When I start the truck in cold weather, the transmission doesn't want to shift out of 1st gear. Some time it take driving it a 1/8 of a mile before it shifts.
What is wrong / need replaced ? I was told to shift it thru all the gears before I move it to warm up the transmission fluid ? I'm thinking some sensor needs replace ???
I have a 2002 Dodge Dakota with 130,000 miles on it, 360 engine, automatic transmission, and I am the original owner. About three months ago it started not shifting out of first gear correctly. I can bring the speed up to 30 mph and let up on the accelerator and then it will shift up. Once it is going it shifts back and forth in the upper gears and I can override the overdrive just fine. I have towed a trailer during this time and the transmission is as strong as before. I have the oil and filter changed as per the owners manual. Years ago the owner of our local dealer and I had a dispute over the warranty on the front brakes locking up and he asked me not to darken his door ever again so I have obliged him and would rather not change this arrangement. The shop I have used for years cannot find any problem and no codes show up on the computer.
View 3 RepliesMy 2003 Dodge Dakota does not shift properly sometimes going into second gear and it only happens in second gear. I have to lift my foot off the accelerator for it to shift into third. If I don't it just screams at a high RPM and sounds as if it is about to blow. It has a hard time making it up a small incline such as an off ramp. Truck will not shift properly when going up grade. Engine will rev at 4500-5000 rpm but will not shift until I slightly release the gas pedal. Truck will also perform multiple hard up shifts whether in cruise control or not in cruise control, going upgrade. Took the truck to the dealer reprogrammed the computer with a "flash update" that was no luck. Not once has the ENGINE LIGHT ever come on.
So a lot of the comments that were presented to me I have done. Here is a list:
Changed govner senors and solenoid. Did not work.
Checked for exhaust leaks and other leaks. No leaks.
Checked all vaccuums. No problems there.
Had engine checked and dyno tested. No problems there.
Had transmission rebuilt. Same problem. (dealer did work)
Had new transmission put in. Same problem. (dealer did work)
Also, sometimes when I put the truck in reverse, it seems to about to stall, but it doesn't. It also does it sometimes when I put the truck in drive it seems that it wants to stall.
I just recently learned that my truck has a Transmission computer module, Transfer case computer module and of course the main computer. Is there a way to test those modules out?
I have a 1999 Dodge Durango, 8cyl., auto transmission with about 211K miles on it.For several months now the car has problems shifting from 2nd to 3rd gear. It goes from first to second without trouble, but to get to third I have to over-rev the engine and then let off the gas and then give it a small bit of extra juice for it to catch the third gear. In the past it seemed to happen only AFTER the engine got hot. Interestingly for the last couple of months it shifted just fine, maybe because it's very cold outside.
Today, the transmission gave me a ton of problems and I was afraid it would give up on me before getting home. It just wouldn't shift into 3rd gear at all. I limped the last 5 miles home in 2nd gear. Checked fluid and that was fine. I added a 1/2 quart. After a few hours I drove the car for short distances at various speeds to force the transmission to shift. At first it seemed to be OK again, but as soon as the engine got hot I ran into the same problem again.
I last changed the fluid 3K miles ago, but before that I drove it for 120K miles without a change. What to look for now or is this a job for a specialist? A neighbor of mine suggested to pour a cup of acetone down the transmission and this would "clean up" and cut through the gum and varnish. I am not so sure this is a good idea, but wonder what it could do to seals and other rubber-type things inside the transmission.
Last year, July, replaced Trans.modulator..All went well. Now..sloppy shifting, occasion heavy thump changing gears when slowing. Trans. people say All good according to their programs.....but they also feel the same problems. Its an internal problem, they say, too expensive to tear down.Drive it until it dies. ( 161 K on the odometer.....otherwise is perfect. I want to do a flush, then drop the pan, change the screens, tighten the bands and replace Trans. fluid.
View 1 RepliesI noticed a humming like noise when my transmission is engaged. I looked under the truck and saw a wet spot on the transmission(leaking)It is a manual transmission 5 speed Dodge Dakota 2001.
