Chevrolet - Tracker :: 2003 - Noisy Engine After Rebuilt - Replaced 3 Times?
Nov 25, 2012
2003 Chevy Tracker 4 cylinder. Engine rebuilt and cannot get lifters to quiet down. Replaced 3 times. Bent valves on first install.
View 3 Replies2003 Chevy Tracker 4 cylinder. Engine rebuilt and cannot get lifters to quiet down. Replaced 3 times. Bent valves on first install.
View 3 Repliesmy 2002 Chevy Tracker has run faithfully for the last 5-6 years. a few things have come up recently that have needed to be replaced, but nothing huge. after my AC compressor was replaced, my car started powering off in the middle of driving (not while revving engine standing still). mostly on cold starts, but now more frequently. mechanic swears it has nothing to do with AC compressor.
But he is checking drive train today. He has changed the tranny fluid, fuel filter, cleaned the gas tank, cleaned the throttle body (IAC motor), cleaned the mass airflow filter sensor, checked the battery voltage in case of an alternator problem. he has scanned the vehicle while driving and sitting still several times and no codes come up.
I have a 98 Chevy Tracker 1.6 auto. My OBD reader shows engine load @ 25% in park at idle. What would cause this.
View 5 RepliesI'm having the well known situation with P0345, P0022
Replaced both phasers, replaced cam sensor, checked timing (properly aligned), assembled back still running rough and rattling, used 10w40 oil,
Complete rebuilt engine, we did head work new seals and springs, valves are straight I had it checked out twice for assurance. New pistons, new rings, new bearings, new oil pump and seals of course. If I disconnect cam sensor Bank 2 it works fine but still runs a little rough.
- Replaced one tensioner due to gasket wear.
- I was told to check on alternator ground (it's missing I know cause it got broken and I haven't replaced that ground that goes into the engine.)
- I also was told change oil to 5w20 and filter (Not FRAM), add some lucas and it should be the fix.
- Also told to disconnect the oil pressure sensor and it would fix the problem but it will throw a code for that.
- I haven't replaced the timing chains I feel they're a little loose but they haven't jumped the teeth, so I guess they're good.
- I saw in one thread to move a teeth on phaser giving me code bank 2 (moved one teeth back and then one teeth forward but it didn't work)
When I first rebuilt the engine I was having the rough iddle then I scanned it and it gave me the cam positioning sensor code P0345, then after I replaced it problem got fixed and code was gone, I was using the truck for 2 days with no issues, then the problem cam back with the two codes P0345 and P0022!
I'm having trouble with the headlights on my 2003 Chevy Tracker. When it's light out, my headlights come on automatically when I release the parking brake, but turn off if I turn the switch that would normally turn them on. When it is dark out, or I drive under a bridge etc, they turn off and I can't manually turn them on. I can "flash" my headlights, but if I turn them on as if to leave them on, they don't turn on. This problem started about the same time that my AC blower stopped working, so I replaced the blower motor resistor and all fuses (I've heard that the blower motor resistor is also involved with the headlights). This fixed the AC, but had no effect on the headlights.
I can trick the lights into turning on at night only by shining a bright light directly on the sensor - they turn back off as soon as I remove the light. I took it to Pep Boys for a basic electrical diagnostic to see if I might be missing something silly, but once I described the problem they wouldn't even bother - told me to take it to the dealer and have the body regulator module reprogrammed.
I drive a '99 Chevy Tracker with the 2Liter engine, a 5 speed manual transmission and 110K mi. on it. When I lift my foot from the throttle pedal in preparing to shift gears the engine takes a very long time to reduce it's RPM. This is a problem, when up shifting, as the transmission is spinning too fast for smooth gear engagement.
The engine idles normally under all other circumstances. It is only slow to decelerate whenever I lift my foot from the throttle pedal. This makes up shifting very slow and/or causes the gears to sometimes grind slightly.
I have an '02 Tracker and I've noticed if I have several accessories running, that my engine will start to sputter and come to the verge of stalling when I come to a stop. It happens if I have the heat/air and radio or charging my phone on together. What is the cause and/or remedy for this? I've changed the alternator a few yrs. back, but it still continued.
