Chrysler - 300m :: 2000 - Press Harder Than Normal While Stopping At Light?
Sep 15, 2012
My 2000 300M has 135k miles on her. With the a/c on when I come up to a traffic light and stop, it feels like i have to press harder then normal to keep the car stopped at the light. the other night at a light I put the car in nuetrel and the engine rpm went from 700 rpm to 1500 and up to 2000 rpm. There is no check engine light at this time. the car does not to this when the a/c is off. I have not scanned the car yet.
View 7 Replies
Advertisement
I own a 2000 Chrysler 300m, and have been driving it daily for the past three years. The car had 102,000 miles when I bought it, it now has 158,000. About three months ago, at 154,000 miles, the driver side wheel bearing began to hum. Shortly after, before i was able to fix the bearing, the ball joint on the passenger side snapped. I had it towed in to a shop, and the mechanic told me I needed a ball joint as well as a new CV axle.. The mechanic didn't fix the wheel bearing on the other side, and I took the car back as it was because I needed transportation. when he returned the car, he told me that I needed the same thing done on the other side, but that I had a month or so to do it.
A week later, the wheel bearing broke on the driver side, and I returned the car to him. This time he changed bearing assembly, another CV axle, two outer tie rods, new caliper bolts, and new tie rod sleeves. When I got the car back, he told me I needed an alignment, and to go someplace else and get one. I drove the car and it rode the same as it did before, so I didn't get the alignment. Three months later, I have put only 4000 miles on the car and the passenger side ball joint and CV axle just broke again.
The mechanic says that this is because I didn't get the alignment, but I'm not so sure. I've driven cars that needed to be aligned before, and never had any ball joints break as a result. I think that he may have not put it on right, or missed something else that caused the problem. Is it likely that needing an alignment would cause a ball joint to break this quickly, on only one side, or is this guy trying to hose me?
View 3 Replies
MY 2000 300M has a problem with the fuel gauge. When over 1/2 a tank and just under the full mark the gauge will randomly drop down to empty and turn on the low fuel light then go back to the correct reading and will do this over and over again. my mechanic has looked at the car believes it's the sending unit. Just wanted a second opinion before I spent the money for a fuel pump module for the car.
View 7 Replies
I have a 2000 neon, a knocking sound has started only when I get on the gas a bit harder than normal from a dead stop. It seems to last only a few seconds knock knock really fast and then its gone, does not sound like engine knock (rocker knock or persistent knock) more like a mechanical noise. Where to start ? Front breaks were done 4months ago, new rotors / pads / and 1 caliper ...
Seems it to be worse now....now starting to lean towards broken motor mount ... how to check or where to find them. Also now starting to hear while braking.
View 1 Replies
Three days ago while stopped at a light the car creeped forward forcing me to press harder on the brake to keep vehicle from moving.
Next day drove for 100+ miles with some stop and go traffic no problems. Third day drove 50 miles and upon arriving at home brakes felt spongy and nearly hit the floor the dash illuminated "Check Brake System".
My Camry has 5437 miles on it.
The dealer just called and said they need to replace a "brake booster". They said there is a TSB that addresses this issue in a VIN range.
Image here : YouTube [URL].....
I'm glad I was only stopping to pull into my drive way and not the freaking stop and go freeway traffic on the way to work in the morning.
View 3 Replies
When it is hot out and the interior of the car gets really hot these things do not work: the electric windows will not work, the turn signals will not work, the display on the air conditioner does not work the blower on the air will not work but the air will come out of the defroster. All the dash lights come on abs, trac on trac off. After the car sits in the shade for at least an hour all these things will work.
View 1 Replies
I have a 2000 Chrysler 300M. Recently I got in the car and shut the door normally, not a hard slam or anything, and the driver side window just shattered to pieces. After having the glass replaced I had my mechanic check out the window regulator thinking that may have have been loose or in some way caused the glass to break. It checked out fine, no problem with the mechanism could be found. I've been using the window since then for about 3 months with no problems. What could have caused this window to crumble?
