Electrical-wiring - Chevrolet - Suburban :: Dead Battery - Ride Control Compressor Runs For No Apparent Reason When Car Is Off
Mar 21, 2011
I have a 2001 Suburban (chevy) 5.3 liter Vortec engine, auto trans 4 wheel drive, fully loaded. As of late I come out in the morning to find a dead battery. this happened before and I disconnected the fuse for the dvd player that was installed aftermarket. some times I have to hit my dashboard to get the dash lights to work, now they dont work at all. sometimes the ride control compressor runs for no apparent reason when the car is off. I replaced the battery 3 years ago and it seemed to solve the problem until now. I replaced the battery with an optima red top yesterday and now the electrical system is going haywire. the ABS light is flashing and the service ride control light is on, the fuel gauge is bouncing back and forth from full to empty. What should I do. I am a fair mechanic but electrical is not my forte.
View 3 Replies
Advertisement
I recently bought a 1969 chevy c10 pickup. I have been having problems with the electrical system, the battery consistently going dead despite a new battery and alternator installed by the previous owner. Is there a step-by-step for diagnosis of this problem?
View 3 Replies
Have and intermittent condition with my 1996 F-150 4.9. AC runs and then cuts out (compressor not turning). I lose 12v to both side of high side switch. I tried to troubleshoot using a schematic in Haynes Foprd Pickups and Bronco for 92 and later F-Series/Bronco, but the color code for the wiring doesn't match up.
On my truck, there is 2 wires from the low side pressure switch which mates to a socket with only 1 wire. I have 12 volts at switch terminal on dash control, and it seems that I have an broken wire behind the dash, as I can get it to operate again when I move the harness around. Where can I get a schematic of this part of the circuit?
View 5 Replies
I checked the cables, no corrosion and tight as a drum. I connected an OBD II computer to the plug under the dashboard and the computer replied that there were no trouble codes present. Is OBDII the proper code reader? none of these lights were on before I replaced the battery. now I have constant ABS, flashing Service ride control, change engine oil. The battery has not gone dead as of yet but the ampmeter is charging at about 16.5-17 volts. I disconnected the pos terminal while the vehicle was running and it continued to run even with the lights on.
View 2 Replies
Earlier this year had dead battery after sitting for a week. 5 year old battery so bought new one battery still goes dead randomly (overnight), instead of playing radio for a few minutes after key off, dash displays "system off to conserve power" ran it thru local repair place (ex ford dealer) nothing found. Voltage 14v at 1800 rpm, lights on". STILL goes dead randomly...
View 6 Replies
I have a 02 f350 v10 with a starting problem. Sometimes it will crank but really slowly almost like the battery is dead, but its not! bench tested the battery and actually just bought another new one. And with the same result. I tested the relay that's on the firewall in between the starter and the battery and it checked out, i also bought a new relay and i want to put it in except I haven't figured out which wire goes to the coil and which one goes to the ignition. the battery and starter poles are marked and easy to follow ..
Also last month I changed the starter but I'm starting to get desperate and i think I'm going to take it off and have it bench tested as well. I'm just really at a loss in which direction to go. The truck on the outside really looks good but living in the northeast the frame and probably most of the outside grounds are toast and I've been renewing or just placing them as I come across them. Before i forget i tried jumping the starter directly from the battery with cables and got the same result. it would crank but too slow to actually turn over.. Sometimes my radio and ignition lights will sometimes come on without the key in the ignition..
View 6 Replies
I own a 2003 BMW 5301 with the sports ,premium and 'M' package. Of late the battery drains for no apparent reason. This happened a few times 2 months ago and I had the battery and alternator replaced. This has again started happening. The car starts promptly in the morning but refuses to start in the evening when I am ready to leave work. It has to be jump started. This does not happen everyday and the BMW service folks have not been able to figure this out.
View 2 Replies
Just had my first battery boost for my year-old Prius 2K10.
This morning I went to start the car, it didn't open the door for me, then I had all troubles in the world turning the key ... And obviously nothing was opening, no lights, nothing.
I had my car boosted. First time they put the booster, I couldn't start the car (everything showed up but starting the car didn't start the conventional motor - the lights were all on). They unplugged it (everything disappeared yet again) and plugged it back in ... Then I could start my car. Of course, everything was reset: time, trip meters, everything.
That's where I noticed my battery indicator was half-full.
