My son has a 1987 Chrysler 5th Ave. The transmission (auto) does not want to shift in reverse. It does go in neutral and forward. And it drives well forward. How to fix this?
View 1 RepliesWhen backing up in reverse I come to a stop and shift into drive. About 60% of the time it slams into gear (Drive). It feels as if someone rearended me. It's a 2012 Chrysler Town and Country with 40K miles. 2 dealers worked on it, reprogramed the computer and replaced 2 seloniods and the problem is still there. What is wrong but said thats typical on that 6 speed. What to do next?
View 2 Replies1987 Celica ST
3sfe
auto trans
Last week the rad cooling fan stopped working. The fan itself is fine. It spins when connected directly to the batt. Relay tested good, and fuse isn't blown. I unplugged the temp. switch connector, and grounded it to the batt. to test the circuit, and nothing. Switched on the A/C, and both fans spin. So, where else should I look for the problem?
My '87 Chevy S-10 transmission slips like mad in forward gears and I can't go everywhere in reverse. The truck is gaaged in southern Virginia about 60 miles from my home and is used on some country property. The local transmission shop wants $1600 to rebuild the trans. He says he used sturdier parts than the replacement GM parts. I'd like to fix the truck because it comes in handy and was my dad's old mode of transportation around the Va. countryside, so it has sentimental value.
View 3 RepliesI have a 2004 Chrysler Sebring with a 2.4L dohc and automatic transmission with 115k miles. I recently had the timing belt and water pump replaced. Shop left the front 2 engine mounting bolts off and the rear one loose. Picked up car after business hours drove it that evening and kept hearing a strange metallic squeak.Returned it to the shop the next morning and as i was driving it began to smoke and stall with the temp gauge pegged. They had also left a hose to the heater core disconnected. Could the engine not being mounted to the chassis and/ or the overheating have damaged the transmission.
View 3 RepliesFor a few months now I have been hearing a tap clunk type noise coming from under the car when I shift the auto trans into drive and reverse. Also sometimes when the car is slowing when driving I hear the tap sound as it shifts into first. I drove in by my local dealer and they listened to it and said Elantra transmissions can get noisy there is nothing wrong. They told me I have plenty of Warranty left so if something happens I will be covered.
View 2 RepliesAuto/transmission will not shift to overdrive. Is there a relay between the o/d switch and the solenoid? Is it alright to drive on the freeway?.1988 Volvo 240 DL.
View 1 RepliesI own two of the most hated cars on this show, a Renault Alliance and a Peugeot 505 V6. On the 505, the transmission was shifting pretty roughly, it was knocking hard. I bought another 505 for spares that was shifting smoothly. So this summer, I decided to spend 4 weekends on hard labor and I swapped the ZF automatic transmission from the rough car to the good one. After all that job, I didn't notice any real difference. So I guess it was the torque converter that I left on the engine?
Anyway, I decided that it will stay like that because I will rather take a bullet than drop this tranny again. Now yesterday, it was -30?C outside, after 3 months of storage outside, just for fun, I tried to start it. It started right on! So I let it warm up for few minutes then went for a little ride. Big surprise, it shifts very smoothly now in cold weather... So what's wrong? Wrong type of oil? I filled up with the one suggested in the owners manual!
'87 Peugeot 505 STX V6
'87 Renault Alliance DL
'70 Renault 16
'97 Volks Transporter T4 (Eurovan diesel).
How the auto gear shift works on a ford E350.Does it work by wires or does it have a steel column to change the gears.I have looked for pictures but with no luck. I have spent 2 hours looking.
View 4 RepliesThis may be an old question: is it beneficial to shift into neutral while coming to a stop in an automatic transmission? But, my new Ford Fiesta has a PowerShift 6-speed transmission that behaves differently from a standard automatic. According to Ford, it's "like two 3-speed manual transmissions put together, with the dual clutch and shifting components controlled electronically."
Since the PowerShift is really a computer-controlled manual transmission (without a fluid torque converter), it's actually in neutral when I'm stopped and the shifter is in Drive position. I can feel it disengage as I come to a stop. However if I try coasting to a stop uphill, the engine still pulls the car upward at low speed without my foot on the accelerator. So the computer has to judge when to activate the clutch.
