Civic - Honda :: 2004 - CEL Came On Again With Code P0134 / Replaced Wrong O2 Sensor?
Dec 3, 2013
2004 Honda Civic with 166000 miles.
--Had Check Engine light on for a couple days and code reader said P0135. Parts guy said this means "Bank 1", my Haynes book calls this code for " Primary Sensor 1" Is this the same as "Upstream"?
--Replaced O2 sensor (Denso 192400-1160 05F12) myself with a new one (Bosch 15710). Fit perfectly, plugged right in.
--Check engine light goes off for about 5 minutes but comes back on with code P0134.
What should I do now? I replaced the sensor closer to the engine before the catalytic converter. Very easy to reach from the top. I rented the correct tools and did not damage or force anything. Is there a second O2 sensor after the cat that is not so easy to reach? Was that the one I needed to replace? Did I misunderstand the meaning of "upstream" or "Bank 1"?
View 12 Replies
Advertisement
33k Civic 2001 "PO335 Crankshaft Position Sensor A circuit" error code
My Civic 2001 LX (non vtec 1.7) threw an error code today. It was, "PO335 Crankshaft Position Sensor A circuit" error code. It was raining a lot today, and this is the first day that it did it. I have never had this problem before. When the error code came on the engine automatically lost power. I couldn't get the car over 3000 rpm. Then it stalled in an intersection. Now it won't start period. It only has 33k on the clock.
The timing belt was done about two months previous, but i haven't had one problem until today, when it was raining.
View 4 Replies
My Civic 2001 LX (non vtec 1.7) 33k threw an error code today. It was, "PO335 Crankshaft Position Sensor A circuit" error code. It was raining a lot today, and this is the first day that it did it. I have never had this problem before. When the error code came on the engine automatically lost power. I couldn't get the car over 3000 rpm. Then it stalled in an intersection. Now it won't start period. It only has 33k on the clock.
The timing belt was done about two months previous, but i haven't had one problem until today, when it was raining. So much for a reliable honda.
View 4 Replies
I replaced the pads and rotors on my 05 Civic 3000 miles ago. Now it is pulsing badly again when stepping on the brakes. I can feel the pulse in the brake pedal and the steering wheel. What should I be looking for when I pull off the wheels again.
View 8 Replies
I have a 2005 honda civic. About a month ago it started overheating. Drives Ok on the highway but heats up to the H mark almost as soon as I get off the highway. Have replaced the water pump, thermostat, radiator, flushed the system, most hoses, fan, 2 sensors, timing belt, spark plugs and had the head gasket checked 3 times by 2 different shops. Both said it was fine. The mechanic that has done most of the work is baffled. Says he has never seen anything like this and is at a loss as to what to do next. I am supposed to drive this car halfway across the country in a week to meet my husband who is in the air force. Should I just sell this piece of junk!?
View 10 Replies
Replaced clutch master cylinder last week. Now when I accelerate it revs the RPM's and finally catches after about 5-10 seconds. Is this related to the previous repair? They are saying needing new clutch. What to do?
View 3 Replies
My friend was replacing the temp sensor on his 2000 Civic, and twisted too hard and it broke off leaving part of the screw still in the hole. I got him a screw extractor kit, and he tried it this morning, and it too broke off. How to get these things out? I'm including a photo.
View 14 Replies
1998 Civic HX ... The air temp sensor is held on by threaded devices that seem to have smooth, rounded heads.
How do you get them out? And, they are at the back of the engine so that there is limited space between the engine and firewall.
View 1 Replies
I checked my engine codes after the engine light came on. They were P0133 and another indicating an A/F upstream sensor problem. I had it replaced by an independent mechanic. A few days after I had the same code. Mechanic went over it and thought it was loose wiring. A few days after codes P0133 and P0128 were generated. Now the light will come on every few days, will stay off for a few. Do I have to get my computer upgraded? Honda 05 CRV ...
View 2 Replies
I have 1999 Honda Civic with an automatic transmission and I cannot remove the key. I have shifted it in and out out of Park and turned the steering wheel without any success. I suspect the problem is related to a sensor to determine the shifter is in Park. How can I verify this or rule it out. If it is a sensor what is a reasonable cost to have it repaired.
View 4 Replies
This is a 2003 honda civic with about 150k on it. Recently the check engine light came on so I went to Advance auto parts to get my codes read. I got back that the oxygen sensor had gone bad and each and every cylinder was misfiring?
What could be causing the each cylinder to misfire like that? I drive it about 60mi every day and it doesn't seem to drive all that rough. So it's kinda weird that it said every cylinder was misfiring, like how could I even drive it like that?
I heard the oxygen sensor is something I don't have to worry too much about. I could still drive it. The clerk told me to some spray carburetor cleaner on it and that should do something for it.
But recently I've noticed that it starts up rough, seems to strain for about 2-3 seconds then it starts.
View 12 Replies
I had an engine swap recently done on a 2005 Honda Civic, and within a couple days, Check Engine light came on. Mechanic ran the error code and I have to apparently replace the camshaft position sensor. They are claiming that the sensor was not replaced in the engine swap, and so not covered by any warranty.
