Civic - Honda :: 2005 - Shaking / Misfire After Taking Out Ignition Coils During Rainy Day
Nov 23, 2014
I have honda civic 2005 Lx with 170,000 miles. I noticed increased RPM about 1.5 with cold start but no missfire. I attempted to take out ignition coils to see if genuine ones solve the issue. It is very little rainy today with high humidity. After I put new ignition coils, I noticed increased shaking with misfire. I have not touched anything except for putting in/out coils. I ensured the position and connection of the coils. Is this anything with humidity? I did it really quick without much exposure to the rain. How to resolve this issue? at least return to previous condition?
View 7 Replies
Advertisement
The check engine light is on in my 1996 Honda Civic. The code for it is P1382, which is supposed to be either a misfire or the ignition control system. It runs fine most of the time, but intermittently cuts out while I am driving sometimes. I have replaced the spark plugs and fuel filter and the check engine light actually went off after replacing the fuel filter, but came back on the second time I drove the car. The distributer was replaced not quite a year ago with a reman distributor.
View 2 Replies
I haven't had a check-engine light yet, but at idle, my 1996 Maxima has a sporadic misfire -- there's no rhythm to it at all. Does this sound like a symptom of a coil going bad? What would be a good way to test them without having to replace all 6 of them? The car has about 175,000 miles on it. I just put in a new set of NGK iridium plugs, and hope I didn't damage any wiring in the process (that doesn't seem likely, but I guess I can't eliminate that possibility).
View 16 Replies
I have 06 XLS with 56,000 miles and about 3 weeks ago the check engine and VSC lights came on. It was fixed, a ignition coil on the 4 cylinder.
Now driving home today the check engine and VSC lights are on again! I was wondering should try to get the dealer to replace all the remaining ignition coils ?
Plus I read their was some type of manufacturer defect on the original ignition coils from the factory. Why Toyota won't recognize this issue ?
Two ignition coils in a little over a month . My first Toyota and I'm rolling with the punches .
View 14 Replies
From a cold start, my '89 Civic starts and runs just fine - on a short trip. If I shut it off for 15 minutes and let it sit, then try to restart it, it cranks REALLY slow, misfires and won't start (like the cylinders are fighting each other). The battery's brand new, with plenty of juice. So the next time it happened, I disconnected all 4 plug wires - it cranked nice and fast, no resistance. This leads me to believe that the ignition timing is getting messed up once the engine warms up. I think the coil is fine, because the plugs are firing when the wires are connected. I'm thinking it could be a bad sensor that acts up when it gets warm. My prime suspect is the TDC/Crank Sensor. Does the TDC/Crank Sensor can fail when warm?
View 2 Replies
Found out today that my third ignition coil is bad, it's a Honda civic 03' my question is, do I have to buy a new ignition coil. I had a clerk tell me I could switch the coils and it would run fine? Is this right? could I just switch the ignition coil with another ignition coil? This doesn't sound right. Well If I do buy new one which would be the third ignition coil? is it counted from left to right or right to left? Are there any telltale signs of a bad ignition coil on sight?
View 16 Replies
Anyway, so a little over a year ago I had to have my head gasket replaced and when I picked it up they told me I had a cracked motor mount. After having just spent an exorbitant amount and being poor, I decided to wait to fix that. It seemed to run fine so I didn't worry about it too much. Sometime last year I started hearing this rattling noise when I pushed the gas. It would start and then die off. But it didn't do it all the time.
Fast forward to the past month or so and I've started to get vibration and shaking, usually between 60-70 mph. Thinking it was my tires, I took it in to have them balanced. It rode smooth after that for a few days and came back. The rattling noise has also become more prominent and is pretty constant now. I took it back to the shop and they told me it was more than likely the motor mount. So I went ahead and had that fixed today.
When I picked it up it seemed fine. The noise seemed gone and it rode smooth. But as I drove home and got on the interstate everything came back and sounds/feels just as bad as before. What gives???
View 14 Replies
I have had a problem compounding for about 6 months. The car will not even try to turn over. One day she works perfect, the next day the starter won't even try to turn over. Recently it has been getting worse, I continued to roll start when it wouldn't start and kept driving... but now it will not even try to start at all.
