Chevrolet - Cobalt :: Steering Wheel Won't Return To Center Position?
Feb 2, 2014
I noticed this problem day as I was out and about, as I come out of a medium to hard turn (at least one wheel rotation) my wheel doesn't want to return fully to the center position. The wheel starts to slow down about half a turn in either position and I need to get it around the quarter turn position. I don't have to force it much, it feels more turning the wheel while in park.
I has winter tires put on in December and the mechanic told me they couldn't do an alignment because one of my rear coils was broken (planning on getting that fixed myself once I get a weekend where it's not at or below 0 outside) and my front ball-joints (I think that's what they said) was loose and that the front joint didn't need to be looked at immediately, but by spring should be replaced.
That front joint is what's giving me problems? Or is it something else?
View 5 Replies
Advertisement
Today, I just picked up my 2014 prius. Basically, when I do a right/left turn on the car, when accelerating out of the turn, the steering wheel does not fully return to the center position (its approximately in the one/eleven o'clock position). Also, if I leave the wheel straight, and drive straight, the car will drive straight and not pull towards the side so I don't think its an alignment issue. I'm not sure if this is normal, or if its happening just because they car is new or just because I'm not accelerating hard enough out of the turn (I always stayed in the eco range with the HSI. )
View 5 Replies
13.5k, 2.2 Ecotec, Automatic
The MAF had to be replaced, while the car was at the dealer the power steering motor was replaced (recall). When I got the car back the steering motor (reman) was making a lot of noise and I took it back. This time the motor and the steering column were replaced. After a week I got the car back last night.
This morning I noticed the steering wheel is off center (~1/2 to 3/4") to the right. The car tracks straight with no pull to either side.
View 11 Replies
I have a 2009 screw with ~60k miles. It is used for DD and tows our small camper or my flat deck w/jeep.
The other day I noticed an issue when turning right. The wheel gets hard to turn and does not want to return to center. There is also a low speed clunk you can feel in the steering wheel/column itself.
The truck is at the dealer now and they said the rack needs to be replaced and there is something in the column they need to replace too. I have the extended warranty, so this is all but covered 100%. I just have a deductible to pay.
I have not hit anything with the truck, so I am not sure what caused these issues.
View 3 Replies
This started several months ago. I can feel it in steering wheel & gas pedal. I thought it was the tires so I put 2 new tires on front, but no change.Tires had no unusual wear. Happens at any speed, worse around curves, left or right. Worse when temp is colder, 55 degrees, better at 75 degrees. Not affected by braking or in coasting neutral. No problem with steering or pulling.
View 2 Replies
So 2 weeks ago I noticed that after 30 minutes of driving on the highway my steering wheel started making a loud growling noise and vibrating really hard! When I hit the brakes it got worse but got better as I slowed to 30 mph. It doesn't happen all the time and not right away, only after a while of driving and the dealership says without codes they can do nothing...
View 7 Replies
I have a 1987 ford ranger 4x4 with automatic hubs. My automatic hubs completely destroyed themselves and are being replaced with manuals as soon as this new problem is solved. Initially the truck seemed to go in and out of 4 wheel on the hubs and jumped, snapped and ultimately destroyed the retaining clips in the hub itself so that those gears fell out when wheel was removed. I removed both sides and that stopped, but now when I turn the vehicle, this worse at lower speeds, it doesn't want to return to center and will stay in the turn without much effort to turn back to straight.
The pump seems fine on the power steering system. A mechanic friend of mine told me that my universal and upper and lower ball joints where shot on the front axle, but I feel that this might have more to do with the steering rods etc. The originals have been replaced and I am able to grease them, after doing this it seemed really loose for a bit, then by second day of driving it was back to the usual. I just am looking for some verification before replacing tie rods etc and then eventually the hubs, but winter over so there is less concern right now for that.
View 2 Replies
Just bought this '08 F250 CCSB 4X4 5.4 Problem is the steering seems heavy, it tends to wander at higher speeds and won't return to center after a turn. I've searched on here and found a few possibilities (axle u joints, ball joints, steering gear, etc). I have an appointment with the dealer on Friday to fix it under warranty but he is convinced it's the u joints in the steering shaft seizing. When my F150 steering shaft began to seize, it would be hard to turn then break free then be hard then break free and this is not what is happening on the SD. I haven't had a chance to check the front end myself but not sure how you would check the axle u joints if there was no play in them. How would you check to see if they were seizing up.
View 3 Replies
My wife was about to pull off of our hill (facing uphill) to go to work. She said she stopped, held on the brake, and looked back and forth. She then went to press the gas and the pedal wouldn't respond (no rev either) but the engine WAS on. The car started drifting backward and she said that both the steering and the brakes were very difficult to control (power and brake assist had disappeared). She was able to guide it back into the driveway and get it parked. She said that when she got it parked, she turned it off and started it up again. She tried the gas and it worked and she tried the steering and brakes and both worked. She stayed home today while we try to figure out what's going on with it for fear that it will happen again.
