I have an intermittent brake noise, which sounds like rubber rubbing against rubber. There is no discernable effect on the brakes, pulling, etc. My mechanic can find noting wrong with the brakes.
View 5 RepliesMy 2009 Dodge Ram 2500 with diesel engine, intermittently makes a noise similar to the sound knobby tires make. It also sounds similar to the exhaust brake, but louder. A vibration accompanies the noise. Two mechanics (one a tire expert, one at a Dodge dealer) test drove it and examined it on their racks and said it's the right front wheel bearing/hub assembly. I replaced that, despite not hearing or feeling any problem when rotating the wheel by hand. I've examined all tires and turned the wheels by hand while listening for odd sounds or roughness, and examined all drive shafts and joints which have not apparent problem, to no avail. When this issue first started, I heard a sound like rubber squeaking while driving at very low speed, especially in reverse.
View 1 Replies2002 Dodge Durango 6.9 R/T... I had my bearings replaced 3 weeks ago. And about 1 week later after 40 mins in stop and go traffic I started smelling this hot metal and rubber smell. Then my breaks got really tight when I pressed the paddle. Is this related to having my bearings replaced, what could be causing this to happen every time I am in the car 40 mins or more. It's happened 4 times now and the first time it started smoking. I'm really nervous to drive my truck in stop and go traffic.
View 3 RepliesI have a 2003 Dodge Neon and recently had transmission work done on the car. When I got the car back the radiator cap was left loose, I didn't know this until I took the car for a drive and it overheated. I let the car cool down, replaced the coolant, and made sure the cap was sealed down. The car now has a slow coolant leak, when I turn the car off I can see it drip underneath for about 2 minutes and then it stops. Also, after the car heats up to running temperature I get a burning rubber smell coming through the vents. What could this be? The car only has 70,000 miles on it and I would like to keep it going if I can.
View 6 Replies2002 Lexus ES300 202k ... What causes a temporary burnt oil or rubber smell when I brake hard, lasts only about 1-2 minutes ...
View 2 RepliesThis may be my only chance to do a step-by-step ...
Tools Required : Fingers (preferably attached to hands)
Step One : Check diver side floorboard for cleanliness (people are going to see it in the pics)
Don't worry about passenger side. There will be no pics of it.
Step Two (fingers required for steps two through seven and ten) : Vacuum driver floorboard since there will be pictures made of it.
Step Three : Remove old, worn out brake pedal cover.
Step Four : Remove aftermarket brake pedal cover from ridiculously oversized Amazon box that's still in the passenger side floorboard.
Step Five : Take a picture of the old and new covers together to make fun of the old one.
Step Six : Install new brake pedal cover.
Step Seven : Remove new brake pedal cover and re-install right side up..
Removing the old cracked rubber brake line hoses on my daughters 2003 Ford Escape. Front left no problem. Old off, new on in 5 minutes. All the other won't come free. Can break nut loose, but just spins & spins. What is going on here? Did search and should be very easy.
View 6 RepliesSubject Vehicle: 2003 Ford Escape Limited AWD V6
Mileage: 165,878
The front brake line hoses blew out (R & L) while driving in the city. The parking brake was ineffective in slowing the vehicle as it was traveling down hill. With no means of slowing, the vehicle was turned into a parking lot in an attempt to get on level ground where it was more controllable and could be stopped more easily. The parking lot was not large enough to slow the vehicle and a choice had to be made to crash into a building or drive off the edge of the parking lot to another lot that was approximately 4 feet lower. The 2nd option was chosen. Once the vehicle had landed with great force, it was directed uphill where it eventually came to a stop and put into park.
Unfortunately, extensive damage was done to the frame and underside of the vehicle including oil pan, exhaust system, engine mounts, radiator support frame and under body engine and transmission mounting points. I was told by the tow truck driver, the Firestone auto center and found in other research that Ford Escapes are known for rubber brake line failures. I have had vehicles much older than this and have never had a rubber brake line dry rot and rupture like these. This seems to be a known issue and should be addressed before more damage is done and more people injured or worse. We were lucky. This could have been much worse. Safety issues like this need to be addressed with an immediate recall.
My mother-in-law moved my car and put the emergency brake on (2010 Santa Fe) when she got out. When I got into drive home, I drove about 10miles with it engaged (for some reason the light didn't indicate it was on). When I got home I noticed a burnt rubber smell from the left rear tire. (no smoke though)
Our driveaway is an incline. After engaging/disengaging the e-brake, the light started coming back on again. If I put the car in neutral and release the regular brakes, it will quickly roll back. If I put the e-brake on in netural and disengage the regular brake, it still holds fine on the hill.
I know the damage can vary, but any test or check I can do to determine the amount of damage?
I have a 2012 dodge caravan bought new. After about 6000 miles the left rear brake began making a grinding noise, only when applied, every time the car sat more than a few hours, that goes away after about 2-3 miles. It began in winter and continues into the warm and dry days of spring now with 9000 miles total. Had it to dealer twice and inspection found no malfunction so they say its from rust build up because it goes away all the time and is nothing to worry about. It does not occur with the other wheels. My niece has the same van, in same geographic area and does not have this problem. Does this selective rust build up explanation make sense? Previously burned with bad brakes on a caravan, so am skeptical.
