Chevrolet - Camaro :: 2002 Just Cranks Like Out Of Gas And Not Turning Over Completely
Aug 30, 2016
2002 Camaro SS. Been sitting in my garage and I have not started it for 2 months (I know, not smart). So I started it yesterday, it ran for about 20 seconds then just died and I cannot get it to restart. Battery is fully charged, it turns over, I can hear the injectors seemingly shoot fuel when I just turn the key into accessory mode, but when I try to start it, it just cranks like it's out of gas and never even gives the slightest hint of trying to turn over completely. There is a 1/4 tank gas, that is at least 2 years old in the car. Also, when it started the first time a ton of black stuff came out of the tail pipes.
Bad gas? Fuel pump? Not sure which path to go down first.
View 10 Replies
Advertisement
I have a 98 camaro z28 and im having some problems with my rear end. I am positive its a limited slip. Ive removed the cover from differential and know what a lsd looks like. My problem is when i turn and hit the gas only 1 tire spins. But if im going straight and hit the gas both tires spins. When i say spin i mean break loose. I removed the cover tonight and took a look. No metal shavings at all. It all looks in good conditon. It has a 390 gear in it. Owner before me put it in. I removed the calipers and the axels have a little play in them. About a quarter inch play going in and out. Was wondering if this was normal. Also while it was jacked up i could hold one wheel while spinning the other. And if i play with it i can make the back left tire spin by its self also not making the ring gear move. Is it normal for a wheel to spin and the ring gear not move? I have a lot of questions about differentials. But mainly why am i only getting one tire to spin when turning?
View 19 Replies
I have a 2000 S10 Chevy blazer .One day I was at a stop sign when the truck went completely dead , I had no power . I walked home , I came back a little later and figure I would give it a try well it started so I brought it home .. from then on it would start up some days and other times it would just crank but not start .After keeping it my garage for over a year , the other day I charged the battery and try to start the truck , it kicked right over and I let it run for awhile . I turned it off and restarted it again let it run for awhile . Yesterday I went up to start it again and nothing ,so I gave up , today it was the same thing it would just crank but not start . I know its not a fuel issue , and I don't think its an ignition problem ..
View 5 Replies
I am having problem with the battery light coming on headlights on when switch is off the fuel gauge dancing up and down radio works intermittently that's when I start the van it will only run a few miles and the battery will go completely flat I have changed the starter do not believe it is the alternator as there to many electrical problems thinking that a short somewhere. Where to start and what to look at .....
View 3 Replies
First time ever. It has 175K on it. Ran fine yesterday. Went out this morning and it almost started, then stopped firing. It was facing down hill, so I thought possibly it wasn't getting the proper volume of oil, so I checked it and had to added 2 quarts to get it up to the proper level. This did not work.
I do have one question: Does the Water in Fuel light stay on until it starts? After turning it over again, it wanted to start at first, then stopped firing completely, but while cranking the WiF light goes off. Does this mean that there is no water in the fuel?
I m keeping it on the charger to make sure the batteries are up to snuff when I try it again. I only crank it for about 15 seconds before I let it rest. I don't have a code reader but I do have a ScanGuage2.
View 2 Replies
I have a 2002 trailblazer that will start fine in the morning and after it sits for an hour or two, but once i start it and run it for over ten minutes and i shut it off when i try to re-start it, it will crank but won't start. the dealer cleaned the throttle body and injectors, check the fuel pump for presure and it was fine,and they got no error codes?????? I've read that in can be the ignition switch??
View 14 Replies
My 2002 Tahoe cranks over fine (new battery), but, will not start. I have checked the fuel pump relay and have control power to energize the relay, but. no switched power from ECM to change relay state. Jumped rely 30/87 and pump runs. No DTC's. Gauge on instrument panel reads no fuel. Scanner shows 56% level. Tried to use my Snapon MT2500 to switch relay state and received error message "generic device control limit exceeded" ECM?
View 3 Replies
About 3 weeks ago my truck decided not to start after having driven many miles. It has happened again after a day of driving with multiple stops. It cranks but doesn't turn over. Mechanic could find no code errors, there is no service engine light. Problem?
View 9 Replies
First thing in the morning It seems to take a lot of turning over before it fires, but after it fires up it seems ok untill it sits for some time, Am I dealing with a fuel pump problem?
View 3 Replies
I recently purchased for my son a 1986 camaro 2.8 MFI v6 the car had been sitting for over a year in the previous owner's back yard because it would not start.I have had a mechanic do the following: heads redone, replace the distributor, replace the timing chain and gears, new wires, and emptied the fuel tank and replaced the fuel filter.
I picked up the car and it ran for about two week no problem. Then it started diying occasionally when you let of the gas to come to a stop, so he replaced the fuel relay switch thinking that it may be going bad. The next day he had been driving it about 15 miles when it just died and would not restart. We shot a little starting fluid to see if we could get it to start and get it back home. it fired up and ran all the way home and died when turning into the driveway. and would not start again.
We replace the fuel regulator the car started right up and he took it for a test drive. The car ran about 4 miles, long enough to warm up and died again and would start. and again we were about to get it started with starting fluid to get it back home. pulled in the driveway and it dies. again it would not start, let it sit all night and the next morning still would not start finally got it to start with a squirt of starting fluid and moved it into the garage. shut if off and then tried to start it and it worked 5 times in a row.
View 4 Replies
I have a 2000 Chevy Camaro. Two years ago my catalytic converter went out and I had it replaced. 20,000 miles later my mechanic says that I need to replace it again. Is this accurate? I thought the life of a Catalytic Converter was much longer.
