Electrical-wiring - Honda :: Hesitating When Started To Drive
Jul 31, 2011
My 1995 honda passport ran great until a couple of weeks ago. I moved to North Carolina, and it sat for a few days as I was unpacking. When I started it back up, sometimes when I hit the brake, the lights on the middle dash come on for a split second, then go off. Also, my winter and power drive buttons don't work (anymore). As of yesterday, the lights didn't come on when I hit the brake, but it started hesitating when I started to drive.
View 4 Replies
Advertisement
While my wife was driving tonight the VSA light went on, the emergency brake light went on, and the "D" for drive was flashing green. She stopped the car and called me. One the Car was in park, it would not go back into the Drive, and it continued to flash green. I've tried pulling fuses, disconnecting the battery. The other issue is that The hazard lights will not work and the turning blinker will not function. I have determined its an electrical issue. Other than that I'm clueless.
I popped the button just below port just below the shifter and manually put in drive and drove it home.
View 5 Replies
So I get in my X today and she fires right up as usual... Then the battery light started blinking then stayed on... Then I hear a click and all my stock gauges go out my window and lock switches don't work and my radio doesn't work... Battery light stays on and all signals work as do the mirrors and everything else... I turn the truck off then back on it all comes back on.. 15-20 seconds later I hear the click and all the same stuff is off again.... No seemingly applicable fuses are blown... And the behavior is repeatable...
View 4 Replies
This morning, while looking into why the front drive wouldn't engage, and moving the plastic cover over the battery out of the way to check for any vacuum issues, the positive battery post cable to the battery post moved. There was some fluctuation engine-wise. After I shut it off and tightened down the cable, re-started the truck, and continued looking for vacuum leaks, a few minutes later the truck died.
What's been done thus far, re-checked battery connections, checked in-line mini fuse-20amp, checked both mega fuses-power both sides of each, checked 10 amp #4 in cab fuse block, removed alternator and took for check-checked ok. Would there be something else that would trip if there was an abrupt dis-connect from the battery with the truck running?
View 10 Replies
I have a 2004 Honda Civic, and my phone and my Bluetooth unit are (sometimes) plugged into the cigarette lighter (euphemistically renamed the 12V Power Adapter). Problem is, when I shut off the car, the power adapter shuts off, depriving my phone and/or Bluetooth unit of a sometimes much-needed charge. My Suburban keeps the adapters on even when the power is shut off, and I love it.
View 9 Replies
I have a 2008 Honda Accord that about 4 months ago the drl light on the dashboard would come on for a few seconds and then go off. This happened 2 or 3 times a week. During this time the driver side drl light would also quit working. A couple of weeks later it progressed to the drl dashboard light would come on, then the tpms dashboard light would also come on. After an intermittent period of time (seconds to minutes) the icon showing low tire pressure would flash for a second and the drl light and tpms light would go off. This happened maybe 3 times in a day, then not happen again for a week or so. Air pressure in all tires was correct. About week ago it progressed to the drl dashboard light and the tpms dashboard light stay on all the time and neither the drl light (drl mode or high beam or will work on the driver side. In the past few days the low beam on the driver side has also quit working.
View 1 Replies
So my Honda Civic has been flashing my check engine light, which is telling my my cylinders are misfiring. I checked the ignition coils by removing them while the car was running and cylinder 2 and 3 I can remove and it doesn't change how the car runs. I put a new ignition coil In and that doesn't work so it isn't the ignition coils, what it could be?
View 8 Replies
2003 SCrew, 5.4, auto, 4x4.... Yesterday my left turn signal started flashing fast; checked and the front was not flashing. Picked up a new bulb, changed it, didn't fix anything.
I've tried:
-tilt wheel up/down in all settings-no change
-checked the wiring at the top of the column; still good and solid.
-swapped the bulbs left to right and vice versa-no change.
-swapped the sockets left to right and vice versa-no change.
Other info:
-the left front is the only one not flashing with hazards on.
-all original equipment, except I removed the stock side mirrors (w/signal) and installed manual trailer towing mirrors, but that was 2 or 3 years ago.
