I just bought a used 98 chevy metro. I drove it over a total of 30 miles on test drives. Every thing was as it should be. Now it dies at idle and is difficult to restart. I have to wait til it cools down completely to get it to fire again.
View 1 RepliesMy 98 Chrysler sebring has a fast idle at about 1500, occasionally dies but will restart, and has been making the garage smell like gas. Can't seem to figure out the problem.
View 4 RepliesMy brother (deceased ) had a girlfriend (very manipulative person ) who has left a 99 Metro 3 cyl sitting since 2012 ,now it wont run ,it will fire if you pour gas into the throttle body How hard is it to get to the fuel pump on that thing ?
View 17 Replieswhen car dies driving or idle- will not start for appx 30min after- cranks over immediately like it wants to, but will not actually start for about 30minutes... is this a sensor?
View 5 RepliesThis Buick began stalling, then difficult to start. We have replaced fuel filter, fuel pump and sending unit. It will start sometimes and either run smoothly for a few minutes or run rough stumble and backfire through the throttle body. It has not thrown a code thru any of this. How to proceed?
View 4 RepliesI have a 97 Geo Metro two door that just stalled on me one day driving up a hill. It was low on fuel and so I thought it might have just ran out of fuel. I put more fuel in it but it would not start. I had it towed back home and disconnected the hose out of the fuel pump to see if any fuel would spray out. It did not. This lead me to conclude the fuel pump is bad. I replaced the fuel pump but this still did not fix the problem. I had an electrical guy looking at it run a bypass wire to the fuel pump and it still did not work. His conclusion was that the ECM is bad. Does this sound like a logical conclusion?
View 3 Repliesok, 3 times now I've been extremely close to being hit head on by oncoming traffic due to a seemingly uncurable stalling problem. It idles rough sometimes, and other times it seems fine. BUT when sitting at a light, waiting to turn left after the oncoming traffic has a quick opening, I start to go, I get halfway across the intersection and then without warning, it dies completely. Now its too late to stop and back up- and the cars are flying head on towards you locking up they're brakes. One time I would have been killed by the 18 wheeler that was coming if I hadn't gotten it started and moving again just in time.
I replaced the IAC, the plugs, filters and wires, and the EGR valve. I checked everywhere for intake leaks and found nothing. Changed the O2 sensors since they had plenty of mileage on em. It idles like crap still, even after 30+ tanks of every kind of injector cleaner they make. We used the snap on scanner tool to monitor things and it never acted up then. The TPS seems to move smoothly, and fuel pressure was checked and found to be around 25-30 psi. Don't know if that's normal. The intake air temp was reading a constant 120 degrees F. I also checked the fuel cap to make sure it was closing completely. The dealer checked the TB for excessive clearance and said it was ok.
It seems to only stall like that after driving on the highway and then stopping at the first light after that.
94 Chevy W-4 wheel-lift wrecker 5.7L TBI4l80e trans
Had a run of about 100 miles round trip on Wednesday. On the way back running at 65 mph on the interstate, got a couple of quick muffler-end back fires and engine died. Coasted to shoulder. Had memory of almost exact same incident last year and it was dead ignition module. Fortunately had a spare (used) module in glovebox. Swapped it out and engine started right up. Remainder of trip didn't quit, but ran very rough, lots of stumbling and getting it up to 60 mph was a struggle. Also when I got on surface roads it died twice when I was sitting stationary. It would restart, BUT only after cycling key; if I just turned to the key to "start" from "on" it would crank but not fire.
Limped it to my tow buddy's shop where I freeload and told him the tale. He said, "throw those old spare modules away and get a new one". Called the local parts house and had them send two, one for installation and one for glovebox. Took for test drive and appeared to be running okay except idle was a bit low. Couple of hours later went on a call and first stop sign I came to, went "blip" and I'm dead in the water again. Same story as earlier, must turn key off and back on to get it to fire. Drove rest of day without incident. Yesterday, no issues all day, drove total of about 120 miles both highway speed and surface. Gassed up this morning and mpg was above average (yay!), actually about .5 above average which is significant improvement (about 6%). Success?
Today died four times while sitting still. Same having to cycle key for it to fire. Did some quicky t/s to satisfy my curiosity about the key cycle thing. With truck running, pulled fuel pump fuse to kill truck. Then reinserted and it started up without having to turn key to off. Tried same thing by pulling one of the module plugs to simulate loss of signal to ignition. Reconnected and again fired up without key cycling.
