Ford - Crownvictoria :: 1998 - Slight Vibration Last For About 5 Seconds?
Jun 28, 2014
About 2 yrs ago there was a slight vibration in the car, it would happen every couple of months and last for about 5 seconds. It has gotten progressively worse and now happens quite often. There is no pattern as to when it will happen, when I first start the car, in park, neutral or driving. The vibration is the same at hwy speeds as it is at idle. I only have 111,000 miles on the car. I have been told it's anything from the torque convertor/transmission to the IMRC.
View 4 Replies
Advertisement
A few days ago the head lights and all inside lights would flicker and go off for a second or two while I was driving at highway speed. Thee flickering stopped when I slowed down. Yesterday the car would not start at all. The motor is turning over but not catching. Also only the radio work but not the sound system. I put in a new hi-output alternator but the car still will not start. The car has 155,000 miles and generally runs well. How to repair this?
View 3 Replies
I am experiencing a slight rumble-strip-like vibration/noise when veering to the right. There is no noticeable vibration when driving straight or to the right - sounds like it's coming from the front. I thought it was my tires but had them rotated with same symptoms/ I first noticed this shortly after I had them rotated in July. So it's probably front suspension.
View 3 Replies
my car is FORD C.V. at 50+ mile/h. starts slight vibrating. did alignment and leaded front tires, but no success.
View 3 Replies
I have had a minor vibration above 50 or so mph(by speedometer). Installed a new driveshaft and corrected the pinion angle to near perfect. I have OEM 4.30 gears and 33.4" tall tires. I had to retune motor/PCM and one of the options while installing the new tune was tire revs per mile.
I input 620 and pressed on. Now my slight vibration is gone. Even at a corrected 70 mph it's smooth. I'm a little baffled, as I do not understand how a tire diameter correction in the PCM could affect the drivetrain?
View 5 Replies
I've got a 2003 f150 with the 5.4 and 128,000 miles with an engine tick. Its not an exhaust leak I know that for sure. It has came up in the last 20,000 miles. I've used motorcraft 5 20 w/ motorcraft filter. I've tried a kreen engine treatment with no change. Heres the description/syptoms:
-Slight clatter for 2-3 seconds upon cold startup (happens very rarely)
-top end ticking that is loudest and most noticable when warm (quieter when motors cold)
-not timing chains/tensioners etc because the noise is coming from the top end and most noticeable on the passenger side.
-at idle the tick is present-when you rev at idle, the noise goes away.
-Driving (or having the engine under any load for that matter) the noise gets louder.
-Anytime I accelerate, tow/haul, go up an incline the noise gets worse
-Sounds like a "whirring" sound from within the dash.
With all that said I am thinking the lash adjusters are getting noisy. I had a certified gm tech that has 40 yrs mechanic experience under his belt and builds prostreet muscle cars on the side look at it. He listened to it to it and that was his diagnosis as well as its not that bad so just live with it. The noise at idle doesn't bother me, its when im driving with the windows down. The noise drives me crazy and is a little annoying to me.
Heres a link to a video of the sound and keep in mind it is much louder now : Triton engine noise/tick - YouTube
View 6 Replies
I haven't really gotten under it to check this out, but my truck (see signature) has a slight vibration on take off. It only does it when the wheels are turned to the right or left. They don't have to be turned very far either. It doesn't do it on straight line take offs, or on a take off from a rolling stop. ONLY when pulling off from a dead stop and the front wheels are turned any degree to the right or left. I'm running mostly bald all terrain tires, the wheels are not bent. My current wheels are new to the truck, and the problem was there with the previous rim/tire combination. The rear end doesn't seem to have any slack in it. The transmission shifts like a top. There are no other clanks or vibrations anywhere in the drivetrain and it drives good.
View 9 Replies
Iv got this escort from my sister, i assume it has been hardly maintained considering the... state. I bought it because she was tired of dealing with the problem... driving, it will turn off. She said it got to the point where she just stopped driving it, although it only happened twice. It began when first time it shuttered then died. Took air filter off and it only ran it like that to get it home. Now it doesn't run but for a few seconds even without air filter, so Its the best choice to leave in.
