Civic - Honda :: 2010 - Squealing Noise When Make Left Turns
Apr 5, 2012
I have a 2010 Honda Civic with about 32K miles on it. Last fall, at around 23K miles, I needed new brake pads and rotors (because I waited too long on the pads). Got those replaced. A few weeks later (I think), it started making a kind of squealing noise when I make left turns. I mentioned it to my mechanic when I took it in for an oil change shortly thereafter, and he said it was probably the belt, but I could wait a bit on replacing it if I wanted to (as he knows I'm always broke).
Three weeks ago, I took the car in for another oil change and to have him change the belt. He put in a new belt, but alas, after driving the car about a mile the noise returned. I called my mechanic, and he said it might be my tensioner, but that such a new tensioner shouldn't need replacing already and that it would still be under warranty. I needed to take it to the dealer anyway because my window mechanism was broken, so while I was there, I had him check out the tensioner. He also said the tensioner was fine, and said that since the belt wasn't a HONDA belt (naturally), that might be making the noise. Last week, I took the car back to the mechanic, who ordered and installed a Honda factory belt free of charge.
Naturally, a mile later, the noise returned. I resisted every urge to drive into oncoming traffic. I used my phone to record the sound so that I could e-mail it to the dealer and my mechanic, give it a listen: [URL] ....
View 14 Replies
Advertisement
My 2002 Honda Odyssey makes a squealing noise when I make a hard left turn. Could it be related to power steering? Is it an urgent problem? I will take a trip next week (~650 miles each way), and need to know if I should address this first.
View 3 Replies
I have a 2010 Honda Civic with about 67,000 kms. There's a mechanical squealing noise that's started over the last week when I accelerate and turn. It's coming from all 4 wheel areas. It only seems to disappear when I brake. Although if I run/accelerate the car for longer than 5 mins, it disappears as well. Additionally, there's a stretching/groaning noise from the tire area when I reverse. I'm thinking it's probably shock or suspension related.
View 3 Replies
Due to the clicking-ratcheting sound my 1997 Civic makes when I make hard turns or U turns, two mechanics (one drove the car) say that I need two new front axles at a cost of $400 ($200 each). I have driven the car like this for maybe a couple thousand miles before I looking into it. How much longer can I drive it like this before it gets dangerous or fails? I now only make gentle turns and so minimize the clicking-ratcheting sounds that happen only on hard or aggressive turns. The car only has 76,000 miles on it. Is it dangerous to keep driving it?
View 7 Replies
Well my girls car is acting up again. when you make left turns, you can hear this real loud popping, almost cracking noise coming from the passenger side front tire. its a 06 passat with 88k miles on it. What is wrong with it??
View 4 Replies
On left turns, even just slight left turn, but mostly when weather is humid, I get a loud squeal that sounds exactly like squealing brakes, except I am not applying brakes. May not be relevant, but this is a minivan modified for wheelchair access via a ramp that comes out on the passenger side.
View 4 Replies
I bought a 2012 honda civic HF, now has 1000 miles. I hear a clunk when I release the pedal. I heard the same noise on another car that was on the dealer's lot. The dealership has not been useful with fixing this issue; they said the clunk is normal. Honda has not been all that supportive. What is making this sound and what can I do about this?
View 5 Replies
My 2003 Honda Civic Hybrid (manual) makes a loud squealing noise (between the speeds of about 25 and 45. It usually starts making the noise once the car has warmed up (but does not always make the noise). It makes the noise when the car is coasting but not when I accelerate or brake. The noise seems to be coming from somewhere in the front end.
View 6 Replies
We have a 2005 honda civic hybrid; there is a squealing noise coming from front passenger side, when braking, when accelerating, decelerating, but not while driving at speeds of 30 mph, straight. Also when backing up, turning wheels. It's going to the mechanic on monday for regular maintenance, 100K miles, etc.
View 3 Replies
Back in January I had my right front wheel bearing and u-joint go out, so I replaced them both. At the time I didn't realize my outer stub axle shaft was wore so I just put it back in. After a little driving the right side started to "thump" and "pop" when I would make hard left turns driving around town.
I replaced the outer front stub axle shaft and seal again because the old one was worn down. This eliminated any play in the u-joint. After a bit of driving the thumping and popping noise came back.
I decided to dig into it today so I pulled it all apart. When everything is apart it turns easily, no issue at all. When I assembled the wheel bearing, torqued it to 55 ft/lbs and installed and "locked" the hub I noticed something peculiar. I can barely turn the whole assembly by hand. I have to put a good amount of force to get the whole assembly to turn at all. When I walk to the driver side with all the same parts there i can turn the wheel bearing and locked axle shaft with one finger on the studs.
I have been in this thing 5 times and can not figure out what the heck is wrong. I can't figure out why this stupid axle shaft and wheel bearing are so hard to turn, together or separately, and I can't figure out how to get my front end to stop that thumping and popping.
View 6 Replies
2004 PSD 4x4 72k. I thought I would be proactive so I bought the front ball joints and have plans to install them but recently I starting hearing (and feeling) a clicking sound in the front LEFT when I make sharp turns to the left and hit small bumps now and again. I jacked up the front end and am able to get 1/4" of movement front to back (top to bottom so not steering) in the wheel.
I narrowed it down to the hub. I took it apart and it is most likely a sealed unit so no adjustment is possible....that I can see.I pulled out the locking hub and got as far as I can to know there is not an adjustment. Need to confirm that it indeed is a sealed bearing and if so what are the part number(s) I may need to repair it.
