Chevrolet - Venture :: 2003 - Low Engine Oil Light Is On - But The Dipstick Shows Full
Dec 14, 2013
I turned on the car (2003 Chevy Venture) today and the "Low Engine Oil" display came on. I checked the oil (car had been parked on a flat surface overnight and engine was cold) and the oil was about 1/3 of the way up the dipstick, which is way, WAY past the full line. I let the car sit and warm up a little, checked again and the same level appeared. I am wondering what that means. After being on for a minute or so the engine oil light went off.
The check engine light has been on for about two days and when I went to check it yesterday the error code was p0171. Are the two related? Is there an easy fix for this or is this a sign of a serious problem?
View 11 Replies
Advertisement
My Chevy Venture 2003 approx 120 thousand miles is idling high at times. It will drive fast. I can feel it speeding up even when I am not pushing on the gas. When I put the car in reverse it flys backward (I have to keep my foot on the break to back up at a safe speed) and then when I put the car in park the engine is VERY loud. Again, this does not happen all the time. Usually when I drive it over ten miles. I thought it might have something to do with the AC, but I played around with that (driving with and without the AC) and that did not factor in it.
I took it to my own personal mechanic and he couldn't find anything wrong with it. I then took it to a dealership and they said they couldn't find anything wrong with after doing their hundred dollars worth of diagnostics and said they needed it to actually be doing it..what they called a hard fail...for them to know what was going on. . They drove the car for quite some time and nothing happened. I drove it all this pass weekend and nothing happened. It might go a week or so without doing it. Thenn it does it. Usually I can turn the car off and restart it and it will be back to normal. The check engine light is NOT on. Any clue as to what might be going on?
View 2 Replies
My mini van after driving it say 20 miles, starts shifting kinda like its slipping every know and then, and check engine light comes on. Its ok until about that first 20 miles, before that its ok.
View 1 Replies
I have a misfire on cylinder #5 on my 03 Chevy Venture with a 3.4L, I changed the #5 Injector because the shop I took it to said that's what it was. But the same code came back for misfire cylinder #5, would a bad plug or wire cause the same code to come up.
View 6 Replies
I own a 2003 Chevy Venture minivan that had the front left tire go flat yesterday. I backed out of the parking space and drove a few feet before realizing we had a flat and then immediately re-parked. The spare was bad (rusty and flat) so I had someone take me to Goodyear to replace the tire (it had a hole on the inside sidewall and was not repairable).
We got the tire on and drove the 30 miles home - as I was driving, I noticed that there was a slight vibration and a buzzing/humming sound coming from the front of the car. It definitely changed pitch/feel as the car sped up or slowed down.
I'm going to take the tire back off today and inspect everything to make sure everything is in place, but what might be going on? Bent rim? Tire balance?
View 4 Replies
My engine will occasionally lope at startup. If I look at my scanner the fuel trims will suddenly go negative up to - 20 and then the engine smooths out. It seems to happen in open loop and when in closed loop the fuel trims balance out. I changed my maf sensor, but it did nothing. I don't smell any gas, no Check engine light.
1998 Chevy Venture LS
240,000 miles
Engine replaced at 165,000
Platinum plugs replaced at 165,000
Plug wires replaced at 190,000
View 3 Replies
I have a 2009 Accord. Twice on long trips (~40 miles) in the rain, the car started missing badly, and the check engine light began blinking on and off. The first time, I pulled over and shut it off, restarted it, and everything was fine. A few weeks later, I took it for an oil change, and told the mechanic about it. He checked for codes, but there were none. The next time it happened (again on a rainy day on the same 40 mile route), I shut it off, turned it on, and drove straight to the dealer. He said it was 2.5 qts low on oil, and that could make it act that way. I check my oil regularly, so I was really surprised at that. It hasn’t happened again, but now I’m really obsessive about checking (and recording) oil. It’s always full, never low – except that twice, after the car has sat all day in cold weather, the dipstick was dry. I drove it home (a couple of miles), let it sit for an hour and checked the oil to find it full both times. I’m religious about changing the oil, so I doubt that there’s sludge in there…
View 8 Replies
This morning, when checking the oil in my car, I noticed the brake fluid was about half way full.
Before doing the 5k mile service, I had noticed it wasn't full. I told the dealer to make sure they top it off, and they did. Now at 12k the reservoir is half way again. Rarely brake fluid should go down.
View 19 Replies
I have a 2007 accent. I just changed the oil and filter. I typically don't look at the dipstick after I change the oil but this time I did. The dipstick is ready a good 1/4 inch over full after the change. I started the car and let it run for a while and it still reads the same.
I don't see how I put too much oil in, but I am paranoid that I did. Is it typical for this model to read a little over full on the dipstick?
View 11 Replies
I like to efficiently use my regenerative braking. Proof of that is that I have 107K miles on my 2008 and haven't had a brake job yet. Referring to my 2012, on the Hybrid System Indicator Screen, there is a CHG bar. The harder you brake, the more the bar fills from right to left. When the bar is full (when braking harder) do the brake shoes offer the balance of braking power needed.
Does the CHG display indicate that much accuracy?
View 13 Replies
I been having this issue when I drive to 0 miles left on gauge, then fill it at gas station and it clicks like its full, but shows only 8.5-9 gallons? And fuel gauge shows 1 bar missing from full.
