Chevrolet - S-10 :: Thumping Or Banging When Push The Clutch In
Feb 7, 2014
(That was my first mistake). He did it in his garage and everything seemed fine. Then about 2 weeks later I noticed that when I pushed in the clutch to shift gears it would come out of gear fine but, did not want to go into gear without a wrestling match between me and the gear shift. It didn't grind or make any noise it just refused to go into gear like I was pushing and some invisible wall had dropped preventing it from going back into gear. It doesn't always do it. I have noticed no pattern in when it does it.
Sometimes Ive been driving a while and it starts, other times I just started the car and within minutes of driving down the road it starts refusing to shift back into gear. I have noticed when It gets really bad I hear and feel this thumping or banging when I push the clutch in. When I pump the clutch a few times, sometimes this works to get it back into gear. At times it is so hard to put back into gear that I have had to use both hands on the clutch to force it into gear.? I have discussed this with some people they think it is my "pressure plate" (what ever that is). I do know that when the guy put the new clutch in he was not able to polish something down? The new clutch was installed about may 2012.
View 6 Replies
Advertisement
I recently purchased a used 2001 Chevy Blazer with a manual transmission. In order to start it, I have to push very hard on the clutch, almost through the floor. Is there some type of adjustment to make starting a little easier? Also, when I push on the parking brake, it also goes right to the floor and seems like it barely engages.
View 1 Replies
So when the car is idle i hear a weird rattle noise but when i push the clutch in the noise goes away.
View 5 Replies
When I push down the clutch there is an annoying whining noise. I can be at a stop or driving and either way it does it. It goes away when I let the clutch up. 04 GLi 1.8T 6 Speed. Has the Valeo Single Mass clutch conversion.
View 4 Replies
I have a 2004 mazda b2300 4cyl 5 speed that wants to stall on me sometimes when I engage the clutch and all most come to a complete stop. It does not happen every time i do this, but some of the time. I am able to instantly restart the truck and drive just fine. I am just confused at what might cause this. I did a tune up to it this weekend, and the cap from the clutch fluid did come off, I don't know if this would have anything to do with it. The truck runs great, just wants to stall some times.
View 19 Replies
Today I started my car (in the garage so it wasn't too cold) and everything was fine. The car warmed up in a couple minutes and I was off.
As i was driving, I noticed that my shifting was horrible. It felt like i was burning the clutch and not releasing the clutch smoothly in general.
I then noticed that when i pressed in the clutch ready to take the next gear, the engine would raise the rpm's about 500-1000 revs before coming down.
I started to wait till the revs came down to shift and that seems to work.
Why would the engine be revving itself higher the second after i push the clutch in. My dealer can't take me until Wednesday so I don't know what to do.
View 46 Replies
2001 Accent 1.5 GL 165K miles.
The clutch doesn't engage until it's on the floor. I have to push real hard to allow the gear to engage. It then shifts... sometimes smoothly, sometimes it takes a hard push of the gear shifter, or it grinds until getting into gear.
I've changed the master cylinder twice in about 3 years but those times the pedal had no spring and just fell to the floor and stayed. Now, the pedal has spring (I push it to the floor and it springs back) so I assume the MC is ok. I even bled it with fresh fluid.
I'm not sure if the tranny fluid has ever been changed. Would changing the fluid fix this problem or does it sound like I need a new clutch? I'm guessing it needs a new clutch (or corresponding parts) since I've had two MC's go bad in a few years.
The pedal, even when it's shifting smoothly is pretty non-responsive and still engages a little mushy (comparing it to my 2012 Elantra 6sp).
View 4 Replies
Ok my car is not starting. It is not turning over when you turn the key and push in the clutch. I can here a relay click under the drivers side dash. I can push start it and it runs great, sometimes it will start and run fine but it is a frequent problem now. What could be causing me these problems. 1991 Honda Civic DX ....
View 10 Replies
I just brought my gti in for the 20K oil change etc... I have noticed something weird... when I accelerate hard or have been driving for a while, and then shift into neutral or push in the clutch, the engine revs up to almost 2K, then back down to 1K once or twice, then finally settles to 700rpm's. It doesn't do it cold, or when I have the AC running.
I have no CEL's, and the dealer just said they ran a fault check, and it was clear. I do have an APR exhaust and a K&N intake (I think stage1 tune)... I asked about the PCV valve, and they said that would throw a code... They said they could do additional diagnostics out of warranty, since they think it has to be part of my aftermarket stuff.
I don't know if it's related, but if I really jump on it, in 5th gear or so, I can hear the car losing a little rpm's then around 4K just for a second, then it's goes back to normal... This only happened once or twice, so maybe it was just in my head...
View 8 Replies
Just noticed a clicking noise every time I push the clutch pedal down, I had my wife push the pedal while I listened under the hood and no noise it's coming from the clutch assembly under the dash! It's a 2013 only 4000km's on it so it's not like anything should be worn from over use etc. It's when I had the radio off driving I heard it, not super loud but more curiosity if it's normal noise from a clutch assembly.
