Chrysler - Lebaron :: 1994 3.0 Engine Water On Spark Plug
Jul 23, 2011
I wanted to no why my car has water on the spark plugs not a lot though couple drips on the threads and on the part u gap(numbers 3 and 5 both are side by side), the oil looks like a light chocolate shack, it also spills a lot of water out the exhaust pipe. sort of like its being sprayed out non stop. i haven't did a compression test but all plugs are removed I am thinking its a head gasket. And the rest of the spark plugs look good just numbers 3 and 5 were wet.
View 19 Replies
Advertisement
Thought this would be a fairly straight forward fix of making sure that the transmission fluid was full with no air in it, as well as a few other things to try.
Well, I've run out of things I can reliably try right now. Replaced the output sensor on the transmission, filled the transmission fluid with the proper type, read error outputs. (boy was that odd, you have to turn the key three times in a certain way and it blinks codes out at you)
The error readouts point to an Oxygen sensor, and the speed sensor. The oxygen sensor I could care less about at the moment, as I can't really reliably drive the car in first gear. Once it shifts, then I'll fix that, otherwise its wasted money as I won't be driving anyways.
None of my local mechanics have a machine to read or program this thing by the way, so that is kind of out of the question.
View 8 Replies
I have a 1994 Chrysler Lebaron. The issue I've been having is for the last two weeks, my oil pressure gauge starts very high(out of normal range), and stays there for a very long time. Whilst it's at the highest possible level, the engine starts to heat up, until the gauge goes into range. This all happens without the car moving. If I leave the car on for 30 minutes(without moving it) the gauge goes into normal range, and for the most part operates normally. I have disconnected the Compressor's belt, in order to be able to turn on the engine fan from inside the car. As long as I keep the fan on, the engine stays cool for the most part.
I have considered that it was sludge, as it would soften as the engine heats up, but I have done an engine flush(machine), and the issue continues.
So far every mechanic I take it too, acts like it's impossible for the oil pump to have any issues, and claims it's normal behavior, which it's not.
View 10 Replies
I had a remanufactured 2.5 Liter engine installed in my '88 Chrysler LeBaron Convertible. The engine vibrates and starts and dies in the AM until it warms up. I also had the engine and transmission mounts replaced; it made the vibration worse, I can really feel it in the steering wheel.The two balance shafts have not been checked, in addition to that, what else should I check for to resolve this problem?
View 7 Replies
1997 f-150, 4.6, 147K miles. This morning I started the truck and the engine light was on. Felt a miss in the engine. Drove 1 mile and back then checked the wires. Found one not firing. Traced it back to the plug. When I pulled the plug boot off I noticed water in the recess, surrounding the plug. Once I blow out the water, I'll checjk the plug but I would like to know if this is a natural occurrence. I thought the boot would prevent water from filling the recess and sitting there. Or does the water just evaporate when the engine gets hot?
View 14 Replies
I have a small problem, the dealer that serviced my car just told me that my water pump was leaking and I was low on coolant. I can't remember when was the last time I checked the coolant level but when the dealer top off the coolant, he nearly used the entire bottle. Needless to say, I believe the radiator was pretty low on coolant.
Now I've never noticed a high temperature warning lamp or ever broken down. Today at 125,000 miles, I went to change my spark plugs. The 1st plug to the far left as you are facing the car has oil in the spark plug. This is freaking me out, could my engine be damaged from the low coolant?
View 19 Replies
I have a 1996 Chrysler LeBaron and when it idles it overheats so I did my research and I figured it could be the water pump I replace the water pump and during that process I had to disconnect the timing belt then put the water pump on and reinstall the timing belt when I put everything back together I thought I was done but it didn't start and I'm wondering if it's because the timing is off. I did not reset the timing nor move the camshaft how can I tell what's going on.
View 1 Replies
I have 1988 Chrysler Lebaron. It dies after I first start it and now it is doing it any old time. If I tromp on the gas it sputters and keeps going. It is really bad at stop lights, stop signs or slowing down for corners. Also the ac is not cooling. The blower is fine, but no cool air coming from vents.
View 3 Replies
1993 lebaron GTC... I just got the oil change, and the tec slip and the wrench touch the starter, positive and negative ends. I have power every where but no crank to start. I had a new backup starter and replace it figure that it was shot but after getting it tested its fine. I can hear the starter but i get no crank. Where do i look?
