Electrical-wiring - Honda :: Delay In Start / Taking 3 To 6 Cranks Before Firing Up
Jun 18, 2011
So heres the deal 1989 civic dx hatchback 106k on the odometer automatic 1.5l d15b2 engine . It's been having delayed starts taking 3 to 6 cranks before firing up then running fine, suddenly it dawned on me maybe it was the distributor , so I swapped it with a spare I had because sure enough the old one had red death red dust in the cap. Cleaned the contacts set the timing reassembled, some wires broke on the back of the wiring harness to the distro. Rewired them, the car kept getting worse I jumped it and took it to my friend a vw mechanic it drove 49 miles there fine after the jump, new plugs new wires new fuel filter we did the wire job set the timing checked the timing belt got the battery tested and the alternators new and did a oil change also did a coolant flush a few weeks ago.
It started right up drove it back to Chicago , in the morning I was getting off the highway it stopped running no noises I pulled over 8 cranks later it started parked it 3 blocks away, went to test drive it when I stopped at a light it shut off cramming it and hitting the gas pedal got it to start drove it a block down it shut off at a stop sign and I parked it. What it is I'm throwing code 8 which is a top dead sensor which I think is in the distro which I replaced a month ago. Fuel pump sounds like its priming but you have to gas it and crank it to start it which is odd for a automatic , it is girk injected is this tds sensor going to do that by itself? Or could it be a ignition module? ( what I read online) starter? Main relay , fuel pump switch?
View 6 Replies
Advertisement
While the owner of 2 Ford Trucks, I also have a 2004 Ford Taurus with 28K on it. For a while now the vehicle is hard starting, cranks but acts like it is not getting fuel, however, I can hear the pump come on. Other times it starts right up, but a clicking sound can be heard coming from the firewall area. At times the gauges will not immediately respond when the Vehicle is started and then all at once they will begin to work. Now, my check engine light is on, but my hand held obd will not read it. All the terminal pins look great, obd tester works on my other two vehicles, cigar lighter working, the fuses i checked are good. Vehicle runs great. Can this all be related to a bad module?
View 1 Replies
I have a 02 f350 v10 with a starting problem. Sometimes it will crank but really slowly almost like the battery is dead, but its not! bench tested the battery and actually just bought another new one. And with the same result. I tested the relay that's on the firewall in between the starter and the battery and it checked out, i also bought a new relay and i want to put it in except I haven't figured out which wire goes to the coil and which one goes to the ignition. the battery and starter poles are marked and easy to follow ..
Also last month I changed the starter but I'm starting to get desperate and i think I'm going to take it off and have it bench tested as well. I'm just really at a loss in which direction to go. The truck on the outside really looks good but living in the northeast the frame and probably most of the outside grounds are toast and I've been renewing or just placing them as I come across them. Before i forget i tried jumping the starter directly from the battery with cables and got the same result. it would crank but too slow to actually turn over.. Sometimes my radio and ignition lights will sometimes come on without the key in the ignition..
View 6 Replies
When the 4x4 switch is moved to 4x4 high, what is the sequence of operation?
I note the 4x4 light on the dash has a small delay. Does the switch engage the transfer case and draw a vacuum to the hubs or does the transfer case engage first and then close a relay to light on the dash and engage the hubs? I have hubs that are not working, but no detectable vacuum leak, a dash signal lit for the 4x4, but a wheel still turning freely. My vacuum hoses are all soft and pliable.
I'm trying to figure out what my dash signal is telling me, if anything, before proceeding. Fuse for transfer case is good.
View 5 Replies
My Viper 2 way alarm, instead of the brain being wired to each of the 4 doors individually. The installer ran 1 wire to the dome light. Seems to work fine as far as arming/disarming/locking/unlocking, but since the dome light stays on for 10 seconds or whatever after the door is shut, when i arm it.
The 2 way remote says "door open" because the light is still on so it thinks a door is open. this eventually times out and all the sensors arm, but there's a long delay. it arms fine and no alerts pop up if i lock the doors first from the outside keypad on the door, making the lights go off, then hit arm on the viper, and everything is good to go.
Can I change it so no matter what, as SOON as i shut the door, the light goes off? I want there to be NO delay, if possible. If not, I may need to just have the installer run a wire to each door and take the single run to the dome light off, as it is sorta annoying to me.
