Ford - Aerostar :: 1988 - Suddenly Engine Dies / Electrical All Works But Won't Turn Over
Apr 30, 2013
My 1988 Mustang 5.0 GT has stalled out once last year and again recently. Same situation. I drove it for 300 miles with stops about every hour and a half. Pushed to to 90 MPH at times. Ran fine other times on the road for more than two hours. But all of a sudden the engine dies. Electrical all works but won't turn over. If I sit in it for about 10 minutes, it will start and run for the next 5 to 10 minutes than a cough or two and pull over. I have had new plugs put in and also replaced the whole distributor. Ford mechanics have stared at it and scratched their heads and say it is running fine when they hand it back to me.
View 2 Replies
Advertisement
I jump started my wife's mini Cooper using my aerostar van 3.0l cargo. Her battery was so dead we had no luck after running my van for 8-10 min. There were a couple of attempts. My van suddenly died when she wasn't cranking the mini. It won't restart.
About one week prior I had a no start situation. I thought I had solved the problem. The first thing I did was listen for fuel pump engagement. I didn't hear it. I pulled the fuel pump relay and cleaned the connections. I put it back and the van started. I drove all week and then I get the call to jump start the mini.
So back to today. Fuel pump is engaging. I checked for spark at #4 cylinder with fuel relay disconnected so as not to flood the engine. I have spark. Battery is strong. I put a new fuel pump relay in place even though it appeared to be working properly. I had my wife crank the engine and the pink/blue wire at the fuel pump relay which goes to the pump lit up my voltage tester. Power appears to be present when cranking and not just initial engagement.
I'm thinking the original no start had nothing to do with the wire connections which I cleaned and it was just coincidence that it started and ran again for a week. The connections are now clean with a new relay attached and not starting. I'm thinking if I have spark and a fuel pump engaging then injectors may not be firing???
View 3 Replies
Yes, I have photos of this, its possible, I did this twice!
View 14 Replies
I've got an oddball '88 SWB with the M5OD transmission. Since I've had it (about a year now), its always required a lot of gas to get it rolling without it stalling after sitting overnight or during the day at work, especially putting it in reverse for the first time. The shifts have always been a little choppy/jerky/grabby/whatever you want to call it, too. Mostly going into first from a stop, but you can feel it other gears too, especially if you're not flooring it.
Anyway, it seems to have gotten worse and I'm getting to the point where I'm looking at a cause. One thought I had was oil contamination on the clutch discs, I know this will make a clutch feel "grabby". There is some sludge accumulation between the trans and engine, and it appears I may have a very slow leak there.
I have to change the trans fluid this weekend and am wondering if there's anything I should inspect while I'm at it -- I don't know a whole lot about the clutch system on this van and there's next to no information on it. Frankly, I don't even know if its hydraulic or cable.
View 14 Replies
1994 Econoline E350. All the other lights work but on the front right the turn signal light flashes but the Hazard lite will not flash. I check for power at the wire at the light and there is none.
View 6 Replies
I installed LED tail lights a few months ago, now all of a sudden the passenger side does not light for brakes or turn signals. The lights came with resistors that I put in when installing and the adhesive wore out and they were dangling in the truck frame. The wires connecting the resistors to the light were damaged. I taped the exposed wires and secured them a with a heavier tape, but taping did not work. I also tried switching the resistor packs with the driver side to see if it was them that have an open winding, but they are still operable.
I narrowed it down to wiring between the trailer hook up and passenger light assembly in the electrical circuit. I plugged an LED light bar into the trailer connection and the same problem occurred (running lights come on, but no turn signal or brake light). Where could there be a short? Or is this circuit fused somewhere that the running lights come on but a separate fused circuit triggers the higher voltage for LEDs.
View 9 Replies
I also tried jump starting - get same same result. Engine cranks, turns, and then sounds like it is just about to start up normally but it just dies completely. It seems to want to start but just can accelerate the engine high enough to keep it running. Almost like it's flooded on a carb motor.. 2000 V10..