View 7 RepliesWas bleeding my brakes and clutch. Using a power bleeder and it seems as though I put a little too much pressure into the system. The Slave cylinder's green rubber boot filled with brake fluid and began leaking a little. Did I blow a seal? Is this normal with pressure like that? I feel like pushing the clutch in would give more pressure than my little hand pump gives...
View 2 RepliesNoticed a burnt rubber smell while driving today. Stopped at a gas station and before I could get around to the other side of the truck, a guy stopped and told me there was smoke coming from the passenger rear wheel well. The truck seemed to run and drive fine. Didn't seem to be any noticeable drag, but once I got home I felt that wheel and it was a bit warmer than the others.
My parking brake pedal is all the way out and pulling on the release doesn't seem to relieve any pressure or "Pop" like it normally would if releasing the brake. We've got a good downpour of freezing rain right now and I'm not able to start pulling things apart. Anything easy I can try for now? Pretty sure it's seized by the way it's acting but I really don't use the parking brake. Auto trans and I live in a really flat area.
My Gen III is currently at 95k miles, and the large rear bushing on the lower control arms have had small tears for some time.
I have also been experiencing a rubber "crunch-like" noise from the right control arm. I have been able to silence the noise temporarily by spraying silicone lube on the bushing, but the noise returns after a month or so.
While it is a bit subjective, the handling has noticeably degraded compared to when new.
I own a Hyundai Santa Fe thats reaching 70,000 miles. I had my brakes and rotors looked at a month ago and they said its getting low but im good for a couple months.
Now I have this weird noise that sounds like as if my tire is flat almost. Its a rubbery creaking noise coming from my front passenger side tire area. I alternated between using the e-brake and regular brakes and the noise only occurs when using the regular brakes at slow speeds, coming to complete stops and turning as well as going over bumps occasionally.
The video attached, the noise occurs at the end when I have the camera on the tire. Its louder than that usually, but I recorded the video in my driveway.
My friend has a 2007 Avalon with 150,000 miles. He ran over a chunk of rubber tire that was in the road and now has a load noise at 40 to 60 mph. He believes that a sound deading material is missing from under the car. He took it to the dealer and they could not determine the cause. He also took it to a local repair shop and they could not fix it. It appears that this material is used in the wheel wells also.
View 1 Replies98 Windstar 251K
I recently replaced wheel bearing on Front driver side, the noise was present before replacement. When I step on the brakes I hear a squeaking sound like a rubber bushing squeaking, also it changes as the wheels turn. I have also cleaned the brake rotor but have not had it turned for being warped, could this be the piston seal in the caliper or pins.
I have a 2001 T&C, 3.3L, 4-Speed tranny and around 116K Miles. On occasion, I totally lose power steering for about a second or two. It acts like the engine has stalled and I have to muscle the steering wheel. There no belt squealing, no pump noise, and the serpentine belt is relatively new. PS Fluid level is good. It seems to happen at idle RPM.
Of all the caravans I've had, this is a first.
Now, I'm OK with it as long as I don't let anyone else drive it. I know what to expect, and I can muscle the steering when necessary. Once this happened to my on a highway offramp and I was able to control it with no problems. I suspect it is a problem with the rack, maybe?
My question is this: Is this an indication of something going terribly bad, like the total loss of steering control?
For some months, I've heard squeaking noise from passenger side suspension. Sound like it's from shock & spring on bump road.
This video sound is very similar : Squeaking Noise, Front Driver Side - YouTube ...
I looked at my suspension. and found rubber bushing is broken. Driver's side bushing is normal.
Is this noise related to the broken bushing?
Is it easy to replace the rubber by myself?
A guy said ATP AT-205 reseal will fix this noise in Youtube video. Is it true?
How To Fix Squeaks In Your Car - YouTube ....
I just picked up my new Tiguan Wolfsburg yesterday. Beautiful! Drives wonderfully! But an odd thing, I noticed that as I brake, there is this thud, thud, thud noise around the back tires; almost like something is hitting the tire because the thud interval slows as the car slows. Then, when I got out after a 10 mile drive home, I noticed the heavy scent of burning rubber. Does this sound at all like a new car settling in, or possible issues already?
View 3 RepliesMy honda accord is an 05 model, and ever since my mother passed it down to me a year ago, EVERYTHING has been breaking. As of a week ago, any time I turn on the ac, the car shudders violently. It first started when I was parked with the engine on for about an hour, and a low screeching noise along with a smell like burning rubber started emanating from the engine. The noise stopped whenever I turn off the ac, and now it shudders when I turn it on.
Along with that, for the last several months before it completely screwed up, the air being pumped out of the left side of the vehicle was noticeably warmer then the right side. And lastly, starting today, the back center light is fine, but the brake lights don't turn on when I hit the brakes but do turn on when I turn on the headlights. What is going on?
I have a 2005 Dodge Caravan. The blinkers have stopped working...sometimes. Sometimes I put the right blinker on and the left starts blinking, sometimes both left and right work normally, but most of the time neither work. The hazards work all of the time. What I should do, or where to begin.
View 2 Replies