View 9 Replies
2004 echo, 109,000 km. P0301 came up and upon investigation I discovered that my no.1 spark plug well was filled with what I believe to be coolant. The top of the valve cover (where the coil packs are seated) was bone dry. The oil, from what I can see on the dip stick looks ok - I intend to replace to investigate further. Coolant is low. Spark plug wells for cylinders 2 - 4 are ok.
View 8 Replies
92 lebarron conv. 4 cyld. non turbo
New cap, rotor, and plugs
Misses on 3 and 4.
When pull plug wires engine doesn't change. When pull 1 or 2 it dies. When put in gear it chugs and dies.
View 10 Replies
I have a 95 chrysler lebaron that stops accelerating while driving. I have had the fuel pump replaced twice in the last year and now it is acting up again! It jumps and then gives up. I have not noticed any other signs that happen.
View 2 Replies
I own a really nice original ' 89 Chrysler Lebaron coupe with the 2.5 N/A, throttle body injection and 3 speed automatic. It has just over 100k miles. The car sits in the garage all the time and is not used during the winter months and is never used in the salt season. I do "try" to start it sometimes just to keep the battery up. The problem is when I want to start it, especially after sitting for a while, often it will crank and crank but won't start. It's acting like it has no gas. When I take the aircleaner lid off and dump a little gas in, it fires up just fine then runs perfect after that. Even after it has been used as a daily car after that, when I shut it off, sometimes it will start just fine, other times it won't, then I have to use the gas can again. It has a mind of it's own. When you think it will restart, sometimes it won't. I've been keeping a little gas can in the trunk in case it does happen at odd times. With the gas can, it will always restart. I've talked to a few shops about this, they have no idea what might do this. Naturally, when I brought it in to show it to them, it would ALWAYS restart for them. Getting rid of this car is not an option for me, I love the car, except for that part of it.
View 10 Replies
My son has a 1985 lebaron and the brakes just suddenly stopped working. He has replaced the pads, rotors, calipers and bled the system but when you push the brake pedal it goes to the floor. the mechanic where is works is stumped - been like this for three days and they can't figure out what the problem is.
View 6 Replies
I have an ' 89 Chrysler Lebaron coupe in very good condition. The car has an overhead console which is digital. It shows the compass and outside temperature. The compass works fine, but the outside temperature is always way off, normally about 30-40 degrees higher than it should be. I was told that the "thermometer" for that is located somewhere behind the grille. I am unable to locate it and am unaware of what it looks like. Auto part stores in my area don't seem to have a listing for this part. Most of these cars were convertibles, so only the higher end coupes had this option, I'm told.
View 3 Replies
I have a 1993 Chrysler Lebaron and the power steering on it just stopped working today. It was low on power steering fluid and I replaced the fluid but it still doesn't work. I can't find anything related on the Internet.
View 5 Replies
Chrysler 1998 Lebaron. The door locks will run constantly, they go up and down when driving and when parked, the same with the lights...now finding that in the middle of the night the car alarm is going off for no reason...also finding that the dome light will not shut off
View 2 Replies
My mother in-law has a 94 Chrysler LHS, 3.5 V6, auto, 66k. Yesterday she was driving home and said the check engine light was on. I went to check it out and the light was not on. The light come on when the key is turned on but goes out when it is started. This is not an OBD-2 car it has a little blue plug and i do not have a code reader for it. Took it to auto zone and they do not have a code reader for this car. Auto Zone and Pep Boys both told me that if the light is off there will not be a code. Further checking on the internet I found out you can get a two digit code by turning the key on and off and count the flashing check engine light. It worked I got code 12 and 51. 51 means lean O2 sensor. If this is true that why does the CEL not stay on. How can I test the O2 sensors?
View 2 Replies
I have a '99 Rodeo 2.2L, 2wd with 60k. Time for new plugs and wires. Any engine diagram? I haven't found the Distributor Cap.. AND... my Haynes Repair Manual mentions coil packs... when I went to AutoZone for Spark Plug wires, they didn't say anything about coil packs.
View 2 Replies
01 vw passat 1.8, spark plug hole number 2 is full of liquid possibly anti freeze, head gasket looks wet. Water pump is pumping and thermostat is opening, car overheated. Also my engine clicks so bad it sounds like a diesel when i am below 1500 rpms but above with more oil pressure it's fine, I have been told camshaft.
View 4 Replies
How long should I let my engine cool down before changing the spark plugs? I have a 2003 Toyota Tacoma 4cyl 2.4l. My drive home from work is about 10 miles and I would like to change my plugs after work but I am not sure how long I should wait before working on the vehicle.
View 5 Replies