-the dash indicator light for left turn (arrow) does not come on at all.
-last trailer tow was over a month ago and all was good.
I ran out of daylight last night and at work now so I would like know which Fuse, Flasher, Relay, etc., I should check/replace and where to find them on the truck; under the hood (1st or 2nd stack of the fuse blocks); under the dash above the pedals; steering column???
View 5 Replies
While driving I turned on my headlights and my car became possessed. My warning lights started to flicker on and off, my car was dinging out of control. The speedometer, gas, and RPM gauge went to zero. My brights light would not come on. My dinging for the lights being left on, or the key being left in the ignition, after the car is parked, and the door is open, will not go on either. I turned my lights off and all was well. Turned them on again and the same thing happened.
Now, the following day, it is doing this periodically every couple of minutes while I'm driving, whether the lights are on or not. My radio and head lights work fine. I checked all my fuses and they all seem to be AOK. I disconnected my car battery and reconnected it to see if it would reset and it still did the same thing. One other strange occurrence. The last month or so while I've been driving my battery light came on for a few minutes. I had the battery checked and it is not bad. Then last week my gas-cap warning started to randomly appear. I changed my gas cap, and guess what.....it still came on, at random.
View 1 Replies
So heres the deal 1989 civic dx hatchback 106k on the odometer automatic 1.5l d15b2 engine . It's been having delayed starts taking 3 to 6 cranks before firing up then running fine, suddenly it dawned on me maybe it was the distributor , so I swapped it with a spare I had because sure enough the old one had red death red dust in the cap. Cleaned the contacts set the timing reassembled, some wires broke on the back of the wiring harness to the distro. Rewired them, the car kept getting worse I jumped it and took it to my friend a vw mechanic it drove 49 miles there fine after the jump, new plugs new wires new fuel filter we did the wire job set the timing checked the timing belt got the battery tested and the alternators new and did a oil change also did a coolant flush a few weeks ago.
It started right up drove it back to Chicago , in the morning I was getting off the highway it stopped running no noises I pulled over 8 cranks later it started parked it 3 blocks away, went to test drive it when I stopped at a light it shut off cramming it and hitting the gas pedal got it to start drove it a block down it shut off at a stop sign and I parked it. What it is I'm throwing code 8 which is a top dead sensor which I think is in the distro which I replaced a month ago. Fuel pump sounds like its priming but you have to gas it and crank it to start it which is odd for a automatic , it is girk injected is this tds sensor going to do that by itself? Or could it be a ignition module? ( what I read online) starter? Main relay , fuel pump switch?
View 6 Replies
2005 Honda Accord. I have been experiencing a loss of electricity to my dashboard - the radio cuts out, tach and speedometer needles drop, sometimes warning lights come on. I don't think I have experience a loss of power with this but when it happens, it lasts less than a second.
I can go days of driving without issue. Then, in one drive it may happen four or five times. I hate the idea of taking it into the dealer on an intermittent electrical issue. That could be a real bank drain.
View 6 Replies
I have a 1997 F250 that I am fixing up. The issue is this... The dash lights now flicker off when I place the transmission in Drive position. I can slightly move the slack in the gear selector and the lights come back on. When the transmission is in Park, the dash lights work correctly. Not sure why there is some type of switch to control the dash lights buried within the steering column?
View 2 Replies
My Honda has a strange problem that is vexing my mechanic. While I am driving, the engine spits and sputters and sometimes dies. I try to restart and it starts right up but runs rough. Sometimes it takes a while to start back up. If I wait a few minutes, it will start again and drive fine for a while. Then it will do it again. After it is warm or when it is cold at the start, it won't do it.My mechanic cannot get it to do it long enough to diagnose. The computer is not throwing any codes. I believe it is electrical because when it does this, the speedometer goes crazy bouncing up and down. Electrical problem also may explain why the computer is not throwing any codes. I need to narrow it down because my mechanic is reluctant to start trying things as I don't have a lot of money to throw at this.
View 4 Replies
Yet again my honda is doing some new. My mid dash lights don't come on at all anymore (even when i start the car), my power drive and winter drive buttons don't work, I can't stop/start on a hill, I have to get 2rpms going to get anywhere, and my battery volts are over 12 when driving.
