Dodge - Ram1500 :: 1998 - Crank For Long Time Until The Car Starts
Oct 16, 2011
I have a 1988 Dodge pickup 1500 with a 5,9 gas engine. It used to pop right over all the time. Now, in the morning, I have to crank it forever until it starts, and if it sits for 1 hour or more, same thing (have to crank for a long time). It is my understanding there is a valve called a one day valve that holds pressure on the gas line. Is it possible this valve is not working properly? And if so, do I have to replace fuel pump to fix problem? once started it starts up with no problem until it sits for hour or more then hard to start.
View 15 Replies
Advertisement
I own 2013 Mk6 GTI. I am having to over crank the engine for a period of 8 seconds or so before the car starts, especially after it has been sitting for a few hours. My thought was a faulty check valve in the fuel pump. I have heard that our fuel filter has a built in pressure regulator that may get stuck open for whatever reason and that may also cause a long crank time.
View 9 Replies
The past couple of cold starts (not real cold mornings though) I have experienced long crank time to start. Once started she starts normally. No time to read but I'm getting a little worried that I'll get stuck somewhere. I'll check back with my phone when I get into an area with cel service.
View 14 Replies
I recently (in the last few months) have noticed my truck (1999 F350 duallie) seeming to be running very rich … I pull a 32' trailer with it and noticed on the art few trips the front and right side of the trailer covered with diesel fuel spots when I got home …. It also smells very rich when idling…. The last couple times I started it in the mornings it seems to crank a very long time before it starts …it still runs but its got issues evidently … it has these 3 codes :
P1280
P0475
P1670
The 1670 will clear , but the other 2 I can't clear, they are right back every time you turn the key on …
View 14 Replies
I have a 1996 Dodge Ram 1500. The starter does not crank at all. I put the key in and turn it and nothing, just a click. I have replaced the starter/solenoid with a new one and I have charged the battery and it is good (battery is only 8 months old). It still does not crank, nothing.
View 19 Replies
I have a 2005 Dodge ram 1500 Hemi that has had starting issues for over a year. After sitting for over 30 minutes, it will crank like it is flooded. If I lightly put pressure on the accelerator, it fires right up. It happens with regular or mid grade gas....but seems to happen more when at 1/4 tank or less. It starts normal first thing in the morning or after several hours of sitting. Now along with this, when I turn the key in the ignition, there will be a dead pause, then start cranking. Fuel pump and ignition switch?
View 12 Replies
When my truck is cold, I have to turn the key two or three times to get it to start. By that I mean I turn the key, turn it all the way off, and turn it again until the engine starts. The first two times, it doesn't crank or make any noise at all, but the radio and dashboard lights come on. I got the truck in May and it hasn't done this all summer.Also, if it idles at a red light when it is cold, it will stop running and I have the same problem as above when I try to re-start it.There is also a smell of burning rubber in the cab once it has warmed up.
View 1 Replies
I have a 1994 Dodge RAM 1500, v8, 5.2 liter truck. A few months ago, I noticed that when it's at normal temperature, it would not crank unless I floored the accelerator. Once it cranked, it was hard to keep it idling at a constant RPM. I have to rev it up a lot to finally get it to idle by itself or to put it in Drive to move. Once it's moving, everything seems pretty good. If I stop and change gears (Park, for example), it will stall. I have also noticed this happening if I'm in Park, then turn on the air conditioning putting a load on the engine, it will stall.
When the engine is cold (sitting for several hours), it cranks fine and runs fine.
I have replaced the idle air control (IAC) valve, the throttle position sensor, the MAP sensor, the Crank sensor between the motor and the transmission (what a pain to replace), the O2 sensor upstream of the catalytic converter, and the computer (with a used one from a salvage yard. And, I had a mechanic check out the distributor cap and it's internals and do whatever he did.
I did read somewhere that the coolant temperature sensor may be an issue?
View 2 Replies
I just bought a 98 Dodge Ram 1500 4x4. Of course it didn't do this when we test drove it, but as soon as we put the money down the problem started. When you start the truck, the interior lights start blinking. I thought it was a door ajar warning, but after testing the doors, it doesn't stop blinking.
Sometimes it will stop when you put it in gear, sometimes it starts again. some times it stops for a few seconds and then starts again. So far it has always stopped blinking after we have driven for a little while. It seems like it will sometimes stop when I fiddle with the 4 wheel drive shifter.
View 1 Replies
So ive had a starting issue in the R32 for quite some time now. With waterfest approaching and the new S3 going into production that i ordered, it has come time to finally fix it. I have taken in to many dealerships and very talented techs, and no one has any idea. The car seems to crank for a very long time or start right up and then just completely stall and die. The second time i start it, it starts completely fine like nothing ever happened. This only happens when the car sits for a few hours. It has never done it if the car has sit overnight or during the cold months. It has to be warm and sit for a specific amount of time. Its like it catches the car transferring into a cold start but not fully cold yet, if that makes sense. Also i am now noticing a small squeak each time it starts, like a belt. I have replaced the fuel pump/spark plugs/coil packs. Nothing has changed. We thought maybe a stuck injector but were doubtful as its not constant. Im debating a cam position sensor just to see if thats the issue. There is no CEL or any codes.
View 12 Replies
I have a 2006 Sonata GLS with the 3.3L V6 and close to 230,000 miles. A few months ago I noticed that my crank time at starting was longer than typically - it has steadily gotten worse.
Now the crank time is close to 8 - 10 seconds. (Which might not seem like much but trust me, it is).
