Dodge - Dakota :: Truck Goes Dead When In Neutral But Will Stay On In Gear
Mar 18, 2015
Yesterday my truck would stay on if I had the gas on, or if I put it in gear and drove but when it was in neutral it would shut off. And then after driving it for a few minutes it completely shut down. It is a manual transmission.
View 4 Replies
Advertisement
When cold the trans works fine for about 15 mins, then its like you put it in nuetral. No forward no reverse. A friend suggested changing filter/fluids so I did. Worked great for about 4 hrs then same thing. Leave it sit for a few hours and it works good for about 15 mins then nothing. Should I try another filter or something else?
View 1 Replies
At first it wouldnt start without me burying the throttle, and wouldnt stay running if i took my foot off the gas, i replaced the throttle position sensor and it starts with no issue, but now if i give it any gas, it shuts of, unless i let off the gas very slowly, what do i do?
View 7 Replies
I have a 1997 Dodge Dakota V8 (automatic) with about 140k and live in Vermont. Recently, my truck will konk out while I am sitting at a red light. As I'm sitting there, the RPM's keep going down below 700, until finally stalling out completely. When I shift into Park/Neutral then turn ignition, it will start right back up again. To get around this, I have been shifting into Neutral while I wait at the light, then back into Drive when it turns green. I have recently installed a new battery and exhaust system. I am wondering if this is occurring because of worn plugs, a dirty air filter, cracked vacuum hose, or bad alternator?
View 2 Replies
so my 96 dodge dakota has been acting up a lot lately. I can barely drive in town let alone on the highway. when I drive, keep in mind its random most of the time, my truck will start jumping and then lose power. when I try to power thru it my truck will backfire and then shut off. once I try to start again it floods the engine. most of the time it will do this going up a hill or when it has to get above 3000 rpm. I don't know what's causing it. I replaced the throttle body fuel injection sensor and tranny filter but I figure its a fuel problem.
View 9 Replies
I have an '88 Dakota, 230K miles, with the following problem:For the last month or so, the truck has been hard to start--had to crank once, wait 10 seconds or so, then crank again. Gradually, this problem increased to the point where it would stumble at WOT, then even at 3/4 throttle or so.Thinking it was the fuel pump, I replaced it, along with the filter.
Problem remains; in fact, it seems even worse, to the point where the truck only idles (can't put any load on it, or it stumbles). So, at this point I suspect the fuel pressure regulator. However, I don't want to buy it unnecessarily. Given that a F.P.R. is designed to send a part of the pump output back, would pinching off part/all of the return line be a valid diagnostic test?Anything else that comes to mind?
View 1 Replies
I have an 87 longbed Dakota that I bought new. It's my work truck. Lately it has developed a chirping noise that I hear best with the rear slider window open. I think it is safe to say that it is not coming from under the hood. When I accelerate from a stop the chirping noise increases in pitch and frequency. The frequency does not change when the auto trans up shifts. There has been no noticeable out-of-the-ordinary vibrations, even at freeway speeds.
I have stopped driving on the freeway since the chirping became impossible to ignore. The chirping becomes less and less audible the faster I go as the pitch and frequency increases. When just starting from a dead stop, it sounds like a metallic scraping noise. Whenever I take my foot off the gas the chirping stops, even when still coasting, so it only occurs under load. It does not occur when the truck is stopped and the engine is revved.
View 9 Replies
The truck will go into reverse, but will not go into drive or any of the other gears. When shifted into one of those gears, it just idles as though in neutral. This started as I was driving down the highway at approximate 70mph. The speedometer jumped up then fell to zero as the car slowed to a stop. There was no noise except the sound of rapid fuel intake and then it went to idling. I have been told it may be a speed sensor, but I was wondering if there was anyway to confirm that before I have the truck towed down to a mechanic and find out its more than I want to pay to fix it.
View 1 Replies
I have a 2000 dakota in the morning after the first start, moving foward the truck rocks and feels like trans. slipping. After 5 mins, just fine. Change the Trans. Ffilter?