View 14 Replies
Noticed this morning that my Honda Civic is making a metallic scraping noise while moving -- happens when not braking. Appears to be coming from the left front. I noticed it at very low speeds. It isn't exactly the "wah-wah-wah" grinding sound that changes a little in pitch as the wheel rotates that I'd expect from a bearing. I've been through a bunch of Youtube videos from people diagnosing various wheel- and brake-related problems and haven't found one that matches mine yet.
View 3 Replies
I have a 2005 Saturn Ion stalls when I make left hand turns! The engine light comes on and the car goes into limp mode! I stop the car and wait a minute or two and it starts right back up and after driving it for a while the engine light goes out! I took it to a shop and they replaced the throttle body and ignition coil on two different occasions and my car still does the same thing!
View 2 Replies
I have an 08 AWD GS350 ...
For the last few months, it has been squeaking whenever I make hard left turns, (into parking spaces etc, usually low speed). I thought it was the brakes, but just replaced all 4 pads and all 4 rotors. So that officially eliminates that.
The car doesn't have any unusual vibration, tracks straight, so I don't think its a wheel bearing or anything. I jacked the car up and tried to shake the tire/wheel to see if there was any play but don't see anything.
View 3 Replies
Just started hearing a thumping/ rubbing sound when I make left turns (nothing moving forward or right turns). Thought it might be a tire rubbing but I can't see anything. Starting to think maybe a bad cv joint. Is their a way to check if a cv joint is bad? How hard would it be to replace a cv joint and shaft?
View 3 Replies
I have a 2006 GMC Yukon XL 4WD 1500 with 95,000 miles. When I make left turns, after coming to a stop, the antilock brake system engages, making a groaning-pumping sort of sound in the upper front left area under the hood. (This does not happen every time I turn after stops, but frequently.) My local GMC dealer mechanic believes that there is a faulty wheel bearing, and that a signal is being sent to the antilock brake system to engage. Not sure whether I should believe that or not. The repair would be expensive.
View 4 Replies
2010 LE 4cylinder... Turning right has no noise, turning left of center gives a rumbling noise. Looked under the car for any damage or steering leakage and found nothing. Just 30K on the car still looks like new under there.
I could not find any steering problems in the stickies for this gen Camry. I could not find any TSB about this either...
View 4 Replies
I have a 2010 Honda Civic (automatic transmission) that has about 38K miles on it. For months now, it has been making a very gentle metallic rattling noise after going over bumps and at highway speeds on our "rougher" roads (crappy PA highways). I took it to a Honda dealer about 10K miles ago, and had them inspect the heat shields and take it for a road test, but they found nothing and said the heat shields were fine. I was content to turn up the radio a bit and ignore it (sometimes Hondas just rattle). Today, however, I turned a corner on a residential street and suddenly heard a metallic shrieking noise coming from the right front of the car that didn't go away until the car came to a full stop.
I turned the car off and took it for a quick spin around the parking lot I was in, and it continued to make the noise when the car was moving... forward and reverse. It got louder the faster the car went. Disturbed, I called a tow truck and had it taken to the Honda dealer, who will examine it tomorrow when they reopen. The last time my brakes were checked, which was only a few months ago, I was told that the front brakes were 8s and the rear brakes were at 4, so I don't think the pads are worn down yet.
I don't know if the soft metallic rattle and this noise are related, but they're coming from the same area of the car. It is getting inspected and having an oil change tomorrow as well, since both are due very soon. I know I will find out tomorrow, but I was hoping someone could put my mind at ease and settle my curiousity as to what this might be. There was nothing hanging down from the bottom of the car and making contact with the road, and there are no maintenance lights or other lights lit on the dash. It has been a well-behaved car so far, but it only has 38K miles on it.
View 10 Replies
I have a 1998 Honda Civic with 153,000 miles. Whenever I come to a stop my car turns off, before it turns off the check engine light will flickr and the right passenger door makes weird noises. When it turns off I put the car in park and it turns back on perfectly. When it does turn off the battery light and oil light comes on and stays on. This morning it happened again and the car wouldn't start up for 10 minutes I need to know what's wrong before it gets worse. I already got a tune up on it. Could it be transmission problem because the car will sometimes just jump up 1000rpm.
View 1 Replies
My wife reported that her 2010 Civic LX sedan sometimes made a noise in the front, like cutting sheet metal with an electric saw. I have not heard it myself during several times I drove it. What could be the possible causes?
I plan to drive it some more until I hear the noise. What specific info should I note for mechanic to diagnose the problem correctly?
View 5 Replies
Honda Civic ( not a hybrid) with 137k miles has had inconsistent starting issues since last Spring. I had a new battery installed in March of 2014, and it still had inconsistent starting issues. It acted as if it wanted to turn over, and then finally would after 2 or 3 turns of the key. Some days it started just fine, too. The mechanics that replaced the battery said that they battery was fine and then they could not find any issues.
It still continued and I brought it to a different mechanic after a jump 6 weeks after the new battery was installed. They put a new starter in, and said that the seams or seals were worn and drawing too much power from the battery. That starter was replaced in May. Once again, and over the last couple of days the car is not wanting to start. It is cranking, but takes 2 or 3 turns of the key. Sometimes it has started just fine, and it started for the mechanics just fine this morning.
Simple things I've ruled out: regular oil changes, a full tank of gas, not sitting outside in cold weather, and not sitting for long periods of time. An idea is that something might be drawing a current from the battery while the car is off.
View 3 Replies