View 10 Replies
2005 Hyundai Accent stalled on freeway today. It was running fine and suddenly stalled without warning. I tried to restart but the engine doesn't turnover just makes a electrical "weeee" sound. Battery works and lights work. Code reader gave P0340 and P0134 codes.
P0340 Camshaft position sensor "A" circuit malfunction bank 1 single sensor
probable causes:
-Open of short circuit condition
-poor electrical connection
-Faulty CMP sensor
-Engine Mechanical fault
P0134-Heated O2 sensor bank 1 sensor 1 (H02S11) circuit no activity detected
Probable cause:
-Poor electrical connection
-Rich or lean Air/Fuel ratio
-Engine mechanical condition
-Faulty H02S11 (Bank 1 sensor 1)
I'd like to fix it myself; where should I start?
View 3 Replies
[URL] ..... I had the P0430 code come up in my 06 GS300 AWD so i changed both passenger side 02 sensors. i followed the above instructions on changing the pre-cat sensor, changed my 02 sensor plugged everything back up and the P/S light came on and i lost power steering. I unplugged and checked everything at least 10 times until i finally gave up and gave it to lexus today. been about a week though driving without power steering. I know I did everything right and plugged everything snug. Did my P/S just decide to die?
View 6 Replies
Like the title says...'02 Accent,1.6 dohc.Won't start.No spark.
Pulled code p0335-crank sensor circuit A.
Replaced sensor...still nothing.
Is there something else that commonly goes with these symptoms?...or did I just get a bum sensor?
Also,once I try starting or turn key on,I hear a buzzing coming from throttle body area for about 10 seconds even after key is off. Not sure if its related or normal.
View 2 Replies
I started my car the other day and found that it only drives the first gear and I can also put it in reverse. VCDS gave me a 00281 code saying no signal from Vehicle Speed Sensor G68. I replaced the sensor, but it still doesn't go into gear beyond 1st.
VCDS gives me the following codes after replacing G68.
2 Faults Found:
00652 - Gear Monitoring
27-10 - Implausible Signal - Intermittent
00281 - Vehicle Speed Sensor (G68)
03-00 - No Signal
I came across TSB 01-99-02 which says something about the codes being incorrect. It seemed a little vague about whether it is actually G38 or G22. I don't want to buy more sensors only to have it be something else. The speedometer and tach work fine so G22 doesn't seem likely to me.
The VCDS site says it could be several things including bad G68 or G38 sensor, low fluid & bad valve body. Was it the G38 sensor?
View 2 Replies
I have replaced the transmission Range sensor (with OEM) and it is adjusted correctly, however This did not clear the. Code P0705... I am stuck ....
View 1 Replies
I have a 97 Honda Civic Manual transmission and my Check Engine Light Came On. The error code is P0135 which shows up as needing a O2 sensor. My question is:
1. Do I need to replace it?
2. How long do I have to replace it?
3. Will driving with it as it hurt my car?
The weather is getting colder and I read that could be the cause. I really don't have much extra money but I don't want to kill the car. I have kept up on Oil Changes with MaxLife Full Synthetic, Radiator Flush, etc if that matters. I also went into Valoviline Instant Oil Change and they double checked all of the fluid levels and that was OK.
View 11 Replies
I am running a 2008 Ford F-250 with the DPF Delete and the Mini Maxx Tunner. I have replaced the ECT (Engine Coolant Temp Sensor) as well as the EGR Valve and housing troubleshooting this issue. Both the Engine light and the coolant icon come on when I turn on the vehicle. I am getting a P0117 Engine Coolant Temperature Circuit Low code on the Mini Maxx.
From a cold start with codes cleared if I turn the engine to ON even without starting the engine the Engine codes will come on and the the Mini Maxx will read engine coolant temp 302 and will go into Defueling Mode. I have repeatedly tried removing and reattaching the connector to the ECT thinking it could be loose connection. I can't drive the truck because there is no power and i know the engine is not hot because I have let it sit all night before doing these tests. I do not have a scanner to test other than the Mini Maxx. Other notes: I have checked Coolant I have checked Oil
View 3 Replies
I have an 02 Civic EX. Engine light has been on for over a year, runs just fine. Reading misfires on 3 cyl, and cat code. I have since: changed all plugs and coils, changed both front and rear o2 sensors....switched coils around to see if code misfires changed (yes).
I see this is a common problem but no one has a solution..? I'd rather NOT change the cat converter and pay for that only to find out the light stays on. Need to smog so I can sell!
View 7 Replies
I have a 96 Honda Civic CX. The check engine light came on the other day while it was raining (don't know if the rain had anything to do with it) and now it comes on every time I start the car until it warms up. Once in a while it comes back while driving but that's rare. I tried to get the code with a cheap reader and it didn't show that anything is wrong. I then took it to an auto parts place and they used one of their nice readers to scan it and told me that everything is fine. What's the next step?
View 7 Replies
