Cold start. engine starts but wont idle, just dies. rpms drop. Restart same. Must neutral drop to get going keep rpms up until engines shifts then things are fine until next cold start. Cleaned throttle, changed air filter, dry gas, injector cleaner, no warning signal, scans clean. 180k miles.
View 6 Replies'97 dodge dakota engine starts and vehicle will move and then engine dies. Just bought it and it ran fine. Coil was replaced by previous owner four months ago. At times it will run fine but is not reliable and wife will not drive in it. Had it towed to dodge dealer and they said it needed a new coil which they installed and still have the same problem and now think it might be the ecm which is mine even if it does not cure problem. Truck has 145k miles and otherwise is in good shape. When it does run, engine is strong, automatic shifts good and all accessories work. But, it won't keep running.
View 14 RepliesI have a code scanner which indicated that I should change the MAP sensor. I did that, and just for fun changed the idle air control valve and throttle position sensor. Now the idle is extremely smooth in park or neutral, but once I'm in a moving gear it's up to the same shenanigans, antics and tomfoolery I described in my original post: 96 Dakota SLT idles rough & stalls. So I have a 96 Dodge Dakota SLT 3.9 4WD. Anyway, it idles relatively smoothly at about 700 RPM in drive or neutral, but if I'm in a moving gear and need to stop, the idle is extremely rough. Usually, the RPM's will drop to near 0 within about 20 seconds of coming to a stop. It will typically recover and continue with rough idling and near stalling a few times, but within a minute or two it stalls. A few additional details: it starts right up again after falling, it doesn't make any difference if I start it cold and drive immediately or drive it for an hour before coming to a stop, the same thing happens. Anything that looked suspicious to me has been changed (drivebelt, spark plugs & wires, distributor cap & rotor, pcv valve, idle air control valve, and, of course, the air freshener).
View 1 RepliesSo I have a 96 Dodge Dakota SLT 3.9 4WD. Anyway, it idles relatively smoothly at about 700 RPM in drive or neutral, but if I'm in a moving gear and need to stop, the idle is extremely rough. Usually, the RPM's will drop to near 0 within about 20 seconds of coming to a stop. It will typically recover and continue with rough idling and near stalling a few times, but within a minute or two it stalls. A few additional details: it starts right up again after falling, it doesn't make any difference if I start it cold and drive immediately or drive it for an hour before coming to a stop, the same thing happens. Anything that looked suspicious to me has been changed (drive belt, spark plugs & wires, distributor cap & rotor, pcv valve, idle air control valve, and, of course, the air freshener).
View 1 RepliesI have a 2000 Neon with about 170K miles on it. with in the last 2 weeks it has been having a problem with acceleration. When i start to drive the RPMs will get up to 4 before it will start to move. Also when i am drive and need to pick up speed the RPMs will also go up to about 4 before it starts to pick up speed, but will drop back down when the speed goes up. I have found a little oil in the spark plug tubes and will be changing the seals out, and I have cleaned to MAP sensor as will. What is going on with my acceleration.
View 3 RepliesHere's what is going on with my 2000 Dakota V6 3.9L V6:
After sitting for at least a couple of hours, the truck will crank but not start. After 3-5 tries, the truck does start but idles roughly at a very low RPM for 10 seconds or so and then stalls. I turn the key one more time and it starts up great and idles and drives normally. This behavior is very consistent. I have only driven it about 5 miles after it started doing this, because on that trip, the engine stalled while I was driving. Occasionally the MIL comes on and gives P0443 as the code. Question is, can the evap purge solenoid cause this behavior if it is going bad? I have inspected the vacuum lines, and they seem ok.
One more note: When this first started, I was pretty sure it was the fuel pump. Replacing that has not fixed the problem, and the fuel pump relay is good.
'99 Intrigue (3.5L) with 65k miles. The car has sporadic starting problems where turning the key in the ignition turns the starter motor and results in one of the following scenarios:
1) The engine does not turn on.
2) The engine turns on, RPMs drop and the engine sputters and dies.
3) The engine turns on with no problems (like this morning).
It does not appear to matter whether the engine is hot or cold.
Reading forum posts of people that have seen similar problems, several different solutions would seem to be in order:
1) Replace fuel pressure regulator.
2) Replace crankshaft position sensor
3) Replace camshaft position sensor
4) Replace fuel filter
5) Replace spark plugs
6) Replace idle air control valve
7) Clean the throttle body
Since I rather not start throwing money at the car by replacing parts one by one until the problem is gone.
