Chevrolet - S-10 :: 1995 - Gauges Are Not Accurate After Engine Swap?
Dec 19, 2015
I have a 1995 Chevy S-10 4.3 V6 TBI Z engine, manual trans 4x4 with 228,000 miles. I went through a long and expensive ordeal trying to fix an ignition problem. I won't get into the whole story but I went to 4 mechanics over 1.5 years. I finally have it fixed and running good. Last mechanic replaced the whole engine with a used one.
One of the quirks I have now is some of the gauges are not accurate since the engine swap. The new engine came out of a 1500 truck, not an S-10. The battery and oil pressure gauges are working fine. It's the speedometer and coolant gauges that are off. Speedometer is reading about 10+ mph above the actual speed and the temp is reading very low. Mechanic says the new engine wouldn't affect the gauges. The gauge needles are moving smoothly, not sticking or jerky. Is there any way to adjust them? Or maybe the sensors? Mechanic says I have to replace the whole cluster. I don't see any aftermarket ones for this truck.
View 19 Replies
Advertisement
I have a '95 'vette LT1 that I bought new for my 50th birthday. I only drive it about 4-500 (yes - hundred) miles a year and for the most part it sits in the garage, gets washed and waxed, and put away. 51000 original miles, the first 40000 put on in the first 1 1/2 years. I've had an ignition and fuel injection problem since I bought it. Get's fixed then some new ignition/injection problem comes back. Here's what it does now: car starts fine, runs about 30 seconds with no problem, then starts to miss, runs very rough and very rich (can smell it in the exhaust). After about 3 minutes, the engine smooths out and 2 seconds later, the "check engine" light comes on and the cooling fan starts to run. It runs fine for about 5 minutes, then "check engine" light goes out, fan stops, starts to run rough, misses, gas mileage (per the dash display) goes to about 5 mpg, runs rich, etc. Then the cycle starts again with the "check engine" light and fan coming on and the car running fine. I have no clue.
View 6 Replies
I have a 1995 Ford Taurus, and I just swapped in a new engine from a donor from 2000. The engine is a Flex Fuel 3.0L Vulcan OHV.I've got a wealth of background knowledge as a mechanic [5 years+] and an electrician [4 years+]I have swapped over everything required to make this work, in theory. I swapped exhaust, fuel system, and computer/harness and all the relays to go with it. I also made a custom gauge cluster from a 2000 Taurus as well.
Well everything works just peachy, all the wiring for the most part is correct minus a few buzzing relays that I just need to work out. The main issue this [now monster in my eyes] has is the PCM is not telling the FPDM to tell the Fuel Pump to start. Turn key, and no 3 second startup. I've checked the fuel pump, and it's fine. I replaced the PCM and that didn't solve it. I have the security system from the 2000 in there as well, thinking that was an issue. I also have the emission sensors and canisters installed, just like you would see in the 2000.
I'm at my wits end trying to figure out why the PCM isn't sending voltage out to the FPDM. I had to of missed something along the way but I double checked and still can't find anything. How to get this working properly.
View 17 Replies
Car is a 1995 Chevy Cavlier LS. 2.2L engine, about 127,000 miles. Has a minor coolant leak (freeze-out plug) and a slow oil leak (if I forget to check the level, the oil light comes on about 3000 miles after an oil change). It's beat up, had a few years of poor maintenance (but limited use) before I got it from a relative 3-4 years ago. I do oil changes at 3-5k miles, keeping fluids topped off, and try to remember to change the air filter regularly (which reminds me, I think I'm due for one).
Problem history: About 7 months ago, I had problems with the battery going dead. Some of it related to stupid mistakes--lights on or door ajar. Battery was old, parts store suggested replacing it. New battery fixed the issue. About 2 weeks ago, I tried to start it and ran into the same problem after the car hadn't been run for 2+ days. Dash lights come on, the key-in/startup bell chimes, but turning the key to start leads to fast clicking from the engine and the chime sounding rapidly. I forget if it made any other sounds at the time. Attempting to jump it didn't work, but the other car had an old battery and the cables were kindof cheap.
