Every time we make a sharp right or left turn the engine on my van stalls. It has to be completely restarted. In the last year we replaced the trans and steering column and had a major tune-up. So far, no one has been able to diagnose the problem.
View 5 RepliesWhen turning right, it seems as if my brakes don't want to work. There is somewhat of a grinding sound and what I can only describe as a "shutter" from the pedal. They work great going straight or turning left. I should also mention that the steering locks up when turning sharply, haven't noticed if it's only when turning a certain way. This happens mostly when backing up. Also, the ABS light is on occasionally. I drive a '96 GMC Suburban.
View 7 RepliesI have a 2006 with 106K miles. Noticed after making a sharp left turn in a parking lot that the Red Triangle came on along with a beep and the message, "Problem" on the touch screen. Started happening more frequently either when the wheel is turning left or if I'm driving straight and the car drifts a little towards the left if I'm on the highway. Today it happened about 6 times. Warning goes off after a couple of seconds.
View 9 RepliesI've had my R since late mid-summer, and one of the first things I noticed was this clunk sound when reversing into my parking spot and when making an aggressive sharp turn. Usually Left.
After reading multiple threads on this topic, I came to the conclusion that it was my sub-frame and the bolts need replacing. I got in a GB for the tyrol subframe stiffening kit after reading some good reviews/responses.
Today, on my day off, I finally went to a mechanic to get this installed. I just changed my mechanic, and this was my first visit to the guy hes had over 10 years experience at vw and just opened up his own shop. He did a great job, torqued the bolts to spec, made me drive around, do some pulls in 2nd and 3rd gear, reverse forward etc.
So hes about to pull the car back in to retorque and.... CLUNK...
Get in the car, reproduce the sound, get the car back up on the hoist... and at this point I'm expecting the worse. He takes my control arms off, checks the end links...
Brings the car down, and the clunking sound is louder than ever. It was the weathergaurd. When I turned on the wheel it was pulling it out and when I straightened the wheel it was popping it back into place, making a big clunk sound.
This was the exact sound that I was hearing, thinking it was my subframe. The bolts that came out were not stretched or bent out of shape like the ones you see in other reviews. They're actually in great shape. I'm glad I did the Tyrol kit and do not regret it, and I definitely feel a difference when I went into some aggressive turns.
Just had a new issue pop up - sometimes, when making a sharp left turn when the engine RPM is low (going into driveway, turning at a stop sign), the engine will suddenly die. It seems to be running fine otherwise, it does not idle rough, and the idle RPM is around 600-700. It never dies on the highway or higher speeds, yet anyway.
I do notice that my power steering pump is making a little noise. It is an aftermarket pump. The steering assist seems to work fine though.
I recently had the spark plugs, valve cover gasket, and a fuel pressure sensor replaced. As I understand it, the mechanics checked the fuel pump and it was working fine.
So 2 months after my accident I'm finally able to drive again and my car is 100% fixed and ready. Only 1 problem, every time I make a left turn my car makes this weird noise but I don't know what it is. I replaced my suspension and I thought it would take a couple days for the tightness to wear down and for the noise to go away, but of course with my luck it's still doing it. What can it be??
View 5 RepliesFor the last few weeks, when I make a turn (particularly a sharp turn in either direction) I get a "clunking" noise that sounds like it is coming from the front end somewhere. I can also feel it - almost like a gear slipping and engaging again. I am not in 4WD mode when this is happening. It NEVER happens unless I am turning a corner. If I drive straight, it's fine. 1999 Explorer XLT (4 door, 4wd model)....
View 2 RepliesLariat stepside, 5.4L with 150k miles. Loud popping noise, almost a clunk, when making a slow sharp turn. Put it on jackstands and did the normal tire grab and shake and found no issues there. Tie rods, ball joints and sway bar links all seem tight. Looked for signs of unusual rubber to metal and metal to metal wear and found nothing. The only thing I did see was the rubber boots on the upper control arm ball joints were split. What I have checked or if I am missing something?
View 9 RepliesI was pulling out of a parking lot making a sharp turn when all the sudden I lost my power steering. I have a '94 Ford Ranger manual transmission. It didn't make any sounds. I was going to try to keep adding power steering fluid to it and try to get it home to my mechanic in my hometown - but it drips constant liquid when I drive it down the street (you can see drips) so I don't think that's possible. I've read a lot on here about gear boxes failing, but would this cause it to leak even if the truck wasn't running? (the puddle builds quickly when its just sitting there, engine off). I took it to a mechanic (I don't have tools), and they said they can't say anything for sure until they look around, it could be seals or a new gear box.
View 2 RepliesMy steering pulls hard left or hard right, and also seems to have a mind of its own when it turns sharp right or left suddenly, as though someone else is driving. It's very disconcerting when you think you're making a left and the truck veers right.
