Eagle :: 1984 AMC - Turns Over But Engine Stops Running Unless Accelerator Kept Depressed
Apr 9, 2011
I recently acquired a 1984 AMC Eagle and I'm having trouble getting it to start. It turns over but the engine stops running unless the accelerator is kept depressed. Also, the car stalled at a light the one time I did get it running, so I'm thinking that there are some issues with the idle or with the carburetor maybe. I live in Colorado and I gather that the idle on these vehicles needed to get adjusted for the altitude, but I assume this has been done already as it has always been a Colorado car and has 125K miles on it. The gas is low, so possibly it might be something as simple as a gas supply issue, but judging by what other owners have posted online, it seems that this stalling problem is common with the Eagle so I think it probably is something more involved.
View 3 Replies
Advertisement
Sometime the car is fighting to move forwards when I start to depress accelerator pedal and it sounds like "click click CLICK..." the sound changes from lower to louder depending on how I depress accelerator pedal... (like the car is trying to hard to move)...
View 3 Replies
1984 prelude...1.8l .... I have posted previously on this vehicle and I have had some "success". The car will run with the support of starting fluid but will only stay running if the engine is kept at 2500 rpms or higher. If you let off the gas, it will bog out and die. Starting it requires another shot of starting fluid and a foot on the gas.
View 14 Replies
I have a 1984 Ford Ranger 4x4 with 2.8L V6, carburetor number E37E-AEA. The accelerator pump diaphragm is perforated.
Small holes are visible when I hold it up to a light. Is this part available anywhere? Is it included in these carb repair kits that I see on a lot of auto parts sites? The sites don't list the contents of their "kits."
View 2 Replies
I've noticed lately that my Prius (2008) sometimes decides to keep the ICE running even though the engine is warm and the gas pedal is not depressed. I can pulse and glide (with the engine off during glide) the first 5-10 minutes of driving, and then all of a sudden the ICE starts running constantly. I have to press the EV button to be able to glide. Quite annoying... I bought the Prius just to get rid of the ignition jerking.
View 7 Replies
I have some serious vibration at about 40 to 50 MPH only when the accelerator is depressed. As soon as I let off the gas it stops. I have had the tires rotated and balanced and the U joints checked. My Mechanic says he can't figure it out and to drive it until it breaks.
View 3 Replies
I brought my car to a dealership for its 120,000mi check-up, and they told me that the front axle boots were torn. They replaced the right axle, and on the ride home, I noticed a burning smell. Short story is four return trips, and the right axle replaced three times (including the initial replacement), and the smell has finally gone away. The weird part is not that I went back to the same place four times instead of giving up, it's that they told me this last time that they moved the replacement #2 right axle to the left when they installed replacement #3.
Why would they do that? Why would the smell go away if the issue was with that axle? I looked it up, and the same part is used on the driver's side and passenger side, so it wasn't as though they installed a left axle on the right the first two times. Does this mean the "new" axles were just new-to-me and had been reconditioned? If reconditioned, would it matter if a previously left axle was mounted on the right?
Meanwhile, about six weeks after replacement #2, the car started making a thumping noise when the accelerator was depressed at a speed over 35mph (but not when coasting above 35mph or with the gas on below 30-35). I was wondering if it was misfiring or something, but lo and behold! That noise went away with the axle switching. Way back at replacement #1, they replaced the boot on the left but not the entire axle until #3.
View 7 Replies
I have a problem in my Touareg 2005 R5 TDI, my heater blower works fine while ignition on. When I start the engine, blower starts for a moment and then stops .This problem happened first time before 2 months and suddenly blower worked fine till today.Now i have the same problem.I tried to replace the blower motor but nothing changed.
View 1 Replies
99 Ranger XLT 4.0 4WD Automatic. With the turn signal blinking and I depress the brake the turn signal stops blinking until I release the brake. Where to start.
View 2 Replies
Ok, I changed my front brake pads and rotors last week and since then everytime I get in the truck and drive for about the first 2 or 3 miles when I push the brake pedal it feels like my ABS sytem is activating. Then it stops and the ABS light comes on but the brake pedal stops pulsating when depressed. Is my ABS going bad or did I possibly do something wrong? I have changed the rotors and pads before without problems....
View 3 Replies
Starts right up, runs fine. No CEL. No warning. No symptoms. It just stops running. It may or may not start right back up, but when it does start back it runs as fine as it was running before it quit.