View 19 Replies
I just recently purchased a 1996 celica GT Hatchback. It had 263K on 235K the timing belt was changed, oil and filter, tire rotation. When I bought the car on the 13 of August it drove and ran well. Drove it home over 45 miles with no issues. Only issue I noticed was that third gear grinded a bit but it's to be expected. Today after it had sat for all that time with the lights on the battery was dead. Jumped the car. cleaned and protected the contacts on the batt. and hooked it all back up. Let it charge for an hour and then drove it to work. On my way to work the engine oil light came on and the car died on my. It has oil and there are no apparent oil leaks. The car is turning over but not starting.
View 8 Replies
My "service ride control" warning came on today. I have searched the forum and all I find is about air shocks. My 2002 3/4 ton Suburban has the electronic shocks, no air. Is there a common problem I should check? It is the first really cold day we have had, if that means anything.
View 9 Replies
Looking for wiring diagram for the older Ford cruise control switches. I'm wanting to add an aftermarket system but use the factory switches. It's for a 99 ranger with the steering wheels like the mark 8s, older mustangs, explorers, and many others, had.
View 1 Replies
2002 1500 4WD 126K miles. A/C not working, compressor does not engage when A/C is switched on. Is there an interlock if the refrigerant level is too low to keep the compressor from engaging? Original owner, A/C has never been recharged. Is recharging my best first step.
View 2 Replies
The A/C is not working in my 2002 S-10. Currently the compressor runs, but the air is not getting cool. I tried adding freon, but it has not worked. The low side pressure is about 50 psi, and would drop a few pounds when the compressor is started, but it drops no further. I have not noticed the compressor cycling while it is on. The can of refrigerant is not empty, but the system does not seem to be taking any more from that can.
Do I just need to add some more coolant from a fresh can, or is something else at work here. Also, probably unrelated, when down shifting it is fairly common for the air to switch from blowing up front to blowing on the defrost.
View 6 Replies
I have a 70 Ford f250 with a messed up wiring harness. Truck will run only in start position. which wires are wrong.
View 7 Replies
I have a 02 f350 can not get power to a/c compressor have power at high pressure And low pressure can run a hot wire and ground to compressor and it works.
View 1 Replies
I pumped gas at the local Chevron after noticing I was running just below a quarter tank this morning and immediately after turning the truck back on the instrument panel was dead. All other electric components worked fine (windows, headlights, signals, radio, etc.) Yukon GMC 2003 110k miles...
View 8 Replies
I have an early 99 F250. The a/c compressor stopped working. Have checked pressures, switches, freon etc. Found the switch in the dash is not getting power to send to the compressor. Where the feed for this switch is? I have checked all fuses, all good. The manual does not show a relay as being an a/c relay, so I am stumped without taking it somewhere now but I would like to avoid that.
View 7 Replies
My 92 F250 5.8 won't start but fuel pump runs all the time the key is on. Some times it runs. But has no power and check engine light is on.. But I cant get it to flash codes, only steady light on.. It did this before then ran good. Now back to no start.. I checked grounds and relays ..
View 2 Replies
I'm planning the install of a 1996 351w into my '77 F-100. I'm using the '96 accessory serpentine drive (FS-10 A/C compressor, '96 alternator, etc.). It needs to mate up to the '77 wiring. I'm going to use stock '96 underhood A/C components (accumulator, hoses, condenser).
As best as I can tell, the '96 system uses the ECU to manage the A/C system, but I've converted the '96 motor to a carb.
Looking at both the '77 and '96 systems I think the easiest underhood wiring solution would be to use the '77 compressor ON wire as a relay trigger, and use the '96 High Pressure Cut Off (HCPO) on the compressor manifold, and compressor cycling switch attached to the accumulator to interrupt the relay output to the compressor.
I can get the switches and pigtails, and I can look up their pressure trigger points, but I don't know the voltage the '96 switches operate at (12v or some reduced voltage?) or how to simulate their trigger conditions to see how they work. I guess that at ambient pressure the HPCO should be normally on and the cycling switch should be normally off. So I could just wire them into the relay ground or trigger connection. But of course they aren't simple two wire switches. (Edit: Looking at it online, the cycling switch appears to be two wire, the HCPO is 4 wire).
How to wire them, should I use them to interrupt the relay ground or trigger connection?
View 7 Replies
1998 Jeep Cherokee sport ... My mechanic tells me that my #1 fuel injector is always spraying and that that is why the jeep runs rough. This is after he already told me that my injectors were clogged and needed to be replaced (which he did). When the car is idling for a while, the exhaust really begins to smell like gas, so this seems to make some sense to me, unlike his previous diagnosis. But now he is telling me that I need to replace the computer to fix this problem.
View 8 Replies
I have an 07 Camry and the alarm keeps going off for no apparent reason. Is there anyway to reset the alarm system itself? If so how and what do I need to do? How to do this.
View 2 Replies