View 1 Replies
I went to start my car this morning it cranks and nothing it is not firing at all, and I do not hear the fuel pump when I open the door like I usually do. It just happened all the sudden. Is there a way to check fuel pressure in these in the W8? Also any known problems to make them do this? So irritating...
View 4 Replies
So I've been having problems with my old duraspark 2 ignition box and I replaced that but it didn’t seem to fix the problem. The truck doesn’t start if the voltage is down around 12v, it cranks but no spark. So I put it on the charger a couple hours ago and came inside and was reading old posts on here about testing the ignition system and then just went out to test the negative side of the coil with a test light and low and behold when my assistant went to crank it over the truck started right up like everything was fine. I took off the charger.
So then what I did was I checked the charge at the battery while the truck was running with a dvm and the voltage was 14.33 then I turned on the electric fan and it jumped up to 14.88 and spiked at 15 then held at 14.88. is that normal or is the voltage a little on the high side? If it is high then could it be the voltage regulator or alternator? And could that have been my problem all along instead of the ignition module?
View 14 Replies
My 95 Honda accord 4 cy. vtech, will turn over but not will start, you can try unlimited times and it just cranks, but no fire or start.... UNLESS I wait about 30 seconds first. In this time what happens is, for 15 seconds the usual dash lights are on, including check engine light, at 16 seconds the D4 green transmission light starts to flash rapidly. At 30 seconds the main relay can be heard to finally click in, and the fuel pump whirs and primes the fuel system for 1.5 seconds and immediately the check engine light turns off, the D4 light turns off, and the fuel pump also stops whirring. AT this point, at any time from here on out, (until you turn the car off again) you can turn the key the rest of the way to start, and the engine cranks over and now immediately starts right up!
Sometimes all the above happens just as described, but the D4 transmission position light does not start to flash. Everything else happens the same way and timing and after 30 seconds the car will start. NOTES: a. The obd trouble codes do not flash any codes when the jumper is put in place to read the codes. b. I have removed and checked the main relay, looked ok, and just in case I re-soldered all connections on the main relay board. c.the car drives and shifts fine. d. The time frames are exactly the same every time. Electronically perfectly the same, like the computer finally decides, OK go ahead and work now. Or like the car is attempting by some programmed response to say that something is wrong and needs attention.
View 3 Replies
I don't drive the truck much anymore but over time my MPG has gone to total crap...about 10mpg around town...and that's baby-ing it.
Now it suddenly takes many cranks to finally start on a first start. (cold or warm days)....
View 8 Replies
Just recently bought a 07 Nissan Maxima SE. Has a few issues.
The car sun roof does not work at all. It worked the day I bought it though.
Has issues turning on. Cranks slowly then after a few seconds of struggle it turns. Didn't have this issue when I bought it.
Goes idle when first starting to drive. From park, I put the car in drive, or reverse, and let go of the brake, it basically does nothing. Engine is on as if it were in park or neutral, but the car doesnt move. When I press the gas it takes a few seconds before it decides to actually move.
View 2 Replies
Lately my car takes 2-3 cranks before it starts and I'm thinking it could be my fuel pump. There were a few times recently it took like 8 cranks to start. How to test fuel flow to see if it has issue? Also, could a old battery cause this issue?
View 18 Replies
My 1999 Ford Ranger XLT, 6 cylinder, auto trans, with 134K miles has an electric problem. When I turn the key to the 'on' position, all dash lights show normal, headlights work, radio plays, etc. But when I turn the key to the 'start' position, all electric power is lost. The power remains lost until I disconnect and reconnect the battery ground wire. After reconnecting, I again have power until the key is turned to the 'start' position. I was able to jump start the truck, so I assumed I needed a new battery. I bought one a week ago, and was back to normal until today. The truck started, I drove 4 miles to the grocery store, and then I found myself back to square 1 (i.e., the no-start situation).
View 3 Replies
I just bought a hard to start 1990 F250. Per the board, just replaced all 8 glow plugs with Motorcraft. Still wouldn't start (it turns over but will only start if you use either). I attempted to install a new BWD brand (Borg Warner I believe) glow plug connector relay today...I removed the old no problem, but am unsure what wires to plug where....the only connection that I'm sure about is the blue wire that works the WTS feature...it plugs in easily but I don't know if there are other connections that need to be made or not? All the wires run from the posts and into the bottom of the unit.