I have a 1999 Camry. I just spent $1250 (half of it borrowed) to have some basic maintenance, diagnosis, and serious repair work done. More than half of the serious (translate: expensive) work involved replacing a charcoal canister and installing a thermostat. The check engine light had been on for at least 10 years. And I had a gas pumping problem by way of the pump shutting off after only pumping a few cents worth of gas. Needless to say it was a royal PIA to fuel up my car. As far as the check engine light, a friend would clear the code so I could have it inspected.
Then more than 2 years a shop took out my thermostat because a hose had sprung a leak and they rigged up a temporary hose until they could order the part. I never went back because I couldn't afford it. I know it wouldn't have been a terribly expensive repair, but at the time it was more than I could afford. So for almost 3 years I have driven with out a thermostat and also couldn't get it inspected.
Fortunately I was finally able to get the necessary repair on my car--replacing the charcoal canister and thermostat--so that it could be inspected. I picked the car up yesterday and everything felt fine and the car ran fine.
Today I drove it about 12 miles from my home, made 3 back-to-back errand stops of not more than 15-20 minutes each and everything seemed fine. Nothing felt or sounded out of the ordinary. Then when I was leaving my 3rd stop, the car would not start unless I gave it gas. And it wouldn't stay started unless I gave it gas. In other words, the car would go, but as soon as I would take my foot off the gas to press the brake to put it in gear, the engine would die. There was no problem restarting it as long as I gave it gas, but I could not let off the accelerator at all or it would immediately die.
The car would go just fine, but if I let off the gas for any reason, even if I was driving 40 miles an hour on the street and let up completely off on the accelerator, the rpms would immediately drop to 0 and the engine would immediately die---no noise, no shuttering, no nothing---just die. This problem occurred almost the whole 12 miles back to my home. Then when I got about a mile and a half away, it went back to behaving completely normal and did not die when I let off the gas.
I'll try not to post an entire book.. But I bought a 2000 F250 not even 8 months ago, it did have issues before but I changed out the spark plugs and coils and it fixed it's original missing issues.. I also just recently changed the fuel filter but it didn't fix it's new problem.. It drives ok around town but if I get over 35 mph it doesn't run well... If I try to keep a steady foot on the gas but don't get the RPMs over 2000, the RPMs will stay where they're at for just a second then they will drop down and the whole truck starts shaking.. I push more on the gas and it shakes even more and the RPMs don't move at all until I really step on it.. It lacks in power going up hills as well... The dealership i bought it from said the Catalytic Converter was bad but my uncle who is a mechanic says it isn't.. It's the first vehicle I've bought so kinda wanna make it last..
View 11 Replies2000 Dakota, 4.7 V8 ... The 'CHECK GAUGES' light comes on intermittently. As soon as it comes on, the voltmeter gauge drops to zero (it is a brand new battery); the temperature gauge does flip flops; the truck dies right now. Walk home and come back later, and it starts up again. When you get home, you sure don't feel secure in taking it on the road again. The shop checked it and of course there was nothing wrong when they had it Where do I start the troubleshoot? Is it computer or?
View 1 RepliesAfter I fill my 6 cyl 2004 Hyundai Sonata (280,000 km), the engines starts, then stalls. I can only get it to work by keeping the accelerator pushed to ensure sufficient rpm's. If I remove my foot from the accelerator, the rpm's drop to zero.With the engine revving, I put the car in drive and 'lurch' away from the pump. After that, everything is fine. It starts up properly … until the next fill. My mechanic is mystified and I am frustrated.
View 6 RepliesEngine is a high mileage (over 150,000) one. Truck is manual transmission. Above 2000 RPMS, low rumble noise and vibrations felt through gear shift lever. Only hear it when engine under load. I think its worn crank bearings... 1993/3.9 Dakota ....
View 2 RepliesI just replaced fuel pump and tps on my 1989 Dodge Dakota 4 cyl truck. Now it idles rough and the check engine light came on. I have removed battery cable to reset computer but did no good. What could be the problem now? I have since replaced the plug wires and distrib cap and it is flashing 3 5 5 twice now?
View 10 RepliesA few days ago, I went to start the car, and it will start, and idle fine for a few seconds, and then begin to run crappy, idle down, and die. I tried starting it, and giving it some accelerator pedal, and it dies. I changed the timing belt, idler pulley, and tensioner this summer, so I'm ruling out a bad timing belt. There is no check engine light, and I replaced the plug wires because when I removed the cover, I noticed one of them was worn in a spot, and the wire shielding inside the rubber insulation was visible.