The issue is, I tend to apply the brakes lighter than average and decrease speed at a slower rate to come to a stop. So I think I might be confusing the computer, working against the engine before it wants to disengage the clutch, whereas most people would come to a stop more abruptly and the shifting action would have no problem. This is why I shift into neutral early in my slow-down phase, so the engine doesn't have a chance of pushing the brakes.
I just did a motor swap on a 2003 with 3.5 auto tranny and awd. engine runs great and every thing is running fine. Only problem is that the trans will not create any power. With no drive shafts on it still wont move the splines. With that said the trans was driving/running great b4 the swap.
View 2 RepliesAnything else that could cause reverse to go out of an automatic tranny other than the tranny being shot? I don't know of anything but any way to keep me from replacing a tranny.
View 2 RepliesI have an 04 jetty with an auto Transmission. It doesn't seem to shift after the first time when speeding up. What might cause this?
View 5 RepliesA friends son just bought a 94 powerstroke. auto trans. it will not shift out of first unless you let off throttle. but once in second it shifts fine, until you stop and go back to first. I am thinking bad or sticking second gear solenoid, but do not want to give bad info.
View 1 Repliesi have a 94 vw passat vr6 that wont shift. when you start off in drive it takes a second for it to start to move. if you shift it manually from first on up it shifts okay but sometimes it slips in between 2nd and 3rd. the only time the car will shift is after driving it a few miles at about 65-70 it will shift itself into second gear and not come out you have to shut the car off and wait a few minutes to "reset" itself. after driving it on the highway it kicked itself into second gear, i pulled over and the fan was on and it looked as if there was some fluid on top of the transmission but cant recall if it had been there earlier. i checked the ATF and there was no shortage of fluid. could the fan be on due to the transmission over heating? what could be the cause of it not shifting?
View 2 RepliesMy 2007 Dodge Grand Caravan with a 3.8L engine won't shift going up hill. On any incline, it stays in the gear it was in when the incline starts and will never upshift. So we're stuck going 20 to 25MPH up hill. Once we get to the crest of the hill, it shifts to the next gear and we're good to go. From a standing still on flat land, if I nail the accelerator pedal, it also won't shift, I have to back off the accelerator, and it will upshift normally. What's up with this?
Have engine light on and the code indicates a bad EGR valve, and possibly a bad catalytic converter, but Autozone indicated that a bad EGR can also produce a code for a bad catalytic converter. They recommended replacing the EGR valve first, then see if the code comes back. But they didn't know if this would cause a loss of torque, which might be related to the shifting problem.
I got a 2006 3.3l v6 sonata and for the past 6 month I have no had reverse which sucks let me tell you but I've looked into my codes it's throwing out. Anyway when I throw it in reverse it doesn't lock on it just spins making a kind of whining sound,
And when I'm driving it I take my foot off the gas or I slowly push the break it will jump down to third gear and get stuck I'll be doing 40mph at 4K RPMs, what this could be or what I should do?
Why does the automatic transmission stay in 3rd gear and not shift into overdrive until it gets warmed up? It is so annoying. This is the only car that has ever done this. Even the camry I don't think does this. Especially the fact that the rpms stay above 1k rpm until the engine is warmed up.
View 7 RepliesI'm thinking about getting the 2014 Subaru Impreza with the CVT transmission, w/o paddle shifters, and found that there is a manual mode in the CVT. How does that work if there aren't any paddle shifters or actual gears to shift to? (I don't know a lot about cars).
View 1 Replies2002 LS V8 162K Miles. Its been sitting in the garage for 10 days. ...went on vacation. Started her up and let it idle down. Shifted to reverse and transmission shift error displayed. Went back to P. Waited a minute. Shifted again and she was hard jumping into the gears. The error went away. Drove it around and it seems to shift fine. Opinions?
View 4 RepliesI've got a 1994 F-150 with the 4.9 straight six. The transmission is the E40D.
In drive, it shifts silky smooth. In reverse, it acts like it's bogging down the engine.
I only recently got the truck. It's had a fluid and filter change, and is full on the stick when hot.
I didn't notice this problem until I replaced the engine thermostat. It was stuck open, so I replaced it with a 195 degree Stant unit.
Should I let the engine control computer re-learn this engine? I've fixed bad vacuum lines, too.
I've heard tales about the electronic transmissions. This one has 145K on it.