Then the transmission starts to slamming the gears. Is it the alternator acting or the Battery Which is new. I don't have the battery light on the dash but I think the dash light is not working .
View 14 Replies
I have a 1994 Toyota Camry. Took it to a shop to repair an oil leak. They had to dismount the transmission to get to the gasket. I got the car back and the transmission was messed up. Took it to a transmission shop and they told me that the transmission "cable" wasn't positioned correctly by whoever had done the work and they could fix it. They told me it was safe to drive it until my appointment. The engine was revving too high before changing gears and while driving home, I heard a loud rattling noise in the engine and my car stopped in the middle of the road. I'm told that a rod has broken inside the engine. My question is: can this in any way be related to the transmission cable not having been set/positioned correctly?
View 5 Replies
I had been waiting to fix my explorer for a long time. The "previous owner" I will call him knowingly sold me a vehicle with a bad tranny without disclosing it... long story. To get to the important part, it had the common 2/3 shift flare. I dropped the pan, filter, and valve body, making sure to use a template and put the bolts where they go. Then i took the valve body to the work bench and replaced the gasket, which was surprisingly not blown. After more looking around, I realized the previous owner had already had the fix done. I tightened the EPC 1/4 turn and reassembled the tranny. When i started it, it was stuck in first gear. PRN21 all went forward (park just revved a bit due to the park lockout.)
I tore it back apart and found that the plunger on the side of the valve body was stuck in the 1st gear position. I pushed it back out and cleaned it up so it moved freely. Then I reassembled the tranny using new fluid again.
After that the tranny was stuck in neutral. I dropped the pan again today, and tightened the valve body bolts and made sure my solenoids are tight. Filled it back up slowly with the engine running. It shifted into gear for a second (tried to go forward while it was in reverse though). Then it was again stuck in neutral in all the gears again.
View 2 Replies
Every so often, my manual transmission Corolla will "overthrottle" during acceleration, especially shifting into 2nd and 3rd gears (and sometimes even 4th), i.e., the engine will race above the usual RPMs associated with each gear, just for a bit. This however, isn't consistent. I still need to check if the engine air filter is dirty, which I suspect could be a part of the issue.
The vehicle has ca. 124,975mi, and only started exhibiting this problem 2-3 months ago, and only in 2nd gear. Again, this issue is very intermittent, and sometimes I can go a week or two without any incidents at all. The regular maintenance (oil changes, cooling system maintenance, etc.) has been faithfully performed according the manufacturer's specifications.
View 8 Replies
Ok let's start I have a 1999 f350 7.3 4x4 Work Model that I'm have some odd transmission problems. I drove it 20 mins to do a 2hr job no problems finished that got in took off I few seconds down the road it was like the tranny just dropped out no sound just reved no gears at all. So I shut it down tried to start again would not start in park without pulling up on the lever which had experienced here and there for a good while. So got it started went in gear took off same thing went popped out no gears. I started it again this time used reverse same thing as drive so got it where I knew I could leave it but now it would not start in park anymore at all. Next day picked up a neutral saftey switch changed it now it starts in park every time but still starts going looses the gear then have no gears shut it down sometimes had to wait a few then again same issue.
View 14 Replies
I have a 1991 bronco with a 351w and the e4od trans.. The transmission is shifting late and hard and sometimes when i let off of the gas to slow down it shifts between gears up and down by itself... The only lights on the dash that are on is the Rear Anti-lock brake light and the speedometer is not working either.. Where to start the trouble shooting to fix it?
View 3 Replies
1999 ranger, 2.55 speed. truck idles with very high rpm's when driving and shifting gears. have changed the AIC, mass air sensor. Throttle position sensor and still does it. the AIC has been changed 5-6 times in 6-8 months as parts store kept telling me it was that. What can i look at, check, etc...
View 6 Replies
My son has a 2013 Fx4 crew cab 4X4 ecoboost with 8500 miles. He says in the morning for the first couple of miles while accelerating gradually the trucks shudders when shifting gears. After a few miles it goes away. Dealer says they can't do anything endless he can duplicate the condition. He went out of town for a few days and left me the truck so I'll drive it in the morning and see what it does.
View 3 Replies
I have a 2002 Ford Focus ZX5 with about 108,000 miles on it. It's driven far distances, about 700 miles round trip, a couple times a month. About about three times since last summer, approximately halfway through one leg (at around 200 miles in), the engine starts jerking when accelerating. It doesn't happen on every trip, and seems to only happen on hotter days.