View 7 Replies
I have a 94 EB AWD I am restoring and have recently picked up an 88 EB to restore as well. The 88 did not run. Here's a list of things done.. New head gaskets, new fuel pump, full tune up, radiator flush n fill, oil change, new transmission and rear seal, new battery, new iac valve, many new lights etc. Well here's where your expertise may come in.. the van starts and runs fine for the first minute or two, but when stopped at red lights the van wants to stall.. and while idling actually has stalled. I was going to replace the MAP sensor as I have found that sometimes causes idling issues. I assume the 88 does not have the MAF sensor to clean/replace? Any other things I could check before heading to the vaccuum lines? Also, both power mirrors are inop, the horn is inop and the gas gauge reads CO. I will check the fuses for those problems..
View 4 Replies
Ok all.. been working on the 88 getting it running (3.0L EB 2wd). It does run now pretty well.. definitely need some suspension work.. but that's a different post. I have had the rear main seal replaced and the oil pan gasket replaced to stop the oil leak. There is a lot less oil on the ground now.. but still leaves spots on the street. It appears oil is leaking down the oil pan from above and dripping off of it to the street. I also had the main cap bolts replaced (one was broken and the end was in the oil pan).
View 14 Replies
I took the 88 out yesterday (3.0 with rebuilt transmission).. it looks like there is transmission fluid on the back (spots all over it).. I can only assume it's transmission fluid... I tried to wipe it off... but it was kind of a mist.. I assume the modulator should be checked? I'm not sure where it is or what it looks like though...
View 14 Replies
My `88 Aerostar needs a replacement steering column. I believe everything can be swapped over therefore color of steering wheel does not matter. Cruise control buttons and tilt are a must. I would like to find one that is tight(er) and not sloppy floppy like mine is slowly becoming (143k miles).
View 1 Replies
I have a 2003 Toyota Corolla CE manual transmission with 431,000 (not a typo) miles on it. About 7 weeks ago I noticed that when I turn on my high-beams after driving for awhile, the car dies for a few seconds. All lights go out, radio stops, engine stops and then it starts up again as if nothing happened. It will just do it once in about a half-hour time frame. I can switch the high-beams on and off repeatedly afterwards and it doesn't do it again. I have to drive for about a half-hour before it will do it again. I usually hear a slight pop sound when it does it.
A month later I noticed that if I parked it after driving for awhile, like at a gas pump, and get back in it, it acts as if the battery is dead for a few seconds. If I step on the clutch or open and close the driver door, the car comes back on. It appears that the battery was disconnected. The CD pops out of the player and all the radio station settings are gone. One morning last week I got in, and it had happened during the night. The CD was out, station settings gone, and the clock was 6.5 hours off.
I have had the car to a Toyota repair center 3 times. They have checked fuses, battery, battery cables, grounds, alternator, tensioner, looked for rodent nests, squirrels and I don't know what-all, etc. They can't find what is wrong. I am scared to drive it, but I depend on it. I commute 200 miles/day. I won't leave anything important in the car because I am afraid it will catch fire. I am scared I am going to have a wreck, too, with no lights and no power steering suddenly.
View 6 Replies
I have an 88 EB, and every time I fill up the gas tank and park on my driveway (slight incline) gas leaks from the top of the tank. 3 different mechanics have checked it out completely and say there it nothing wrong - including the dealer that totally topped off the tank. Does this sound like a fill line to the tank? It only leaks until the gas gauge goes down a notch....
View 14 Replies
My mom has a 1988 350 Econoline van chasis that is a motorhome class C.
The front heater/AC blower motor only works when it wants to. It starts very intermittently and then shuts off then you go down the road a little more and it comes back on, it will do the same thing sitting in the driveway just idling. There is no timing it, it just turns on when it wants to and then back off again.
I checked the fuses and the fuses are fine. The blower motor when hooked up directly to the battery blows fine. When it isnt working of course there is no juice going to the blower motor through the hotwire of the blower motor, I have checked this with my volt meter.
I did replace the switch that turns the blower on in the dahs, and it didnt do the trick.
