I just replaced fuel pump and tps on my 1989 Dodge Dakota 4 cyl truck. Now it idles rough and the check engine light came on. I have removed battery cable to reset computer but did no good. What could be the problem now? I have since replaced the plug wires and distrib cap and it is flashing 3 5 5 twice now?
View 10 RepliesOn empty a week ago, filled 1/2 a tank, drove home no issue. Didn't drive truck for a week. Turned it on this morning (didn't warm it up) about 10 minutes into the drive anytime you tried to accelerate, the truck would buck. If you were idling or just had your foot slightly on the pedal driving at the same speed it was fine, it only bucked when I really pushed on the pedal to accelerate. The check engine light started flashing as well.
View 3 RepliesMy 2005 Dodge Dokota 4.7L V8 152,000 miles has an intermittent check engine light (CEL) code P0420 ('catalylst efficiency') that turns itself off.
1) 151,000 CEL on, code P0420, checked, cleared at dealer.
2) 151,948 CEL on, code P0420, checked, cleared at dealer (Cat Conv).
3) 152,200 CEL on, code P0420, checked, cleared at local auto parts store.
4) 152,597 CEL on. No checks.
5) 152,815 CEL turned off on its own
6) 152,849 CEL on. No checks.
7) 153,137 CEL turned off on its own.
Twice in this time CEL has came on soon after a fill up from near empty.
Engine runs fine, 18-19 mpg highway.
Have seen numerous on-line reports of other possible causes:
a) base engine problems (coolant or oil) -- coolant temp sensor
b) Air inleakage -- air systems or manifold
c) Lazy front O2 sensor
d) fuel pumps
e) timing or misfire
f) what else? - (gas cap, other...)
What to check first or categories to eliminate?
I have been experiencing some issues with my '06 rio5 (same engine as your hyundais). this forum is way more active than the kia forums, so figured id give it a shot here.
I am experiencing a rough idle at start up while the car is low on fuel (<1/4 tank). it idles rough for a few seconds, the check engine light flashes a bit, and then it runs fine.
The car is an '06 rio5 with approx 19k miles on it, five speed manual. Also, sometimes after refueling and it will just shut off while waiting at an intersection. Not sure whether these two issues are related, but thought i would mention it just in case they were.
I recently purchased an 06 f150 fx4 5.4L with 60K miles. Just recently my check engine light came on and I've noticed a slight rough idle in park. I took it to autozone and the code read P0422 evap emission leak. Bought a new fuel cap but didn't work... EGR valve?
View 2 RepliesHere's what is going on with my 2000 Dakota V6 3.9L V6:
After sitting for at least a couple of hours, the truck will crank but not start. After 3-5 tries, the truck does start but idles roughly at a very low RPM for 10 seconds or so and then stalls. I turn the key one more time and it starts up great and idles and drives normally. This behavior is very consistent. I have only driven it about 5 miles after it started doing this, because on that trip, the engine stalled while I was driving. Occasionally the MIL comes on and gives P0443 as the code. Question is, can the evap purge solenoid cause this behavior if it is going bad? I have inspected the vacuum lines, and they seem ok.
One more note: When this first started, I was pretty sure it was the fuel pump. Replacing that has not fixed the problem, and the fuel pump relay is good.
I have a 2000 Dakota 5.9 truck that has all of a sudden started to idle rough, loses power over 3000rpm or any kind of reasonable acceleration , with a big sucking sound from the throttle body ( no leaks), seems like it is not getting fuel. Someone mentioned it maybe the "MAP" sensor.
View 2 RepliesCold start. engine starts but wont idle, just dies. rpms drop. Restart same. Must neutral drop to get going keep rpms up until engines shifts then things are fine until next cold start. Cleaned throttle, changed air filter, dry gas, injector cleaner, no warning signal, scans clean. 180k miles.
View 6 RepliesI recently had a Jasper rebuilt engine installed in my Ford E150. Since than my check engine light keeps coming on and the computer is saying my cas air mix is "lean". The instaler says i need a new fuel pump.Another mechanic says it is more likely a vacuum problem.I know it's possible that the fuel pump is bad bur since this has just started since the install, I don't believe it can be the fuel pump unless it's just one hell of a coincidence.
View 6 RepliesWell I had the dreaded loss of power and EPC/Check Engine light happen on Monday. Was driving down the Interstate and all of sudden we just lost power. It did not go completely dead, but it ran like crap. Called the local VW and they advised to bring it in, still under warranty (27k, 26mths) and it turned out to be the high pressure fuel pump. They replaced the pump and the replacement was bad! Luckily they tested it before they got it out the door back to me. Provided me with a loaner and the dealer had to get a replacement pump overnight. Picked up the car yesterday and everything drives the way it should again.
I had already had the software update, but according to the service advisor that was for the fuel pump in the tank, not the one on the engine. Not sure if that is correct, but that is what the advisor told me..
New 2012 Tiguan S with a manual, 800 miles and the check engine light comes. Seems to idle a little rough, at least the idle seems to fluctuate a bit. The real disappointing part is I took it in to the dealer expecting an easy fix within an hour, its now been at the dealer for 2.5 days and they'll have it over the weekend as well. They tried putting several parts in it, still didn't fix it. They called VW who said pull out the new parts, put back the old parts, and apply some software update. Dealer did that, still not fixed.
View 7 RepliesFilled tank with 8 gallons of 91 octane to top off. One hour later noticed car running rough at idle then check engine light comes on. Could it be the coil pack? Car has been running very well until now, and this Gremlin appears. I don't think it's the gas.
