I bought a used 2009 Dodge Avenger and it did not have an owners manual with it and was wondering how do you reset the "change oil" warning light. The old way of turning on the ignition and pumping the gas pedal does not work on this model.
View 3 RepliesI have a 2008 dodge avenger that stalls without warning while I am driving. It happens without any warning signs, happens when I am driving and also when I stop the car. The dealer can't find a thing wrong with it. What's wrong with it? It starts right up after this happens and they tell me my vin number isn't part of a recall for a problem that I have read that other people have with their 2008 avengers.
View 1 RepliesHow to reset service light after a oil change ?
I have a 2009 yaris.
So I did my own oil change for the first time instead of taking it to a shop. Now I have the service warning indicator that comes on in the MFD every time I start the car. Is there any way to reset the interval warning indicator without a vag com or taking it to a dealer/ind. shop?
View 4 RepliesI had a 2010 Dodge Avenger and going down I averaged about 70-75mph and got about 30 mph, coming back I bumped my speed up to about 79-83 and saw the gas mileage dip a bit. So how do you know what speed (Avg) wise while on the freeway to drive to maximize your fuel consumption? Also, what can you do while driving to maximize it? Going down I didn't have any windows open due to some rain and didn't run my AC just vent air. Coming back had the window open a bit and some vent air.
View 19 RepliesI have a 2012 F150 XL. I don't have a message center, just a 2 line LED readout, and there is nothing in the owner's manual about resetting the "oil change required" message.
View 3 Replies2010 2.4L Dodge Avenger SXT... Last month my car started overheating while I was idling but was fine otherwise. About a week later my cars check engine light and my electronic throttle control light came on. I took it to an auto store immediately and did the diagnosis on it. It came up with P2181 Cooling system performance with no reported fixes. Few days later it started overheating while driving. It only took two or three blocks before in the red. Decided to go to the local dealership (didn't want to go there but car is still under warranty) and they said since my boyfriend had messed with it trying to see what was wrong it wasn't under warranty. They said the wrong kind of coolant was in and that i needed to replace my thermostat/ So we changed out the two thermostat and drained/replace new coolant. It is still is over heating.
View 4 RepliesAlready replaced the starter relay will not crank from the key but even when I jump the starter the car still wont start and the switch is in the on position I checked all the fuses and replaced the ecm ....
View 15 RepliesI got new brakes put on a few months ago month (semi-metalic)... Any way anytime I drive and it is raining, when my car comes to a to a complete stop, and I hit the gas to shift into second gear my car sort of stutters like it doesn't want to shift but then it does.
I took it to two mechanics MULTIPLE times who even drove it in the rain and they couldn't find a single thing wrong. they hooked the transmission up to the computer and noticed nothing.
It has happened multiple times and its both been raining. Could it be the tires aren't gripping the road and that's why my cars shifting funny, like the tires aren't caught up?
I have a 2010 dodge avenger sxt replaced fans but won't turn I connected everything back together still nothing....
View 6 RepliesWhen you press on the accelerator the car feels very sluggish it only has 61,000 miles
View 3 RepliesI bought an avenger that runs a little rough and I am trying to figure out if I have a fuel and air problem or a broken motor mount. In neutral or any other gear the car does not shake. In drive it shakes horrendously. Watching the engine as the car is put in drive the engine moves towards you a about 3 or so inches. Now with throttling the car takes a while to accelerate even after I stomp it on the highway to merge. On home roads I can let off the gas and the car will sustain itself at 25 to 30 mph. 1st gear is not very responsive. All other gears seem to be ok with acceleration. I am trying to find a good starting point.
View 3 RepliesI have a 1997 Dodge Avenger ES that reads code P0743 Torque Converter Clutch Solenoid. I've replaced the transmission control module, and filter. I've called the Dodge dealership and asked if the new transmission control module needs to be programmed. The service department said "Possibly" I said "Well it's shifting better than before. If there wasn't any firmware on it what would it do?" He said "My guess it that the car wouldn't shift." I asked if the Torque Converter Clutch Solenoid visible once you remove the filter. He said "I'm not sure." Clearly, my car isn't going there. Then asked to be transfer to the Parts department to see if there was a part called Torque converter clutch solenoid. That answer was "No" there isn't a part listed called "Torque Converter Clutch Solenoid". What should I do or try?