Today I was making a left onto a bridge and truck kept going straight. I almost hit the bridge. I have an 06 Ford F250 Turbo Diesel. What this could be?
At 120k miles, my 2003 Camry LE 2.4L started to make some noise when making sharp right turn at low speed (below 5mph) going forward. It sounds like the tire rubbing the fender or somewhere, not metallic, and it's periodic, at 2-3Hz or so. It comes from somewhere on the driver side but I'm not sure. The car doesn't make noise when turning at stop or backing up or going straight, and the noise seems to disappear if turning at higher speed (maybe the turn is not sharp enough).
First I suspect the tire is rubbing the fender. But after inspection, no rubbing marks can be found, and there seems no rubbing when the car is parked and the wheel turn all the way to the right. Then I suspect a bad CV axle. But the boots seem in good shape with no leaking grease, and there's no noise when backing up.
A few months ago I had the passenger side Control Arm replaced. Over a year ago I had them both replaced with after market parts. I went into the dealer and was told the reason the parts failed so soon was because the parts were aftermarket parts and that I should have them replaced with original Toyota part. When the passenger side failed again, I had the dealer replace it with an original Toyota part.
Here's the problem: after they replaced the one side with an Toyota part I took my car and immediately when making a sharp turn to the right the vehicle making a jerking motion. It was unnerving the first time. It felt as if the vehicle might turn over. I noticed that this only happen or mostly happen when making a turn to the right.
Also, as I'm accelerating the vehicle will pull to the right the abruptly jerk to the left. What I was told by the dealer is that scene replaced the one side with a Original Part and the other side was an aftermarket part, the two not being of the same quality were what I felt he was saying that the parts were slightly different in size and would cause this problem.
I have 35k on my 2009 camry, (past warranty). All of a sudden in the last few days when I make a sharp left turn (like into a parking spot) I hear a grinding noise from my car. Not really a full on grinding, but like a quiet fart can muffler noise. No issues with alignment, driving straight, or sharp right turns.
View 5 RepliesI have a 2013 Santa Fe with a 2.0T. A couple of days ago, I heard a squealing noise when I make a sharp turn to the left, like maybe a power steering belt would do. This has continued and I have also noticed that the AC fan almost completely dies at the same time. Car has 6,000 miles.
View 3 RepliesWe have an '07 wagon that recently started exhibiting the following: When doing a sharp turn left or right you can hear a rotational shhhhusshhhing sound... shussshhh *pause* shusshhh *pause*.. etc. Its obviously linked to the front wheels since going straight does not produce the sound. Brakes and rotors have 13k on them; dealer has checked out the car and says everything looks good and the bearings are fine.
Could this be CV joints or something similar? Where to look? This is not a thud thud thud (which I have heard before when another car of ours needed new cv joints). Safety is main concern, don't want bearings freezing while driving..
So four lanes, divided, with a left turn lane, five lanes at the intersection. I'm down ~15 mph, maximum turn speed and one car is just clearing intersection and and +100 yards from next approaching slug of traffic. Keeping the speed, I make the left turn confident no problem then halfway through turn:
feels like a soft tuck
traction light flashes
already to straighten out
everything normal
This is the second time I've seen this in a year. Pavement dry, 48 hours since last rain; ~8:00 AM so rush hour is on. Before doing some parking lot tests, any clue about how to replicate?
My dashcam SD card did not play.
2004 PSD 4x4 72k. I thought I would be proactive so I bought the front ball joints and have plans to install them but recently I starting hearing (and feeling) a clicking sound in the front LEFT when I make sharp turns to the left and hit small bumps now and again. I jacked up the front end and am able to get 1/4" of movement front to back (top to bottom so not steering) in the wheel.
I narrowed it down to the hub. I took it apart and it is most likely a sealed unit so no adjustment is possible....that I can see.I pulled out the locking hub and got as far as I can to know there is not an adjustment. Need to confirm that it indeed is a sealed bearing and if so what are the part number(s) I may need to repair it.
2012 F250 left turn signal on all the time no right turn signal.
View 2 RepliesJust noticed a new sound. When making left turns only, a sound comes from the right. Sort of continuous high pitched. What is wrong?
View 12 RepliesThe other day I hit a good size bump at speed, slightly bent a wheel which I didn't even notice at first. The car drove straight and had no other symptoms, thought everything was okay. A couple days later I heard a weird grinding noise while making a left hand turn, it was so faint I honestly thought it was the fender liner. After the noises continued and further examination I noticed that the carrier is rubbing the rotor on the lower drivers side corner.
View 1 RepliesFor the last few months, I have been chasing down steering problems. Alignment, end links, ball joints... and now, humming. Every time I take a turn that requires more than 1/4 turn of the steering wheel, the car hums. It wasn't very noticeable at first, but over the last week it has gotten much louder.
I have topped off my PS fluid and replaced my belts, but this has not solved the issue. Before I start replacing a pump and/or a steering rack.