I thought perhaps it was the starter solenoid failing, but when I took it to advance auto parts they tested it and it was functioning just as it should. I then figured it could be the relay, but I can hear it clicking on. What else could it be? I know that the spark plug wires and distributor are all good because I have personally replaced them in the last 6 months. I found some things on the internet referring to a clutch pedal ignition lock switch. Any good way to test it?
[URL] .....
This would appear to be the switch that I have heard of. Can it cause a complete breach of power from the ignition switch to the starter when failing? I will check to make sure that power is not making it to the starter tomorrow... I'm just not that familiar with the circuit.
View 3 Replies
I have 1999 Honda Civic with an automatic transmission and I cannot remove the key. I have shifted it in and out out of Park and turned the steering wheel without any success. I suspect the problem is related to a sensor to determine the shifter is in Park. How can I verify this or rule it out. If it is a sensor what is a reasonable cost to have it repaired.
View 4 Replies
I have a 1991 Honda Civic DX and it is doing something I can't explain. Randomly the car will not even try to turn over. The ignition switch will click, the dash lights come on... but not even the slightest peep from the starter motor. If I put the vehicle in fifth gear and roll it, turning the engine over even half a rotation, the engine will fire right up.
It started on a road trip and happened very sparsely, but has since become more common. What used to be 1 out of 20 is now maybe 1 out of 4 chance it doesn't start. Every now and then it will go days without any problems, then seemingly randomly the ignition fails again for spurts. I replaced the distributor cap, plugs, and rotor about 2 months ago. The ignition switch appears to be fine....
View 1 Replies
So my Honda Civic has been flashing my check engine light, which is telling my my cylinders are misfiring. I checked the ignition coils by removing them while the car was running and cylinder 2 and 3 I can remove and it doesn't change how the car runs. I put a new ignition coil In and that doesn't work so it isn't the ignition coils, what it could be?
View 8 Replies
My 2008 ex Honda Civic. Engine: (140hp 1.8-Liter SOHC 16-Valve i-VTEC 4-Cylinder 5-Speed Automatic with Grade Logic Control).
In the mornings, when I start it, it shakes & makes a hollow shaking noise in the engine compartment. This noise is normally more noticeable after having it parked overnight or not driving it for a few hours. The shaking noise is more pronounced after being parked overnight, starting it, & also putting it in reverse. After driving it for 30min, the noise & shaking stops.
View 6 Replies
I have a 4cl- 2000 Honda Accord about 160,000 miles on it. I have been having a shaking problem with my engine when it starts up after warm. If I drive more then 20 minutes, stop my car, to say go run an errand, and then come back and turn it on, it shakes and sometimes stalls out. I notice that the RPMs don't go above 1000 and waiver below that. When I do get it going, I have to tap on the gas a bit to get it to regulate. On longer drives after I stop it, it won't start and have to leave it sit for about 20 min. and then get it started by tapping the gas.
The check engine light that did come on has been checked as a cylinder 2 misfire. Sometimes it will flash and sometimes it will not come on.
I have new wires and spark plugs. A 3 year old timing belt. No vacuum leaks or gas line leaks. (all been checked by a mechanic).
View 6 Replies
I am having a very frustrating problem with my 2010 Honda Civic. I have had the anti-theft immobilizer unit activate on me 3 different times now, preventing me from starting the car. The electronics in the dash and the indoor lights turn on like normal, the engine will turn over fully as it tries to start (it will even start for a second before the immobilizer turns the ignition off if I put the key in and turn it fast enough). The first time it happened I did not realize it was the immobilizer and attempted to jump it, to no avail.
Had to go to the dealership to get a dummy key with no fob attached to it (there is a chip in the fob that communicates that the immobilizer unit recognizes (or doesn't recognize in this case) and a brake code to enter to get the thing started and back to the dealership. I left it there for them to service, only to have them call me a few hours later and say it started up just fine. The keys weren't the problem, the battery wasn't the problem, they couldn't tell me anything was wrong with it. They didn't charge me for it.