View 5 Replies
So when i try and brake boost, I put my foot on the brake and then harder on the gas but instead of building power my ecu just cuts the boost. I tried it with traction control off aswell.
View 6 Replies
i have a 2013 golf r with about 2k miles. Say if I am in second gear and i kinda press the pedal a little harder then i usually do, i hear a weird noise. kinda sounding like a fake exhaust sound or some sort of vibration near where the e brake is. when i let go of the pedal the noise goes away. I know my description is terrible but its honestly a strange noise.
View 5 Replies
2000 Chrysler 300M with 142K miles. Was a very reliable car until recently.
Problem began with boiling coolant in the reservoir tank. Then began to lose coolant at a high rate. I tried stop leak products and replaced the coolant frequently for a couple months. Some of it kind of worked, but the problem always returned. The car drives fine for about 10 highway miles then begins to steam out from under the hood on the passenger side. It gets about half way up the temp gauge, but does not really overheat. I usually stop when it steams out, let it cool, replace the antifreeze, then do it all over again. I've also tried a bunch of other things too, e.g., radiator flush. None of it worked.
The mechanic wants to replace the radiator. Says the system does not have pressure so there's no real way to determine if there are leaks in the engine. But he does know that the radiator is no good. I'm okay to replace radiator, but don't want to do it just to find out ten minutes later that I have a blown head gasket, which I would opt not to fix. I have read the tell tale signs of a blown head gasket, such as coolant in the oil, but there is none. My exhaust is white, but it's 5 degrees outside and it doesn't look whiter. I have seen some coolant on the ground at times.
View 15 Replies
I had something unusual happen recently... I backed out the driveway and went to put the car in drive and found the shift lever harder to move than normal and it wouldn't go into drive. It would go into park and reverse easily enough. After some manipulation it went into drive and ran with no problems to my destination. At first, I thought something fell down into the mechanism and was causing it to bind. AND of course, when I showed it to a pal, I could not recreate the issue. The next morning it worked fine, but it happened again later in the day, but it took much longer to get it into drive.
On the way home, the check engine and traction control lights both came on. I dropped it off at my mechanics and he diagnosed error code C1201 P0705 and claims that the remote starter (shop installed after market) is interfering with the transmission control module. I contacted the installer of the starter and he says it is not possible, but I know something is wrong... Now, I can't get it to act up and the idiot lights are gone. I need to rely on my vehicle and can't afford to be stranded somewhere. I feel it would be pointless to take the car to the installer, since the warning lights are gone and there are no shifting issues now.
View 2 Replies
My parents have a 2010 Hyundai Sonata. About a month ago my mom noticed that when she starts to brake, the car stops fine but then it stops again almost, with a loud thunk. The best way to describe it is that you press down the brake, the car stops, then a few seconds later the car feels like it is lunging forward and stopping again with a sudden thump. (Although I don't think it really actually moves at all).
View 5 Replies
2 parts to this problem, Just changed the brakes/rotors, drums, shoes all around again, but still have this problem.
1. While stopping at a light when the truck slows down to 5mph or so the petal seems to go soft and the abs kicks in and the truck seems to carry on another 5-10ft further. It slows down from hwy speeds normally but just when it comes down almost a complete stop the abs will kick on in very fast pulse and keeps rolling for a few more ft. Even on dry surfaces.
2. Sometimes on slippery surfaces (gravel roads/rain/snow) it seems like the rear brakes lock at low speeds when coming to a stop.
Just thinking of disconnecting the abs sensors to all wheels......
View 1 Replies
Lately I've been noticing on my 07 camry when i step on the brakes i have to press a lot of more than normal and when i'm stopped and still have my foot on the brake pedal i hear a hissing sound or hissing air with my foot still on the brakes.
