Civic - Honda :: Engine Would Rev When Gas Pedal Pressed But Car Would Not Go
May 2, 2011
I have replaced the computer in a Honda Civic twice. The first time the car was acting like it wasn't getting power;the engine would rev when the gas pedal was pressed but the car would not go! so the computer was replaced, and two weeks later,t he same thing happened. They said it was a short and would not replace the computer-it was our problem. Finally, they agreed to replace the part. Got the car back, fixed a ouple of othere things and now, two weeks later, the same thing is happening. Car acts like it's not getting any power, and this time the check iengine light came on. The car has a new altenator, new battery, and the after-factory radio has been removed..
View 6 Replies
Advertisement
Ok, did an intake manifold cleaning on my 99 Accord the other day, and now I have problems...
Long story short, some time ago my car started to have a very rough idle. Took me awhile to find the problem. Turned out the air hose, between the filter and throttle body, had developed a big hole on the underside. So I replaced it and while I was at it used some throttle body cleaner, spraying into the intake manifold chamber. Lot of junk blew out the tailpipe. The car ran much better, but the idle could still be a little rough. I ran it that way for awhile, and finally the other day decided there was probably still some junk in there and it was time to really clean it out. So I took ff the throttle body and intake manifold housing. There was a lot of junk in there! The small intake on the passenger side was completely clogged shut. (I understand this isn't surprising on these cars.) I used a bunch of rags and 2 cans of Valvoline throttle body cleaner and a lot of elbow grease and cleaned it out. I was thinking to myself that whatever I didn't get with the rags flushed through OK, but I didn't want to take the whole intake manifold out.
So I put it all back together. (I took a video before I started, so I'm pretty sure it's all back together right.) But now I have problems. The car starts. It idles fine mostly, but can be a bit rough. But the trouble starts when I put the pedal down. If I do it in Park, well, if I push it quick the engine just dies. If I push it slow, the engine revs then quits, revs and quits, over and over. Similar if it's in gear. If I push it hard, the engine stalls. If I push it gentle, it revs up, but chugs along a bit.
I've run some seafoam through it, thinking it was clogged up with all that junk, and sure enough, lots of smoke comes out, but nothing is improving so far. What have I done wrong?
View 19 Replies
I have a 2001 Civic LX; I would like the clutch pedal travel distance to be far less than it is.
As in most manual cars, I find that the clutch pedal travel is mostly useless. That is, once the clutch is fully engaged, the pedal still has a goodly way to go before it hits the stop. On pedal depression the inverse is true. As modern hydraulic clutches are self-adjusting, this once-necessary extra distance is pointless.
(I would rather clutch with my ankle than my whole leg. If I could cut the pedal travel in half (or more), I would like that very much.) Is this possible? How would I do such a thing?
View 5 Replies
My 02 BMW 525i engine starts to stop running when the gas pedal is pressed. The engine starts and drives fine when the engine is cold. However, after driving for a while like more than 20 miles, I mean when the engine warms up already, the engine suddenly stops when the gas pedal is pressed, like stopping in the traffic light or STOP sign and starts to drive. I replaced the idle air control valve, but it does not work. What should I check next?
View 7 Replies
A mechanic recently replaced the pads of the front brakes. After the service, the break makes squeaking noise when I release the break pedal. According to the mechanic, it is normal, and I better ignore the noise. Is it true?
View 1 Replies
I have a 2002 Honda Civic EX 1.7L. Recently the brake pedal would sometimes go to the floor when I'd apply the brakes. The car would still stop, but not as quickly as normally. If I apply the brake and it goes to the floor I would release the pedal and reapply the brake and it would stop at it's normal position and the brakes felt firm and the car would stop fine. I was told my problem was the master cylinder so I bought one on Sunday and replaced it. I bled the lines and it seemed like all the air was out. The brakes worked great and the pedal stopped in the same place and was firm.
Now today on my way to work the pedal went down a little farther than normal during one stop. On the way home it stopped in different places. The brakes would always grab and the pedal felt fairly firm wherever it stopped. I drove it this evening again and the pedal went to the floor like with the old master cylinder. One pump and they grabbed in the normal spot. What is going on? Did I not bleed the lines well enough? Is the new master cylinder just junk? I saw in the manual that air can get trapped in the ABS sensor, but an air bubble problem should just make the pedal squishy, not change where it grabs, right? I'm stumped and I really don't want to take my car in if I can fix it.
View 6 Replies
Vehicle inconsistently/occasionally taking multiple turns of key to start. Then, multiple turns of key with pressing of gas pedal, which has now progress to stalling (three times within one month) immediately after difficulty with starting and when stopped at a light.
Took vehicle to Honda dealership... dealership could not duplicate the problem so replaced...1) coil assembly, ignition2) head assembly, rotor3) cap assembly4) spark plugs
Two days later the problem reoccurred-- two turns to start-up and when placed the car in reverse to back out of my parking space and in the process of moving, the car stalled, but started on the first turn of the key and I drove straight to the dealership.
They now believe it may be the main fuel relay or the fuel pressure regular.
View 5 Replies
Requiring that the brake pedal be depressed in order to start the engine can be a nuisance, say if the driver is out of the vehicle and the passenger wants to start the engine to run the A/C, etc.
There is a workaround though. Press the engine start switch once to go into ACC mode, then press and hold it for 15 seconds and the engine will start without the brake pedal having to be pressed.
View 14 Replies
I started having a strange clicking sound when pushing down the clutch pedal. I have 43,000 miles on it and I have driven the clutch well(I really don't believe I already worn it up). It goes away and then it comes back. There is no problem on shifting from gear to gear, it works just fine. It is only when I push the pedal that it starts clicking like it pushing against something. The car dealership was so useless, they said I need a new clutch and that warranty does not cover it because I may have been using the clutch badly. Also do you think that they have the right to tell me it is my fault even though I have the extended warranty for 100, 000 miles.
