Chrysler - Ptcruiser :: 2001 - Turn Signals Not Blinking
Feb 10, 2014
I just changed the multi-function switch on my 2001 PT Cruiser, because someone suggested it since my turn signals were not blinking or clicking. The turn signals come on, but do not blink or make that clicking sound at all. They just stay on. The hazards do not blink or click either. Lights and all work fine. It's just the turn signals and hazards that do not. What else controls the clicking and blinking of the turn signals and flashers. Could it be the relay that's inside the multi-function switch? I'm almost 100% sure we checked all the fuses, but I could be missing something.
View 1 Replies
Advertisement
I have had this problem for a while now, but can't seem to figure it out. I'm sure it's an electrical issue, but I'm not that great with electrical. My turn signals don't click when I push the handle in either direction. The turn signals come on and stay on but don't blink like they should. I checked the lights in the front and back and they just stay on but don't blink. Also my hazards don't blink. They just stay on and don't make clicking noise either. My horn doesn't work and my door doesn't ding with the key still in the ignition but in the off position. I don't know of it's all related or different issues.
View 10 Replies
The turn signals stop blinking after a few blinks on my 2001.5 Passat 4Motion. There are no burned out bulbs, no aftermarket lighting, nor any aftermarket audio. The problem also happens when using the emergency flashers. The lights will blink for as little as two or as many as 15 blinks and then just stop. Is this a relay switch? Where is it? Can I get to it without taking the dang dash out of the car?
View 4 Replies
When it is hot out and the interior of the car gets really hot these things do not work: the electric windows will not work, the turn signals will not work, the display on the air conditioner does not work the blower on the air will not work but the air will come out of the defroster. All the dash lights come on abs, trac on trac off. After the car sits in the shade for at least an hour all these things will work.
View 1 Replies
What is ABS code 18 2001 PT Cruiser???
View 14 Replies
I was driving the car down the freeway, hear a loud bang from underneath the engine, immeadiately ceased accelerating over 15 MPH and would not reverse.
As it stands now the car will start up, but not reverse, or accelerate over 15 MPH without the RPMs revving like mad. Think it might be tranny-related...
View 1 Replies
My 2001 PT Cruiser began to over heat today. By the time I immediately pulled off the road and smoke began to come out from under the hood. Once I stopped I heard a bubbling noise and watched as all my coolant steadily dripped onto the ground (almost a pour). What does this mean?
View 19 Replies
My 83 year old mom has a 2001 pt cruiser. The gauge is overheating. Some water was leaking from the radiator, not a lot. 3 mechanics have given estimates. The first said it was the water pump. The second said per computer is was not the water pump from his experience it was the head gasket. Third thought it was the radiator cap then said no. A hose was somewhat loose but that did not cause the problem. It heats up going down the hill and not up a hill. Water pump is okay must be the head gasket. Both said it held 15 lbs of pressure. She is too upset to handle this and it is left up to me. Do you think it is the head gasket?
View 3 Replies
drives nice for mile or 2, stalls. turns and turns for 10 minutes, then starts. drives great for mile or 2, stalls. wait 10 minutes, starts. repeat, repeat!!
View 1 Replies
I made the conversion of the regular bulbs to led ( stops, position, turn signals ) but I have fast blinking in turn signals. I know that the led has fewer electric resistance than the regular bulbs so the car takes this like a damaged bulb.
I know two possibilities:
1- A resistance for each one of the led to confuse the system.
2 - Changing the electronic relay
I don't know which one is better. I need a resistance for each bulb? which relay is the appropriate one for this car (there's a lot of references on the internet and I can't find the relay in the hood's car).
View 5 Replies
I have a 1998 or 1997 Honda Accord and just noticed the other day that my left turn signal was blinking faster than normal. Now I know that this would denote a burnt lightbulb but I got out of my car to see if one wasn't working on my left side. All of my lights seem to be "on" but the left side turn signals are flashing faster than normal. Also I did hit a speed bump at app. 40 mph the other day.
View 4 Replies
my car is a 2007 Chrysler PT Cruiser with over 75K on it. My problem is two fold. First, recently the right rear turn signal light shorts out but only in the morning it seems. Because we've been getting a lot of rain in Nashville and the surrounding area, I suspect the high dewpoint and humidity might play a part here but I think I just need to replace the bulb.The second issue is a little more annoying. For whatever reason, the "air bag warning" light on the driver side console comes on and I cannot figure out why.The third issue is a little more pressing. I noticed during the summer whenever I was idling and had the A/C running, occasionally I would hear the engine act like it was about to stall out, like RPMs had dropped significantly. Now I've noticed it does that when the front defroster is running and winter is coming. What can I do about any of these problems listed here?