Called roadside, and he was able to jump it. He suggested taking the battery to Advance, so we did that.Advance charged the battery, tested it, said it was fine. Suggested I bring the car over and they could test to see if it's charging the battery. I did that, and it seemed ok. Engine was a little rough, possibly spark plugs, but I haven't checked that out yet. I figured I had done something stupid again and left a door ajar or the headlights on.Today, same problem again. I last drove it 2-3 days ago. Headlights were definitely off. It's possibly the driver door was ajar causing the dome light to stay on, but I doubt it. Same noises when I turn the key as before, I hear the sound of the engine trying to start once (I think that it's trying to turn over), but it won't start. Haven't had a chance to try and jump it yet.
Possibly relevant: Back in the spring, it wouldn't start one day, but the engine wouldn't do anything, no clicking etc. Neutral safety switch was loose/misaligned. Mechanic was able to make a small adjustment, and it's been fine.
View 5 Replies
After changing my radiator support, my fuel and temperature gauges don't work. I looked to see if everything was plugged in and I don't see anything unplugged. I do know the older trucks used the V-R regulators, but I don't know about this model.
View 2 Replies
Recent motor swap, wont turn over, headlights come on when key is on accesory Wiring problem? Stock Harness. ONLY wires touched were for throttle body and fuel ingection.
View 3 Replies
When I start the car the fuel gauge sometimes goes past F and interferes with the water temp gauge. Also noticed recently that the RPM is not reading correctly.
View 5 Replies
i have a 1988 2.4L 185,000+ miles chevy s10 pu. the check gauges light has been coming on for some time. the gauge bounces up and down a lot. but settles to 20psi at driving speeds. there is no tapping or noises from the engine and has good power and oil. what should i have check
View 4 Replies
I got this car from someone and I just noticed none of the gauges on the dashboard work! Everything else works fine and the mileage still shows, engine notifications still show, etc.It's a 2005 Chevy Impala. What might be wrong?
View 3 Replies
I have a 2006 Chevy Malibu Maxx LT with 94k miles. On cold mornings I have consistent problems with the car's electronics. They can be as benign as a warning bell about 2-3 minutes after starting driving. Sometimes, one of the warning lights will accompany the bell (power steering, traction control, etc), and then return to normal. Some mornings, all of the gauges will not work/stop working for the first 2-3 minutes of driving and then return to normal. The worst case scenario is that the car will not start at all. All lights, radio, etc. will work, but the car will not crank. I have had the car to a couple of shops where they have tested the battery and starter.
Both are new and working fine. No codes are ever generated. My question is how can I go about isolating what appears to be an electrical (or electronic) fault somewhere in the system that gets aggravated by cold weather. I read in another forum that the ignition system in other GM cars (the Saturn ION was one example) would trigger a fault in the ignition system in cold weather and the KeyPass security system would shut down the ignition for 10 minutes. For me, it's only occasional that the car will not start, but there is some electrical issue most every day that it's below 40 overnight. I have never had an issue after the car has started once during the day - this only happens on the first start of the day. Only once did the car go 2 days without starting.
1. Battery cables?
2. fuses?
3. etc.?
View 4 Replies
I travel and often live in a 94 chevy g20 3/4 ton van. Today I started it up and the electrical was flipping out, I got to the end of the road and I smelled electrical smoke and the van died.
I opened up the hood and the piece of wood that I usually wedge between the battery terminals and the metal frame of the van (the battery is very poorly placed and slides around) had slid out of place and the positive terminal had melted a bit and fused to the frame.
After I got it unstuck, I got a jump and it started right back up fine, but now when I turn on anything electrical my gauges drop slightly for a moment and my gear wont shift from low gear (it's an automatic transmission). This definitely won't do...
View 7 Replies
2003 impala 3800 ... My battery drains if i leave it hooked up over night: and the gauges will sometimes start to click and flicker and move when the key is out of the ignition: I have changed batteries 3 times in 1 yr and checked the alternator, everything is fine, I'm tired of disconnecting my battery every night before bedtime..
