Civic - Honda :: 2002 - Front Brakes Sticking
Jul 6, 2013
02 Civic, 1.7L, 114K Found the front brakes sticking. I popped the bleeder open and got a little squirt out of the left side and a less of a squirt out of the right. I'm in the process of changing the pads which are on order from Rockauto. I took the existing pads off and lubed the pad guides/holding slots but I felt them starting to drag again after a short test drive. Also they did not seem to respond properly with normal braking. How would I test the caliper(s)? It's got to be a bad caliper or master cylinder causing this and I just don't want to throw parts at it.
View 19 Replies
Advertisement
I have a 2002 Honda Civic EX 1.7L. Recently the brake pedal would sometimes go to the floor when I'd apply the brakes. The car would still stop, but not as quickly as normally. If I apply the brake and it goes to the floor I would release the pedal and reapply the brake and it would stop at it's normal position and the brakes felt firm and the car would stop fine. I was told my problem was the master cylinder so I bought one on Sunday and replaced it. I bled the lines and it seemed like all the air was out. The brakes worked great and the pedal stopped in the same place and was firm.
Now today on my way to work the pedal went down a little farther than normal during one stop. On the way home it stopped in different places. The brakes would always grab and the pedal felt fairly firm wherever it stopped. I drove it this evening again and the pedal went to the floor like with the old master cylinder. One pump and they grabbed in the normal spot. What is going on? Did I not bleed the lines well enough? Is the new master cylinder just junk? I saw in the manual that air can get trapped in the ABS sensor, but an air bubble problem should just make the pedal squishy, not change where it grabs, right? I'm stumped and I really don't want to take my car in if I can fix it.
View 6 Replies
We have a 99 Honda Civic. Our clutch is sticking in all gears and won't go into 5th gear at all. There is no resistance when I push down on the clutch pedal.
View 8 Replies
She has an old Honda Civic wagon - circa 1987 or so. Recently, the driver's seat belt has been sticking such that it will not pull out. I managed to get it to release by giving it a really good hard yank, and we've clipped it temporarily to prevent it from retracting all the way when she is not wearing it. She can remove the clip and use it when she drives, atleast for now.
But I have a couple of questions: is the seatbelt still safe to use - in other words will it still work if she's in an accident? Also, if it is safe, is there any way to easily see the retractor mechanism to figure out what is happening? It seems to be hanging up on that little "button" on the belt - not sure what purpose that little dot serves?.
Additional info : car has about 120K miles on it, and has never been in an accident - she's the original owner. The seatbelt itself, for those who have not sen this model, is attached to the door. The top buckle is in a fixed position - it does not move. The movement of the belt, bottom and top, seems to come from inside of the door.
View 5 Replies
My 2000 Civic DX has approx. 55K miles on it. For the past several weeks, the Automatic transmission gear is resisting/sticking about half the time when shifting from Drive to Park and vice versa. (In November 2010 I had a local mechanic-- whom I found on Yelp and who has done other work including replacing the timing belt--replace the ATF, telling him he had to use Honda fluid). What is causing the sticking?
View 3 Replies
My girlfriend's 2002 Honda Civic. Whenever she and I make a turn in it, a clunking sound is heard and felt on the front passenger side in the area of the floorboard, and it seems to come from an area between the seat and the wheel well and seems to be getting slowly but surely/progressively worse/more noticeable as time passes. I checked underneath the car earlier today, and there aren't any observable leaks to report anywhere.
View 4 Replies
I have already changed the pads, rotors, and calipers on both front brakes. Now it was sticking so bad the other day it was smoking from being so hot. Its not making me come to a full stop but the pads are sitting on the rotor even when I took the tire off. Could it be something simple? Or is the last thing to change the master cylinder?
View 6 Replies
On my 02 Superduty 4x4 7.3, I just replaced all the rotors,calipers,& pads because two were seizing up, so I decided to do all 4. It's still happening?! What could be causing this? They were all bled of the air & flushed with new fluid. I spent a lot of money here so I don't want to wreck any new parts, so it is parked now until I can get it fixed.