View 7 Replies
A few weeks ago, I went out to my car & the remote opener would not work. So I opened the door with the key. I went to start the car & it would not start. I got absolutely nothing. I also then could not get the key back out of the ignition. It would not even turn back to the original position. My father get the car started with a jump, but since then my car radio does not work. I also do not hear any noise when using the turn signals. They work, but no "blinking" sound. I tried to research this thinking maybe you have to "reset" the radio after a power "outage" but have been unable to find anything on how to do this. My husband recently passed away and I'm feeling a little lost when it comes to issues with my car. Where I can find some info?
View 4 Replies
I noticed that my turn signals stopped working. I replaced the flasher. Now the turn signals work but the signal indicators in the dash don't light up. Also, the hazard lights don't work either. No flashing, no blinking when I turn on my hazards. I've seen many variations while searching? 1994 B3000 2x4 extra cab.....
View 14 Replies
The problem is that both sides blink fast the left one used to blink normally sometimes and fast again all the lightbulbs work and are not led i found the problem on the right side : in the front the side light blinks but the drl doesnt blink with it now both sides blink fast. What my problems might be? What part of the car i should check ?
View 3 Replies
My blinkers started off blinking a few times then stopped working, now they don't work at all. The fuse says it goes to the brake lamps, hazards and turn signals. The hazards work as well as the brake lamps. I found the relay/flasher box and it appears the relay and flasher is the same for both the turn signals and the hazards. I checked for the wire/connector problem in the column and all looks good there. When I activate the turn signal lever I feel one click in the relay/flasher which leads me to believe the turn signal switch is working. I went ahead and replaced the relay with no results. Is the flasher internals the same for both the hazards and the turn signals or is there two independent sections inside for each?
View 4 Replies
My son's wife has a PT Cruiser, she told me last night that it has a shimmy at 70 mph. What are the causes of this ?
View 10 Replies
My PT has a vibration, I've replaced rear drums, rear hub assemblies, front brakes and front rotors and all four tires.The vibration is only while going 55 to 60 MPH each time I've replaced the different parts (rotated the tires and rear drums) the wobble seems to go away for about a few miles and then comes back!I'm going to replace the front hubs and bearings now, but why would the wobble change each time I changed I've changed all these parts around. Could it be a bent rim? or just the front bearings?
View 5 Replies
I have a 2004 PT Cruiser with 111,000 miles on it. A summer or two ago, whenever it got hot out, the check engine light would start to come on. Usually, it didn't affect the car's driveability - but sometimes, it would cause the car to buck and/or stall, sometimes to the point of stalling completely out. Brought it into the shop again and again. Camshaft sensor. O2 sensor. Crankshaft sensor. Replaced. Checked. P0304 misfire code came up in diagnostics again and again. Re-wiring of camshaft sensor wires. And on and on. And yet again, intermittently, the check engine light would come back on and the whole thing would start all over again. Sometimes you'd drive it, stop somewhere, start it again, and the check engine light would be gone. Sometimes it would stay on for days. Weeks. Sometimes with no other driving symptoms - it just depends on how the car is feeling? I thought the problem was limited to the hot months of summer, but now it's the dead of January in Minnesota and it's happening again. Yesterday, it stalled out completely and I had to get it towed to the shop - decided to try a new shop, they said maybe the problem was that the old shop did a bad wiring job. OK. But then, got the car back, no check engine light on first drive, stopped somewhere for 5 minutes, get back in, start it again, check engine light back on. But at least the car started and didn't buck/stall. Now it's back in the shop, but I'm ready to give up.
View 5 Replies
I have a 2002 chrysler pt cruiser. For the past week when I start to crank it it will just click one or two times then crank. Today it won't start at all just clicking.
View 2 Replies
I have an 05 pt cruiser that idles rough sporadically. Sometimes it idles smooth, sometimes it is rough but will calm down when i shift into gear, and sometimes it is rough when i let off the gas and come to a stop sign. When i first crank the car, the idle is rough and will act like it wants to cut out when i first back out of the driveway, but it clears up and drives better after getting gas. I have changed the plugs and wires, which did work, but there is something else still causing some problems. When at cruising speed, you can't detect any stutters or other problems. I looked at the vacuum lines and have a bottle of injector cleaner on 3 tanks of gas back to back with no apparent change. I did put a PCM on it a few years back, is it possible it has gone bad? The gas mileage also has seem to be suffering. I also checked the air filter as a possible problem, but it is very clean.
View 6 Replies