View 9 Replies2008 Dodge Avenger SXT Sedan GEMA 2.4L DOHC I4 / 4 speed automatic75,000 miles Moderately well taken care of (oil change every 3,000 miles, mostly follows recommended maintenance in owner's manual)
Symptoms:
*Car runs and drives fine while the car is in constant motion and decelerating.
*Rough and Slow Idle at a stop on the brakes with car in Drive. Engine speed will drop below ~400 RPM, then "kick" up to ~1,200 RPM, settle back to 'normal' idle ~800 RPM, repeat. I have suggested she put the car in Neutral at a stop to see if that changes anything, but I don't have feedback from her yet. One instance of seeing a puff of smoke from under the hood while the car was doing the above.
*When pulling away from a stop, the car will hesitate; that is the accelerator will be pressed but the throttle response will be delayed.
*When pulling away from a stop acceleration will be inconsistent; instead of rrrrrRRRRRRRRRR, it's more like rrrrRRRRrrrrrRRRRrrrrrRRRRR
*Couple instances where the car just shut off while she was parallel parking (low engine speed).
*One instance where the car did not start on first attempt. Started fine on second attempt.
*No Check Engine Light. The codes have been run.
Shop Visits (at an independent garage recommended by her roommate who's been going there for 5+ years, good reviews on yelp, and always busy):
*First visit: told her they put in a bottle of fuel system cleaner and to use a tank of high octane gas. That didn't really work.
*Second visit: cleaned the throttle body. That was 3 days ago, so far no conclusion either way.
Other repairs:
*The battery was checked (at O'Reilly) and replaced after the starting incident mentioned above. (5 year old car, seems about right).
*2 nights ago I told her to put in a bottle of HEET to get water out of the fuel system (California uses ethanol blend) and a bottle of Gumout Fuel System Cleaner and to fill up with premium gas (based on items below). Be sure to run that tank down to almost empty.
Things I could think of:
*Crankshaft/camshaft position sensor failing.
*Alternator failing (because this problem doesn't seem to exist at higher RPM's)
Research online: It seems that a number of people have similar problems with Chrysler products with this and the previous generation 2.4L engine but no clear conclusive repair. Some of the items mentioned:
*Idle Air Control (IAC)
*Exhaust Gas Recirculation (EGR) valve
*New sparks plugs and wires. (not replaced but should be)
*New timing belt. Timing belt is one tooth off.
*Water in the Fuel System (hence, HEET)
*Dirty/Clogged Fuel System Component (hence, fuel system cleaner)
*Failing Fuel Pump
*Dirty/Clogged Air Filter (replaced per maintenance manual)
*Low Oil Pressure/Failing Oil Pump
*Additionally, there are no recalls against her VIN.
Check engine light computer scan indicates intake manifold runner control valve stuck open. Will it damage the car to drive it in this condition and what does fixing it entail?
View 4 RepliesThe change oil light on my 2013 will not reset. I have tried the routine advised in the manual - turning key to on/accessory and depressing the gas pedal slowly 3 times turning to off and then starting but it does not work.
View 7 RepliesHow to reset oil change flashing light on 2006 Canadian G11.I tried what is said in the manual, but still flashes for about 12 sec. Apparently it will stay on steady if not reset soon? I go to ignition on only and hold odometer down for 5 sec.. It does not reset.
View 10 RepliesHow to reset the Oil Change Maintenance light of 2008 Lexus LS460.
View 1 RepliesI have never had this problem with my 2010 Matrix until this week when I put the summer rims with transponders back on.
As per the manual, I turned the key to "on" and held the reset button. The pressure warning light is supposed to slowly flash 3 times to indicate that it has been reset, then go out. Holding the reset button has no effect this year and the pressure warning light just stays on.
The manual says to take it to a Toyota service centre if the reset procedure fails.
This morning, my 2011 F150, told me that my rear driver side door was a jar on the center console. I opened and closed it several times using the inside handle and the outside handle. It affecting the battery since the interior lights stay on. Is there a way to reset / clean the sensor so that I don't have to take it into the Dealer?.. Their next appoint is mid next week.
View 3 RepliesHow do I reset the oil maintenance reqired check light after change of oil.
View 1 Replies