No codes at any time since this came up.
Swapped out the module since I had bought a spare, no change.
Ohmd the ignition coil and no problems noted. So far, only dies sitting still at idle.
Additional info:
Plug wires, cap, and rotor <1000 miles. Distributor low miles and negligible play in shaft. Pickup coil checks right in middle of ohm range. None of these, of course, should need to have the ignition key cycled to restart if they caused a stall.
Next up will be replacing ignition relay (had to order), but I'm not very optimistic.
I recently bought this cavalier about a week ago its and 88 automatic trans with 1.8 4 cylinder I thing not that it matters much. I noticed the exhaust had a smaller pipe from the manifold and the rest was strung with a bit bigger pipe and was attempted to crimp the pipes togather it was loud so I crimped thhe pipes better and used exhaust glue to patch the holes it runs better now to a point. but when I start the car it revs up a fair im guessing 3 grand since I have no rpm gauge but then it dies down to a low idle to the point were the car shakes a little bit.
with the exhaust fixed I can get it up to 20 kilometres an hour with my foot off the gas when I turn fully it wants to lurch ahead/backwards. when I took it out for a highway drive today I came to a stop sign so I slowed and stoped and the car stalled out. started no problem. but I also tried later putting it in neutral and it doesn't stall as I role to a stop it doesn't shake in neutral. I would like to have this fixed but I need some pointers as of were to look. im not sure if this means anything but when I got the car it had a bad enough radiator fluid leak at the hose meeting the heating car on the engine side of the fire wall I repaired that and no longer leaks.
I have a 1998 Explorer XLT with the 4.0 sohc engine.
Recently the truck started being difficult to start and takes a few times of cranking to get it going. Once running, it idles and drives fine on city streets and freeways. When trying to start it turns over fine but doesn't start. After a few times of that, it will finally start. Sometimes it will sputter out an die but then it will start right away and be fine.
It never starts right away when cold and when hot or after short trips its intermittent...Sometimes it will start right up...others it takes a time or two of cranking. I just replaced the fuel filter and it did not work. I am thinking the fuel pump but since its in the tank, I am hoping its not that.
I have a 1998 Chevrolet Prizm that will not fast idle when it is started in cold weather the first thing in morning. what could be the problem?
View 4 RepliesI have a 2000 chevy metro, whenever i start it up after it's been sitting for a little while a white smoke comes out of the back of it. zWhy this is doing it and how much approx.
View 1 RepliesWhat would cause my truck to have a long turnover start, a really rough idle, and a loss of power after idling at a stop light for about a minute?
This problem gets worse as the truck warms up. It feels as if I'm not getting power from all 6 cylinders but this goes away after about 20 feet of acceleration. The truck has never not started. It just has to turn over for about 5 to 10 seconds before it fires up. I changed the spark plugs and wires thinking it was that and then i tried the fuel filter and it wasn't that either.
Had an interesting problem with my 2006 Camry (134k miles - all maintenance up to date). After returning from trip, I went to start my 2006 Camry LE and it turned over but never started. After a couple more tries, I stepped on the accelerator while turning the key and it finally started. It's starting and running fine now but that is the first time that has ever happened. The car sat for 5 days.
View 3 RepliesI am having with my 2000 Accent GL. It keeps dying while I'm driving it then will not restart. After sitting for awhile it will start but then after a short time dies again. The first thing I did was replace the fuel filter but that did not work. Did a diagnostic scan and it threw a code for the CPS sensor. Replaced THAT and it STILL did not fix it. I reset the computer but it didn't work. The scanner didn't pick up any other codes. Next I checked the relays and they all seem to be fine. Finally, I replaced the fuel filter but the problem did not go away.
View 3 RepliesMy 1999 Yukon will start up, run for about 5 minutes at idle then die. Then it will not start again till the next day.
I hooked up a fuel pressure gauge to the fuel line at the fuel filter. It started up, and the pressure gauge went up to 54. I gave it some gas and pressure goes up to about 60 then back to 54 at idle. I sat and watched it for a bit then it died after about 5 minutes and the gauge went below 50 to about 48. I immediately tried to start again and the pressure actually drops a little while cranking to 45 and stayed there.
Whats weird is when I first started it up, I can hear the pump come on and it kicked the pressure up from 0 to 54. Then after dieing, I don't think I can hear the pump come on, and the pressure does not go up at all. I have a feeling tomorrow it will do the same thing, start up after sitting for awhile, then die after 5 minutes.