View 2 RepliesMy Chevy Venture 2003 approx 120 thousand miles is idling high at times. It will drive fast. I can feel it speeding up even when I am not pushing on the gas. When I put the car in reverse it flys backward (I have to keep my foot on the break to back up at a safe speed) and then when I put the car in park the engine is VERY loud. Again, this does not happen all the time. Usually when I drive it over ten miles. I thought it might have something to do with the AC, but I played around with that (driving with and without the AC) and that did not factor in it.
I took it to my own personal mechanic and he couldn't find anything wrong with it. I then took it to a dealership and they said they couldn't find anything wrong with after doing their hundred dollars worth of diagnostics and said they needed it to actually be doing it..what they called a hard fail...for them to know what was going on. . They drove the car for quite some time and nothing happened. I drove it all this pass weekend and nothing happened. It might go a week or so without doing it. Thenn it does it. Usually I can turn the car off and restart it and it will be back to normal. The check engine light is NOT on. Any clue as to what might be going on?
My 2000 Chevy Tracker will not go into reverse. Had tranmission drained and cleaned. Still won't go into reverse. Does this model have a separate reverse cable?
View 1 RepliesI have a o3 sc430 that's driving me crazy I have replaced the 02 sensor on my car three times and the cars vsc and check engine light comes back on after driving less then a mile. If I really step on the gas it'll come on faster. Where should I look for a vacuum leak? The mechanic says it could be electrical problems too...
View 14 RepliesMy 2002 Chevy Tracker recently has been running poorly after consuming a 1/4 tank of gas. The check engine light comes on the scan tool reports P0171 and P0174 bank 1 and 2 lean(it's a 2.5 liter V-6). If I remove and replace the gas cap it runs better but not perfect. Once I use another 1/4 tank the symptoms return. I have noticed the cap is hard to remove lately. This has been going on for two weeks It's been to 2 garages one of them told me my catalytic converters are plugged up and wanted 2500 to fix .
View 8 Replies2003 Chevy Tracker (same as Suzuki Gran Vitara) v6 2.5L
For about a year, it has had belt squeal on starting, which lasts about 5 minutes..it's louder when AC was on..would go away with higher RPMs. Once the car was warmed though, no squeal. Ac has been working very well and blowing cold whole time. Finally it around to replacing belt, which was a difficult.
Tightened with an idler pulley type system(not spring loaded). Started it up, squealed a little on start, but went away..turned on AC and the squeal is horribly loud now and constant..high rpms only make it louder. Noticed that clutch engages fine, but spins inconsistently..like we'll the belt is slipping. It spins slow, fast, slow..etc. I can't tighten anymore as the tightening bolt is at the end of the channel, don't want to strip it. Also noted that it is about a bolt head width more tight than its previous position.
Surely changing the belt wouldn't cause the clutch to bite it would it?
Other notes...drives great when ac is not on. This is an acc only belt..ac,idler,power steering. Also, during the repair, antifreeze got on the pulleys..I cleaned them all around with generous spray of brake cleaner..they look clean.
The problem started several months ago. At first it would only happen once in a while and would only last about 5 mins. The first time it happened I had it towed to my shop and it ran fine when it got there. Go figure. They told me they couldn't diagnose it if it wasn't acting up while they had it. Makes sense. But it never does it when I'm there for routine maintenance. Now it's doing it for twenty minutes at a crack. It's usually fine around town unless I get stuck in stop and go traffic. When it usually acts up is when I get on the road between work and home.
Every time I stop for gas I have to wait for it to decide it wants to start again. All of this is putting heavy wear on my starter. I changed the oxygen sensor (position no. 01), because that was the only error code that showed up. That didn't fix it. My mechanic says he thinks the next best step might be the cam and/or crank sensor. If not that, then he thinks we should change out the brain. Somebody else said it might be the fuel pump goin out. because I travel too far for work and I can't afford to fix things that probably won't solve the problem.