View 1 Replies
we had a shop replace a thermostat in oct 10, last week our truck started running hot so we put in about 3 qt of 50/50 coolant. it returned to normal temp the next day we noticed some foam coming out of the overflow. when we opened the hood it looked like a brownish/red color and is a thick foam. When taking it back to the garage they cannot tell what it is. They have tried to flush it out and say they put in 3qt of fluid and only get out 1qt. It can be chunky at times. What it could be?
View 1 Replies
My 2003 Dodge Dakota does not shift properly sometimes going into second gear and it only happens in second gear. I have to lift my foot off the accelerator for it to shift into third. If I don't it just screams at a high RPM and sounds as if it is about to blow. It has a hard time making it up a small incline such as an off ramp. Truck will not shift properly when going up grade. Engine will rev at 4500-5000 rpm but will not shift until I slightly release the gas pedal. Truck will also perform multiple hard up shifts whether in cruise control or not in cruise control, going upgrade. Took the truck to the dealer reprogrammed the computer with a "flash update" that was no luck. Not once has the ENGINE LIGHT ever come on.
So a lot of the comments that were presented to me I have done. Here is a list:
Changed govner senors and solenoid. Did not work.
Checked for exhaust leaks and other leaks. No leaks.
Checked all vaccuums. No problems there.
Had engine checked and dyno tested. No problems there.
Had transmission rebuilt. Same problem. (dealer did work)
Had new transmission put in. Same problem. (dealer did work)
Also, sometimes when I put the truck in reverse, it seems to about to stall, but it doesn't. It also does it sometimes when I put the truck in drive it seems that it wants to stall.
I just recently learned that my truck has a Transmission computer module, Transfer case computer module and of course the main computer. Is there a way to test those modules out?
View 3 Replies
I have a 2002 Dodge Dakota with 130,000 miles on it, 360 engine, automatic transmission, and I am the original owner. About three months ago it started not shifting out of first gear correctly. I can bring the speed up to 30 mph and let up on the accelerator and then it will shift up. Once it is going it shifts back and forth in the upper gears and I can override the overdrive just fine. I have towed a trailer during this time and the transmission is as strong as before. I have the oil and filter changed as per the owners manual. Years ago the owner of our local dealer and I had a dispute over the warranty on the front brakes locking up and he asked me not to darken his door ever again so I have obliged him and would rather not change this arrangement. The shop I have used for years cannot find any problem and no codes show up on the computer.
View 3 Replies
When I start the truck in cold weather, the transmission doesn't want to shift out of 1st gear. Some time it take driving it a 1/8 of a mile before it shifts.
What is wrong / need replaced ? I was told to shift it thru all the gears before I move it to warm up the transmission fluid ? I'm thinking some sensor needs replace ???
View 4 Replies
This morning my 2006 Dodge Dakota v8 auto decided to become a large paperweight. I started it up fine and let it warm up a bit (about five-ten minutes), then shifted into reverse to leave my driveway and it won't move. It just rev's and rev's like it's in neutral. I tried Reverse, Drive, and both low gears, but no luck.
Since it got very cold, it has been making a buzzing/whirring sound that seems to be coming from the belts. But that sounds would go away when the car warmed up. I thought I needed a new power steering belt (and still may), but that wouldn't keep the car from moving at all, right?
View 19 Replies
The starter in my '93 Dakota was dying (usual signs of worn brushes) so I replaced it with a new one from AutoZone. The starters looked the same, and after calling back to double check the part #, the store swears it's the right part. However, when I engage the starter, it spins but the pinion gear doesn't engage the flywheel. I can't see how I could have installed it wrong - the two bolts seem to have only one place they can go.
View 19 Replies
2008 prius won't stay in gear, goes to neutral when hot...
