Honda Civic, 2003, around 180k miles. Code P1457 is showing, no drive ability problems. Everything seems to point to the evap canister valve as a common problem. I crawl under next weekend and start replacing parts...
View 5 RepliesI own an '01 Honda Accord LX with the ULEV engine and 178k on it. My CEL light came on about 6 months ago. Ran the scanner and it showed a P1457 (EVAP Leak). Waited until now when my inspection was due and expected it to be caused by the EVAP shut valve as I read that's often the cause of the problem with this code. Mechanic said that it can't pass inspection because of the OBD fail but that the diagnostic scanner showed everything functioning properly, including my assumption about the faulty shut valve.
He reset the code and said to drive it the 50 miles for the system to ready itself and bring it back in. As I've reset the code several times over the 6 months to see if it would self correct, I'm pretty confident it will come back on. My questions are, is it possible I've done damage to the onboard computer by not addressing the underlying problem 6 months ago? Are there emissions problems that are not checked by the diagnostic tool that the mechanic should be looking for?
I'm getting a weird code on my engine it's p1298 which is electric load detector circuit high input and I'm also getting 3 misfire codes but the car runs great what can I do to fix these.
View 10 RepliesMy daughter's 2002 Honda Civic is overheating unless you drive over 60 mph. The heater is also not working - it blows air but the air is cold. It is full of coolant - we checked. The thermostat was replaced about 2 months ago.
View 4 RepliesI had my car towed to the shop today because when I put the gear in drive, the engine would gun like it was in neutral. It would go in reverse, but not in drive. I asked them to check the transmission fluid and it wasn't low. What it could be?
View 6 RepliesMy 96 civic stalls when i put in drive sometimes, problem comes go's, was told tps sensor or trans control solenoid ?
View 4 RepliesMy Honda Civic DX (1997) is over 200k. Over the past six months, it's been to the repair shop multiple times including each of the brake pads, shoes were replaced. Nowadays, it's making a squeaking and scraping noise as the vehicle is moving at any speed. The squeak comes and next the scraping. The sound is becoming more pronounced, it seems, daily. What the problem is coming from?
View 1 RepliesIn my 2006 Civic I intermittently get a dirty gas smell in the interior after I drive and park the car, and then come back a few minutes later and start it. Do I have a gas leak of some kind? I have not noticed a loss in mileage.
View 5 RepliesI have a manual 98 civic with 120k miles on it that has recently developed an annoying habit of stalling. The car started fine the other morning so I backed it into the driveway to warm up, no problems there. When I went to leave for work, the car stalled and died. I got it restarted but when I tried to drive it stalled again. It happened as soon as I disengage the clutch. As I said, moving in reverse was no problem. The battery died after I attempted several times to restart it so I charged the battery overnight.
The next morning the car fired up right away with no hesitation nut as soon as I released the clutch it started sputtering so I gunned the engine to keep the RPM's up. I managed to get it into 2nd and even 3rd but as soon as I down shifted for a stop sign it died. So far I've replaced the battery and the alternator, both were on their way out anyways. Then this past weekend I got a good deal on a new fuel pressure regulator and put that on. The car started right up and ran nice and smooth. I took it out for a drive for about a half hour.
About 20 minutes into the drive I noticed that when I pressed on the gas pedal, the RPMs wouldn't move up much higher. Shortly thereafter the car started sputtering while accelerating. When I got home I turned the car off and went inside. I came out about 15 minutes later and the car wouldn't start. This has happened after every part replacement. New alternator, runs fine for 20-30 minutes,then won't start again. New battery, same thing. And tonight the gas pressure regulator. Could it be the main fuel relay, should I pull the injectors? The plugs and wires are new and the distributor is less than 2 years old and well sealed. I'm at a real loss here.
I have a honda civic 2000 and recently I noticed that it overheat only after exiting a long drive on highway. The car does not overheat for my normal daily commutes (within the city).
I tried the following:
- Checked coolant on bot radiator and overflow tank.
- Changed the thermostat- No leak on the ground in the garage where I parked the car overnight
- No noise to lead to an eventual issue with water pump
- Radiator fan is kicking ok
- Had a mechanic do the chemical test for the head gasket: negatif
- Found that there is air in the cooling system:tried to burp the system 2 times but air is still in the coolant system. Not sure where its coming from !!?? Might be that this could be causing the overheating ?
- Found a crack on the manifold and changed the manifold then tried to get rid of the air (burping the system): no success. The air is still not removed completely.
- Changed the radiator cap.
What can I do next to diagnose the overheating condition that happens only after exiting long drive highway?
So my civic has 167,000 miles on it. I have replaced the thermostat and radiator but the mechanics are stumped. The problem is when I am driving on the highway for about an hour or longer (I live in the mountains, so this is not easy driving) and when I come back into town and get stuck at a red light, the temperature in the car starts to slowly rise. I have never let it fully overheat.
