Chrysler - Ptcruiser :: Right Tire Wasn't Spinning Or Gripping
Apr 1, 2014
It's a 2002 Pt Cruiser. I think it's the ball bearing but I don't really know. Car got stuck in some snow a few days ago and we were unable to get it out even after digging it out from the snow.. Seemed like the right tire wasn't spinning or gripping. We got someone to pull us out and it's driving fine, no problems but when I try to drive up our driveway that has a slight hill, it is having troubles and barely makes it up and seems like the right tire is vibrating and not spinning properly. There is no humming noise. Just a vibrating when trying to drive up my icy muddy driveway. Could this be something else besides a bearing? I'll be making an appt with my mechanic tomorrow but typically it's a one week wait to see him and I have to work this week so can't just not drive it.
View 12 Replies
Advertisement
I have a 06 PT cruiser with about 70k miles.About a month ago a small click started near the left front tire. I thought it was a pebble and checked the tire to find none. It increases volume and frequency with speed. There's no vibration or grinding. Brakes are good, and I just had the bearings replaced about 6 months ago.
View 5 Replies
Upon putting on my winter wheel i was checking if the bolts were too long and my rear passenger side wheel wasn't spinning. I took the wheel off and checked the rotor and it took a lot of force to spin because the caliper didn't go back. I took the brake fluid line out hoping it would decompress the caliper and it did not, and brake fluid leaked out a tiny bit. This leads me to believe that my caliper is bad. Just want to make sure before I order another one
View 4 Replies
My son's wife has a PT Cruiser, she told me last night that it has a shimmy at 70 mph. What are the causes of this ?
View 10 Replies
My PT has a vibration, I've replaced rear drums, rear hub assemblies, front brakes and front rotors and all four tires.The vibration is only while going 55 to 60 MPH each time I've replaced the different parts (rotated the tires and rear drums) the wobble seems to go away for about a few miles and then comes back!I'm going to replace the front hubs and bearings now, but why would the wobble change each time I changed I've changed all these parts around. Could it be a bent rim? or just the front bearings?
View 5 Replies
I have a 2004 PT Cruiser with 111,000 miles on it. A summer or two ago, whenever it got hot out, the check engine light would start to come on. Usually, it didn't affect the car's driveability - but sometimes, it would cause the car to buck and/or stall, sometimes to the point of stalling completely out. Brought it into the shop again and again. Camshaft sensor. O2 sensor. Crankshaft sensor. Replaced. Checked. P0304 misfire code came up in diagnostics again and again. Re-wiring of camshaft sensor wires. And on and on. And yet again, intermittently, the check engine light would come back on and the whole thing would start all over again. Sometimes you'd drive it, stop somewhere, start it again, and the check engine light would be gone. Sometimes it would stay on for days. Weeks. Sometimes with no other driving symptoms - it just depends on how the car is feeling? I thought the problem was limited to the hot months of summer, but now it's the dead of January in Minnesota and it's happening again. Yesterday, it stalled out completely and I had to get it towed to the shop - decided to try a new shop, they said maybe the problem was that the old shop did a bad wiring job. OK. But then, got the car back, no check engine light on first drive, stopped somewhere for 5 minutes, get back in, start it again, check engine light back on. But at least the car started and didn't buck/stall. Now it's back in the shop, but I'm ready to give up.
View 5 Replies
What is ABS code 18 2001 PT Cruiser???
View 14 Replies
I got stuck on ice. FrontWD. Wheels spinning off and on 10 minutes. Got towed. Front end was vibrating btwn 40 and 60 afterwards. Mechanic rebalanced tires and wheels, told me I had damaged wheels from potholes, burnt out the ABS sensors in front, overheated all the brake components, and needed new everything, pads, rotors etc. Brakes are 3 months old. I decided to wait. He put everything back on. No more vibration. Brakes seem fine. What to do?
View 10 Replies
I have a 2002 chrysler pt cruiser. For the past week when I start to crank it it will just click one or two times then crank. Today it won't start at all just clicking.
View 2 Replies
I have an 05 pt cruiser that idles rough sporadically. Sometimes it idles smooth, sometimes it is rough but will calm down when i shift into gear, and sometimes it is rough when i let off the gas and come to a stop sign. When i first crank the car, the idle is rough and will act like it wants to cut out when i first back out of the driveway, but it clears up and drives better after getting gas. I have changed the plugs and wires, which did work, but there is something else still causing some problems. When at cruising speed, you can't detect any stutters or other problems. I looked at the vacuum lines and have a bottle of injector cleaner on 3 tanks of gas back to back with no apparent change. I did put a PCM on it a few years back, is it possible it has gone bad? The gas mileage also has seem to be suffering. I also checked the air filter as a possible problem, but it is very clean.
View 6 Replies
I have a 2007 PT Cruiser that's just about to hit the 100,000-mile mark. My problem is when stopped, the car feels like it wants to stall, but only when the AC/Heater/Defrost is on. Also, when it starts to act up, the heater stops working, leaving only the fan to blow air around. It doesn't happen all the time, but enough to make me turn off the heater or whatever I'm using when I come to a red light. It just started doing this and I just wanted to have a rough idea as to what it was before I took it to a mechanic.