As I was coming home yesterday, as it was shifting up thru the gears it was dragging & held up on 2nd before it went into high & was hard keep moving & the RPM's were higher than normal, then all of a sudden pop and everything let go,it quit dragging, shifted into OD. Before this point I noticed the brake pedal seemed to be higher and hard?
View 14 Replies
1998 FORD E350 CLUB WAGON 15 PASSENGER VAN. Front brakes are sticking bad. Stop at intersection with snow or slick condition and you can barely get the van to start moving. After you do you can fell the drag and the vehicle working hard to keep moving. Take tires off front, can not see anything obvious that is wrong. Can see where the bake pads are leave makes on the rotor.
View 4 Replies
I have a 2003 Honda Civic EX. Purchased used with 82,530 on it. Current mileage of about 114,100 on it now. I recently replaced the front and rear brakes. During that process, I was informed that the rear brakes were warped (they were cleaned & adjusted when I replaced the front brakes, but they continued to squeak like a transit bus). I had the rear shoes replaced and there is no more squeaking, but I get a "drag" that is particularly noticeable when riding at highway speeds (55mph or higher). The drag seems to come from the rear right of the car, and it reminds me of what you might feel if you were driving against the emergency brake.
Took the car back to the mechanic that did the rear brakes. He started down the road of it being bad ball bearings. He test drove it with me and experienced the drag, but when he put it on the lift said something was catching and made an adjustment that eliminated this 'drag'. My impression was that the drag came from some oversight when the rear shoes were replaced.
The car rode fine for a few days after that, but now the dragging symptom is back. The mechanic's assumption was that it could be a ball bearing that is on it's way to going bad. I don't hear any noises in relationship to this drag. It feels either like something is holding the car back, or like something is keeping the power from the engine from making it to the wheels.
Is this a wheel bearing/brake issue? Would needing new spark plugs have any impact on this?
View 1 Replies
Replaced break pads, calipers and master cylinder...still breaks sticking parts were replaced 3 weeks ago and are worn already.
View 2 Replies
I took my car to a nearby repair shop. They replaced the rear brake pads and resurfaced the rear rotors. When I left, I felt and heard clunking while driving. Initially I thought it was just stuff rolling around in the trunk. As I drove on, I realized it must be something the shop did. It sounded like metal scraping metal every time the tire rotated and started making terrible sounds when I hit the brakes. I stopped to take a look. It looked like the rotor or something behind it had ripped. What happened here? It's a 2006 Honda Civic EX. Picture hopefully attached.
View 9 Replies
I am guessing my brake pads are going but figured I'd check with the forum first. What does it mean when you press down and about 3/4 of the way you start hearing this grinding noise almost like two pieces of iron are grinding across eachother?
View 19 Replies
I have a 2011 Honda Civic EX-L sedan with 10,000miles on it. I've noticed that the brakes often make a squeaking noise when I am driving slowly and come to a stop at a stop sign. It seems to happen most often after a cold start (e.g. I notice it in the morning when I start my drive to work and otherwise when I have not been driving around in my car). I took it to the dealership today and they said everything was fine with the brakes; they are in great shape and starting to wear normally. They found nothing wrong and they did not hear the squeaking although I heard it this morning and last night.
View 4 Replies
I have a 2005 Honda Civic with approximately 140K miles on it. When I am going 60+ miles an hour and try to brake, the brakes shake. Or at least that is the best way I can describe it. It makes it hard to stop well when going fast, I have to release the brake and kind of pump them until the shaking is under control. What causes this? and what needs to be fixed? I wonder if it is the way I drive or just a normal occurrence?
View 5 Replies
My car is a 1999 Honda Civic.
This morning I went in for a state inspection, oil change and rear brake replacement. Driving home while going downhill on the highway, I hit the brakes - and they failed completely. At first it felt like the car actually bucked forward. I tried flooring the brake, but felt no resistance and the car didn't stop. I kept my foot off the gas and coasted to a stop.