When the temperature is high, I have turned on the heat and it has come out cold. I have opened the hood as the temp is high and there is nothing leaking that I can tell. It feels hot/smells hot but I can't figure it out. The reserve tank has fluid in it, but I cannot see inside the radiator to see if there is fluid in it. This problem has been happening for about 6-7 months, so I just try not to drive it outside of town anymore. When I am driving around town, it does not seem to have an issue.
it's a 2000 honda civic EX. I pulled into a parking spot and slowed down, then decided to speed back up and when I accelerated it was like the car was in neutral. No gear would drive. Turned off the engine and re started and it shifted and did fine then about a 1/4 mile down the road the same thing happened. It just switched into neutral. The transmission fluid is full and clean and the filter has been changed. There was no warning signs at all.
The only caveat I can think of is last week at 15 mph my front passenger wheel fell off after someone replaced a tire. I traveled less than 10 feet on the wheel. But didn't think the transmission would be low enough to hit the ground.
At first I thought transmission clutch but it would be doing it in one direction? Then I thought maybe a pump? Or could it be a sensor or the torque converter.
We have a 2004 honda civic hybrid, and it is having shifting problems....the drive button blinks when it is in park, and then doesn't engage into drive or reverse. We have a code reader and 2 codes come up...po 700 and po 717. We originally replaced the transmission because those codes were coming up, but it still doesn't work and now we have these two codes. We have read that it could be a sensor...if so, how challenging is that to replace? This all happened when we had the car 1/2 sold. ZERO problems up until the sell day....so obviously we didn't sell it, but want to fix it so we can.
View 5 RepliesMy 2000 Civic DX has approx. 55K miles on it. For the past several weeks, the Automatic transmission gear is resisting/sticking about half the time when shifting from Drive to Park and vice versa. (In November 2010 I had a local mechanic-- whom I found on Yelp and who has done other work including replacing the timing belt--replace the ATF, telling him he had to use Honda fluid). What is causing the sticking?
View 3 RepliesI have a 97 Honda Civic Manual transmission and my Check Engine Light Came On. The error code is P0135 which shows up as needing a O2 sensor. My question is:
1. Do I need to replace it?
2. How long do I have to replace it?
3. Will driving with it as it hurt my car?
The weather is getting colder and I read that could be the cause. I really don't have much extra money but I don't want to kill the car. I have kept up on Oil Changes with MaxLife Full Synthetic, Radiator Flush, etc if that matters. I also went into Valoviline Instant Oil Change and they double checked all of the fluid levels and that was OK.
I have an 02 Civic EX. Engine light has been on for over a year, runs just fine. Reading misfires on 3 cyl, and cat code. I have since: changed all plugs and coils, changed both front and rear o2 sensors....switched coils around to see if code misfires changed (yes).
I see this is a common problem but no one has a solution..? I'd rather NOT change the cat converter and pay for that only to find out the light stays on. Need to smog so I can sell!
I have a 96 Honda Civic CX. The check engine light came on the other day while it was raining (don't know if the rain had anything to do with it) and now it comes on every time I start the car until it warms up. Once in a while it comes back while driving but that's rare. I tried to get the code with a cheap reader and it didn't show that anything is wrong. I then took it to an auto parts place and they used one of their nice readers to scan it and told me that everything is fine. What's the next step?
View 7 RepliesI had plugs and wires changed to try clear code. Car seemed to do some better but while trying to go up a steep hill car started stuttering and jerking. Power went out of car and check engine light started blinking fast. After let the car sit for bout 45mins car started running fine again and light stopped flashing but remained on. Code read cylinder2 misfire again.
View 1 Replies2004 Honda Civic with 166000 miles.
--Had Check Engine light on for a couple days and code reader said P0135. Parts guy said this means "Bank 1", my Haynes book calls this code for " Primary Sensor 1" Is this the same as "Upstream"?
--Replaced O2 sensor (Denso 192400-1160 05F12) myself with a new one (Bosch 15710). Fit perfectly, plugged right in.
--Check engine light goes off for about 5 minutes but comes back on with code P0134.
What should I do now? I replaced the sensor closer to the engine before the catalytic converter. Very easy to reach from the top. I rented the correct tools and did not damage or force anything. Is there a second O2 sensor after the cat that is not so easy to reach? Was that the one I needed to replace? Did I misunderstand the meaning of "upstream" or "Bank 1"?
33k Civic 2001 "PO335 Crankshaft Position Sensor A circuit" error code
My Civic 2001 LX (non vtec 1.7) threw an error code today. It was, "PO335 Crankshaft Position Sensor A circuit" error code. It was raining a lot today, and this is the first day that it did it. I have never had this problem before. When the error code came on the engine automatically lost power. I couldn't get the car over 3000 rpm. Then it stalled in an intersection. Now it won't start period. It only has 33k on the clock.
The timing belt was done about two months previous, but i haven't had one problem until today, when it was raining.
My Civic 2001 LX (non vtec 1.7) 33k threw an error code today. It was, "PO335 Crankshaft Position Sensor A circuit" error code. It was raining a lot today, and this is the first day that it did it. I have never had this problem before. When the error code came on the engine automatically lost power. I couldn't get the car over 3000 rpm. Then it stalled in an intersection. Now it won't start period. It only has 33k on the clock.
The timing belt was done about two months previous, but i haven't had one problem until today, when it was raining. So much for a reliable honda.