Dodge - Ram :: 1997 - Costco Gas Causing Pickup To Stall?
Sep 2, 2013
I've got a 1997 Dodge Ram 1500 pickup. It's got 145k miles. I've been using Costco gas in it for the last two years with no problems. One day, it randomly decided to start stalling out on me. It stalled out 3 times driving at low speed. I didn't have time to work on it, so I just put some good Exxon gas in there and hoped for the best until I could look into it further. Problem went away. I cleaned out the IAC for good measure. When I finished up that tank of gas a few days later, I went back to Costco. The truck begins stalling again. Is there a problem with the gas? Or is there something I should look at on my truck?
View 6 Replies
Advertisement
I have a 1997 Dodge Neon with about 153,XXX miles on it. My check engine light has been on and i know that is caused by a random misfire. But more recently i went to start my car and it started but ran for less then 10 seconds and died. I tried to start it again and it wanted to but wouldnt make the final step i guess. We checked my spark plugs and i had oil sitting in 3 of the 4 there are. We have tried starting it again after cleaning the oil out and it started on the first try, I am just afraid of messing anything else up so until we figure out why it did this to begin with the vehicle is off limits. My Fiance said we need to replace the spark plugs and a gasket.
View 4 Replies
My dad has a 97 Dodge Neon 4 cylinder. The car has been leaking oil, and on Sat the leak grew and was real bad. He took it to the only shop he could find open who put it up on the lift and said the leak was coming from the front of the engine. On monday they did the work ($286) and told my dad it was a seal on the front of the engine behind the flywheel. My dad is old and doesn't hear well and the mechanics english was not real strong and his writing on the recepit is not real clear. As I am worried my dad might have gotten taken, is there a replaceable seal on the front of the engine that could go and cause a leak? They showed my dad the leak as the car was on the lift and running as that was only when the leak occured. I am concerned my dad was taken. He says he drove it around and such and didn't see any leaking when he picked it up and left it running in his drivway for a while upon getting home and no leak. Just wondering?
View 11 Replies
The RPM gauge began surging, which caused my car to stall. Restarted the car and the surging began again as well as the check engine light came on. After a mile or so, the surging stopped and the engine light went off. Drove to Toyota dealership, ran diagnostic and was told 'possible' air fuel filter problem. No surging since the diagnostic. Should I follow-up and have this looked into or just let it be? 2009 XLE 4 Cylinder ....
View 2 Replies
A warm startup on my 2007 Explorer causes an RPM spike and subsequent stall (half of the time) on the way back down. I've tried a fuel additive, Ford ran codes with no problems...
View 6 Replies
I have a 96 Dodge Ram 1500 4x4 5.2L pickup that wont start. I have replaced fuses, starter, ignition switch, tumbler. it still wont run. i can craw under it with 2 screwdriver and start it by touching hot wire and trigger wire. I have hooked it to a diagnostics machine and it said idle air was bad and I replaced that too...
View 2 Replies
Our 18 yr old grandson has a 1998 Dodge Ram pickup that dies when he turns. Was told that
1) either the wiring harness to the oil pressure sensor is rubbing OR
2) the oil pressure sensor needs to be replaced -
QUESTION: Where is this located? Is it hard / expensive to replace?
View 2 Replies
I own a 2007 Dodge Ram Pickup (3500). One day it started by itself while parked outside in the driveway. It drove into one of my other pickups and pushed it into my side by side. It finally pushed both aside and was headed toward the house but was stopped by a tree. I heard a loud crashing noise so I looked out the window and saw what was happening. I jumped into the pickup to try and turn it off but the key wasn't turned on. I put the clutch in and took it out of gear but it just reved up more. The horn was blaring and smoke boiling out. I turned it off by opening up the hood and unhooking the battery cable.
View 18 Replies
have a 1997 nissan pickup 2.4 liter engine check engine light came on code say number 2 cylinder misfiring put in shop. they say that they can't get to misfire.truck run great.just that light keep coming on with code (p o 302)
View 11 Replies
I was riding down the interstate this morning and had my cruise control set at 70mph. all of a sudden the cruise just turn off. I went to hit the gas pedal and there was nothing. No check engine light or anything, no spit, no sputter. I pulled off the side of the interstate and attempted to start the van. the engine turns over fine, but no start. all lights, radio work fine. car has fuel. it did not run hot.