View 6 Replies
Its a 2005 model with 45000 miles on the clock, so low mileage for the year. The problem with it is the engine starts up ready fr a journey, and as soon as the accelerator pedal is pressed, the engine cuts out.
View 7 Replies
I have a 2001 toyota prius. When I start the car and press on the gas pedal the engine rev's but nothing moves and there is some clatter from the engine. I can put it in B mode and drive it a short distance, but that's it.... The engine light has been coming off and on for a week now. It makes a loud audible tone and then I turn it off and back on and then it stops.
View 5 Replies
I have a 2006 F150 that cranks but will not start. I sprayed ether into intake and got it to start but engine dies if gas pedal pressed. It idles after starting just will not accelerate.
View 8 Replies
Ok, my question is, when gas pedal is pressed half or more down-ward, a squeal sounding is coming from engine compartment. 2003 ranger v-6 3.0 flex....
View 1 Replies
[URL].....
Started happening 3 days ago. This only occurs when the car is idle and the A/C is on. It does not kill the engine but makes it bog down during this. The cycle is that it dies this and then runs smooth for 30 seconds before starting again. Does not happen when in gear (that im aware of) When traveling in neighborhoods the air blows cool, main roads cold, highway ice cold. Idle it blows warm. I will be able to test the coolant levels with a friends gauge tomorrow. What is causing this.
View 2 Replies
So my honda 95 civic 1.5 engine is stalling out I think that it is my transmission so Im going to check that out in the morning my question is how much do I put in I watched a video on how to do it, do I need to put 3 quarts of the fluid in it or can I sneak by with just 2 quarts.
View 2 Replies
I have a 2000 Honda Civic, manual transmission with 91,000 miles. I have a rattle coming from the engine, that was there before and after the timing belt was changed. I just notice it more now after the timing belt was changed. The rattle sounds like a marble or nutin a metal container(cylinder?). I don't hear it with just revving the engine, only when the car is in gear...put a load on the engine. It increases in speed as the engine speed increases and is harder to hear or it disappears as the load on the engine decreases. It is NOT tiny like aa heat shield. Could this have something to do with the pistons in the engine, the motor mounts, or something else?
View 5 Replies
I have a 2001 Honda Civic with 145000 miles. My mechanic recently completed a coolant flush on my vehicle and when I went to pick it up said that the radiator sealant was affected by the flush so I should bring the car back in a week to have them check it. On my way home the engine was steaming and continued to that week. When I brought the car back they said it looks like it's sealant again but I may need to buy a new radiator soon. The engine still occasionally has steam coming off of it and another mechanic says I need a new radiator ASAP. I don't know much about cars (obviously) so I am wondering if this is a normal occurrence? Is this something I should pay for if the mechanic damaged the sealant when they completed the flush?
View 12 Replies
I am at my wits' end with my 98 Honda Civic LX. The problem starts around late summer of last year. It is sporadic, so I didn't quite pay attention until one day the engine died on the highway after I picked up the kids at the school. It didn't make any sound nor giving any warnings, just suddenly died. After that highway episode, it seems like it just taken its own fancy schedule as far as when to die, so to say. In a given day, it could 4 episodes in a day. Then it runs perfectly for some weeks then it starts again and went away again.
It just quietly dies while being driven. I had to turn it completely off, wait for some moment and try to turn it on again. Sometimes it just turns on again without me being frustrated and there were moments when I had to do several attempts. Once I heard clicking sound before the engine died, only once, the rest makes no sound at all. No lights are on.
View 8 Replies
Honda Civic LX 1999 - Engine shuts down in hot weather when the sun has been beating down on it for a while>it can happen as I am backing out of the parkway or as I am driving in the first 1-10 minutes ?
I went to the dealer and the vin number of the car shows to recalls have not diagnosed it yet but thinking about it...
View 3 Replies
I had an engine running problem recently with my 92 Honda Civic. I felt the car stalling last Sunday when it tried to shift beyond 25 mph. I had to step on the pedal harder to get it to move over 35 mph, then I felt the gear shift and then it ran all right after it reached 35 mph. However, it happened about 80% of time when it had to stop at a traffic light and go during the last couple days. When I pushed the gas pedal, I could hear the engine stall and it slowly moved (took about 40 seconds) from 25 to 35. The problem seems getting worse today. I checked the transmission fluid and it is low, about 1/3 on the dipstick. I checked the ignition wire and it seemed connected fine. I recall that I had the similar problem about 4 years ago. I was told the # 2 spark plug well was filling with oil causing the ignition wire to short out. They replaced the value cover gasket, spark plugs and ignition wires and charged me around three hundred bucks. Would this be the same issue again? Or it is something else?
View 2 Replies
I have a 2001 Honda Civic Ex that goes into limp mode when the weather is hot. It only happens in hot weather: I drove it during the cooler months, and no problems. Also, it doesn't have any problems if I drive it at cooler times of the day (evening, night).
When the weather outside is hot (~75+ degrees) I can only drive my car for about 20 miles before the check engine light comes on and it goes into limp mode, where the engine just shuts down and I cannot accelerate above 30mph. The engine is still running, but when I push on the gas pedal I can only go like 20-30mph. This happens when the ac is on or when the ac is off, but will happen sooner if the ac is on.
When this happens, I pull over to the side of the road and wait several minutes. Then I can restart my car and drive a few more miles, and then it happens again: limp mode. Then I pull over again, wait, and restart it. It starts fine.
In the winter months I don't have any problems, and my car drives fine. I have had the thermostat replaced, and the temperature gauge does not indicate overheating.
View 12 Replies