98 tracker with 5 speed manual transmission has new clutch pressure plate throwout bearing and shit cable. strictly mechanical clutch mechanism drive for about 30 minutes and clutch goes away and unable to shift gears. let it sit overnight will work until about 30 minutes of drive time when everything has a chance to heat up...
View 8 RepliesThe problem started several months ago. At first it would only happen once in a while and would only last about 5 mins. The first time it happened I had it towed to my shop and it ran fine when it got there. Go figure. They told me they couldn't diagnose it if it wasn't acting up while they had it. Makes sense. But it never does it when I'm there for routine maintenance. Now it's doing it for twenty minutes at a crack. It's usually fine around town unless I get stuck in stop and go traffic. When it usually acts up is when I get on the road between work and home.
Every time I stop for gas I have to wait for it to decide it wants to start again. All of this is putting heavy wear on my starter. I changed the oxygen sensor (position no. 01), because that was the only error code that showed up. That didn't fix it. My mechanic says he thinks the next best step might be the cam and/or crank sensor. If not that, then he thinks we should change out the brain. Somebody else said it might be the fuel pump goin out. because I travel too far for work and I can't afford to fix things that probably won't solve the problem.
My 2005 Chevy Impala is taking a long time to crank. Now after 10 minutes or so of either idiling or driving, the car stalls out. I am able to restart it. Replaced the battery and no change. Lights are not getting dim in any way so I figure it's not the alternator. Could it be a bad starter?
View 2 RepliesI have my suspicion about what is the culprit, and well, the likelihood of it contuing to work.
Occasionally when I am at a stop and try to shift into gear with the clutch depressed to the floor, it does not want to go into gear. So far, I have been able to wiggle the shifter around, try a few different gears then go back to first and it works. Also at a stoplight today, with the clutch depressed to the floor for a few minutes with the car in 1st, after about 3-5 minutes the car started to slowly creep forward.
What are your suspects on this one?
I have a 2003 Ford Ranger, 5 speed, with 180k miles. Sometimes, not all the time, when I press the clutch and shift gears, the engine will rev.I dont drive the truck a whole lot, its a 2nd vehicle.
View 1 RepliesMy 1970 chevy c10 pickup is a 350 with automatic transmission 2wd. It doesn't get driven frequently and when I do the first time I put it into gear, fwd or reverse, it is slow to engage. Shortly after it has warmed up however, this problem goes away. What this sounds like?
View 6 RepliesSo I have a 2001 VW Jetta Wolfsburg Edition, love the car. So here's my problem, whenever I am driving for more then 20-30 minutes my shifting between gears begins to become more and more rough, like whenever I shift from 2nd to 3rd, it directs me to first gear instead of 3rd and I have to kinda force it into 3rd. This only happens when I am driving for a long period of time, why this is happening? and sometimes when I put it in reverse I get a loud crunch noise but I get it into gear...
View 1 RepliesI own a 2002 Monte Carlo SS 3.8 6cyl. I believe it has a 4T65-E transmission.
On a regular basis if I drive 20 miles out of town, on my way back the transmission starts to shift hard (long shift?). From my research online, the 4T65-e is a faulty transmission to begin with. Is it worth replacing the Shift and Pressure solenoids? If I were to buy a new transmission where should I look? What are some model numbers?
Oil, trans fluid, filters are changed on regular basis.New catalytic converter. No Check Engine Light.
Been having trouble shifting into any gears on these chilly mornings in VA now... The clutch has been sticking on its way out when I release it and the gears don't want to engage unless I really push hard on the shift knob.
View 11 Replies1999 5.4 ... I was just driving down road and truck suddenly wouldnt shift into overdrive/higher gear. pulled to side of road and the motor was revving very high at 2500 rpm. shut truck off and on a few times...kept doing it until finally after a while it went back to normal....
View 1 RepliesMy 2000 Chevy Tracker will not go into reverse. Had tranmission drained and cleaned. Still won't go into reverse. Does this model have a separate reverse cable?
View 1 RepliesMy check engine light has come on, and I have white smoke coming from under my hood when I drive. I'm trying to diagnose this and fix it. My mechanic had my car for a whole day and told me he needed more time to find out what it is.
My car is a 2002 chevy impala, and the smoke only comes after about 10 minutes of driving, and only lasts for about five minutes. When I open my hood, it seems the smoke is coming from the right side of my engine, maybe underneath, but it's hard to tell, but when I look just below the right side of the engine it does look to be a little bit wet down there. The smoke has a kind of sweet smell. So far, the car is still running fine.