As well the odd time I hear well my wife heard and pointed it out to me, when I push the brake pedal (more when we get in the car in the morning after sitting overnight) the same kinda sound more like when brake pad's are gently popping loose I guess you could say!? Like I said its mainly only after sitting for awhile, but we did hear it the odd time just as I go to slow down and only a quick 'click' again not deadly or anything more annoying that the car is brand new and we went brand new cause we were tired of creepy older cars we'd previously driven! I'm wondering if that may be exactly why its doing it since its new and need's to be used a bit to loosen up, this is the actually the first brand new no previous drivers car I've had!
View 17 Replies
The clutch on my 2003 Toyota Tacoma has been acting funny for a while. I have to pull the pedal back up with the top of my foot about half the time, otherwise it acts like the clutch isn't all the way disengaged when I push the pedal to the floor. The master and slave cylinders have both been replaced as well as the clutch pedal mechanism itself (thought it might be the spring). I adjusted the push rod a little bit and it seems to have worked slightly but it's definitely still a problem.
View 3 Replies
I have a 1994 Ford Ranger Supercab with 180,000 miles, 4.0ltr 6cyl and it is in relatively good condition. When I bought the truck the check engine light was on. The previous owner said that it was something in the gas tank that has gone bad but it was not a big deal and the truck could be driven with no problems.
My mechanics have tried several times to read the error code but their diagnostic tool won't tell them what is wrong.
I have noticed over the past few days that when I am slowing down and riding the clutch (I was making a u-turn this morning) that the truck will shut off. It starts right back up but it keeps happening.
I have been considering replacing the IAC, new spark plugs, rotor and wires and fuel filter but I am not 100% this will fix my problem. I am NOT a mechanic but know plenty of them so it will be a situation where I buy the parts and a buddy puts them in.
View 9 Replies
In my 99 with a zf6 it seems like when I push the clutch to the floor it's not disengaging all the way. It has a newer valair clutch in it maybe 15000 miles on it. It's really hard to get the truck in reverse or first from a stop. If the truck is stopped and it's in reverse or first with the clutch to the floor it will move in that gear. Is there a adjustment on the clutch? I'm thinking no since its hydraulic....
View 14 Replies
My cluch is almost 2 years old and gets treated with kid gloves , I shift low in the RPM's And accelerate slow for smooth shifting and fuel savings (17mpg avg.). But as of yesterday I can here the gears wind up after I push the clutch in. No problems with power or gear handling , Just the sound of the gear(s) (low dry rev/wind sound) No visible leaks , Clutch has oil at the step mark. Also - I can Make The Trans create the same sound if I keep the clutch petal in and rev the engine.
View 3 Replies
I drive a 2005 Chevy Silverado. I only drive a few miles a day, to and from work. The truck has about 32,000 miles. Recently it has started making a thumping noise, but only randomly. From inside the truck, it sounds like someone is knocking from under my hood while other times there are no unusual noises. I opened my hood while it was making the thumping noise but couldn't hear it from outside the car. Doesn't seem to make a difference what I do - put it in drive, neutral, reverse, park, go fast, slow, stop.
View 5 Replies
I have a 1999 f-150 4x4 4.6 5spd manual 180,000 miles on the clock. My question is, when coming to a stop i push the clutch in an the idle hangs at about twice what it should be until i come to a complete stop then it drops to normal. It's not like somethings sticking cause it will stay at the high idle as long as were rolling but as soon as the wheels stop turning it drops down.
View 2 Replies
Been having trouble shifting into any gears on these chilly mornings in VA now... The clutch has been sticking on its way out when I release it and the gears don't want to engage unless I really push hard on the shift knob.
View 11 Replies
I have the above mentioned car with 50876 miles. I noticed that the steering wheel causes a click in the suspension when turned left or right whether stationary or with the brakes engaged. Also I noticed a thump felt through the steering wheel while doing the same action. What could be causing it, I checked my power steering pump and the fluid is brownish-red in color and no leaks are visible either on the ground or around the pump. I also got under the car and there seems to be no leaky CV boots ( i had to look these up to know what they look like).
View 5 Replies
I have a 97 malibu w the 3.1, the back driver side door window wont go down unless i push it down, if I only use the switch i hear the motor working it appears it came out of the track that operates it. I would like to know how i can repair this myself.
View 4 Replies
My stock 2009 ford f250xl 4x4 with a 5.4 and 6 speed has been giving me a weird sound lately started about a month ago and only happens on a cold start situation meaning if it sits over night it will do the sound. the sound goes away after 3-5 min of warm up in my driveway, the sound happens when i push the clutch pedal to the floor. it has no pronounced abnormal sounds through out the rest of the day when its hot which perplexes me, check out the vid on my u tube site for a sound of it.
MAH00111 - YouTube
MAH00115 - YouTube
View 7 Replies
2000 Chevrolet Silverado 1500... When slowing down for stop, when almost stopped, sometimes the brake pedal pushes back momentarily, makes a bit of a (errrr) noise, and for two or three seconds during the push back the brakes do not work. Mechanic has cleaned ABS wheel sensors. All brake pads are good. The truck computer shows all systems okay. All brake lines are new or one year old.
View 2 Replies