2004 -V8 Treg
52,000 on the odometer
I replaced my EGR valve vacuum check valve, but now started getting sputtering/rough idle. I'm pretty sure the direction of the vacuum check valve is correct, but I tried both ways to be sure and still got the sputtering at idle.
The old vacuum check valve didn't give me the sputter. I only replaced it because it was melted and I'm not sure it was working. I included a photo of it. It's orange and black.
I just purchased my first foreign car ever. it is a 2002 Elantra it idles very rough changed plugs using NGK and wires new fuel filter and ran 2 full tanks of high grade fuel with STP fuel injector cleaner. but had no effect on idle also have no check or service engine light. What to check next?
View 3 RepliesSometimes the check engine light comes on and truck will not start,the fuel pump runs non-stop.. when check engine light goes off,the fuel pump runs for a few seconds and stops,truck will start.... driving down the road check engine light will come on and truck runs bad....
View 2 RepliesWifes car began to idle very rough and check engine light began to blink and beep, I took it to the mechanic today and he informed me that my control module was no good and it was a $400 dollar piece. I said go ahead get it done, cuz she needs the car and i couldn't afford to not have it done immediately. Question I have is does this small-ass piece really go for that much on average and what control module is it?
View 4 Repliesa 2011 jetta. brake pedal is hard no pumping action. The car show check engine. The idle is not smooth.
View 2 RepliesI just bought this car from the original owner. She didn't take that great of care of the car. First oil change was done at 8,000 miles for example. Basically if it was broken she would fix it, but didn't do much preventative maintenance.
I just replaced all 4 spark plugs and coils since one was misfiring and didn't want to have to go back in and replace one in another few months. Replaced the AC belt a few days ago since it was cracked and worn. All other belts are fine. I drove the car around for a few hours the next day and it ran great.
Today, the check engine light flashes and then stays on. The car is idling rough at stop lights and acceleration is poor. Previously, the light came on and it was the EVAP system. Not sure which component and I was told it isn't supposed to affect the way the car drives.
Replaced fuel pump after cycling multiple times the diesel still isn't going to the engine. The line is not clogged or leaking but the fuel in the after market 44 gallon tank which is about half full isn't going anywhere.
View 5 RepliesMy 3.0 with 216k miles has developed a rough idle and it progressively got better with new parts and cleanings. On startup it revs up to 2k then back down to 600. If I let it idle for about 8 or so minutes my Check Engine Light starts flashing. If I drive about for a little bit it stops and is just fine.
While the light is flashing I get codes P1000, P0305, P0306, and P0316. Which are OBDII Monitor Testing Not Complete, Misfire detected in Cyl 5, Misfire detected in Cyl 6 and Engine Misfire Detected on Startup (First 1000 Revolutions) respectively. Any other time the truck runs like a dream. Gets 20 city and 29.5 highway.
I cleaned my Mass Air Flow, replaced my Idle Air Control, SeaFoamed throttle body and vacuum lines, brand new coil pack, new wires, new plugs, new fuel filter, I've only ever run 91 octane, Chevron with Techron goes in at every oil change and B12 every other and I just ran 3 bottles of Lucas fuel injector cleaner.
I started out with my 2000 F150 with a 5.4 V8 running rough at idle. It would idle way down slow and then rev up a little over and over. On a couple of occasions it would even die when in drive or reverse. I did finally get a Check Engine light so i put it on my diagnostic program to see what was up. Here is what I got:
P1151 Lack of HO2S21 Indicates Lean
P0171 System Too Lean Bank 1
p0174 System Too Lean Bank 2
After doing some reading up I checked all my vacuum hoses and cleaned my mass air flow sensor. I then got the same codes again after a few minutes of running. So I went to the next thing that was recommended, the upstream bank 2 O2 sensor. After changing it the truck ran fine for a couple of days, no issues. Then all of the sudden it idled a little funny again and I got a Check Engine Light again. This time:
P0171 Bank 1 Lean
P0174 Bank 2 Lean
P0300 Random/Multiple Misfire
I reset the light to see if I would get the same again later. Before the light came on again I filled my truck up with gas and it seemed to be running pretty good again. Then a day or so later it set the light again. This time:
P0171 Bank 1 Lean
P0174 Bank 2 Lean
P0136 O2 Circuit Malfunction Bank 1 Sensor 2
P0156 O2 Circuit Malfunction Bank 2 Sensor 2
P1131 Lack of Switches HO2S11 Lean
P1151 Lack of Switches HO2S21 Lean
I went ahead and drove for a few days as it had gotten really cold here and I didn't feel like messing around in my shop since it isn't heated. A couple days ago I needed gas so i filled up again. Suddenly the problem was gone again. Truck ran fine idled fine no missing or odd idling at all. That lasted a day or two before it started acting a little weird again. At that point i was down about 1/8 of a tank from full. I have read that there can be issues with the fuel pump.. I am kind of wondering if that may be it now. But I haven't had to deal with this sort of issue before so I am unsure what to check next. The truck always runs fine off idle, it only seems to have the issue when it is idling. I had reset the codes the last time and i have the light on again now. I haven't checked it yet but I am sure it is going be some combination of what i have had in the past.
I have read that the IAC valve can be an issue as well. I had a problem with mine sticking a couple years ago and when it would do it you could just tap it with a wrench and it would idle up. But it never died like it does now and it would also idle a lot slower than it does. Back then I cleaned the valve and had no more issues with it. The truck has always had times when it would act weird at idle usually after slowing down after being at highway speed. The current issue happens at all temps cold or hot.