View 6 Replies
After running for a while traveling to and from the store, my temperature gauge on my 2005 PT cruiser rises to hot and the temperature light comes on. However,when I get out and raise the hood. The engine doesn't seem to be overly hot. No boiling or hissing sound and no steam coming from the engine.
View 3 Replies
I drove the car to town this morning, and then to work without problems. I go to get in the car and the car has no electrical power what so ever. I am going to check the voltage and battery terminals, but is there a fuse that sends power to everything in the car, including lights, horn, etc? There is NO power at all.
View 5 Replies
Recently my PT Cruiser was having trouble shifting into park so the car could not be started or the key could not be removed. I had to force it into park a few times and then something popped and broke. The car thinks it's in drive so it will no longer crank. I took a look under the hood and the shifter cable looks to be fine and connected properly but what I found under the center console seems to be the problem. The entire cable and plastic mechanism move freely. To me it seems as if the plastic piece holding the cable aligned is quite stuck. The metal rod looks like it's supposed to move inside the casing? Here are some photos of what we're dealing with.
View 5 Replies
A/C works fine when moving. At idle, it doesn't work. Fan is not spinning. Is it definitely a bad fan or is it a possible fuse/switch/module? How difficult it would be for a novice to replace the fan?
View 2 Replies
I was driving the car down the freeway, hear a loud bang from underneath the engine, immeadiately ceased accelerating over 15 MPH and would not reverse.
As it stands now the car will start up, but not reverse, or accelerate over 15 MPH without the RPMs revving like mad. Think it might be tranny-related...
View 1 Replies
Our 2005 PT Cruiser has a 2.4 liter turbo. We had to replace the turbo at 78K miles due to “carbon buildup and clogged” so said the dealer. I can not get any local mechanic to tell me why this happened or if it is normal. My wife claims it is because I have been using the cheap, mid-grade gas. I tell her, no, it was because of the cheap oil I was using. I am now using synthetic oil. One mechanic said the turbo needs to be “blown out” occasionally, by either high speed driving or fast take offs. Bottom line: What would make the turbo carbon up so badly that it must be replaced? What can I do to have this not happen again around 156K? Must I always use premium gas?
View 19 Replies
While driving on the highway, I experienced sudden acceleration of the RPM's only on my 1997 PT Cruiser. What would cause this? I had to stop and shut the car off and it was okay when I restarted.
View 15 Replies
I have a 2006 PT Cruiser with approximately 94K miles on it. This year I started a 2-hr round trip commute every week day, so the car went from getting ~200 mi. a week on it to ~700 mi. a week. I bought it used ~4 years ago with 28K mi. on it.
2 months ago, the car started shaking between the speeds of 50 and 60 mph. Not sure how to best describe it - kind of a shake/jerk, like someone was jerking the car forward very quickly and repeatedly. It seemed to be strongest in the front of the car on the passenger side, although you could feel it throughout the car. I took it to a repair shop. They balanced the tires, but that only very mildly worked. Then they changed the front axles (said there was a lot of play in them). They replaced the brakes, rotors, and timing belt at as well, for unrelated reasons. With new front axles, the shake disappeared, but the car has been idling incredibly rough ever since I got it back. You can see the steering wheel vibrate and feel it in the seat when I start the car or am stopped with it running. This never used to happen.
Additionally, the shake has now returned, but from the driver's side of the front of the car now. Again, it's between 50 and 60 mph, although it's slowly creeping up into the 60-65 range also. It's stronger if I'm pushing the gas down more, like when going up a steep hill. If I'm going downhill at 50-60mph, I don't notice it or barely notice it. On flat ground it's noticeable, uphill it's becoming severe.
View 3 Replies
Less than two weeks ago I had the fuel pump replaced and battery terminals replaced on my 2006 PT Cruiser Touring Edition (not turbo.) I have almost 90,000 miles and have had very few minor issues all these years.Car stalled while driving, towed it to mechanic, he diagnoses fuel pump failure. So I had him replace fuel pump, and while I was there had battery terminals replaced, since I've dealt with some pesky corrosion recently.
I've never had electrical problems with this car. So here I am a week after repair, I'm driving and hear an electrical pop in the dash, then the radio turns off and back on within a few seconds. Nothing else happened, I chalk it up to a fluke and keep going. Well it happened again yesterday! Exact same "pop" then radio turns off, comes back on in 2-3 seconds.
Both events happened during the day, so I don't know yet if my headlights had been on, would this "pop" have affected lights too? Perhaps.
So what I'd like to know is: when the mechanic was replacing the fuel pump and battery terminals, do those repairs involve him messing with wiring at all? Could he have left a grounding wire disconnected? I've read a little about the fuel pump relay, but I have not been able to confirm that 2006 PT Cruiser has a fuel pump relay. ? Any other theories on what could be shorting out, creating an electrical "pop"?
View 7 Replies
I have a 2005 PT Cruiser convertible. 3 times now ghetto accelerator has stuck down. The engine light comes on and after stomping on the pedal and releasing it, the car does not want to accelerate and sitters as if it will cut out. After about a minute everything clears up and works normally. I have taken the car into 3 repair shops including the dealership and they cannot recreate the problem ...
View 6 Replies