I suspected that the fuel pump was faulty, however, once started - it runs great.
I put a pressure gauge on the fuel pump outlet and found that it only kicks the pump on when the car is cranking, the fuel pump does not kick on when the key is in the "on" position. Once the vehicle starts, it seems to be drawing fuel.
The pump has all sorts of pressure, I am not worried about that.
I decided to change the Fuel pressure regulator valve thinking that maybe it wasn't holding pressure - That didn't seem to do anything.
Do I need to change the entire Fuel Pump Assembly?
View 5 Replies
So my 2002 ford explorer with the 4.0 L V6, has been cranking along time before it starts. I thought i had this figured out already, i put a brand new fuel pump in it from the ford dealer. That seemed to work, but the problem came back.
Especially when it is cold, it cranks a lot longer than normal to start. and when it does start RMPS go way up briefly and come back down. Seems to only act up when its cold out, say 35 degrees and lower.
So the remote start wont work because it only cranks for a few seconds and then stops. it tries this three times and it gives up. i go out there to start it and cranks for 10 seconds it seems like, sometimes i have to feather the fuel pedal.
View 7 Replies
So how long does one have to crank until it is considered an extended crank? 2 seconds, 5 seconds, 10 seconds.....?
The reason I ask is after all the motor work I did on my truck sometimes she fires up in less than 1 second of cranking and other times it take maybe 2 seconds of cranking. I do not think 2 seconds is considered and extended crank time but was just curious about what is considered extended cranking.
View 12 Replies
Car does not have to get wet, just be in humid air. Problem going on 2 years now, mechanics tried disconnecting a (?) ground/sensor from computer, major tune up, new fuel pump. Until recently, it just took keeping it in crank position for a long time for it to finally start. Recently, in crank position for 30 seconds does nothing and has me worried I'm doing damage. In dry weather, it starts first time every time.
View 12 Replies
I have a 2002 Ford Windstar that only in the fall and winter it has a longer crank time of at least 10 seconds. In the summer it starts as it should within 3-4 seconds. I did notice that the times it did start normally in the colder air is when I turned the key on and listened to the fuel pump prime the system. All other times it doesn't do that and that's when I get the long crank time. Once it is started it runs as normal. Am I looking at a possible fuel filter or pump? I am due to replace the filter as the van has 83,000 miles on it. If this is the possible culprit, is this something that is easily replaced at home?
View 4 Replies
I have a 2006 F350. I have long crank times. No Codes. I have Autoenginuity with Enhanced Codes and everything shows fine. I replaces standpipe and dummy plugs. Glow Plugs and harness. I was hoping it not be the STC but I needed to do oil cooler so wanted to eliminate STC. Got truck apart and the STC Fitting is newer style so I'm kinda bummed out. Not sure if I'm missing something and as far as I have it torn down is there anyway to test what could be causing the problem? Or just put it back together and keep my fingers crossed that whoever put the new STC fitting in screwed it up. I'm beginning to not like my truck.
View 8 Replies
i have a 1998 chevy blazer 4.3 4wd v6 about 130000 miles on it. There is no check engine light on at all. Some reason it takes long time for it to get up to speed.and i can't figer out why that is i did replace spark plugs in it..
View 11 Replies
Removed my oil rail to replace standpipes/dummies (04 Wavy rail) and now I have huge crank times to start. This is after the initial Huge crank to get it started. Do I have air in the system, or did I bugger something. I did the whole deal very careful. I lifted the rail up very carefully, pipes removed. I lined up the rail nipples with the injectors and evenly pressed it back in place, and then inserted my dummies/standpipe. Tightened the rail to 120 inch lbs then the dummies/standpipe to 60 ft lb. I did my son's '06 a month ago with no troubles. (didn't remove rails though). Once running it sounds perfect, turn it off and re-start and it's a long crank (30 seconds or more). I have not monitored ICP/IPR while running, will try that today.
View 8 Replies
I have a 1998 Grand Caravan 3.8L engine with 157K on it. A month ago changed the EGR valve and replaced the transmission oil. Two days ago, went for shopping, parked the van. Came back and did not start (no crank, nothing). Called AAA, checked for battery, which was good. Radio, wiper, lights work. Had to tow to the shop. The mechanic checked for all possible problems. Said everything (Fuse, battery, starter motor, alternator) is good. He is clueless. Told him to check the ignition switch (may be worn out). He says it doesn't seem so.
View 19 Replies
Already replaced the starter relay will not crank from the key but even when I jump the starter the car still wont start and the switch is in the on position I checked all the fuses and replaced the ecm ....
View 15 Replies
I have a 98 Chrysler Concord Lxi with a 3.2 L V6. In the summer time when its hot The car will get warmer than normal (I have figured out that one of the cooling fans is out and needs to be replaced). That said. after running for a few hours on the highway and if sat idle with the temperature raised, if I shut the car off 9 times out of 10 when I go to restart the car it will crank and crank but will not fire. My guess is the computer shuts the fuel off.
I have to wait about 30 minutes and it will start. Sometimes it will start very rough with a carbon smell and the need to idle it high until it smooths out. Other times It will start with out having to wait but the idle is again rough and can smell carbon. I have looked online and found some have a solution of releasing the pressure of the fuel line as it could be a symptom of vapor lock. I have tried this and no pressure is released ( I have disconnected A/C Lines on previous cars only to find a large BOOM a mess in the garage and in my shorts!) so I know I am releasing the right Scraeder valve.
View 8 Replies