View 11 Replies
I inherited this car from my parents a couple years ago with about 80,000 miles. It ran great for awhile, then the air conditioner and the gauges would quit working while driving. After a few minutes they would resume working and everything would go back to normal. Now it will start sometimes and will not start at other times. I have replaced the battery two times and it seemed to work for a short period. I have had several mechanics look at it. After checking the code and replacing a fuse or sensor and replacing the ignition switch the car is still doing the same thing and no one has a clue what is going on. It seems to me that it may happen more often when going over a bump. What could be causing this?
View 2 Replies
I have a 2010 Chev Cobalt LT, bought brand new off the lot- at about 15,000 km's, I started to experience some electrical issues.. Basically, what it is the parking brake light comes on in the instrument panel along with the all the other warning lights, both speedo and rpm gauges stop working, -- basically EVERYTHING electrical, but the lights, and turn signals, hazards work-- took it in to the GM Dealer- they cleaned the BCM Connectors, it was fine for about 4 months- now it's doing it again... Same thing as before warning lights come on, and everything stops except last night the Keyless Entry would not work at all... This has me stumped and it's annoying having to take it all the time..
View 4 Replies
I have a 2001 Chevy S10 4.3L. The CHECK GAUGES light stays on, and the oil pressure gauge stays at 0. The oil is full, and the engine runs and sounds fine. I drove it about 5 miles with no change. Up until now, the gauge has worked normally. Could it be the sending unit?
View 2 Replies
Got no heat in my 1995 Chevy Lumina passenger car with 3100 engine. Have replaced thermostat, water pump and replaced freeze plug that had a pinhole in it. Heater still blowing cold air and temp gage only moves slightly - stays in low range never reaches normal operating temp. what's causing the problem and how to fix it?
View 9 Replies
I have a 95 Silverado 1500 with the 5.7 V8 that cuts out when the pedal is held just above idle. If I am just driving normally as in pulling up to a stop sign and leaving with moderate acceleration it is fine and I don't notice any problems at all. The time I really notice it is when I am backing a trailer up and have to hold the pedal just above idle. It acts like the fuel is just being shut off to all cylinders. When I let off the gas it will sound like it is going to die and then it will come back to idle and idle perfectly. I was told it was probibly the PCV valve and I figured that for a few bucks I didn't have much to loose but that didn't work. I am thinking it has to be a sensor but I may be wrong.
View 2 Replies
i own a 95 monte carlo z34. ever since i bought it last yr. i have had starting problems. i thought it might be a fuse, checked them all and there fine. i noticed when i pluged in the 2 ingnition fuses back in the fuse block under the hood,the security light lit up for a min then went out. now my car has the chip in the key also. i thought the securty system is failing some how. might it be the tumbler in the colum? if so i read here it could be bypassed, by buying a resister, and spliceing in to a fat orange wire under the steering column, to by pass the security system. is it that easy? if the person who posted the ad with the same problems im haveing could give me more detail instructions on doing this my self,because id rather fix it than take it to a dealer and spend big bucks i don't have.
View 4 Replies
we have a 1995 chevy astrovan. Some days it runs just fine and then others it cuts out repeatedly when we slow down or brake. It?s been to the mechanic a million times and he can?t find the problem?
View 8 Replies
I've got a noise that has me puzzled on my 1995 Chevy C1500 (2wd). I hear a mid to high pitched noise when I'm driving at between 45 and 55 mph (70-90 kph). It varies in pitch depending on the speed I'm going, starts at around 45 and goes away above 55, and also tends to go away if I lift off the gas. The sound occurs in any gear, but always at the same speeds. My leading suspect is the differential, but I haven't ruled out anything yet. I pulled the differential plug and the fluid isn't very dark.
View 7 Replies
1995 Chevy Suburban, currently at 150,000 miles, Prior owner had transmission rebuilt prior to 100,000 miles. While towing my 18ft camper trailer on a recent trip every time I started off from a stop I had to really push on the gas to get going. At first I though the emergency brake was on, or I had a flat tire. I then noticed the automatic transmission was not shifting when I had it in D. Checked the transmission fluid and it was full. The transmission seems to be stuck in 3rd gear. When I move the shifter to 2 it will shift down. Reverse is also still working. Am I in for a costly repair?
View 3 Replies
