I have a grinding sound comes from the front of my car when the speed reaches 60 miles, what can cause this sound.also i have a popping sound when putting the gear in reverse is that related?
View 1 RepliesI was recently experiencing problems with my front brakes. It sounded like it was grinding on something (it doesn't screech) whenever the speed reaches below 15 mph. I called up my dealer to take a look and upon investigation they told me that i needed to do the front brakes job but they could save the rotor (they charged me around $300). Is this common ? It is a daily driven car and i mostly drive on highways. I drive the 2014 RWD IS-350 F-sport model and just recently hit 17.8K miles.
View 14 RepliesWhen parking on an incline, say my driveway which is pretty steep, I engage my emergency brake. When I release the brake I get a creaking noise as I put it in reverse to back out of the driveway.Two questions is using the emergency brake really going to keep my car from rolling back down the driveway and does the creaking noise mean the emergency or rear brakes are being stressed by holding the car in an incline for several hours each day?
I really worry some days I am going to walk outside and my car will be in the neighbor's yard.
Mr Squeaky is a 2003 Subaru Legacy
Here are the signs and symptoms that my car wants to die. The car makes sound like grinding metal after I drive it for a good 10-15 miles. It starts up when I turn to the right. It does not seem to matter how slight the turn to the right is but it seems to not start up until I head in that direction a little bit. Once it gets going, it does not stop, and squeals incessantly. I can make it stop by putting my foot on the brakes but the noise almost always starts right back up as soon as I take my foot off the brake. Speed of travel seems to have no effect on this noise. If I park my car for 5 min and then drive away, again the noise normally goes away. My heat gauge never goes into the oh crap zone, and my mechanics swear my brakes are good.
I've had this '96 Dodge Caravan for just over a year now and suddenly I go to try and start it and it will almost start but then stop. All my dash comes on like it supposed to but when I turn my key it just stuggles and makes a grinding noise. The only thing i know is my common sense is saying if it makes grinding noise dont keep trying you'll make things worse.
View 5 Replies2005 Dodge SRT-10 Quad Cab.... There is a strange noise, or perhaps I should say noises that sound most of the time like a grating/grinding sound. Occasionally it has less of that mechanical sound, and more of..well, like blowing air over your tongue with a lot of saliva in the way (like a cat purring with a hairball in its mouth??). Anyway, the ONLY constant I have found is that it only happens when I am accelerating (but not every time I accelerate). Most often (again there have been exceptions) it happens between 1500 & 2500 RPMs...typically just before the transmission would be inclined to shift to a higher gear - if it does shift into the higher gear, the noise stops.
Also, the moment I take my foot off of the gas pedal, the sound stops. About a third of the time, I can feel a slight vibration via my feet when the noise is stronger sounding. On two occasions (this is over a period of approximately 1 year) The sound was extremely harsh, and the truck was shaking.When I took it in the first time they told me it was the catalytic converter, and replaced it. When that didn't fix the problem, they decided it must be the other catalytic converter (yes it has two). That didn't fix the problem either.Ordinarily, rather than simply have them replace half the parts in the truck I would wait until something completely failed, thus making the culprit obvious. However, I am moving soon... and I don't want to be driving half way across the country pulling a large trailer and have the drive shaft, or transmission, or whatever - fall out.
I get a grinding type of sound when I am braking but only when I come to a complete stop and then again when I release the brake. It is only for a second but it is loud and doesn't sound good. What could be wrong. It also is much worse when it rains.
View 4 RepliesI have a 2002 Camry (4 cylinders). About two weeks ago, I started to notice vibration on the passenger side of the car, front side, when the car reaches a certain speed (around 30-40 mph). At first I thought it was a wheel inbalance, so I took it to the Toyota Dealership and have them re-balance the wheels.
The problem, however, did not go away. I remember a while back after I got an oil change, the maintenance guy at the dealership mentioned that the motor mounts were going bad. Is it possible that bad/worn motor mount can cause vibration at certain speeds? The problem only occurs on the passenger side.
I do not notice vibration at idle (I think). I will have to drive the car again to double check this. But vibration is much more apparent when the car hits 30 mph+.
Is it possible to disable the automatic door locking when the car reaches speed via VCDS. So the actuators don't wear out so quickly.
View 4 RepliesI have a 05 Touareg V6. When coming to a stop (when speed reaches 5 mph or less) there is a slight vibration felt in the steering wheel. What causes this? What can I do to correct this? (I had new rotors and brakes put on about 2K miles ago.
View 1 RepliesI'm experiencing a grinding sound that seems to be coming from the rear of the car. I can't tell if it's the tires wearing or it's something else, it's especially prevalent at certain speeds and on a curve..........
I can hear it when going slow and proportionality the grinding is slow... as speed up it's faster and at certain speeds it's quite loud...........it there something besides the rear tires that could be causing that, rear axle? something needs to be lubed?