(Driving around town short distances, even at high RPMs doesn't present a problem at all, it's specifically after a couple hundred miles.) The engine light has flashed, but not every time the jerking occurs and hasn't stayed on, and the code that was pulled doesn't seem to be telling either the mechanics or Ford know what the deal is. I'm looking at having the whole transmission swapped for well over a grand, but with the disclaimer that it's not a guaranteed fix.
View 6 Replies
I have a 2003 Hyundai accent that was not shifting into higher gears about (45 mph) max speed. I took a transmission out of a 2005 ( same engine bad unibody) and put in the 2003. Making sure the torque converter was in all the way. Now I have no gears at all, no park, nothing. But the car does start. I went to the salvage yard and noticed that all the cars like it (hyundai) had no park either. So I must be missing something electrical right?
View 11 Replies
Why does my C6 shift at 4000 RPM when the throttle is open? My motor produces peak torque at 5000 RPM, and peak HP at 6500 RPM.
I would like to have the lower gear until I exceed the peak torque at least.
View 11 Replies
I own a 2005 f-250 superduty with the 6L diesel. Just recently when I leave to work in the morning I notice the trans shifts slow through the gears and when it does start to shift it will start slipping then kinda vibrate for a few seconds then finally shifts into the next gear. It will do this through all the gears until I get up to speed on the highway. After it warms up it shifts and drives great until I let it sit for around 8hrs or more. I really hope I don't need a new Transmission considering I bought this truck as is from the dealership just a little over a month ago. I have checked the trans fluid it is full, I even drained all the fluid and replace with new and it still does the same thing.
View 4 Replies
96 F150 carbed 300 with a C6/208 SAS44/9" with 3.55 on 35s.
I put a transgo shift kit in the transmission before putting it in the truck, it also has a small stall. At half throttle you can manually shift 1-2-3 with no issue at all. Under full throttle when you shift to second it won't go into second until you push the shifter into third. Then it'll go to second and spin the tires when it grabs second in dirt. This is all in 4lo, I was gonna switch to 2hi and try it but it's raining and I don't feel like crawling under it to change it. The truck is a mud toy so will spend 90% of its time in 4lo.
I don't have a vacuum line currently hooked to the transmission because I have the same shiftkit (transgo) in my 77 and no vacuum line on it either and it works fine.
View 4 Replies
The C6 in my truck is acting odd.. its into drive by 17 to 21mph under light throttle and under moderate throttle it slips occasionally when shifting, the 460 had a fuel spurting motorcraft on it, had to swap that for an edelbrock 1406 to drive it. The kickdown is there but setup for another truck. I don't know if the c6 has a vacume modulator or if its all controlled through the kickdown rod.. it does need a fluid an filter change that's gonna happen this week.. this trans just has me leery with the soft shifts.. its in 2nd almost immediately after takeoff....
View 6 Replies
2011 Elantra Limited, auto, 15,700 miles. Past couple of days I have experienced very rough shifts in all gears. First noticed on Saturday. Drove about 10 miles Saturday morning, then parked until around 4pm. Car started normally but rough shifts for first 5 miles.
It felt like the car would drop out of gear when shifting, then go back into the correct gear. There was definitely a "pause" before it went into gear, like bouncing up a set of stairs. Problem resolved itself and did not reoccur until this afternoon. Car was parked for 1-2 hours. Same rough shifting for 3-4 miles.
View 15 Replies
I have a 2003 Ford Focus ZX5 automatic with 143k miles on it. Recently I've run into a problem with the speedometer and RPM gauges dropping down to 0, no reading. It is an intermittent problem and has no logical connection to any of the other functions of the vehicle (it can happen while the car is idling, in motion, upon startup, etc etc.) Everything else on the instrument cluster works perfectly fine, (odometer still reads correctly and works, gas gauge is fine, etc). I'm thinking maybe it is an electrical issue since the car seems to be in fine working condition other than that, even when it drops out. The gauges won't start reading again until I start the car up...and sometimes that is not a guarantee. I use this vehicle to commute locally 4 days a week and I've already put a lot of money into new components for the vehicle.
View 2 Replies
My sonata 2012 with 71K km on it just started hard shifting in the morning, after first start. It slamming in D from R very harsh and then shifts all other gears for ~3 minutes harshly (upshift / downshift) and then it gets fine and shifts gears with absolutely no problem throughout the day. Dealer of course was not able to reproduce the problem.
View 37 Replies