The smoke only comes the first time I drive my car for the day.
In hot weather or even warm / humid weather, my very low mileage Mazda 626 (2002) becomes almost impossible to shift, especially from neutral to first, after about 20 minutes of driving. If I stop driving and the car cools off, it's okay again, until another 20 minutes of driving. It's fine in cool weather. This problem started in the summer of 2010.
View 4 RepliesI have an issue with the transmission not allowing me to shift from Park if I drive for couples of minutes unless I re-start the car. Also, if I drive for couples of minutes while I'm putting the cruise control on Standby mode or ON, it will shut off by itself along with the light for the economy driving mode.And again if I re-start the car everything will work.
This video will show you what I'm talking about : [URL] ....
My car is GLS 2011 and has 85,000 miles.
Has 118,000 miles and we have replaced speed sensors and changed transmission fluid and updated computer software. It runs perfectly for 30 minutes whether driving in town or highway but then hesitates and jerks when shifting from 1st to 2nd and downshifting also. After it shifts into 3rd, it is fine. Repair shop says it could be gear box or computer problem. No one in town seems to know what it is for sure. 2004 Saab 9.3 2.0T
View 2 Repliesmy 2002 Chevy Tracker has run faithfully for the last 5-6 years. a few things have come up recently that have needed to be replaced, but nothing huge. after my AC compressor was replaced, my car started powering off in the middle of driving (not while revving engine standing still). mostly on cold starts, but now more frequently. mechanic swears it has nothing to do with AC compressor.
But he is checking drive train today. He has changed the tranny fluid, fuel filter, cleaned the gas tank, cleaned the throttle body (IAC motor), cleaned the mass airflow filter sensor, checked the battery voltage in case of an alternator problem. he has scanned the vehicle while driving and sitting still several times and no codes come up.
I'll drive my 2000 Ford Ranger, 4cyl XLT about 5 miles to the store without a problem. On the way home, after a few miles, the clutch pedal will either jam at the top, or go all the way to the floor without engaging the clutch. If I wait 5 or 10 minutes, the clutch pedal will start working again for a short time.
If I feel the clutch pedal starting to misbehave, if I ride the clutch and don't release the clutch pedal all the way, and if I don't push the clutch pedal all the way down, I can keep driving the truck. As soon as I release the clutch pedal, it will jam up again, or the clutch pedal will go all the way to the floor without engaging the clutch. I don't like riding the clutch, but that seems to be the only way to get home once the clutch pedal starts jamming.
It certainly seems related to the engine warming, or heating up. Sometimes, after the clutch jams up, I'll wait 5-10 minutes and the clutch pedal will start working as if nothing every happened. So, it can't be strictly a hot engine, hot clutch fluid issue, right?
What would you attempt to replace first, the Slave Cylinder? The Master? Changing the fluid? Shooting the truck!?
So I have had an issue with my Ranger. When the car is cold it's fine. After a while...maybe 20-30 minutes of driving, the clutch will start to stick. No better way to describe it. I will take my foot off and it will stick on its way back. It starts subtle but the this will gradually get worse and eventually the clutch will seize up and I can't press it anymore and the car stalls and I'm stuck. The car cools off and everything will be fine no problem.....but the problem keeps resurfacing.
View 6 RepliesI rebuilt my turbo 350 transmission. I drove it about two blocks and checked my fluids. Everything was fine. So I drove it down town....two or three miles and I lost all gears forward and reverse. I got a ride home and left the car for about three hours then I went back to get it. The transmission shifted fine as i drove it home. I have parked the car since i cant trust the trans not to break down. As I drove to town I noticed a slight vibration in the trans area.
View 7 RepliesMy 2002 Chevy Tracker recently has been running poorly after consuming a 1/4 tank of gas. The check engine light comes on the scan tool reports P0171 and P0174 bank 1 and 2 lean(it's a 2.5 liter V-6). If I remove and replace the gas cap it runs better but not perfect. Once I use another 1/4 tank the symptoms return. I have noticed the cap is hard to remove lately. This has been going on for two weeks It's been to 2 garages one of them told me my catalytic converters are plugged up and wanted 2500 to fix .
View 8 RepliesI have a 98 Chevy Tracker 1.6 auto. My OBD reader shows engine load @ 25% in park at idle. What would cause this.
View 5 Replies