The tow truck driver told me he could feel a problem just getting the car onto the tow truck, and again when he took it off.
The Honda place checked it and did a test drive, found nothing.They said it couldn't be air in the brakes be took me for a short test drive and assured me I'd be fine. The
I headed home again and the brakes failed again at almost the same spot. This time it wasn't a complete failure. After no resistance at first, the brakes "caught" though somewhat mushily. I put on my flashers and kept going, at about 45 mph. Got off the highway and had to crawl because braking wasn't taking effect immediately. But as I drove on at 10 mph, they began working again. Not as well as they should, but enough to get me home.
It seems the brakes fail after 15 - 20 minutes of driving at 65 mph. They work better after a rest and at slower speeds.
If it makes a difference, my compressor is gone, so the car doesn't have a/c, and it is hot out so I'm wondering if the heat is affecting something. However, I haven't had these brake problems until today.
View 19 Replies
The parking brake on my 99 honda civic won't fully disengage. If you use it when you go to put the lever down it pops back up slightly. Just barely one click and sometimes not even that. I just replaced the rear brake drums, shoes, wheel cylinders, and it was badly needed. I thought that this would solve my parking brake problem as well, but after I got everything back together and the car on the road the problem persisted.
I saw in the Hayne's manual for the car the parking brake can be adjusted from underneath the armrest. So would an adjustment fix my problem? If loosened would the brake stay down when not in use and still work when I need it? I also saw as part of the procedure the manual has you put the rear end on jack stands. If you are just tightening or loosening a cable why would the back wheels need to be off the ground? Is this absolutely necessary?
View 3 Replies
I got my car inspected this summer, and the front brakes were reported as 8 and my rear brakes 6. I got front brakes not too long ago, and my rear brakes are original to the car. Recently, my brakes have very randomly (maybe once per car ride) started making a gentle squeaking or light grinding / grumbling noise when I apply the brakes. It doesn't seem to matter how hard I apply them or at what point during the car ride it is. Now, it will never squeak or grumble/grind at the same time, and the sound is never very loud. It also does not happen when my foot is off the brake or when the brake is released. Only when the brake is applied.
I've had squeaking happen in my previous car's rear brakes when some fluid was leaking, and my rear brakes had to be serviced, however, this sounds like it is coming from the front. I went looking in my owner's manual for a service schedule (for a maintenance code not related to this issue) and noted in very small print underneath the schedule that I should have replaced my brake fluid about a year ago. I don't know whether this could be related, and yes, I am going to get my car checked/serviced soon, but I cannot do it until next week. My questions are what might be causing the noise and also if it could be dangerous. I don't think that my brake pads are worn. The brakes also function very well as far as I can tell. I have no issues stopping. I have 75K miles on my car...
View 10 Replies
My car, a 2009 Civic, has started sounding like an airplane when I brake, just in the last day or so. Sometimes the noise continues for a little bit after I'm off the brake and moving again, but mostly not. Obviously, I'm going to get it in to the shop, but my question is do I need to take off work and do it today / tomorrow (Tuesday / Wednesday), or will it probably be OK if I wait until Saturday morning?
View 12 Replies
My daughter's 2002 Honda Civic is overheating unless you drive over 60 mph. The heater is also not working - it blows air but the air is cold. It is full of coolant - we checked. The thermostat was replaced about 2 months ago.
View 4 Replies
I have been driving my 2002 Honda Civic for about 6 years now. For the past 4 years its been all highway, driving 50+miles a day. I have just moved to a small town where its all town driving.
When I would get off the highway before, I would notice a burning type smell, but no smoke and no signs of overheating. Once I moved here where the winter has been significantly colder than what my car is used to, and I am doing all in town driving, I have noticed smoke coming from my engine, but my temperature gauge shows all is well. I have always done regular oil changes etc on the car. I will be making a long trip this summer back home and i am not sure if I should be worried about the car overheating. Should I try and find someone to investigate this problem further or is this just some engine gunk burning as the car gets hot?
View 3 Replies