View 2 RepliesWhen cold the trans works fine for about 15 mins, then its like you put it in nuetral. No forward no reverse. A friend suggested changing filter/fluids so I did. Worked great for about 4 hrs then same thing. Leave it sit for a few hours and it works good for about 15 mins then nothing. Should I try another filter or something else?
View 1 RepliesYesterday my truck would stay on if I had the gas on, or if I put it in gear and drove but when it was in neutral it would shut off. And then after driving it for a few minutes it completely shut down. It is a manual transmission.
View 4 RepliesThis morning my 2006 Dodge Dakota v8 auto decided to become a large paperweight. I started it up fine and let it warm up a bit (about five-ten minutes), then shifted into reverse to leave my driveway and it won't move. It just rev's and rev's like it's in neutral. I tried Reverse, Drive, and both low gears, but no luck.
Since it got very cold, it has been making a buzzing/whirring sound that seems to be coming from the belts. But that sounds would go away when the car warmed up. I thought I needed a new power steering belt (and still may), but that wouldn't keep the car from moving at all, right?
The starter in my '93 Dakota was dying (usual signs of worn brushes) so I replaced it with a new one from AutoZone. The starters looked the same, and after calling back to double check the part #, the store swears it's the right part. However, when I engage the starter, it spins but the pinion gear doesn't engage the flywheel. I can't see how I could have installed it wrong - the two bolts seem to have only one place they can go.
View 19 RepliesI have a 2000 dakota in the morning after the first start, moving foward the truck rocks and feels like trans. slipping. After 5 mins, just fine. Change the Trans. Ffilter?
View 1 RepliesThis is an ongoing problem that has lasted for several weeks now -- I’m completely flummoxed and at a loss. It goes something like this:
My truck (2000 Dodge Dakota, 2.5L, 5-speed) has developed -- for lack of a better term -- a high-pitched whining squeal, which only occurs after I put it in gear and actually start moving (if I leave it idling in neutral, when starting it after letting it sit overnight, the sound usually does not appear at all). After about three or four minutes of driving time, the sound will show up, but there’s an odd twist: the sound is most apparent, and really loud, when the truck is at idle, such as when at a stop sign or traffic signal; when I put it in gear and take off, the noise will drop in pitch and, depending on how hard I’m pressing on the accelerator, it sometimes disappears altogether.
When I take off, every time I shift gears the sound returns -- only for as long as I step on the clutch and back off the gas, and when I step on the accelerator again the noise falls in pitch and vanishes. It does this off-and-on thing through all the gears, and after reaching the desired road speed (and I’ve reduced pressure on the gas pedal) the sound returns and is constant. Also, if I shut the truck off and wait just a few minutes, and then fire it back up, the sound will be gone, but will return after a short while, exactly as related above. It’s worth noting that, during all this irritating misadventure, the engine has run exactly as it always has -- there’s been no discernible impact on performance.
Now, some considerations. The noise is louder and more strident when the ambient temperature is lower, such as in the morning. Later in the day, when the temperature rises, the sound becomes erratic and somewhat unpredictable, and is much lower in volume, and it will even stop abruptly and then reappear later.
Many people have suggested that it could be the belt or a pulley, maybe. I replaced both tensioners and even installed a new, shorter belt to bypass the A/C compressor (to eliminate it as the possible culprit), but the noise remains. I was skeptical of all that because -- and please correct me if I’m wrong -- a shot pulley making such a horrible racket should get louder as engine speed increases, not drop in pitch and disappear. In fact, the noise seems to have no relation to engine RPM; if anything, it seems tied somehow to intake manifold pressure (the sound vanishes when the truck is accelerating, which is when intake manifold pressure goes down, or so is my understanding), or throttle position, or something else entirely. The vacuum system? The noise seems mechanical to me, not like escaping air (or, well, vacuum) . . . but what do I know?
I have 142k miles on my 2005 RX330 AWD. This week I can feel the transmission slip/shudder when shifting from 2nd to 3rd gear.