View 2 Replies
Recently my wife took her car to work. While driving on the highway the car all of a sudden quit responding to pushing on the gas. As if the pedal had no affect at all. The electrical was still in tact as my wife pulled off to the side of the road and turned the car off. Before I could reach her to pick her up she had started it again and it started right up no hesitation at all. Upon dropping her off at work I came back and it started right away and I drove it to her work and she then drove it home at the end of the day with not problems. It sat in our garage for a few days and I decided to take it out to see what happens for myself. I drove it for a full day stated right up every time and it wasn't until the second day I drove it around that it did the same thing to me. Gas pedal had not response. All electrical seemed operational, still had power steering and the dash was lit. I pulled over then waited a few minutes and it fired right up and I was on my way. Wondered if its the fuel pump and how I could test that out. As I said is starts right up every time with no hesitation. Also I have fuel pressure tested it and it shows a 60 the during idle.
View 9 Replies
I have an 03 Passat with about 70K miles on it. My daughter put rug in it this morning (about 7 gallons) and since then the check engine light came on and the car is running really rough at stops. While accelerating, it seems to be fine. It is also getting about 10 mpg less than normal. MIL codes: P0300, P0301, P0302, P0303, P0304, and P0171. He said the P03xx codes were related to misfirings on each cylinder. The P0171 is a bank 1 failure (?). What do those codes really mean and could they be related to bad gas? Sent her off in my TDI JSW so she's not out on the highway if the Passat decides it doesn't want to go anymore.
View 6 Replies
Just replaced my rear gas tank. Drove for a week with no big issues. Started running a little rough just thought it was debri in the fuel line. While it was sitting for a few days fuel was coming out of the carburator. It drained 15 gallons of fuel from the tank. There was pressure building in the tank when I took off the gas cap. Dropped fuel tank and everything seems to be hooked up ok. Put it back now added gas now the truck wont start even using starting fluid.
View 4 Replies
I have a 2007 Mazda 5 and over the past few days, I notice the acceleration seems slightly sluggish, especially on inclines. Then last night I had a problem where I was driving and whenever I took my foot off the accelerator, the car would stop (rather than gradually slowing). And when I put my foot back on the accelerator, the car jerked forward before finding the right speed. I parked and after work, it drove just fine. Drove fine this morning also. The shop says I need a new solenoid purge valve, but after reading about that valve, I don't understand how it could cause my problem. The car didn't stall whom it stopped, it just stopped moving forward.
View 4 Replies
1998 Lexus LS400, ~130k miles, town driving, auto shift.~35mph develops fine vibration with accompanying hum. Both increase when speed up. Hum develops a harmonic and shaking increases to almost a shutter.decreases or stops when release accelerator.
View 3 Replies
I have a 2004 F150 4.6L... There is a slight hissing sound under the dash on the drivers side when you lightly press the accelerator and then stops. No matter what speed you are going as soon as you apply the accelerator it hisses then stops. There is also the same hissing , only louder when the engine is cut off. It hisses for about 3 seconds. What could be causing this. It has been idling rough since the hissing started. The check engine light is on and showing P0420 and P0430 codes . The cats were replaced with resonators so I believe that is the reason for the codes.
View 2 Replies
What could be involved? I heard something about crank sensor or a TBA taking part on this.
View 9 Replies
I have a 2005 Ford Focus zx5, which has been a great car for me so far. I live in DC, and traffic is insane. Over the last year or so, maybe once every other month, my car has turned off when I come to a hard stop (usually braking suddenly at a light/pedestrian walkway). This is my first time owning an automatic, and it's just as if my car had stalled out. The radio will stay on, etc, but the engine dies and I have to put it into park and re-start it.
The RPMs have seemed to fluctuate a bit as well, usually on start-up or on hot days.
So far I haven't been motivated enough to get it taken care of, since it happens so infrequently and things seem great otherwise. What could be causing this?
View 3 Replies
My car stall in the cold weather especially whenever I let up on the gas like when I am going around a corner or come to a stop.
View 5 Replies
Windshield wiper turns on, works for about 30 seconds, and then stops in mid-stride. You then turn off the wiper, then turn it back on, and it works for about another 30 seconds. Intermediate does not work, slow speed starts and fast speed starts, but they only work for about 30 seconds, stopping in any random wiper arm position. (When set on intermediate, slow speed works, again for about 30 seconds.) What do I fix, the control arm on the steering column?. The motor is working, the wiper arm is working, just the brain has "a mind of its own".
View 2 Replies