View 1 Replies
My car is a 1998 Honda Civic. The left turn signal blinks at double speed when the headlights are off. When the headlights are on, it blinks at half speed. Should I replace the left-sided bulbs? Or the turn signal relay? Or something else? None of the bulbs are out in the front or rear.
One other fact: If the hazards are on with headlight OFF everything blinks in synchrony. If the hazards are on with the headlight ON the front blinkers flash alternating (left-right-left etc).
View 7 Replies
I have a Honda Odyssey with 154000 miles on it. In February it started to slip when putting it into drive. I thought this was due to the cold snap. The slip/delay grew until it would disengage from gear when driving. Eventually it was not safe to drive and I had it towed to a transmission shop. They have replaced the TCU, the torque converter arm & the transmission & the ring kit. He has told me that he won't charge more than he originally quoted me, but when I went out there yesterday nothing had changed (it was still on the lift with the exhaust & undercarriage on the floor) since two days prior when he told me it would be done on Friday. Do I have any recourse, and how do I make him finish this job?
View 3 Replies
I am a beginner when it comes to anything involving wiring. I am looking to re-wire all of the wiring coming off of the instrument cluster gauges. Once I have completed all of the wiring on the gauges, I may feel confident to move onto something else. As of rite now, it appears as though my truck is still running on all of the original wiring, and over the past few weeks, I have been having many wiring related issues. I found a schematic that includes the wiring for the gauges that I am going to go off of. I have a couple of questions before I begin.
1.) On the schematic, it shows connectors such as "Connector G" which is moving all of the gauges wires to there locations. Do I need to use a specific Ford connector, or could I purchase a new connector at any hardware store that carries them? As far as I am concerned, connectors do the same thing as all other connectors. (Let you connect and disconnect for easy instrument cluster removal.)
2.) I am not looking to purchase one of those expensive wiring harnesses. I would like to just purchase some wire that I can cut / use myself. What brand / type of wire should I be looking to purchase? I do not care if it is striped / colored as I will use wire tabs to name / label each wire.
Other than that, I feel confident enough to attempt something such as this. Here is the wiring schematic I am going to use.....
View 10 Replies
Any COMPLETE headlight switch wiring diagram? Everything I find online only shows 2-3 wires in each sub connector, nothing with all wires and colors, and what they do. and of course the factory service manuals no longer work on my new computer. the switch and associated wires went up in smoke 2 hours ago, and this truck is my only means of transportation rite now. what i need is headlight wiring with colors so i can temporary hook up a toggle switch to have lights until the new switch and connectors come in next week. I went to pull the switch and connectors out of the parts truck, but of course that does not have fog lights so it uses different switch and connections.
View 14 Replies
I plan on moving the engine/drivetrain from my 1986 F350 460 to my 1996 F250. I also want to move over the 1986's ignition system with a Duraspark 2 setup.
Although I could just cut in the easiest places to remove the wiring for later reuse I am looking for where to make the cuts, what to take and what to scrap. Alternatively I am also asking if there are aftermarket or OEM replacement sets out there are aren't a ton of money. The current harness in the 1986 has been sprayed with engine oil and cooked for 27 years so I am looking at alternative options if there are any.
View 8 Replies
I have a 97 F250 HD. Wiring the rear tail lights. When we bought it the had cut off the wires going to both sides of the rear lighting assemblys and I was wondering what wire went to what i have the left turn signal working just can't seem to get the brake/back up light to work on that side and i can't figure out how to get the right side going either.
View 8 Replies
Looking for a source for a wiring diagram for the 2003/4 f350 instrument cluster, specifically the wiring/connectors to the gauges? A link to a PDF file would be nice. I would like to try and disconnect the PCM control to the transmission temperature and engine temperature and drive the gauges from my own sensors to bypass the non-linear behavior that ford decided was in our best interest. I am NOT interested in installing any more gauges, just want to control the ones already present with my own signals. It is possible that these gauges are all addressable devices on a common bus, instead of individual controls.
View 8 Replies