Anyway, I've replaced:
-PCV Valve
-Fuel Filter
-Some dry-rotted hoses
-I didn't replace it, but i cleaned throttle body and MAF sensor in the intake.
I've tested alternator and batter, both are good. I tried fuel treatment. Being honest this is the extent of my.. automotive understanding. But Im fairly certain it is a fuel system problem.
View 1 Replies
Just bought my 2013 Ford F150 Supercrew 4x4 on Saturday. I noticed a vibration at 35 to 45 mph. Its a slight vibration, the whole truck kind of shakes. Really annoying for a truck with less than 200 miles.
View 14 Replies
I recently sold me 91 F-250 and got into a 98 F-150. It's a SuperCab 6.5' bed, 4x4 off-road, 3.55 gears, 5.4 v8 auto. I love the truck, but I am having an issue with a noise at startup.
Every time I start the truck it fires right up but it makes a grinding noise AFTER it starts for about 3-5 seconds. I thought the starter wasn't disengaging in time so I replaced it. The starter I took off was fairly new. It's teeth had just a little wear and the flywheel had no visible wear. I put in the new starter and there was no change at all.
I also changed the oil and filter using Motorcraft 5w-30 oil and a Motorcraft filter. I also started it without the serpentine belt to rule out a pulley bearing. What the noise could be? The truck runs absolutely excellent, by the way.
View 5 Replies
I bought this Ex a little over a month ago and finally got around to replacing some stuff.
I have a slight vibration between 50 and 60 MPH. The vibration is the same weather I am accelerating, in Neutral, Coasting down (well, a little bit worse when coasting down), in 2WD, in 4WD, turning, going straight, hot or cold.
I have replaced the following:
Rear Driveshaft U-Joints
Tires and Rims
Upper and Lower Ball Joints
Wheel Bearings
Steering Stabilizer
Cleaned and Greased the Hubs
Greased everything greasable up front
I still have the exact same vibration as when I started. I can feel the vibration in the steering wheel as well as in the body of the vehicle. I am thinking that it may be in the steering linkage. If there is a loose joint then the wheels would be allowed to jiggle a little bit. I am at a loss. What else should I check?
Also, When doing the ball joints, I noticed that the tie rod ends were quite stiff. How stiff should these be? I can't move them by hand, but they will move a little bit when moving the free end of the tie rod.
I am taking it in for an alignment on Friday, and if I can't figure this vibration out, I might have them take a quick look into it. Would a stuck slide pin in the front brakes do this? Both sides on my truck are seized at the current moment.
View 14 Replies
Sitting at a light. I noticed a slight vibration while in gear. Get home. Put her in park and noticed it again. Took her for a spin again. It seems to do it at low speeds, cruising and goes away once I'm on it? What would be a good starting point to track this down?
View 2 Replies
With normal acceleration my ex up shifts at about 50-55 mph and makes a shuttering noise and has a slight vibration briefly during the up shift. Could a tranny fluid change work?
View 14 Replies
Have a 99, ext cab, 3.0 , 5 spd man. 125,000 on it. I know the clutch will need replaced shortly but so far it is still functioning with out the slipping. Although I can feel a slight vibration, or buzz when I up shift. My immediate concern is the clattering/rattling. say at idle, not moving with the clutch pushed in when I shift into 2nd and 4th gear it really rattles loud. I can only assume it is some bearing inside the transmission, but need to have a bit more surety as to the problem. I know, I need to do the clutch however i don't know if the transmission is going bad or is that noise in the clutch area.
View 2 Replies
It feels like I am having a front bearing issue, when turning the steering wheel to the right I feel a slight vibration in the steering, need to know which one is going out,??? I have already replaced the passenger side twice It just seems to not tighten completely as I can still move the tire slightly while up on a jack...
View 12 Replies
i have a 04 f150 2WD I've been noticing a slight vibration on initial takeoff, it only lasts for a couple of seconds then it goes away. I have the "non serviceable drive shaft" the u joints are staked into the yoke. there is some up and down play where the drive shaft goes into the transmission extension housing. Does that play is normal or what may be causing the vibration?
View 3 Replies
Over the past month or so my wife and i have noticed a slight vibration or? I don't really know how to best describe it other than a feeling. The truck has developed this feeling thru the steering wheel and pedals. The best way i can describe it is like a bearing going bad?