2011 66k miles
Took to dealer and they replaced gauge module and was ok for 2 fill ups but now its doing it again.
View 5 Replies
We just past 1000 miles on our new 08 2.0T wagon and there is '0' oil consumption. The dipstick reads completely full. And...it is noticeably cleaner than our 06 2.0T after 1000 miles (after oil changes).
View 6 Replies
My gas gauge is intermittent. most of the time it reads right, but like 30% of the time it shows empty regardless of how full the tank is. What would cause this?
View 6 Replies
I just bought my 2012 Elantra Limited from the dealer today . The fuel gauge showed about two bars, a quarter tank I estimated. However when I went to fuel it, the pump clicked off after about 1 gallon, indicating the tank was full.
That was odd so I just figured there was some air in the tank or in the hose, so I tried adding some more fuel. I got about a half gallon more added when it clicked off again. Well, I know you're not supposed to top off the tank so I tried to add more. Got about two gallons added when it clicked off. I stopped fueling at that point for fear of causing damage.
My fuel gauge now shows a little less than half full. How can that be? Is there something I can do to fix this?
View 3 Replies
Been driving for 3 days now for a total of about 100 miles from a full tank averaging 50 miles per gallon. I noticed the gauge still shows FULL. Not even a bar below or something. Is there anything wrong with my gauge?
View 19 Replies
I have a 2004 Nissan 350Z. During the first few years of the car, I always had a gas gauge that read correctly. Then, I had a recall notice about the gas tank. I took it in and got the part fixed. Now, my gas gauge does not read correctly. It rarely shows that it is full. In fact it looks like the needle "floats" up and down when I have driven it and used some of the gas.
Another thing I noticed is if the tank reads below 1/2 a tank and I go in to fill the tank, then start the car up, it looks like the needle just "sticks" and then jumps to almost full. I have put in some gas cleaners to see if that would work and it does a little but two things I would like to know:
If I decide to get this fixed, what is it that I should call this problem? When I mention it to the mechanics, they always act like I am nuts or they have never heard of this problem.
View 1 Replies
Trailblazer 2008. This has happened 6 or 8 times. When fuel tank is 1/4 full or less, decelerating downhill from 50 mph to make a right-hand turn, the engine stalls as I reach the turn. Of course I lose power steering and brakes.
If I stop in that downhill position, the fuel gauge reads ZERO but the Low Fuel light is not showing. Turning the key to restart does not restart the engine but if I roll to a flat piece of road or to an uphill position, the engine starts immediately on turning the key. The fuel gauge continues to show ZERO until I turn off the ignition completely and restart. Then the fuel gauge immediately returns to indicate 1/4 full.
No warning lights of any kind show on the dash. There is no question of the gauge showing a false 1/4 indication when the tank is actually empty, since I can drive for 30 miles after the incident while the gauge slowly drops lower until I fill up again with gas.
SOMETHING tells the engine it has no gas so it stops. No stutter or indication of fuel starvation. Simply an engine shut-off.
I tried to reproduce the effect immediately after it had happened by turning the car round and retracing the route, but it did not happen a second time at that location, but it did repeat a few hours later at another intersection.
View 6 Replies
I have a Chevy 2006 Malibu LT V6 and when i first got the car a year ago I had no problems. After a few months, I would fill up the tank up completely and then drive it around and stop at a stop light. The gas meter would drop from Full to Empty with the light coming on then reset itself. It happened sparingly so I thought nothing of it. Now just a few days ago I filled the tank up and now the gauge is staying at Full when I know for a fact that I do not have a full tank. Whenever I turn on the car, the gas gauge needle jumps from full to empty to half to full to quarter until ending at full. Lately, I've been trying to go off the fuel mileage on my radio but with that resetting to what my fuel gauge says I'm getting fearful of running out of gas.
View 10 Replies
1998 base lumina 3.1 litre. 240,000 miles.
Usually runs great. Burns almost no oil between oil changes. Most recent change was about 3500 miles ago.
Yesterday when I checked the dip stick it had just a little oil showing on the bottom of the dip stick. I ran the motor and checked it a few more times. same thing. Then I put about 2.5 quarts in it and drove about 25 miles.
Then when I checked it appeared to have about 2 quarts too much on the dip stick. Would a bad oil filter cause that or what? Check engine light is on. Auto Zone says the "EGR" is messed up.
I changed the oil and filter today and the stick level looks ok now. I did notice the used oil was very dirty.
View 8 Replies
I am a new Prius III owner and am interested in knowing exactly when the engine is running. While the vehicle is moving it is very difficult to tell. I understand that there is a graphic screen that shows red arrows moving out of the engine, but when using other screens I can't tell if the engine is running. Wiring an LED indicator light that shows when the engine is running? And if so, where what power supplied for the light?
View 13 Replies
I have a 2010 rx350 and had a big oil leak recently because the car shop didn't install correctly the oil filter seals. It didn't leak right away and my wife drove till the check engine light came on, but it was late... no oil in the dipstick... I think no oil at all but the car didn't display low oil level warning. only a beep when i turned the steering wheel.
I had it towed and luckily my wife stopped the car when the light came on, no harm done the mechanic said. But I think it has less power and the engine noise is a little louder than before..., so maybe the engine has a Little wear. but there is no smoke. Should I continue to use the same thin oil.. 0w20. or use a thick like 5w30??
View 4 Replies