My local transmission guy is pretty reasonable but like most salesmen he's going to say rebuild it the entire transmission in lou of something less invasive.
I recently purchased a 2004 Excursion Limited v10 with 129,000 miles.
It has developed a strange sound only when it is shifting to the high gear where the tach drops down to abour 1500 rpms.
It sounds like a 'whump' momentarily, but doesn't seem to be slipping after that. I don't know if the tranny fluid has been changed, although it looks clear on the dipstick.
One mechanic said they would not do a transmission flush on a vehicle with more than 75,000 miles because they didn't want to be responsible for tranny problems caused by doing that. What's going on?
I have a 2004 Dodge Intrepid. Here's the deal. When I drive on the highway (higher speeds) and then slow down, the car (automatic transmission) automatically downshifts drastically (like throw me through the windshield drastically) and then will not come out of that lower gear.. UNLESS I turn off the engine and restart it, THEN it fixes itself (took me a while to discover this). When I am driving around town at lower speeds this does not happen. Only if I get to higher speeds and then slow down. And one other symptom...SOMETIMES I can just be at a stop light/sign, still in drive, but when I put on the gas to go, it stays, like the car is in neutral, even though the gearshift is still in drive.
View 8 RepliesGasoline backs up in the filler neck while pumping. I've disconnected the vent tube on the filler neck and disconnected the hose going to the canister next to the fuel tank. I've let the engine run during fill up, but this does not change things. Violently shaking the truck while cursing only provides entertainment to other motorist at the pump. I gave up my career as an auto mechanic in the 80's when cars were being made out of metal.
View 5 RepliesOn empty a week ago, filled 1/2 a tank, drove home no issue. Didn't drive truck for a week. Turned it on this morning (didn't warm it up) about 10 minutes into the drive anytime you tried to accelerate, the truck would buck. If you were idling or just had your foot slightly on the pedal driving at the same speed it was fine, it only bucked when I really pushed on the pedal to accelerate. The check engine light started flashing as well.
View 3 RepliesMy 04 Dakota 4x4 makes a clunking noise when
1) in 4-wheel drive going forward while turning either direction (but not while going straight) and
2) in 4-wheel drive in reverse (straight or turning). It does not do it in 2-wheel drive under any circumstances.
I suspect the front drive shaft U-joints since it only happens in 4-wheel drive. Rear drive shaft U-joints or front CV joints would be a possibility but I would think they would cause a noise in both 2 and 4-wheel drive and in either direction equally.
The truck had a hard time starting, turn the key over hear that it wants to, but won't. Once getting it started, truck would drive fine, but after about 10 minutes just dies while driving. It then took 6-7 tries to get it started again, drove back like no issue. What it could be? I have come up with, potential battery, fuel pump/filter, spark plugs, EEC relay, PCM, or AIS motor, O2 sensor....
View 2 RepliesI have a question about a dodge neon 2002. I am wanting to buy this car from a guy, but he says it needs a power control module. Then car starts up and runs fine, it doesn't smoke etc; the problem is when your driving it, it will not shift into gear and will go back into neutral. I want a opinion on what it could be and what something like that could even cost to get fixed.
View 13 RepliesMy 2006 Elantra (54,000 miles) shifts really, really hard when it's not cold and passes through the 35 mph range -- hard enough to make you glad you've got your seatbelt on. I've taken it to my regular mechanic and now it's in an automatic transmission shop.
My mechanic changed the fluid (twice), and took it through a "learning sequence". The fluid didn't look that bad and he reported that there were no codes to work with. He thinks I'm going to have to get a new transmission.
The AT shop has confirmed that there are no codes to work with and that the problem begins at 143 degrees. They tell me that the transmission is shifting into a higher gear without releasing the lower gear. They tried replacing a couple of solenoids, but that yielded no change in behavior. Now, they're telling me they "think" I need a new computer. I'm just afraid the trial & error approach is going to cost me a boat-load.