Does this sound like a fuel pump going bad? or does it sound like an electrical issue with the fuel pump?
1987 323 Mazda, manual transmission. Recently replaced motor and transmission and air conditioner, all used. Prior to replacement vehicle burned oil and was leaking transmission fluid and air conditioner wasn't working. Air conditioner was leaking and mechanic fixed the leak. First time I started it after that, there were a few big puffs of white smoke. Drove it about a week. Putting it in first was a little rough (but that was a problem with the transmission we used for replacement from another old car of ours we junked). but no other problems. Then we noticed it was leaking quite a bit of antifreeze and we could see it leaking onto the engine. We were putting antifreeze in it everyday.
I drive around 80 miles a day. After about a week, I had been driving it about 40 miles that day, I backed it into a driveway to turn around and when I put it in first, it was jerking and lurching. Drove it a carlength and it died. No check engine light. No overheating. Started it again and it bucked a few times while driving another carlength and died again. Then would start and die, start and die, start and die. No movement. Called the tow truck and took it to the mechanic. He said it was the fuel pump and fuel filter and replaced both those. He also fixed the antifreeze leak which was a loose clamp.
The next morning I drove it, it still lurched a couple times and a couple puffs of white smoke. Then I drove it about 10 miles, no problem. Parked it for about 2 hours and started it again. No problem initially, but then when I got to first stop sign in about a block, it lurched a bit. Next stop sign, another lurch. Then on the interstate a couple more small lurches, but not bad. After 10 miles I cruised to a stop and put it in neutral (to leave the engine on) and it died. No check engine light. Just the charge light came on. I had been playing the radio and radio was fine.
I started it again and drove straight to mechanic (about 2 miles). It lurched and bucked some along the way, but no white smoke. He replaced distributor but he said it didn't work. He said it was worse than before. I've looked at some similar problems on the net and here's what I found:
ground wire from the battery to the body and from engine to frame
EGR valve
Crankshaft position sensor
Powertrain control module (I don't even know if this car has one of those)idle air control
I don't know if mechanic has looked at any of the above.
I was picking my daughter up from school on Friday, drove to the school, parked and left the motor running while waiting on her to come out. The car suddenly dies and won't restart. I thought initially it was a problem of bad cable connections on the batter, but after resolving that, I still couldn't get the car to crank due to a drained battery.
I pulled engine codes and got a 306, misfire on bank 6, pulled and replaced the plug, and put a new battery on the car. Now, when I try to start it, the starter spins fast, RPM goes up to close to 1000, and the motor will eventually start to turn over correctly, but will quit and go back to the fast spinning. It will rotate back and forth between the try to crank and fast spinning continuously. I tried pulling engine codes again and got nothing.
Symptoms:
- Check engine light: misfire on all cylinders, and "lean fuel trim at part throttle".
Started with changing leads and plugs without improvement. Then I found the tank ventilation seemed to be clogged, as there was a massive vacuum when opening the filler cap. Checked the canister and replaced a couple of corroded lines. Also used compressed air to blow through the canister and lines up to the Evap-purge valve. Seemed to be OK afterwards (no vacuum), but still misfires.
Changed the Mass Air flow sensor, and it seems the misfires got better, but instead I have some other issues:
- Hard to start when cold. Starts up fine for a second then sounds like it's getting to much fuel and dies. Possible to keep it running if pumping the pedal or holding it at higher revs.
- Rough idle when warm. (Same as before I changed the MAF and plugs/ leads.)
- Drives and runs ok when out on the road.
- Pulled the cable to the Idle Control Valve without any change in idle...?
- Got flashing engine light and "misfire cylinder 4" when giving full throttle on low revs and seond gear up a steep climb.
What could cause this?
- Temperature sensor?
- O2-sensor?
- Idle control valve?
- Coilpack?
I have a 2001 chevy metro 4 cyl. with 13 inch wheels and automatic transmission. The engine rpm's are running high at highway speeds. Would a larger diameter wheel support this situation?
View 8 Replies4 cyldr has very rough idle along with engine shake. Just started doing this. I replaced the cam sensor a few months ago and all has been well. But it started running so rough, almost like it jumped time. I was disconnecting sensors to see if motor idle changed and when I unplugged mass air flow sensor on air filter intake tube, nothing changed. Could this cause such a dramatic idle ?
View 2 Replies