View 1 Replies
(code p.o.302) number 2 cylinder misfiring. 1997 nissian pickup 2.4 liter automatic. when I take truck out on highway check engine light come on with code p.0.302.when I get back to town. and cut truck off for maybe 20 minute. check engine light go off automatic I do not have to use a scan tool to erase. As long as I am in town light. say off. when I get back on highway check engine light come back on. have had 3 mechanic look at this they can't get it to misfire. they tell me the fuel and spark are doing what they support to do..do you think maybe computer bad. has 255,000 miles
View 5 Replies
My truck will start and idle but when I engage it into a gear, whether it is drive or reverse, it will start to bog down and not respond to throttle. Sometimes the truck will stall other times it will just bog down then the rpms shoot up and the truck will run normal after. If the truck does die it will fire right up and have no issues and run great. Now whenever I stop and shutoff the truck the next time I start it up it will go through the exact same process. It doesn't matter how long the truck has been shut off. Could be a minute could be a day. Truck has 177k miles, in the last year it has given a code for camshaft sensor going bad and has been replaced twice. Have also had the catalytic converter and the O2 sensors replaced within the last 6 months. Not sure if this matters but was told my truck is California Emissions by the garage that replaced the cat.
View 3 Replies
I have a 1988 Omni, so a 2.2 non-turbo with TBI. Within the first 10 minutes of driving, regardless of the amount of fuel in the tank, the engine will stall out. Throttle position does not matter - it stalls the same way under full throttle as it does idling. It always starts back up on the 2nd or 3rd try immediately after stalling, and runs perfectly. When it stalls, it's as if someone actually shut the ignition switch off - the motor completely shuts off without sputtering or running rough. All of the other electronics seem to be unaffected (for example, the radio and lights still work during the motor drama).
It may do this 3 or 4 times in the course of 5 minutes. After the engine is up to operating temp, the problem disappears entirely and only resurfaces whenever the car has had a chance to cool back off.
I thought it was the coil, but replaced that with no effect. I also recently did plugs and wires (2 months ago, long before this issue surfaces). I just remove the air intake assembly and watched the fuel injector. It ran perfectly normally for about 10 minutes again and then I saw the injector suddenly stop spraying, and the engine stalled instantly. The injector seemed to be working fine before the stall and worked fine again after I restarted. No weird noises or anything.
What this could be? ECU, maybe? Something specific in the throttle body assembly or fuel system? The little car is in great shape otherwise, and I drive it 100 miles every day to work and back to keep miles down on the newer thirstier car.
View 5 Replies
I have 2000 Grand Caravan w/ 3.3L, AT. When warmed up, in stop and go traffic, at lights, or in reverse for parking, the idle speed drops, the oil light flickers and unless shifted to neutral, stalls. I've replaced the fuel pump and filter. I've adjusted the idle screw on the throttle body to 700 rpm, where it stays when the van is cold or when stopping in normal driving. Someone suggested the oil pump, and I added motor honey, but no change in symptoms. There are no vacumn leaks evident. How do I keep the idle from sagging? Would this be a sensor issue?
View 5 Replies
My 1996 Dodge Grand Caravan has developed a curious problem. It intermittently stalls, sometimes when slowing down, sometimes when going up an incline, sometimes on straightaways. Once stalled, it often won't start again until it has sat for 20-30 minutes. Then it starts right back up again and drives perfectly normally until the next time that it stalls-which can be days or hours. The problem is definitely getting worse--six times today. Warmer temperatures seem to exacerbate the problem. Again, the engine runs very smoothly up to the point of the stall. My mechanic was unable to replicate the problem and his diagnostics showed everything to be normal.
View 5 Replies
My AC blows cold for a little while, then it blows warm. If I wait and turn it back on the cycle repeats it self. I had the freon filled. Not sure what to do? 1997 nissan pickup....
View 3 Replies
I have an 2002 Dodge Grand Caravan that cut off shortly after starting the other night. Every time I try to start it, it will crank and then stall almost immediately. I tested the fuel pressure and it was strong so I hooked up a pocketscan and my van starts and runs normally while the pocketscan is hooked up. I even took it for a drive around the neighborhood. As soon as I unplug the pocketscan my engine shuts off. The only code on the scanner was for the O2 sensor(not something that would shut my engine off.)
View 1 Replies
Working on a 1998 intrepid got the codes po134 po171 po154 and got all the codes taking care of except 1 po134 which it says its a oxy sensor just took it for a test drive after about 10miles it starts spewing black smoke and trying to stall out, then it clears right up after that.
View 2 Replies
I have a 2000 Dodge Caravan SE 3.3L. The timing chain recently broke. So I replaced the timing set, cover, water pump, camshaft sensor, and oil pan. The timing is all aligned. It starts right up, but then stalls. Unplugged the front three spark plugs to see if one of those were the problem, and then it ran better and didn't stall out.
View 3 Replies
When the truck is in reverse, turn the wheel, it acts like is about to stall out. Sometimes just idling the engine at a stop and turn the wheel it acts likes its going to stall out.
View 4 Replies
my mechanic is stump have a 1997 Nissan pickup 2.4 liter auto tranny. number 2 cylinder misfiring.my mechanic say it have fuel, spark. and he did a compression check say compression is good. code (p. o 302) keep coming on. he change spark plug and wire and distributor cap and rotor. but light keep coming on. he say the only other thing he can think may be is. to change the whole distributor he say the cam sensor is in the distributor. tuck have 264,000 mile on it.
View 5 Replies