View 12 Replies
This is an ongoing problem that has lasted for several weeks now -- I’m completely flummoxed and at a loss. It goes something like this:
My truck (2000 Dodge Dakota, 2.5L, 5-speed) has developed -- for lack of a better term -- a high-pitched whining squeal, which only occurs after I put it in gear and actually start moving (if I leave it idling in neutral, when starting it after letting it sit overnight, the sound usually does not appear at all). After about three or four minutes of driving time, the sound will show up, but there’s an odd twist: the sound is most apparent, and really loud, when the truck is at idle, such as when at a stop sign or traffic signal; when I put it in gear and take off, the noise will drop in pitch and, depending on how hard I’m pressing on the accelerator, it sometimes disappears altogether.
When I take off, every time I shift gears the sound returns -- only for as long as I step on the clutch and back off the gas, and when I step on the accelerator again the noise falls in pitch and vanishes. It does this off-and-on thing through all the gears, and after reaching the desired road speed (and I’ve reduced pressure on the gas pedal) the sound returns and is constant. Also, if I shut the truck off and wait just a few minutes, and then fire it back up, the sound will be gone, but will return after a short while, exactly as related above. It’s worth noting that, during all this irritating misadventure, the engine has run exactly as it always has -- there’s been no discernible impact on performance.
Now, some considerations. The noise is louder and more strident when the ambient temperature is lower, such as in the morning. Later in the day, when the temperature rises, the sound becomes erratic and somewhat unpredictable, and is much lower in volume, and it will even stop abruptly and then reappear later.
Many people have suggested that it could be the belt or a pulley, maybe. I replaced both tensioners and even installed a new, shorter belt to bypass the A/C compressor (to eliminate it as the possible culprit), but the noise remains. I was skeptical of all that because -- and please correct me if I’m wrong -- a shot pulley making such a horrible racket should get louder as engine speed increases, not drop in pitch and disappear. In fact, the noise seems to have no relation to engine RPM; if anything, it seems tied somehow to intake manifold pressure (the sound vanishes when the truck is accelerating, which is when intake manifold pressure goes down, or so is my understanding), or throttle position, or something else entirely. The vacuum system? The noise seems mechanical to me, not like escaping air (or, well, vacuum) . . . but what do I know?
View 3 Replies
Caravan acting like it was in neutral when she put it into gear and then jumping abruptly. She solved the problem by turning it off and back on. I think her problem might be the Speed Sensor b/c my Ford Taurus did the same thing for years: When put into gear, doesn't move and revs like in neutral, then suddenly jumps into gear sometimes. Problem could sometimes be solved by turning it off and on or moving gear shift to park and then back to drive. Also, even after warming up, when starting from a stop it would stay in 1st gear and not shift up, then suddenly shift up and car would jerk forward. Sometimes when it wouldn't switch gears the RPMs would remain high, even on highway. We thought we needed a new transmission! We found on line that it might be the speed sensor, which lets the car know what speed you are going. We switched it out and all the problems disappeared!
View 1 Replies
I have a 1994 Dodge Ram 1500 with the 5.2L V8 (and 46RH AT), with 147,000 miles. Here's what I've been noticing over the past few months: when the engine is up to full operating temperature, and the truck is in gear but idling, the oil pressure (according to the oil pressure gauge) gets very low, and in fact, the needle often "bottoms out", going to a reading of "0", and the "dummy light" comes on. When this happens, there's no change whatsoever in how the engine is running; it runs perfectly fine (which is why I haven't bothered to fix it). Also, as soon as the engine is given a little throttle, the pressure reading goes back up and behaves normally under driving conditions (unless at idle). As mentioned, this only happens when the engine is completely warmed up.
I check the oil regularly, and it is always within the acceptable range.
View 9 Replies
97 Dodge Dakota Sport V8. Has spark, turns over, won't fire.
View 1 Replies
My dad has a 2001 Dodge Dakota extended cab with a 3.9L v6 (standard transmission). It will start and run for a while and it will die, if you turn the key it will start up again but will eventually die. He has changed the spark plugs & wires, the distributor cap & rotor, the MAP sensor, and the throttle valve sensor. It still does the same thing.
View 1 Replies