View 2 Replies
A year ago my 1998 chevy camaro 6 cyl eng. randomly did not start. Then came back to it 15 min later and it started right up and did not give me another problem.3 months ago it did the same thing, but then would go a week at least with no more trouble sometimes longer sometimes more frequent.
within this past month it has become very frequent and I have had to push start it with the clutch a few times to get to work. It starts right up when I pop the clutch every time. Now the car will not start with the key no matter what.
Some more details on what it does now - When I first get in it after it has sat a little while you can hear the starter solenoid click the first three times or so when I turn the key. After that you do not hear the solenoid click anymore, but the relay up under the hood clicks every time with the key. (for kicks I even swapped the starter relay and the ignition relay with no change)
The battery is fairly new, but I load checked it anyway and it is perfect, plus I tried another good battery and jumper cables from a battery in a running car so that's not the problem. I have cleaned all corrosion off terminals and the ground to the engine and to the car.
I checked the resistance of the little piece on each of two ignition keys and they check fine.
I have checked the clutch switch down by the pedal multiple ways. checked resistance of the switch, voltage when the key is on and jumpering the plug with a paper clip.
when I push start the car and have it running I can turn the key with the clutch out nothing happens, but if I push the clutch in the starter will engage (grind) every time (I didnt do this a lot). this tells me that the clutch switch is working and the started is working right?
I did switch the starter out with another used unit and it did the same thing.
I unhooked the alternator on the off chance a short in that was drawing too much juice and not giving enough to the starter (I know I am really reaching here).
View 4 Replies
2000 Camaro, v6 auto, 103000 miles, 2 years ago car started making a roaring noise in the rear. the faster i go the louder it gets. if i let off the gas it almost goes away. at high speed over 90 the rear vibrates. noticed today that if i push on rear fender there is a clunking noise coming from rear wheel. checked lug nuts and they are tight. Is it unsafe to drive?
View 4 Replies
When turning in both directions, front end makes a CHEEP-CHEEP-CHEEP-CHEEP-CHEEP sound. Frequency increases when speed increases.Brakes are NOT engaged when this happens. Goes away when coming out of turn.
I am sure the problems could be multiple, but what is your first thought? Not that it matters, but its a 2002 Chevy Trailblazer.
View 17 Replies
I keep good maintenance for my car. Just had the 45,000 mile major tune up also. However, the engine overheating light came on the other day - said I should idle until it cooled down. I was just about to park, so I did that and left to do some shopping. When I came back and started the drive home the light came on again and indicated I should stop and turn the engine off. I drove two more blocks and put the car in the garage. I noticed what I thought was some leakage on the garage floor also. Next AM, I had it towed to the dealership since I'd checked the coolant dipstick and it looked EMPTY!. Dealership tested it out and could find nothing wrong - no leaks, no computer faults either. They sent me on my way and neither warning light has come on since. I've kept an eye on the engine temperature gauge and it hovers around 200F - mid range on the gauge. No further problems. Funny thing is, now my A/C seems to operate better!
View 10 Replies
I have a 2000 z28 Camaro, and I'm having problems with it slipping at high speed. and I noticed today that fluid is leaking and the car loses power as it warms up. it runs great starts right up, just having problems with the tranny. What may be going on, I do check the fluid and fill it when it needs it. and it runs great until I need to get up to around 50mph.
View 1 Replies
I have a 1979 Chevy Camaro and whenever I turn the car on so it only lights up my dash, my RPM gauge goes all over the place, and the engine isn't even turn on yet. And also before i even put the keys in the ignition, the RPM is sitting at 10.
View 3 Replies
I have a 1994 V6 Chevrolet Camaro with ~197K miles. Recently I have noticed that after starting the engine it idles rougher than normal and also as I accelerate, especially between 45 and 65 mph. Several things have just been replaced and/or fixed: spark plugs, spark plug cables, oil, coil packs, water pump, & thermostat. I regularly use premium gasoline and when for some reason a lower octane is used I add an octane booster. Since this problem arose I tried a fuel system cleaner; it hasn't worked thus far. The last time something like this happened, I took my Camaro to a trusted repair shop and when being diagnosed its' cylinder chambers and many different lines flooded with fuel. After replacing the fuel regulator my car returned to normal.
View 4 Replies
I own a 1988 Camaro Iroc-Z with a 5.7 350 TPI motor. I was driving the car onto I-95 at a speed of 65 when I heard a loud boom under my car, and pulled over to see what had happened. I couldn't see what happened, so I drove the car slowly to a friends garage to find the exhaust pipe from the converter back to the muffler had split and blew apart. I took my car to another shop to repair the pipe, but when I left the shop after the repair, I accellerated to about 40 mile per hour, I get another loud backfire and loss of power. The pipe is still intact, but I cannot figure out what is causing the backfire. My friend from the first garage says it is a failing fuel pump. I never heard of such a thing to be honest.I am at a loss and I have to correct the issue soon, as this is my only car to drive.
View 4 Replies
My '97 camaro has a cracked cylinder. (or something like that; the water keeps getting "consumed" by the engine). my mechanic put something in it that temporarily "sealed" the crack. it bought me more time but now it's not holding on to any water. My question is, can i do this again and is it something i can do myself?
View 5 Replies
The owner's manual for my 2010 Camaro states that the passenger seat height can be adjusted by pumping the handle used to slide the seat forward and backward. However, pumping the handle does not change the seat height.
View 13 Replies