View 11 RepliesI'm struggling with an intermittent (of course) issue where, esp. if cold, I can't start my car unless I give it lots of gas. If I take my foot off the gas at all, it will stall, which means I drive this automatic two-footed (one foot on brake, one on gas) , giving it lots of gas at all times, including when stopped. After about 10 minutes it is fine, and is then good for the rest of the day. My trusted Volvo-spscific repair shop has tried replacing booster pressure sensor, fuel pressure regulator (both indicated by engine codes) and new plugs. The end result is I've got $500 into the car that does seem to run better when it starts, but the original issue is unsolved. I was thinking something is sticking with a cold start, or idle speed is incorrect, but can't figure it out. Seems like it should be an easy fix.
View 2 Replies1997 Subaru SVX (Alcyone) LSi, 3.3L H6 engine.
My SVX was driven from Denver to Las Vegas, NV and it developed an odd habit where the RPMs would start to oscillate while on cruise control. I had to disengage the cruise control to get the oscillations to stop. Three days later I was driving the SVX to work and the RPMs started oscillating at idle and the car started running rough and it died.
These things have all been replaced with OEM grade parts: Spark plugs, electric fuel pump & strainer & fuel filter, Mass Air Flow sensor, new air filter and fuses.
The car starts up fine but after a few seconds the RPMs begin to oscillate. Then the car tries to recover, the idle becomes rough, and the the RPMs drop very low and the engine shuts off.
Twice now this has happened to me and I'm concerned it will become worse if I don't fix it. Driving down the road my engine has disengaged. By this I mean the vehicle both times has been at 55 MPH, my foot on the throttle rpms riding around 1300 revolutions, and the engine disengages rpms drop below idle and my "wait to start" light comes on. This both times lasts approximately 2 seconds and throttle reengages while still traveling 55 MPH, "wait to start" light goes off and its like it never happened. What's going on with my truck? Ford diesel 97 250 7.3 ...
View 2 RepliesOnly started happening within the last month. 1994 V8 Dakota. When its warmer out, half the time I turn the key and nothing happens, doesn't even crank over, but if I tap the gas then turn the key, it starts right up. What this could be?
View 2 RepliesMy '99 Saturn SL2 has from time to time in the past year or so had brief bouts where the engine will suddenly rev up to about 2000rpms while at a stop and/or drop down to about 650rpms combined with surging and stalling while moving. The Service Engine light would typically come on in conjunction with these spells, but then a few days later, things would be back to normal and the light would go off. The episodes seem to correspond with weather that has high humidity, but not necessarily extreme heat. Once or twice when the heat was above 90, the car quit completely and wouldn't restart for several minutes, but that was last summer.
About a month ago the car, which is normally parked in a garage, spent the whole weekend outside when we had some extreme rains (in air temps only about 60s or so). Since that weekend, the car is running frequently with the issues previously described, especially the surging and stalling while driving. It will feel like the timing of the fuel is all out of whack, will shudder and run hard, and then it will suddenly correct itself and run normally. A friend has a code reader and the codes that came up are 404 and 1404, which indicate the EGR valve. We replaced that with a new one and put in 4 new spark plugs, but the problem still persists. I believe the fuel pump is in the gas tank, so from other things I've read, a vapor lock may not be the problem since the fuel is being pushed.
The truck had a hard time starting, turn the key over hear that it wants to, but won't. Once getting it started, truck would drive fine, but after about 10 minutes just dies while driving. It then took 6-7 tries to get it started again, drove back like no issue. What it could be? I have come up with, potential battery, fuel pump/filter, spark plugs, EEC relay, PCM, or AIS motor, O2 sensor....
View 2 RepliesMy 2004 Dodge Dakota V6 4X4 hesitates/jumps/lags (don't know what to call it, but it feels like something momentarily holds back the truck from behind) when I am starting up a hill. I start to loose speed/RPMs and give it a little gas, the RPMs don't change, then it happens. As soon as the transmission does down shift though, and the RPMs go up, it stops. This issue happens the most between about 40 to 50 mph and 1000 and 2000 RPMs. If I turn overdrive off then this problem does not occur even when the RPMs dip down below 2000, which in all fairness is not often. The truck has appx. 128,000 miles on it. What this could be?
View 9 Replies