View 2 Replies
2000 7.3 Excursion. Truck ran fine on a 5 hour trip for family vacation. Pulled and to where we were going turn the truck off then what I had to do I came outside try to restart the truck for the next three days it would take 2 to 3 cranks before it was would start. Then on day number three tried six times and didn't start went to bed woke up the next morning and it took three cranks to start. drove it down to mechanic shop near me they have been troubleshooting and think it's an electrical issue the code is P1280; he said there were a couple other codes too and he would tell me what they were later but he never has. I took him a new CPS a new ICM and a new PCM, none of that fixed it. I am at my wits end here and really have to have my truck for work every day.
View 12 Replies
While my wife was driving tonight the VSA light went on, the emergency brake light went on, and the "D" for drive was flashing green. She stopped the car and called me. One the Car was in park, it would not go back into the Drive, and it continued to flash green. I've tried pulling fuses, disconnecting the battery. The other issue is that The hazard lights will not work and the turning blinker will not function. I have determined its an electrical issue. Other than that I'm clueless.
I popped the button just below port just below the shifter and manually put in drive and drove it home.
View 5 Replies
My 1995 honda passport ran great until a couple of weeks ago. I moved to North Carolina, and it sat for a few days as I was unpacking. When I started it back up, sometimes when I hit the brake, the lights on the middle dash come on for a split second, then go off. Also, my winter and power drive buttons don't work (anymore). As of yesterday, the lights didn't come on when I hit the brake, but it started hesitating when I started to drive.
View 4 Replies
2000 7.3 Excursion. Truck ran fine on a 5 hour trip for family vacation. Pulled and to where we were going turn the truck off then what I had to do I came outside try to restart the truck for the next three days it would take 2 to 3 cranks before it was would start. Then on day number three tried six times and didn't start went to bed woke up the next morning and it took three cranks to start. drove it down to mechanic shop near me they have been troubleshooting and think it's an electrical issue the code is P1280; he said there were a couple other codes too and he would tell me what they were later but he never has. I took him a new CPS a new ICM and a new PCM, none of that fixed it. I am at my wits end here and really have to have my truck for work every day.
View 1 Replies
I have a 2004 Honda Civic, and my phone and my Bluetooth unit are (sometimes) plugged into the cigarette lighter (euphemistically renamed the 12V Power Adapter). Problem is, when I shut off the car, the power adapter shuts off, depriving my phone and/or Bluetooth unit of a sometimes much-needed charge. My Suburban keeps the adapters on even when the power is shut off, and I love it.
View 9 Replies
I have a 2008 Honda Accord that about 4 months ago the drl light on the dashboard would come on for a few seconds and then go off. This happened 2 or 3 times a week. During this time the driver side drl light would also quit working. A couple of weeks later it progressed to the drl dashboard light would come on, then the tpms dashboard light would also come on. After an intermittent period of time (seconds to minutes) the icon showing low tire pressure would flash for a second and the drl light and tpms light would go off. This happened maybe 3 times in a day, then not happen again for a week or so. Air pressure in all tires was correct. About week ago it progressed to the drl dashboard light and the tpms dashboard light stay on all the time and neither the drl light (drl mode or high beam or will work on the driver side. In the past few days the low beam on the driver side has also quit working.
View 1 Replies
So my Honda Civic has been flashing my check engine light, which is telling my my cylinders are misfiring. I checked the ignition coils by removing them while the car was running and cylinder 2 and 3 I can remove and it doesn't change how the car runs. I put a new ignition coil In and that doesn't work so it isn't the ignition coils, what it could be?
View 8 Replies
2005 Honda Accord. I have been experiencing a loss of electricity to my dashboard - the radio cuts out, tach and speedometer needles drop, sometimes warning lights come on. I don't think I have experience a loss of power with this but when it happens, it lasts less than a second.
I can go days of driving without issue. Then, in one drive it may happen four or five times. I hate the idea of taking it into the dealer on an intermittent electrical issue. That could be a real bank drain.
View 6 Replies