View 1 Replies
I am at my wits' end with my 98 Honda Civic LX. The problem starts around late summer of last year. It is sporadic, so I didn't quite pay attention until one day the engine died on the highway after I picked up the kids at the school. It didn't make any sound nor giving any warnings, just suddenly died. After that highway episode, it seems like it just taken its own fancy schedule as far as when to die, so to say. In a given day, it could 4 episodes in a day. Then it runs perfectly for some weeks then it starts again and went away again.
It just quietly dies while being driven. I had to turn it completely off, wait for some moment and try to turn it on again. Sometimes it just turns on again without me being frustrated and there were moments when I had to do several attempts. Once I heard clicking sound before the engine died, only once, the rest makes no sound at all. No lights are on.
View 8 Replies
I recently attempted to change out the clutch on my bug for the first time. All went well right up until I tried to start it. The starter kicks over, all the electrical works, but for some reason she's not firing. Upon removing the spark plug i found out there is no spark. The plug cables and plugs themselves are brand new, so I'm guessing that's not it.
View 7 Replies
I have a 2004 freestar that cooling fans come on when engine gets to temp but not when I turn on ac it has 5 relays for the cooling fans and they run in series and a dropping resistor. Ithink someone replaced #2 relay with the wrong one and has caused my problem because they did not know what they were doing...
View 3 Replies
My Grandpa has an 88 Ranger 2wd with the 2.9l V6 and a 5 speed, I believe, M5od. I was driving down the highway when I heard a noise. I tried throwing the tranny in neutral but when I pressed the clutch pedal in, I had no pedal whatsoever. Engine took awhile to restart. It'd turn over a little almost as if a rod was bent or something of the sorts. Eventually the engine started and would stay running as long as the clutch was pressed in (disengaged).
The engine dies no matter what range the transmission is in,neutral included unless the clutch pedal is depressed. It Will die when the clutch is released in any gear with no forward movement that is noticeable. I can spin the tail shaft with the driveshaft installed and all gears in neutral but the input does not spin at all. Input shaft wont spin at all, period. I originally thought the slave cylinder was KIA but now I am very confused on what the problem could be? Is there a bearing the input shaft rides on that may of seized?
I pulled the tranny last night and took the top cover off. Yes, I made sure it was in neutral when I removed the cover. I can manually shift the collar to all gears by hand, 5th and reverse included. I'm stuck between a rock and a hard place here and where to go from here. I have bought a new clutch assembly and slave cylinder. This truck was bought by my Grandpa brand new in 1988. It has 98,000 miles and everything is original. I did forget to mention that there was very little oil in the trans when I drained it and it appeared to be gear oil vs ATF.
View 3 Replies
I have a 2000 7.3 f450 having some electrical issues. When you turn the key on sometimes the dash will start ticking and left side light flashing...engine will turn over but it won't start. The ticking is coming from under the hood relay 32 (you can hear and feel it clicking). Book says its injector driver module power relay. A lot of the times it will start fine other times it will be running and just die (prob because of this issue) happened once when I was driving.
What to check here already replaced the relay still have the problem.
View 6 Replies
I got my first truck today and it's a 1988 Ford F-150 and it runs great! The only issue is that the speedometer doesn't work and I won't be able to register it until it does. I was wondering what I can try out to maybe fix the issue and if not, how I would replace it. Every other gauge works, it's just the speedometer that isn't. The needle doesn't move at all it just sits at a 0 all the time.
View 8 Replies
I have an '88 E-250 with no power to accessories. Was starting fine but now no power to anywhere but the ignition light that is below and to the left of the steering wheel. No headlights or radio. Checked my fusible links but just visual so gotta get the meter out there and start poking around. Only thing I did different before it started this was take loose the ground wire holding strap that holds the middle of the ground wire to the body but I didn't think this was an actual ground spot but I could be wrong.
Earlier I reinstalled that strap and took out the ignition switch. I noticed that the radio turned on when I turned the key to acc. but not when I turned it to run. Would the headlights run through this ignition switch on the column? I have power to the yellow wires coming into the switch and the ground is good. I checked the fusible links I could find out in the engine bay and all tested good but could've missed some. Fuses in the box looked good but don't know if there is a master fuse box for bigger fuses but I don't see one.
1988 E-250 5.8 auto.
View 9 Replies