At first i was sure it was the tires which are turanaza's and they have gotten louder (I think) as the mile have accumulated, but now I'm not sure since i can hear it at low speeds on turns.
Got the stabilizer bar recall done in February and have been on a couple of long trips since then. No real issues until about a week ago I noticed at low speed, when turning left, and usually if there was a small bump or incline........like turning into my driveway, there would be a popping/grinding sound. It could happen at speed, but never heard anything. I go last night to install some ECS cross drilled and slotted rotors and flush spacer kit and noticed this on the left front....
Well honestly I noticed first that I needed to wash my car, just got back from the beach and it has been raining here, but is this installed correctly. The bar is bent near the top, easier to see in person and I am fairly positive this is not correct. Called the dealership and they are going to check it out Monda. The picture below is of a left front on a MK7 and it appears to be the correct.
I can't isolate whether this is in the transfer case or the front axle.
While driving along at a moderate speed in 2WD the truck GRADUALLY began making a grinding sound, similar to riding on grooved pavement or over a steel bridge. It stops IMMEDIATELY when switched to 4WD.
I can ride for 10 miles before the growling begins. When switched back to 2WD the noise returns gradually usually after a minute or so.
The frequency of the sound is faster than the rotation of a driveshaft and it continues right down to a very low speed at just about the same intensity.
I've read a few posts on here that suggest spindle bearings, but the problem came on very abruptly and usually bearing problems, from my experience start small and get worse. Last week I changed brake pads and rotors.
Mazda5; 2010; 105,000 miles.
Recently, our Mazda has started making a subdued grinding sound. It happens only when accelerating from idling to 10 miles per hour. It does not occur over 10 mph, in neutral, or park. It doesn't happen when starting the car or in reverse either. according to my wife, it does happens when turning right at slow speeds, but not left.
We have just driven it to our mechanic but it may take a couple days before they are able to look at it.
I have an 08 explorer 4x4 with 90k. I have a front end grinding noise. Noise is loudest at lower speeds and doesn't change with braking or turning. I have read that tires could cause this. I have the spare tire and rim on the front at the moment until I can afford a new tire. My other tires are all pretty new... And the spare is a different size rim but a brand new different brand tire. I'm going to check for play in the bearings tonight and maybe swap the spare to the rear .
View 4 RepliesMy 2009 Dodge Ram 2500 with diesel engine, intermittently makes a noise similar to the sound knobby tires make. It also sounds similar to the exhaust brake, but louder. A vibration accompanies the noise. Two mechanics (one a tire expert, one at a Dodge dealer) test drove it and examined it on their racks and said it's the right front wheel bearing/hub assembly. I replaced that, despite not hearing or feeling any problem when rotating the wheel by hand. I've examined all tires and turned the wheels by hand while listening for odd sounds or roughness, and examined all drive shafts and joints which have not apparent problem, to no avail. When this issue first started, I heard a sound like rubber squeaking while driving at very low speed, especially in reverse.
View 1 RepliesSo yet I found out about another common issue but not that publicized. This is the grinding sound when turning at full lock (left or right) in slow speed. I've read several people in the forum who has encountered this. I read different remedies but the most common one is to have the CV boots lubricated.
I have a 2014 Wolfsburg with almost 5k miles. I am really now worrying about my water pump crapping out on me but I heard this grinding sound yesterday.
i have a Subaru legacy rs 1996 twin turbo, about 6 months ago now i replaced both front outer CV joints and boots due to a grinding when turning at slow speed e.g a car park. the grinding had gone and its was all fine until now the same grinding as come back. its it normal for the CV joint to wear out that fast or could there be a different problem?
View 5 RepliesMy wife has a 2008 Dodge Charge SXT with the 3.5. The front passenger wheel is "shaking/bouncing" at highway speed, but only when turning that direction on a curve. It doesn't do this when turning left. We had the tires replaced, because that was the suggested fix because the tire was "chopped". They were at end of life anyway, past the ware bar. But it didn't work and it seems to be getting worse. One mechanic said he thought it was the wheel hub, another said tie rod. I replaced both front tie rod ends after the passenger one fell out about 18 months ago.
View 15 RepliesI am trying to get some advice on a diagnosis for a transmission problem i'm experiencing with my vehicle? It's a manual transmission and the sound i am hearing is when i shift gears is a loud whirling grinding sound. It's really loud in 2nd 3rd and 5th and doesn't stop.
View 1 RepliesI have a 2000 honda accord. I have it for a long time and then few months ago i just notice that every time my car reaches 40 km/hr onward, my car is producing a loud sound even i put it in neutral sound will never gone it will only go back to its normal sound when the car goes 39 km/hr down. My car has a problem with the cv joint i think because i can hear a "tik-tik" sound every time I am turning. do you thing the loud sound comes from the cv joint too?
View 2 Replies