About a year passes and happens to me again last week, stranded in between Austin and San Antonio at a gas station. Tow home, get brake code from dealer, drop off at dealer for service, dealer calls back hours later and can't find anything wrong. Says they scanned the immobilizer unit but came up with nothing. Now it has happened again this morning, this time I got it towed straight there so they can see that the immobilizer has it locked down and maybe they can see something that wasn't apparent last time. I will find out tomorrow what they find.
Faulty Honda immobilizer unit?The battery in the key fobs shouldn't be the issue, as they unlock the car and function properly when the immobilizer unit hasn't thrown a fit. The battery may be the culprit, as I had to get a jump for leaving my hazards on for an afternoon, but I am doubting that since there is no dimming or other noticeable differences with the dash. The tech liaison theorized it might be an A/C relay but I don't have too much faith in his theories since they didn't get it right the first two times.
View 2 Replies
I had plugs and wires changed to try clear code. Car seemed to do some better but while trying to go up a steep hill car started stuttering and jerking. Power went out of car and check engine light started blinking fast. After let the car sit for bout 45mins car started running fine again and light stopped flashing but remained on. Code read cylinder2 misfire again.
View 1 Replies
On cold mornings here in California, like most older cars with high mileage, it makes some ticking/valve sounds until I fully warm up my car after a mile or two of driving. At that point, the sounds disappear.
I've noticed that if I blip the ignition or turn over the engine without starting the car, when starting up on cold mornings, it doesn't make valve lash noise or ticking when I pull out of the garage.
I chalk it up to the fact that I "threw" some oil on top the head before starting up the engine fully. I've only done this maybe 5 times since I found out.
Car: 99 Civic w/ 217k+ miles.
View 16 Replies
I have a '96 Honda Civic DX model, manual transmission. I replaced the battery, sparkplugs, distributor last summer. Yesterday, hottest day yet this spring, my car wouldn't start. When cranked, the lights came on the dash, the fuel line was running, the check engine light blinked, but then no ignition. Left it overnight, started up fine this morning. Took it to a shop,Mechanic said battery and alternator were good and a replaced starter later, I took it home. Driving home, the idle dropped way too low (no tach) and almost stalled the car (battery light came on) when I pushed in the clutch. Now when I turn it on, it starts, idles regular, then the idle drops again.
View 3 Replies
I just put on KW v1 coils and 19 inch merc wheels about four weeks ago, and the car shakes over 55 mph. The tires are balanced( had them rebalanced to double check myslef) but I haven't had the car aligned yet. I had coils before or other cars but never had them aligned because of always moving the car up and down and never had the problem of a shaking car. Will getting it aligned fix everything.
View 15 Replies
What would cause me to have to replace several of the same ignition coils in less than two years time? It seems like it always happens after I purchase gas.
View 1 Replies
05' Civic HX 5 speed with 167K. I picked up the car two years ago with 134K on the OD, and the only service records were regular oil changes.
Did: Timing belt; Valve job; Brake job. Both dealer and tire shop have gone over it / safety checked it twice. About 10K miles ago it developed a racket (rotational noise, as if something was coming apart.) above 1,800RPM. "Can hear from a block away" in 1st gear, to a lesser extent in 2nd, etc (no racket revving, only in gear). CV joints, bearings, anything belt driven, has been checked out.
Figured it was the transmission, but it shifts perfectly - and I've drained the oil twice, perfectly clear, and no shavings on the magnet. I know the clutch is original (doesn't slip, don't want to spend $700 if I don't have to). The car, other then the noise, runs as if it's new, and averages 34MPG, so I'd like to keep it!
View 19 Replies
I have honda civic 2005 with 170,000 miles on. My car has been little shaky with cold start in the morning and Engine light finally on. I was told that I need new fuel injectors from local mechanics. I'm a poor student so I decided to fix it myself. I was able to reach down to fuel rail and It was very challenging to take the rail & injectors out. After I finally pop them out with long driver/hammer, It is even harder to put new ones inside, all the way in. I tried put some oil at the end but still did not completely go in. Is there any special tool I need to use to put them in? I tried oils...ect.
View 9 Replies