It is full time awd and I am assuming it is an awd issue. The truck has about 60,000 miles on it. It can be felt at all speeds. I rotated the tires with no change. My next step would be to go thru the front end, ball joints, tie rod ends, etc. But I really don't think the issue is in the steering. the truck drives straight and no steering vibration.
View 3 Replies
I have a 2010 Explorer XLT that I bought in 8/2012 with 7,000 miles on it. I had had a problem with a groaning noise and slight vibration starting at 34 mph, under load. I don't hear the noise if I let off the gas at 34. I hear it a little past 35 or so and it doesn't seem to groan again until about 60 mph or so. I also have a feeling of the all wheel drive engaging when I back out of the driveway, put it in drive and turn the wheel slightly.
I took it to the dealer this week under warranty and he calls me today and says the tires are worn differently all around and that is causing the problem. He says the tires could be out as much as, or as little as 1/16 of an inch and that is what is causing the all wheel drive to catch and also the groaning noise. I understand what he is saying, but I can't believe that is the problem or more would have been written about it.
I asked the guys about rotating the tires and he said it would not matter, it would just take the problem from one end of the vehicle to the other. These tires are not worn like the truck is out of alignment, it is just normal wear. It now has about 21k on the odometer. What do you all think of this diagnoses? The guy says the PTU thinks it needs the all wheel drive and therefore engages it. This truck can also be manually put in 4 wheel drive by flipping the switch.
View 14 Replies
New, 2 month old 2015 CC, gas 4x4 with standard bed. At 50-55 I have a rolling vibration, or it can even be explained as a slight growl. Seems worse since I upgraded to 285/75/18 Toyo AT's and new wheels. If i speed up to about 60, goes away. If I pop it down to 5th gear, it seems to go away, however, I need to try this a few more times to make certain.
View 9 Replies
I have an 08 F250 supercab 5.4L that I bought this past July. The truck has 153000 miles on it now it had 150000 when I bought it. I don't drive it every day just usually on weekends and when I need the truck. The truck was really well maintained and had all the work done at a local ford garage. I live in western pa and lately it has been pretty cold and snowy so I have been using the 4x4 more than I normally would the past few days. My wife was driving the truck the day before yesterday and had it in 4x4.
The past 2 nights it has been really cold right around 0 degrees. I drove the truck yesterday and it just didn't seem right when I first drove it almost like there was a tire going flat or a flat spot with one of the tires. I got out and checked and everything seemed ok but it was still doing that. I saw that the passenger side hub was still locked while the drivers side was on auto and I was in 2 wheel drive. When I got home I sprayed the hubs down with PB Blaster and tapped on them with a rubber mallet. I put the truck back in 4x4 and drove it down my road to the end then put it back in 2 wheel drive and reversed down the road. When I got back into my driveway and checked the hubs were both in auto so all was good. T
he only thing now is when I am driving everything is normal but when I start to brake or decelerate I get a humming noise like you would get with off road tires on the highway. I wouldn't say that it is that loud but definitely noticeable and there is a vibration in the floor in the front along with the humming. When I am going really slow decelerating you can also hear a noise similar to if you would spin one of those wheels with the metal pegs at a carnival or something to win a prize.
View 6 Replies
Noticed my 2002 F150 had a very slight vibration in the seat / steering wheel when cruising down the highway at 60 MPH.. Very slight, but was not there 2 weeks ago.. It seem to get a little worst as the 2 weeks progressed. Got all 4 tires balanced and rotated... no luck...Took both rear wheels off-- no problems with tires -- checked bearing clearance-- pushed and twisted on driveshaft yolk to check pinion bearing... nothing found......... last resort was drop back end of driveshaft and check U-joint.. It was tight and dry. Put drive shaft in 12 ton press and pushed out the u-joint bearings. Very dry and joint pins were starting to spall....... I mention this because I had checked " clearance" and "slop" and had "no noise" before removal... Truck has 139K miles on original u-joints .......... Something to keep in mind. Eventually it would have worn to the point that it was obvious, but in the first stages of failure, you just get small symptoms.
View 7 Replies