I initially thought some sort of power loss but she said that the radio stayed on. There were no dash warning lights or sounds indicated to her and she said that there were no unusual sounds from the car during this whole thing.
View 4 Replies
If I understand the manual the "Steering wheel auto away and return function" can only be turned off by the dealer. Is this right?
What do most of you do? Seems nice to have. But also could be a lot of wear and tear on the two motors to do this. Is it worth it.
View 8 Replies
Runs into a problem with steering wheel not wanting to return back to straight after a turn...spray wd40 on u joints on steering shaft ( under hood)....
View 2 Replies
My 2005 RX330 has 140,000 kms...and I am now witnessing frequent periods of hard steering. I even sometimes find that after I turn a corner, the steering wheel doesn't return back to straight as I move through the turn - I have to forcefully return the steering back to straight steering. There is plenty of power steering fluid, and there are no abnormal whining noises from the power steering assembly. And since the ease of power steering does still work...I suspect that a ball joint needs looked at.
View 14 Replies
Just recently i have noticed my truck acting up. the other day at about 10 to 20 mph i made a 90 degree turn and noticed my steering wheel wouldn't return but i had to bring it back. than this morning the same thing happened. I made a 90 degree left hand turn and it happened again. the truck wanted to keep going left but i kept turning right. it almost feels like my power steering pump is going out. The pump was changed about 4 years 90k miles ago. I'm curious to see what others have to say. What could it be????
View 14 Replies
Ok just swapped out the stock steering wheel(polyurethane) to the oem leather wheel...
The diy install went fine then i went to sleep, in the morning i took the car for a spin, i noticed when keeping the steering wheel straight i kinda veer to the left, ok maybe i got the install wrong so i popped out the wheel and adjust...but now it veers to the right!
How can I now keep my steering wheel straight w/out it veering left or right? I did change rims about 2 months ago, wheel alignment perhaps? Probably wasnt paying attention to the steering wheel before..
View 3 Replies
When I picked up my car I noticed the steering wheel is slightly off center to the left. I brought it back to the dealer who checked the alignment which was spot on. Toyota was notified and another C on the lot was driven which it's wheel was also slightly left. Dealer notified Toyota and offered to adjust wheel one more click but at the risk of it possibly moving to far to the right. I left it as is and as long as alignment is in specs I'm not to worried.
View 19 Replies
Just got my golf R 4 door/Nav. When driving straight on the highway (regardless of road crown)... my wheel was about 4 degrees off to the left. No problem alignment wise, but the nice flat bottom wheel is cockeyed.
Car has only 330 miles on it. Took it back to the dealership, they put it on the alignment rack - actually had me sit in the car ensuring the wheel was straight as the tech adjusted the Tie Rods below.
This made it better - I instantly noticed it was better when I took a short test ride with the tech, just as they were closing. However, on the highway home I noticed its still about 2 degrees to the left. Really frustrating as now I have to take it back to the dealer a second time.
The tech actually showed me the alignment printout which was close to-but not totally perfect. Said the only way to make it perfect is to adjust the sub-frame? Really? on a new vehicle.
I do have plans to mod the car's suspension with H&R Coilovers - but will not touch anything until I get this wheel thing square and I am 100% satisfied.
View 13 Replies
2012 Sonata ... I took it to dealer for alignment. Steering wheel off center.
mechanic said the left camber is off, cannot be corrected.
My question is, can the steering wheel still not be put to center so as it is not tilted to the left aprox. .5 "
View 1 Replies
The center of my steering wheel rattles (part that you press for your horn) is there any way to tighten this?
View 4 Replies
I'm stuck failing a vehicle inspection for the steering wheel not returning to center after a turn. It turns most of the way back but you definitely have to finish the job yourself. I've jacked it up and turn the wheel lock to lock with no bind at all, one finger, nice and smooth. I've replaced almost everything up front (ball joints, u-joints, bearings, drag link both ends, etc.).
Mechanic that did the inspection seems to think the steering gearbox and/or the power steering pump could be the source. I have only seen threads for loose/wandering steering (which is why I replaced everything up front already) pointing to the gearbox. I brought the state trooper in to verify it and he said while he wouldn't necessarily fail it, he can't override the mech's call because it does require assistance to straighten out.
View 14 Replies
My exit seating position was working great up until this morning. The seat remains in set position. Am I missing something or is it to the dealer I go.
View 5 Replies
I have a 1999 jeep cherokee 4 liter in line 6.tilt steering wheel is lock in one position. The handle that you release to move the steering wheel up or down don't have any tension on it.
View 1 Replies