View 10 Replies
Experienced excessive brake noise? Driving to work this morning and noticed the car was not stopping as normal and brakes being very loud. Did a quick check and found my driver's rotor looking like this...
View 2 Replies
I know it seems like everyone's truck tends to have different tolerances when it comes to when it starts and stops regen when it comes to gpl but the last two times my truck has gone into regen it starts at 100% and finishes at 25%. Is it normal to stop regen when it gets to 25% or should it be stopping at 0%. Or could it be that the percentage in my truck is off and it's actually using the gpl to start and Stop? The only thing about that is that forscan says it's supposed to start at 100% which it does so if my percentage is off that would mean it was starting at 75% does it not?
View 14 Replies
I have a 2000 Buick Century that only has 70000 miles on it. I have an issue that when I drive the car for a while, the transmission will shift hard after stopping at a light or stop sign. It only does it through the first three gears. If I shut the car off and let it sit for a few minutes and start it back up, it shifts fine through all of the gears. I have not had the change to change the fluid and filter yet. The fluid looks clean and is always full. I have read that there has been a common problem with a pressure control solenoid in the transmission needing replaced to correct the hard shifting. I am not getting any kind of error codes from the PCM, so I am not sure.
View 4 Replies
2000 v10 with 188400 miles. Everything runs great. No leaks. Oil pan gasket is weeping, but not dripping. Don't want to cross that bridge yet. Been towing a dual axle trailer with a little car on it quite a bit the last couple of months. Probably total 1,000 miles. Drove it up north which was a steep climb so it really had to work getting up the hills.
My question is, the oil light started flickering last night, and the gauge was also flickering from the L to normal range. It was jumping quite quickly. I put a quart of oil in it today, and the gauge never acted up again. So i think that ruled out the oil sending unit. The truck doesn't leak oil anywhere, at least according to the driveway. Maybe burning oil since I've been towing a lot? I checked the oil dipstick, but couldn't get a good reading. I can post pictures later.
View 9 Replies
I normally drive my 2010 Prius. But I have been driving my wife's 2012 Camry XLE the last couple of days. (My Prius was clean and hers was not.
Well twice in the last two days I started her car and put it in drive to find it was accelerating uncontrollably! The harder I pushed on the brake the harder it accelerated.
After taking my foot off of the brake I discovered that my size 13 EEE shoe was on both the brake AND the accelerator.
Now knowing this, the same thing happened the second day! Luckily They both happened in parking lots and NO damage was incurred!
This has never happened in my 10 Prius or my 08 Prius. maybe the pedals are not as close or the Prius's low end power was not noticeable.
It would be ironic if all the BS over the floor mats came down to big feet or improperly placed pedals. My feet have been the same size for 50 years and many cars and NEVER had this occur before.
View 14 Replies
At idle temperature is above middle. Upper radiator hose, which is connected to the thermostat is hot. Lower radiator hose that feeds back to the engine is cold. Radiator fan will not stop running if the temp guage is at middle to needle above middle. When running the temperature reading is normal at 30 mi/hr (middle to just below middle). Temperature will also go down if at high rpm idle, about 2,500 RPM.
New thermostat replaced last week. Water pump replaced less than one year ago. Upper radiator and lower radiator hoses are pressurized when running and off.
I suspect the thermostat was installed incorrectly. Pressurized hoses mean excess air in the cooling circuit/system. If so, does it mean I have to bleed out the air? How do you bleed out the air on a cooling circuit of a car, I thought the reservoir tank already does that naturally? I think the normal range for the temp guage should be 1/3 of the whole range of the guage, right?
View 19 Replies
I am on my 3rd engine in this car (known issues unfortunately) and for the past few weeks have had problems with the engine feeling like it is quickly cycling through normal and 'losing pressure' at MPH over 40 when gas is going into the system. Mechanic replaced oil pressure sensor but problem recurred on next drive and AC cooling went out at the same time.
View 6 Replies