For 8 or 9 months now the dash lights and headlights on my 2001Chevy Tracker are dimming (more like flickering but they don't go completely out). It is not the alternator - it has been checked. For a period of 4 orso months in between the beginning of this and now - the dimming stopped and now it's back. The only thing I can correlate to the dimming stopping was I had to have my car jumped because I left the headlights on and the dimming seemed to stop for the long period of time.
View 1 RepliesPaid a shop 9000 to rebuild engine. Went to pick it had a major oil leak from back of the motor. They pulled the Trans and resealed the back plate. I test drove the truck and had some boost leaks and the AC needed charged. They pulled the truck in this morning and fixed those items. Now the truck will not move in any gear.
View 7 Replies98 tracker with 5 speed manual transmission has new clutch pressure plate throwout bearing and shit cable. strictly mechanical clutch mechanism drive for about 30 minutes and clutch goes away and unable to shift gears. let it sit overnight will work until about 30 minutes of drive time when everything has a chance to heat up...
View 8 Replies2006 chevy Colorado, 4 cyl engine, 50000 miles, at times when engine is warm it won't restart, when cold no problem, starter turns engine over OK, just won't start, wait 15--30 minutes starts OK... when engine is running it runs good..drives good, Chevy Dealer found no problems, I can find no fault codes when hooked up...
View 6 Replies1994 Geo Tracker 1.6L 16V engine won't start, but cranks. I have spark, compression is good, fuel (good fuel), new spark plugs, the crankshaft and camshaft are timed, the distributor is timed, there are no error codes but the ECU is fine.
I've put in new spark plugs and wires, new fuel injectors, new timing belt, new air filter. All sensors are hooked up and working. It cranks, but doesn't start. It keeps burning fuel, I can hear it and feel it in the engine, but it won't start and run.
One thing which I've noticed is weird is the crankshaft is very difficult to turn when it hits certain points. I try to turn it and it will go about a third or a turn pretty easily, but then it gets stuck and I have to turn the key to get it past that point. Then I try to turn it by hand again and it has the same problem in a different spot. It hasn't started in a month at this point, I'm planning on taking the distributor out and realigning it tomorrow, but I'm running out of things to test.
My wife drives a 2005 Solara 4 cylinder 2AZ-FE. Over the past few years, it has been going through batteries about every year and a half. The batteries have all failed on the load test.
So far, I've removed the alternator and taken it in to get it bench tested, tested fine. I had the full charging system check with the machine, starter tested fine, alternator volts were fine, only problem was the CCA load test (for which the battery was replaced under warranty). I tested for parasitic battery drain several times, got some drain for awhile after car is powered off, but it eventually falls to zero. I checked for voltage drop across the wiring, visually inspected the wiring to the starter, alternator, etc. and made sure the ground connections were tight from the battery to the frame and engine. Everything looked good.
The only thing I can come up with is that the most recent battery boiled over a bit at one point in time because there was evidence of acid spillage. Also, once (and only once), my wife noticed her lights flickering while her car was idling for awhile during a cold morning. These two things lead me to think it must be the alternator (voltage regulator), but neither the bench test nor anytime I test it at home reveals any issue.
Maybe it's an intermittent problem from vibration, etc. I just hate to plunk down the cash for a new alternator if that isn't the issue.
2003 F150 Super Crew 5.4
When I turn off the ignition, the drivers door lock unlocks or pushes the arm through the door for up to 30-60 seconds over and over again. I would say like 10 times and it is annoying as hell.
Is the only part in the door that controls this the actuator or is there something else that can be doing this?
I had been having battery issues with my 97 ford f150 4.6 liter for the longest time, thought i had a short under dash, i pulled entire dash out, disconnecting bat first of course, and inspected all wiring harness connections and fixing my issues and putting it all back together. now with new bat and all put back together i am now getting the airbag light flashing 5 times then 2 times (error code 52) i know it has some thing to do with power failure or backup battery, but now with the new battery in i cant seem to get it to reset. How to do this?
View 3 Replies